CS Paper Radar

Emulation of Closely Spaced Spatial Sensing Targets Using a Parabolic Cylindrical Compact Range with a Multi-Feed Amplitude-Phase Controlled Linear Array

Zhangzhang Jiang, Guokai Jiang, Le Yu, Chunhui Li, Zhengpeng Wang, Wei Fan

eess.SP ·submitted 2026-09-14 07:27 UTC · v1

Abstract

Integrated sensing and communication (ISAC) base stations (BSs) are emerging as critical infrastructure for 6G networks, requiring advanced over-the-air (OTA) testing methodologies that can emulate dynamic, multi-target scenarios under far field (FF) conditions. However, existing testing solutions often suffer from limited angular flexibility, insufficient bandwidth, and prohibitive costs. {To address these challenges, this paper proposes an OTA testing system that integrates a radar target simulator (RTS), a multi-port amplitude and phase modulation (APM) network, and a multi-feed linear array with a single parabolic cylindrical compact range (SPCCR).} The proposed system is capable of emulating closely spaced spatial targets with varying incident azimuth angles. This setup meets the essential conditions for ISAC BS testing, including FF characteristics, wideband and multi-band compatibility, and the capability for sensing multiple dynamic closed-spaced targets. The feasibility of the proposed method is validated through both FEKO simulation and measurement. Experimental results demonstrate that the system successfully emulates multiple closely spaced targets within an azimuth range of $\pm 10^\circ$ with high emulation accuracy while maintaining excellent quiet zone (QZ) performance.

Comment
14 pages, 11 figures

Closest papers

Nearest neighbours by meaning across the whole index.

Multi-feed Plane Wave Generator for Compact OTA Multi-Target Emulation With Joint Angle-Delay-Doppler Control

eess.SP ·2026-09-30 ·Le Yu, Guangming Dong, Chunhui Li, Wei Fan
similarity 0.72
Abstract

Over-the-air (OTA) radar target emulation is an important method for evaluating the sensing capabilities of integrated sensing and communication (ISAC) and radar devices. Conventional single-feed compact antenna test ranges (CATRs) are generally limited to a single target direction, while multi-feed angular-synthesis methods commonly used in radar testing still require far-field illumination over the device-under-test (DUT) aperture. To overcome these limitations, this paper proposes a radar target OTA emulation framework based on multi-feed plane wave generator (PWG). The key capability is the simultaneous emulation of spatially close targets from different directions with joint angle--range--Doppler control. Target range is emulated through the corresponding delay, while Doppler and the complex echo coefficient are controlled by a channel emulator. Meanwhile, a multi-input amplitude and phase matrix (APM) maps each independent target-signal path to a dedicated PWG excitation vector that synthesizes the corresponding incident plane wave over the same test zone. This enables multiple target directions to be reproduced as local plane waves at a test distance substantially shorter than the conventional far-field requirement. The framework is experimentally validated at 3~GHz using a real $1\times11$ phased-array DUT. The PWG--DUT separation is 1.6~m, substantially shorter than the 7.2~m Fraunhofer distance of the DUT. At this separation, the synthesized $0^{\circ}$ and $10^{\circ}$ incident waves each exhibit an amplitude peak-to-peak error of 1.0~dB. Across two four-target angle--delay cases and one two-target angle--velocity case, the estimated target parameters show angular deviations within $1^{\circ}$, interpolated delay errors within 2.4~ns, and velocity errors within 0.15~m/s.

0.18

Practical Hardware-Efficient ISAC: Enabling Multi-Target Sensing With Few RF Chains

eess.SP ·2026-10-12 ·Zhenkun Zhang, Cunhua Pan, Hong Ren, Jun Tang, Dongming Wang +1 more
theory similarity 0.65
Abstract

Hybrid analog--digital arrays reduce hardware cost in integrated sensing and communications (ISAC), but spatial compression and beam-dependent scan responses complicate multi-target estimation with few radio-frequency (RF) chains. To address these challenges, this paper proposes a burst beam-scanning multiple-input multiple-output orthogonal frequency-division multiplexing (MIMO-OFDM) framework that reuses downlink reference signals for joint range, radial-velocity, elevation, and azimuth estimation. Specifically, a structured global--local dual-tensor estimator separates targets by using scanning observations and refines their parameters from selected-beam RF-chain responses, with delay--Doppler signatures maintaining cross-stage target correspondence. The recovered subarray responses yield closed-form elevation and azimuth estimates through exact sum--difference relations, avoiding small-angle approximations and fine angular grid searches. To further improve Doppler accuracy, spatial-mask-aided weighted least squares exploits the longer inter-burst temporal aperture while resolving phase ambiguity using intra-burst estimates. The joint multi-target Cramér--Rao lower bound (CRLB) and corresponding three-dimensional (3D) positioning bound are also derived to characterize estimation performance. Simulation results show that the proposed scheme achieves near-CRLB estimation accuracy at high transmit powers and centimeter- to millimeter-level 3D positioning with only four RF chains, while maintaining low computational cost.

0.12

Fluid Antenna Array-Enabled Near-Field ISAC: Joint Port Position Optimization and Transmit Beamforming Design

cs.IT ·2026-11-02 ·Wangqi Shi, Zhentian Zhang, Hao Jiang, Zaichen Zhang, Kin-Fai Tong
similarity 0.63
Abstract

Fluid antenna systems (FASs) have shown that activating a single port from a densely packed antenna array can yield spatial diversity comparable to that of tens of independent antennas, a property that has substantially improved communication reliability and efficiency. The fluid antenna array (FAA) extends this concept to multi-port configurations while avoiding complex multi-dimensional spatial correlation, and offers significant geometrical flexibility under a finite aperture and a limited port budget. These attributes motivate environment-adaptive array geometry for sensing in integrated sensing and communication (ISAC) systems. Although this flexibility enables adaptive array geometries that exploit near-field distance-angle information, improving multi-parameter target estimation under communication and deployment constraints remains challenging. In this paper, we propose a planar FAA-assisted near-field ISAC framework for multiuser communication and target sensing. Specifically, we derive the Fisher information matrix (FIM) and the corresponding Cramér-Rao bound (CRB) for the joint estimation of target range, zenith angle, azimuth angle, and radial velocity. Based on the derived CRB, we jointly optimize the FAA port positions and transmit beamforming to improve sensing accuracy while satisfying communication signal-to-interference-plus-noise ratio (SINR), transmit power, and physical deployment constraints. To solve the resulting non-convex problem, we develop a two-stage alternating optimization algorithm, in which transmit beamforming is optimized through semidefinite relaxation (SDR), while FAA port positions are successively optimized through discrete search and continuous refinement. Simulation results indicate that the proposed algorithm achieves favorable sensing performance while maintaining a reasonable computational cost.

0.16

Beamfocusing Beyond the Near Field: Frequency Diverse Arrays for OFDM-ISAC Systems

cs.NI cs.ITeess.SP ·2026-10-30 ·Arda Akyazi, Ahmed Hussain, Asmaa Abdallah, Ahmed M. Eltawil, Abdulkadir Celik
hot direction similarity 0.62
Abstract · 8 pages, 5 figures. Interactive figures and code: https://akadircelik.com/demos/fda-ofdm-isac/

Traditional phased arrays (PAs) achieve near-field (NF) beamfocusing through spherical wavefront curvature, but lose this range selectivity in the far field (FF). Frequency diverse arrays (FDAs) instead introduce frequency offsets across antenna elements. These offsets synthesize a range-dependent beam whose beamdepth is governed by the aggregate frequency-offset span rather than the physical aperture, thereby extending finite beamdepth into the FF. Although FDAs have been extensively studied for radar, their broader potential for wireless communications remains largely unexplored. Accordingly, this article examines how this capability can support wireless communications and integrated sensing and communication (ISAC). We compare PA and FDA focusing mechanisms, explain FDA coupling and periodicities, and assess coexistence with orthogonal frequency-division multiplexing (OFDM). Integer-multiple offsets preserve alignment with the OFDM subcarrier grid and avoid offset-induced intercarrier interference under ideal synchronization, but require suitable symbol mapping and receiver processing. We also distinguish FDA beamdepth from waveform-based radar range resolution and discuss their complementary roles in sensing. For the configurations studied, FDAs offer no additional single-user spatial degrees of freedom. Interestingly, their principal benefit is multiuser separation through location division multiple access (LDMA). Numerical case studies under an idealized FDA channel model show that FDA-LDMA achieves higher sum-rates than PA-based schemes for users with small angular separation in the FF, even after accounting for the bandwidth reserved for frequency offsets.

0.44

Multi-UAV Tracking Evaluation Using 5G Uplink Signals on an O-RAN ISAC Simulation Testbed

cs.NI eess.SP ·2026-08-11 ·Arun K. Gurung, Satha K. Sathananthan
similarity 0.61
Abstract · 25 pages, 3 figures, 12 tables

We evaluate multi-target detection, association and tracking end to end on an O-RAN simulation testbed built from OpenAirInterface, FlexRIC and Sionna RT that repurposes the 5G NR uplink sounding reference signal as a passive radar waveform, and against what a counter-UAS command-and- control (C2) consumer requires rather than by detection alone. Three UAVs differing in altitude, velocity and radar cross section (-8 to -20 dBsm) fly one bistatic pair with an 8-element planar receive array. Once every target is detected the binding limit is contention, not sensitivity - two targets share one nearest detection in about 74% of coherent processing intervals, and targets are detected far more often than they are tracked. Elevation from that array cannot separate targets sharing a range-Doppler cell, but it decides association in 58% of intervals. Concurrent tracks are exported from the RAN Intelligent Controller (RIC) xApp to a C2 fusion node over a SAPIENT interface carrying a calibrated detection confidence, validated at schema level against a mock fusion node. The evaluation is emulation-only on one geometry with 10 noise seeds, the mechanisms are characterized and analyzed to identify the key factors influencing multi-target tracking performance.

0.42

Electromagnetic Channel Model and Sensing Performance for ISAC: The Case of a Single Cylindrical Scatterer

eess.SP cs.IT ·2026-11-17 ·Gabriele Gradoni, Ahmed Elzanaty, Yadong Yang, Mohsen Khalily, Mahmoud Shahabadi +4 more
top venuetheory similarity 0.60
Abstract · 16 pages; published in IEEE Transactions on Wireless Communications

We propose an electromagnetic wireless channel model for accurate target localization in radar-like sensing scenarios. The model employs a self-consistent method grounded in wave scattering theory and imposing boundary conditions, providing the (impedance) channel transfer matrix for a propagation channel with a single target modeled as a cylindrical scatterer. The model is: 1) physics-based, as it includes electromagnetic interactions between objects; 2) unified, as it is valid in both near- and far-field regions. Within the canonical two-dimensional and 2.5-dimensional configurations with line-source and dipole-source excitations, respectively, the model supports dielectric cylinders with frequency-dependent permittivity. Localization accuracy is assessed via the Cramer-Rao lower bound for a dielectric cylinder with variable position, radius, and dielectric constant. Provisions for future extensions to extended targets are discussed in the context of 3GPP channel modeling.

0.46

Electromagnetically Consistent Monostatic ISAC Beamforming: Mutual Coupling, Active Mismatch and Tx-Rx Leakage in Compact Dipole Arrays

eess.SP ·2026-11-05 ·Stylianos D. Asimonis, Christos Tselios, Dimitrios Tyrovolas, Ilias Politis, George K. Karagiannidis
similarity 0.59
Abstract · 6 pages, 9 figures, 2 tables. Submitted to IEEE ICC 2027

Beamforming for integrated sensing and communication (ISAC) is usually designed on ideal array manifolds with a norm constraint on the transmit signal. In a compact monostatic transceiver this hides three antenna effects: distorted embedded patterns, beam-dependent active mismatch at the power amplifiers, and transmit-to-receive leakage that raises the radar noise floor. We build a multiport scattering model of a shared-aperture dipole array directly from method-of-moments simulations and use it to formulate a Cramer-Rao bound minimizing ISAC beamformer with multiuser SINR constraints, per-port active reflection constraints and a leakage budget, solved as a semidefinite program with a one-dimensional budget search. Full-wave evaluation shows that coupling-unaware designs miss their SINR targets by up to 6.2 dB and drive amplifiers to an equivalent VSWR above 3.3 at small spacings. For spacings from 0.3 to 0.5 wavelengths, the proposed design meets all targets with an equivalent VSWR below 2 and lowers the root Cramer-Rao bound by 32 to 53 percent for 80 dB of self-interference cancellation and by a factor of 3.4 to 5.6 for 70 dB. An independent finite-difference time-domain model of the final layout in openEMS confirms that the leakage null and the ranking of the designs are preserved.

0.24

A Four-Branch Radar Target Simulator with Fractional Delay on a PlutoSDR

eess.SP ·2026-11-11 ·Florian Euchner, Stephan ten Brink
code/data similarity 0.56
Abstract

Repeatable test setups support the development and evaluation of integrated sensing and communications (ISAC) hardware and algorithms. Commercial radar target simulators are expensive, while sub-6 GHz ISAC experiments often need only tens of megahertz of bandwidth within their available spectrum allocation. This makes simpler, low-cost test hardware attractive. We present a low-cost, open-source radar target simulator based on an ADALM-Pluto without hardware modification, supporting four independently configurable targets and analog bandwidths up to 56 MHz. The FPGA generates echoes with independent delays, Doppler shifts and gains, using fractional-delay filters for sub-sample adjustment. For motion-consistent echoes, delay and carrier phase are updated together to reproduce both changing range and frequency-dependent Doppler shifts. Over-the-air measurements demonstrate simultaneous echoes, sub-sample delay adjustment, and smooth target motion between sample positions. The FPGA source, firmware and on-device web interface are publicly available.

0.30