CS Paper Radar

Automotive Hardware Attacks: An Architect's Guide to TARA

Jakub Breier, Xiaolu Hou

cs.CR ·submitted 2026-10-07 08:56 UTC · v1

Abstract

Threat analysis and risk assessment (TARA) according to ISO/SAE 21434 treats implementation-level hardware attacks inconsistently. We show that two of the three attack-feasibility approaches exemplified in the standard rate every attack path that requires physical access as very low by construction, independent of the implementation, while the third can assign the same path any of the four ratings, depending on the assumed state of attacker knowledge and on the attacker profile. This paper presents a hardware-aware extension of the TARA that covers side-channel analysis (SCA), fault-injection attacks (FIA), and abuse of debug and test interfaces. It adds an attacker model for physical access over the vehicle lifecycle; a path-dominance relation on the attack-potential factors that identifies when a simpler path makes a sophisticated one irrelevant; a three-level hardware relevance gate (H0 to H2) with an explicit decision rule that fixes whether resistance of a hardware step may be argued, must be documented, or must be demonstrated by test; and a rating rule under which a hardware step receives no credit for implementation-specific resistance until the required evidence exists. The gate is positioned relative to cybersecurity assurance levels and targeted attack feasibility. The method is applied to a reference gateway architecture, and its structural inputs are examined on ten published attacks on automotive components. In seven of the ten studies, the demonstrated attack included a debug, programming, boot, diagnostic, or update mechanism, whereas only four studies included an attack on a cryptographic computation.

Closest papers

Nearest neighbours by meaning across the whole index.

Lessons from the Hardware Hacking Competitions: Verification Techniques, Findings, and Insights

cs.CR cs.ET ·2026-08-23 ·Sudipta Paria, Aritra Dasgupta, Raghul Saravanan, Jayanth Thangellamudi, Sai Manoj P D +1 more
similarity 0.65
Abstract · 11 pages, 5 figures, 9 tables

Hardware hacking competitions have emerged as practical platforms for evaluating security weaknesses in complex System-on-Chip (SoC) designs while promoting security-aware verification and tool development. This paper presents a systematic study of SoC security verification through open-box hardware hacking competitions, focusing on practical vulnerability analysis strategies, observed findings, and lessons for security-aware verification. We present a multi-strategy vulnerability analysis methodology, combining simulation-based verification, formal verification, lint analysis, Large Language Model (LLM)-assisted bug detection, and coverage-guided hybrid fuzzing. Representative vulnerability findings are analyzed to illustrate how different techniques expose complementary classes of security flaws, and we derive practical lessons for pre-silicon security verification. Finally, we discuss how competition benchmarks can support the reproducible evaluation of emerging hardware security techniques and guide future security-aware EDA research.

0.19

Automotive HSMs - Architectural Challenges and Security Implications

cs.CR cs.ARcs.ET ·2026-08-25 ·Krishna Teja Medam, Austin Bruce
similarity 0.64
Abstract

Automotive electronic control units (ECUs) increasingly depend on hardware-rooted security to protect software integrity, authenticity, and lifecycle management in the presence of remote and physical threats. Hardware Security Modules (HSMs) have become a key building block in automotive system-on-chips (SoCs), providing isolated cryptographic services, secure key storage, and controlled execution under stringent real-time and cost constraints. This paper presents an architectural analysis of automotive HSMs and examines their role in establishing secure boot and hardware roots of trust. We first survey common HSM integration models used in production ECUs and discuss their flexibility and current automotive use cases. We then introduce realistic threat models to motivate hardware-backed security controls and analyze how HSM design choices influence secure boot chains of trust, secure storage, secure execution, and software signing mechanisms. Key tradeoffs between isolation, performance, updateability, and attack surface are discussed, with optional consideration of side-channel implications. The paper concludes by highlighting open challenges and future directions for scalable and resilient automotive hardware security. Finally, we discuss emerging challenges such as cryptographic agility and post-quantum readiness that are likely to shape the next generation of automotive HSM architectures.

0.20

JENGA: Exploiting Counter-Based RowHammer Countermeasures to Break Real-Time Predictability

cs.CR cs.AR ·2026-09-01 ·Valentin Abgrall, Marcello Traiola, Ruben Salvador, Maria Méndez Real, Alessandro Palumbo +1 more
published similarity 0.62
Abstract · To appear at the 47th IEEE Symposium on Real-Time Systems (RTSS) 2026, 14 pages, 11 figures, 1 table

Safety-critical real-time systems must satisfy multiple dependability requirements, notably time predictability and security. In such systems, tasks must complete within bounded and known execution times, typically characterised through Worst-Case Execution Time (WCET) analysis. At the same time, DRAM-based platforms are increasingly sensitive to the RowHammer read-disturbance security vulnerability, which has motivated the development of numerous hardware and software countermeasures in both academia and industry. However, the impact of these defences is generally evaluated in terms of average-case performance, a metric that is insufficient for safetycritical real-time systems, where worst-case behaviour is the primary concern. In this paper, we study the impact of RowHammer countermeasures based on hardware counters on the timing behaviour of real-time systems. We use a Per-Row-Activation-Counter (PRAC) countermeasure as a case study, standardised for recent DDR5 memories, and show that it can introduce significant timing variations. Based on this observation, we introduce JENGA, an attack in which an attacker-controlled task manipulates the internal state of the RowHammer countermeasure mechanism to increase the execution time of a victim real-time task beyond its expected WCET. We implement JENGA in a gem5 and Ramulator 2.0 simulation environment and evaluate its impact on TACLeBench workloads. We show that such an attack can delay tasks up to 200% of their WCET, making the initial timesafety assumptions unsafe. To address this issue, we derive a safe analytical bound that accounts for mitigation-induced delays in WCET analysis for DRAM systems protected by hardware countermeasures, such as PRAC-N.

0.26

Mission-Aware Attestation Envelopes for Time-Critical Autonomous Action: A Hardware-in-the-Loop V2I Study

cs.CR cs.ROeess.SY ·2026-10-06 ·Dimitrios Nikou, Nikolaos Kekatos, Sophia Petridou, Stylianos Basagiannis
published similarity 0.61
Abstract · 25 pages, 4 figures, 8 tables. Accepted at Modelling and Simulation for Autonomous Systems (MESAS 2026), to appear in Springer LNCS

An autonomous system that asks for a privileged physical action is usually gated on integrity evidence: a platform proves what it is running, and the request is granted or refused on that basis. Such a gate is normally treated as a predicate, yet the evidence behind it has an age, the decision that consumes it has a latency, and the physical system that waits for it has a deadline. We formulate mission-aware attestation as a runtime assurance contract that holds only when integrity is valid, the evidence is fresh enough, and the decision completes inside a budget derived from the current physical state. The contract yields four operational outcomes where a binary gate yields two, separating a refusal caused by tampering from one caused by stale evidence and from one caused by a late decision. We evaluate it on a hardware-in-the-loop vehicle-to-infrastructure platform: a driving simulator supplies the physical state and the authorisation deadline, while a microcontroller on-board unit and a TPM-backed roadside unit running Linux integrity measurement supply the assurance evidence. A security-blind model admits the whole operating space and a hardware-informed one three quarters of it, and every point it refuses fails the freshness margin rather than the response margin. Moving the attestation interval across the range the verifier permits costs about as much as a fivefold scaling of the latency distribution, and the interval is directly configurable, which makes it the immediately actionable deployment parameter. If the freshness bound does not exceed the authorisation budget, every late decision is also stale and lateness becomes unobservable, so the attestation interval and the freshness bound cannot be chosen from security requirements alone.

0.40

LLM-Assisted Dynamic Threat Analysis for Attacker-Reachable Software Weaknesses in Autonomous Vehicles

cs.SE cs.CRcs.LG ·2026-08-13 ·Md Wasiul Haque, Sagar Dasgupta, Mizanur Rahman, Md Rayhanur Rahman
code/data similarity 0.59
Abstract · 17 pages, 8 figures, 8 tables

Autonomous vehicles depend on large safety-critical software stacks, where weaknesses reachable from adversarial inputs may affect steering, braking, or other control decisions. Static analysis can identify candidate sites, but dynamically confirming exploitability requires executable test artifacts that are difficult to construct manually. We investigate whether large language models (LLMs) can automate this process for Autoware, an open-source autonomous-driving stack. We perform compiler-precise static analysis across 185 packages, identifying 1,375 decision rules, 2,274 validation checks, and 482 input-to-safety-output flows, from which we derive a weakness taxonomy and sample 740 reachable sites. Two local open-weight LLMs, a no-static-context ablation, and a naive-template baseline generate 3,700 artifact sets, which are compiled against the real build under sanitizers, repaired through compiler-in-the-loop feedback, and fuzzed when executable. The main result is a build-integration failure taxonomy showing that 80% of first-shot compilation failures arise from dependency wiring rather than program logic. The reasoning model compiled 64% of harnesses on the first attempt, compared with 6% for the code-specialized model. Repair achieved full object-compileability for the reasoning model only through extensive stubbing; fewer than half of its harnesses reached the fuzzer, and all 37 observed crashes originated in stubbed code rather than Autoware. No candidate weakness was dynamically confirmed within budget. These results show that build integration, not candidate generation or fuzzing, is the primary barrier to reliable LLM-assisted dynamic analysis of full autonomous-vehicle software stacks.

0.59

CHERI under Fault Injection: An Emulation-Based Security Evaluation of Capability Hardware Enhanced RISC Instructions

cs.CR cs.AR ·2026-11-15 ·Eva Sophia Schreyer
similarity 0.58
Abstract · Submitted to KTH Royal Institute on Technology as a Master Thesis

Memory-safety vulnerabilities continue to dominate real-world exploit chains despite decades of research into software mitigations. CHERI is a hardware architecture that enforces spatial and temporal memory safety by augmenting pointers with hardware-checked metadata, thus preventing software-based exploitation, but its threat model explicitly excludes fault injection. This thesis investigates whether targeted fault injection can undermine CHERI's memory-safety guarantees in a pure-capability CHERI-RISC-V environment. Two fault classes are considered: bit flips corrupting capability metadata, and fault-induced check skipping on capability store instructions. We implement fault injection primitives in a QEMU-based emulation environment, which enables deterministic, repeatable experiments without specialised hardware. With them, we demonstrate four attack scenarios: buffer overflows, control-flow hijacking, data-only attacks, and use-after-free. Each succeeds with one or two targeted faults (lower bounds under the emulation-based setting). Check skipping offers an alternative route to control-flow hijacking and data-only attacks, with a minimum of one fault. These results show that CHERI's guarantees depend on the physical integrity of capability metadata, the uninterrupted execution of metadata checks, and the integrity of the revocation bitmap: a single targeted fault can circumvent spatial safety, temporal safety, or control-flow integrity. CHERI still raises the cost of exploitation, since fault injection is a prerequisite for every attack and the sentry mechanism forces an attacker to supply a valid tagged capability or spend a second fault restoring the tag. Based on these findings, we propose mitigations: ECC-protected capability memory, capability field authentication codes, redundant execution of security-critical checks, and revocation bitmap integrity verification.

0.29

RISK: Auditing Industrial Control Systems for Too-Late-to-Recover Vulnerabilities

cs.CR ·2026-09-29 ·Syed Ghazanfar Abbas, Gang Wang, Dongyan Xu
similarity 0.58
Abstract · 17 pages

The security of industrial control systems (ICS) is important. Yet most ICS security efforts focus on the detection of ICS attacks, with much less attention to the recovery after detection. In this paper, we address this underexplored area by jointly auditing the detection and recovery of ICS. Specifically, we define the too-late-to-recover (TLTR) vulnerability, which allows an attack to drain the available recovery margin before being detected, such that the subsequent recovery procedure will fail to bring the ICS back to a safe state due to the insufficient margin. To audit an ICS for TLTR vulnerabilities, we develop RISK, an automated framework that discovers and validates possible TLTR attack scenarios. RISK holistically models and analyzes, statically and dynamically, the PLC control logic, attack detection policies, recovery procedures, and operational behaviors of an ICS to generate TLTR attack scenarios with concrete attack parameters. We evaluate RISK on three ICS testbeds as well as a real-world fertilizer production plant. Across the three testbeds, a total of 392 TLTR attacks are generated and confirmed, whereas only a small fraction of them can be discovered by existing ICS vetting tools. In the real-world plant, RISK identified a critical TLTR vulnerability which was validated by plant engineers.

0.26

Model-Free Stealthy Attack on Vehicle Systems and Its Implications for ISO/SAE 21434 Risk Assessment

eess.SY ·2026-11-15 ·Qazi Mairaj ud din, Qadeer Ahmed
benchmark similarity 0.58
Abstract

This paper investigates a model-free stealthy adversary targeting in-vehicle networks and its implications for automotive cybersecurity risk assessment. Conventional stealthy false-data-injection (FDI) attacks often assume privileged knowledge of system dynamics, estimator parameters, or detector statistics, understating the feasibility of adversaries with limited system information. We develop a model-free FDI attack that uses a Vector Autoregressive model with Exogenous inputs (VARX), identified from passively recorded nominal measurements, to characterize a compromised channel and construct attack sequences within a data-calibrated residual envelope. The construction requires no vehicle dynamics model, estimator parameters, assumed noise distribution, or detector knowledge. In a closed-loop lane-keeping benchmark, the attack induces a 1.25 m lateral displacement, exceeding the specified 0.9 m half-lane width, and keeps the vehicle outside the lane corridor for 9.21 s. At a matched 1 % false-alarm operating point, attack-period alarm rates stay below 2.4 % across five learning-based intrusion detection systems (IDSs), a chi-squared residual monitor, and a liveness monitor, versus 66-100 % for conventional baselines. The proposed adversary matches the impact and evasion of a privileged model-based adversary while requiring 13 fewer attack-potential points, raising its assessed feasibility from Low to High under the considered ISO/SAE 21434 Threat Analysis and Risk Assessment (TARA). We further show that conventional impact-and-feasibility risk scoring can assign identical risk to attacks with substantially different detector responses, and introduce a detection-conditioned risk formulation to distinguish them. These findings highlight the importance of accounting for adversarial knowledge requirements and measured detectability when assessing risks in safety-critical vehicle systems.

0.05