CS Paper Radar

Controller-Only False Confirmation in Passive RF UAV Link Detection

Rajendra Upadhyay, Rajendra Paudyal, Al Nahian Bin Emran, Duminda Wijesekera

cs.CR ·submitted 2026-09-21 18:39 UTC · v1

Abstract

Passive radio frequency (RF) sensing is widely used for counter-unmanned-aerial-vehicle (counter-UAV) detection. Existing studies commonly report high accuracy against background RF or WiFi/Bluetooth interference, but rarely isolate controller-only operation without a linked aircraft. We present a dual-band software-defined radio (SDR) measurement study with ambient, controller-only, and linked states for three commercial UAV platforms (DJI Phantom 3 4K, Hubsan H501S, DJI Mavic Mini). Two USRP B210 receivers simultaneously scan eight 2.4 GHz and twelve 5.8 GHz observation windows across twenty rounds. We first train an energy-based detector using linked and ambient scans only. At four ranked concurrent dwell steps (8 s), it achieves 0.992 linked-versus-ambient balanced accuracy but false-confirms 30 out of 60 controller-only scans (FCRctrl = 0.500). We then include controller-only scans in training and use confirm, reject, and defer outputs under an explicit controller-only false-confirmation-rate (FCR) constraint. For the pooled all-platform analysis, the constraint reduces observed FCRctrl from 0.350 to 0.050, while confirm-linked TPR decreases from 0.900 to 0.400 and 42.1% of scans are deferred. The corresponding compact scan performs substantially better for Hubsan and Mavic than for Phantom. A hardware-in-loop experiment reduces measured wall-clock time from 82.9 s to 28.9 s. These measurements show that linked-versus-background accuracy does not measure controller-only false confirmation and that this error should be reported separately.

Closest papers

Nearest neighbours by meaning across the whole index.

Multi-UAV Tracking Evaluation Using 5G Uplink Signals on an O-RAN ISAC Simulation Testbed

cs.NI eess.SP ·2026-08-11 ·Arun K. Gurung, Satha K. Sathananthan
similarity 0.64
Abstract · 25 pages, 3 figures, 12 tables

We evaluate multi-target detection, association and tracking end to end on an O-RAN simulation testbed built from OpenAirInterface, FlexRIC and Sionna RT that repurposes the 5G NR uplink sounding reference signal as a passive radar waveform, and against what a counter-UAS command-and- control (C2) consumer requires rather than by detection alone. Three UAVs differing in altitude, velocity and radar cross section (-8 to -20 dBsm) fly one bistatic pair with an 8-element planar receive array. Once every target is detected the binding limit is contention, not sensitivity - two targets share one nearest detection in about 74% of coherent processing intervals, and targets are detected far more often than they are tracked. Elevation from that array cannot separate targets sharing a range-Doppler cell, but it decides association in 58% of intervals. Concurrent tracks are exported from the RAN Intelligent Controller (RIC) xApp to a C2 fusion node over a SAPIENT interface carrying a calibrated detection confidence, validated at schema level against a mock fusion node. The evaluation is emulation-only on one geometry with 10 noise seeds, the mechanisms are characterized and analyzed to identify the key factors influencing multi-target tracking performance.

0.42

Physical Sensing Verification for Cognitive ISAC against UAV Spoofing via Digital Twins

eess.SP ·2026-11-05 ·Seyed Bagher Hashemi Natanzi, Bo Tang
similarity 0.60
Abstract · 6 pages

As integrated sensing and communication (ISAC) lets 5G and 6G base stations detect drones, software agents will soon act on what they sense. This amplifies the threat of a relay replaying the base station's signal as a phantom drone. For such cognitive ISAC systems, this paper proposes a wall-based physical check. A digital twin (DT) predicts where a real target's wall echo must arrive; a relay can fake range, but not where its own reflections come from. The paper proves that line-of-sight beam steering cannot expose a matched relay, and that, under stated conditions, a single-antenna relay faking a wall echo leaves a telltale echo where a genuine target leaves none. In a pre-registered ray-tracing study, the twin's evidence separated genuine targets from replays perfectly (AUC 1.000) on held-out streets, and a later-registered passive check needing no extra transmission accepted every genuine target and no replay. The primary active probe was inconclusive, at 5.3\% false acceptances against a 5\% limit, for lack of threshold margin. At the evaluated relay positions, the conditional bound certifies 3 of 24 held-out streets, reproduced on fresh ones, against single-antenna relay signals meeting its conditions, adaptive or fixed, and 11 of 24 at double bandwidth.

0.24

GPS-Triggered Adaptive Trajectory Control and SDR-Based RF Jamming for UAV Geofencing

cs.ET ·2026-11-09 ·Muhammad Moazam Azeem, Abdul Rehman Khan Tareen, Muhammad Obaid Ullah
similarity 0.56
Abstract

This paper presents a GPS-triggered geofencing and enforcement scheme that integrates real-time satellite positioning with Software-Defined Radio (SDR) based RF jamming to detect and neutralize unauthorized unmanned aerial vehicle (UAV) boundary violations. Conventional geofencing depends on onboard GPS and cooperative flight firmware. The proposed approach instead moves enforcement to a ground base station, so the response does not depend on the UAV. An ESP32- WROOM-32 microcontroller paired with a u-blox NEO-6M GPS receiver streams telemetry over Wi-Fi to a Python/GNU Radio base station. There, a lightweight Haversine boundary-violation algorithm computes the great-circle distance between the UAV and the geofence. This distance drives a piecewise-linear adaptive speed and altitude control law. The law progressively decelerates and descends the UAV inside a 1 km warning zone and brings it to a complete halt at the boundary. If the boundary is breached, a HackRF One SDR escalates to band-limited noise jamming of the 2.4 GHz control link. The hardware stack was integrated on a GoolRC S116 quadrotor with an end-to-end enforcement latency of about 1 s. Field trials achieved 95% disconnection accuracy within a 50 m radius, and u-center NMEA analysis confirmed sub-2-meter GPS positioning precision. Simulation over an 8-sector, 50 km geofence model confirms speed and altitude-invariant boundary enforcement for cruising speeds of 5 to 50 m/s and cruising altitudes up to 100 ft. A comparison against a PID baseline shows that the proposed law guarantees overshoot-free shutdown at the boundary without gain tuning. It also runs in constant time, which makes it well suited to low-cost, resource-constrained embedded platforms.

0.23

6G ISAC Drone Detection: Signal Processing and Experimental Validation at FR1

eess.SP ·2026-11-03 ·Enrique T. R. Pinto, Marcus Henninger, Lucas Giroto, Markku Juntti, Silvio Mandelli
similarity 0.56
Abstract

Integrated sensing and communications (ISAC) enables mobile networks to detect passive targets such as drones at minimal additional cost. However, in ISAC, a small drone must be detected against strong ground clutter with the limited radio resources left by communications. In this paper, we propose two ISAC target detectors: a coherent detector, which combines all frames and beam dwells of a revisit, and a non-coherent detector, robust to inter-frame clock phase drift. The algorithms leverage per-dwell clutter whitening and the adaptive coherence estimator (ACE) detection statistic to improve performance. Both detectors estimate the range, radial velocity, and azimuth of targets in real time on a laptop graphics processing unit (GPU). Measurements with an FR1 ISAC proof-of-concept system based on a commercial base station show that the coherent detector outperforms the non-coherent one and recovers the full track.

0.32

Aerial Person Detection under Edge Constraints: Held-Out Evaluation and Edge-Ground Verification

cs.CV cs.RO ·2026-11-15 ·Raghu Venkat, Tricha Anjali
code/datahot direction similarity 0.56
Abstract · 14 pages, 1 figure, 8 tables. Code, truth registers and result files: https://github.com/numberz-ai/aerial-person-detector

A search drone sees a missing person as a few pixels, carries a small computer, and shares a narrow radio link. We study person detection under those limits; the primary evaluations were declared before they ran, and later analyses are marked exploratory. In an exploratory comparison, holding out recording blocks inferred from thermal frame identifiers cut recall at a fixed false-alarm target from 32.7% to 12.3%. With nothing tuned on test blocks, a 46,000-parameter detector gated by a contrast cue finds 10.4% of people against 5.7% for the same network applied everywhere. A standard detector, YOLO11n, trained under the same folds finds 54.5% at a similar false-alarm rate for about eleven times the arithmetic, and on our 4K field footage at 117 m has a walking person among its top 16 detections in up to 92% of frames against 74% for our board. Run alone, YOLO11n's thresholds set at one location overshot their false-alarm target 1.7 to 3.4 times at new locations, and its best configuration at altitude cost 4 to 24 standard passes per frame. Re-scoring its 16 best crops (154 KB per frame) with an 842,000-parameter ground model, thresholds frozen on a validation location, raised recall from 44.9% to 53.7% against the same 16 crops with YOLO's own scores; in a post hoc paired analysis over 15 test locations the gain was +8.8 points [+2.4, +12.5]. Pooled false detections fell from 0.86 to 0.64 per frame, but that paired change was not distinguishable from zero. Coverage of a still person in earth tones was very low for both detectors in the clips we flew.

0.36

Vehicle and UAV Detection and Tracking with LTE Downlink Reference Signals: A Ray-Traced Evaluation on a Mapped Suburban Site with Licensed Base-Station Records

cs.NI ·2026-11-01 ·Arun K. Gurung, Satha K. Sathananthan
similarity 0.55
Abstract · 18 pages, 7 figures, 14 tables. Revised version

Passive sensing on the cellular downlink places the receiver at the user equipment and changes nothing in the network. We report simulation results for an LTE band-3 cell-specific reference signal arm on a ray-traced channel. On a synthetic street canyon the arm is compared with an uplink sounding reference signal arm on the same band, target and scorer: missed-detection probabilities of 0.667 and 0.772. On a surveyed site built from OpenStreetMap footprints and the licensed site record, nine receiver positions along the street track the vehicle at coverage between 29.9 % and 61.7 %; a 283 m lap separates target height from trajectory at 1.6 to 30 m; a 137 m lap on the built-up street tracks a vehicle and a 15 m airborne target on every cell, and 8 receivers at 135 m spacing carry one illuminator's coverage over 1140 m of the street. Potential future work includes extending the analysis to multiple illuminators and varying receiver configurations, and confirmation through over-the-air measurements.

0.34

RSS-Based Verification of Drone Remote ID Position Claims with Unknown Transmit Power

eess.SP ·2026-10-30 ·Cole Dickerson, Ismail Guvenc, Wahab Khawaja, Ali Cafer Gurbuz
similarity 0.55
Abstract · Submitted to IEEE ICC 2027: Communication & Information System Security Track

Broadcast Remote Identification (Remote ID) is a key enabler for integrating unmanned aircraft into the airspace. However, the position it reports is self-declared and can be falsified with low-cost hardware. In this paper, we study how Remote ID receivers can verify the declared position from the received signal strength (RSS) when neither the transmit power nor the path-loss exponent is known. In particular, we derive a Rao score test whose null distribution is exactly chi-squared for any number of packets. Its threshold and detection probability therefore follow in closed form. We then bound the detection probability of any detector that is invariant to the unknown link parameters. This bound saturates as the falsified position recedes along a fixed bearing, so a sufficiently large falsification can remain undetectable. From this limit, we obtain the worst-case bearing in closed form, the observation length needed to close it, and a receiver placement rule. Simulation results show that the proposed test considerably outperforms an estimate-then-threshold detector at low false-alarm rates.

0.29

Geometry-Aware Multi-UAV Full-Duplex Communication: System Design and Experiment

cs.IT ·2026-09-27 ·Tao Yu, Kiyomichi Araki, Tomohiro Mogi, Yasushi Hada, Kei Sakaguchi
published similarity 0.54
Abstract · accepted by IEEE Transactions on Vehicular Technology

The deployment of unmanned aerial vehicle (UAV) systems relies on high-performance yet lightweight wireless links between UAVs and ground stations (GSs). This paper presents a geometry-aware multi-UAV in-band full-duplex (MU-IBFD) communication system that uses high-gain directional antennas and separated uplink/downlink channels to convert self-interference into controllable co-channel interference (CCI) between UAVs, thereby avoiding energy-intensive self-interference cancelers on UAVs. We also derive a geometry-aware CCI model and define a reliable operating region (ROR) in the 3D airspace, within which the SINR requirement is satisfied. A prototype consisting of two UAVs and a GS is developed, and field trials are conducted. The measured CCI as a function of UAV positions agrees well with the theoretically predicted non-ROR region, and the downlink capacity significantly exceeds that of a conventional time-division duplex (TDD) with omni-directional scheme and higher transmit power and approaches that of ideal IBFD in most of the airspace. A proof-of-concept 4K/60p video transmission further demonstrates the practical potential of the proposed MU-IBFD system.

0.34