CS Paper Radar

Unsupervised Maneuver-Aware Acoustic Fault Detection for Autonomous Drones

Ali M Ali, Ziyi Tang, Nurdaulet Nazarbay, Hashim A. Hashim

cs.SD eess.SY ·submitted 2026-10-07 17:55 UTC · v1
top venue

Abstract

This paper presents a maneuver-aware acoustic fault detection framework for autonomous drones that integrates Noise2Noise-inspired deep learning denoising with maneuver-conditioned reconstruction. A key practical constraint motivating this work is that labeled faulty-flight data are difficult and potentially unsafe to collect; the proposed framework therefore follows an unsupervised learning paradigm in which only nominal flight recordings are required for training. In flight environments, acoustic signals acquired from unmanned aerial vehicles are subject to variability arising both from environmental noise and from structured, maneuver-dependent aerodynamic effects. To address these challenges simultaneously, a two-stage learning architecture is developed. In the first stage, a Noise2Noise-inspired denoising model attenuates stochastic acoustic noise while preserving fault-relevant spectral-temporal structures, without requiring clean reference signals. In the second stage, a maneuver-Conditioned Convolutional AutoEncoder (maneuver-CCAE) is trained using maneuver-related labels including drone type and flight direction to model nominal acoustic behavior under varying operating conditions. Fault detection is subsequently performed using reconstruction error as an anomaly score. Experimental results demonstrate that the proposed maneuver-aware conditioning raises the area under the ROC curve (AUC) from $\AUCaeOnly$ (unconditioned baseline) to $\AUCfull$ (full model), validating the critical role of maneuver-dependent modeling. The complete framework is deployed on an NVIDIA Jetson Orin Nano Super embedded platform within a ROS2 pipeline, achieving an end-to-end fault detection latency of approximately $20\,\text{ms}$ per audio segment with a TensorRT half-precision (FP16) backend, confirming real-time viability for onboard UAV health monitoring.

Closest papers

Nearest neighbours by meaning across the whole index.

A Machine Learning Framework for Fault Detection, Isolation, and Severity Prediction of Autonomous VTOL Aircraft

cs.LG ·2026-09-12 ·Ripon C. Sarker, Pedram H. Dabaghian, Raman Goyal, Atanu Halder
published similarity 0.67
Abstract

Fault detection in autonomous VTOL aircraft is critical because even minor component degradations can rapidly destabilize multirotor vehicles operating in complex, safety-critical environments, motivating robust fault detection and estimation strategies capable of identifying early signs of rotor damage; however, real-flight fault detection remains challenging due to sensor noise, environmental disturbances, and the nonlinear aerodynamics of multirotor platforms. This study proposes a comprehensive machine-learning framework for rotor fault detection, isolation, and severity prediction using real flight data. A convolutional neural network (CNN) architecture is developed to learn spatio-temporal patterns from multivariate flight dynamics, enabling direct inference of both the faulted rotor and its damage level. The framework is first validated using simulated data generated by a data-generative model, and experimental validation is then performed on a hexacopter by introducing controlled blade-tip breakage. The trained model achieves rotor-wise fault classification accuracies above 99% and severity estimation accuracy of 96% within a 1% tolerance in experimental data, demonstrating strong generalization and supporting real-time health monitoring for autonomous VTOL systems.

0.36

TGTV: An Interpretable Framework for UAV Fault Detection and Traceability via Spatiotemporal Graph Learning and Large Language Models

cs.LG ·2026-10-28 ·Zixuan Wang, Changbo Shi, Ji Liu
similarity 0.62
Abstract · 21 pages, 8 figures, 4 tables. Submitted to IEEE Sensors Journal

Fixed-wing unmanned aerial vehicles experience operating-condition transitions, asynchronous sensor sampling, and control-system compensation that can obscure fault signatures. Existing temporal detection methods have limited capacity to represent coupled faults across subsystems, track their evolution, and constrain language-model diagnoses with quantitative evidence. This paper proposes TGTV, an interpretable fault detection and traceability framework that integrates spatiotemporal graph learning with a large language model. A temporal convolutional network and a graph attention network with weighted fused adjacency extract multiscale temporal patterns and spatial dependencies among sensors. A hybrid temporal Transformer and variational autoencoder then evaluates window-level anomalies using prediction errors and reconstruction probabilities. Continuous-time Shapley attribution identifies critical sensors and high-contribution intervals while preserving the temporal continuity of fault evolution. A structured evidence package combines detection results, graph relationships, temporal attribution, sensor attribution, and operating context. An evidence-constrained diagnosis protocol uses this package to generate flight-level conclusions with traceable evidence identifiers. Cross-flight holdout experiments on the public ALFA fixed-wing flight dataset yield a window-level area under the precision-recall curve of 0.976, accuracy of 0.973, recall of 0.902, and F1 score of 0.920. Flight-level fault diagnosis achieves recall of 0.943 and an F1 score of 0.944. These results demonstrate accurate anomaly detection and quantitatively supported fault-tracing cues, providing a basis for interpretable post-flight fault review and analysis.

0.25

NAViLoss: An Underwater Navigation-Aware Dual-Residual Objective for Physics-Consistent Learning

cs.RO cs.LG ·2026-10-07 ·Arup Kumar Sahoo, Itzik Klein
similarity 0.56
Abstract · 26 pages, 7 figures

Autonomous underwater vehicles (AUVs) commonly rely on inertial navigation systems (INS) aided by Doppler velocity logs (DVLs) for reliable underwater navigation. Accurate DVL velocity estimation is therefore essential for successful operation. Recent learning-based methods have demonstrated improved DVL velocity estimation, particularly under degraded measurement conditions. However, their training objectives typically rely on conventional regression losses that are highly sensitive to large residuals and corrupted observations. Additionally, they do not explicitly account for the physical consistency and measurement uncertainty associated with the underlying sensing process. To address these limitations, this paper introduces navigation-aware loss (NAViLoss), a robust and uncertainty-aware objective function for learning-based AUV velocity estimation. NAViLoss jointly penalizes the velocity-estimation residual in the navigation-state domain and the beam-consistency residual in the DVL measurement domain. Its bounded formulation limits the influence of large residuals, while an adaptive mechanism regulates the uncertainty in beam geometry. Furthermore, NAViLoss is integrated with a DeepONet architecture to form a novel NAVi-DeepONet model for seamless estimation of an underwater vehicle's velocity. Lastly, our model is evaluated using approximately 10,000m of semi-synthetic AUV experimental data collected during multiple real-world sea trials. Experimental results demonstrate a 44% improvement in velocity-estimation accuracy compared with conventional and learning-based baselines. These results demonstrate the effectiveness of navigation-aware and uncertainty-adaptive loss design for robust learning-based underwater velocity estimation.

0.15

Learning-Oriented Fault-Tolerant Control for UAVs with Time-Varying Fault Estimation

eess.SY ·2026-10-22 ·Moh Kamalul Wafi
published similarity 0.56
Abstract · This is an extended version of the paper published in the proceedings of IEEE CoDIT

The increasing deployment of unmanned aerial vehicles (UAVs) in safety-critical applications has created a growing demand for control strategies that remain reliable in the presence of actuator and sensor faults. This paper presents a fault-tolerant control framework that combines constructive mathematical modeling, proportional--integral (PI) fault estimation, and learning-oriented control. A nonlinear quadcopter model is first developed using both the Newton--Euler and Euler--Lagrange formulations, from which a discrete-time linear model is derived for observer and controller design. A PI observer is then proposed to estimate actuator and sensor faults, with exponential estimation-error convergence established for constant faults in the absence of disturbances and ultimate boundedness established for slowly time-varying faults under bounded disturbances. The estimated fault signals are incorporated into an active fault-tolerant control architecture together with a Deep Deterministic Policy Gradient (DDPG) controller, which is trained using only the yaw channel and subsequently applied to improve closed-loop tracking performance. Numerical simulations illustrate the observer's estimation performance under constant and slowly time-varying faults, including bounded disturbances, and the tracking performance of the integrated controller under multiple actuator and sensor fault scenarios. The proposed framework combines model-based fault estimation with learning-based control to improve fault accommodation and tracking performance in UAV systems.

0.49

TileNet: Tile-Based CNN-SVM Architecture for Autonomous Unmanned Aerial Systems Inspection of Flat Roofs

cs.CV cs.AI ·2026-09-11 ·Samuel Dunthorne, Hashim A. Hashim
published similarity 0.55
Abstract · Journal of Safety Science and Resilience

Flat roofs are among the most influential components of the building envelope, governing both structural performance and thermal efficiency, and thereby contributing directly to household energy consumption, carbon emissions, and long-term environmental sustainability. Timely detection of roof defects is essential for reducing heating and cooling losses, preventing moisture-driven degradation such as mold growth, and supporting national climate-change mitigation goals. This paper presents a real-time, Unmanned Aerial System (UAS)-based deep learning framework that autonomously detects defects using live imagery captured during dual-altitude aerial passes. The multi-resolution flight strategy is designed to aid the identification of both small, fine-scale defects and larger structural issues, enabling more comprehensive assessments. To meet the strict computational and power constraints of embedded UAS hardware, the proposed framework integrates a tile-based architecture with a lightweight Convolution Neural Network-Support Vector Machine (CNN-SVM) classifier designed for low-latency onboard inference. The final model-comprising five convolutional layers and four dense layers, the last a linear SVM head, achieved a mean test accuracy of $94.4\%$ ($95\%$ confidence interval $\pm0.4\%$ over three seeds) on a photo-level split ($43,383$ training, $3,869$ validation, and $2,540$ test tiled and augmented images), outperforming GoogLeNet ($89.2\%$) and AlexNet ($79.8\%$). Experimental evaluations using real UAS imagery collected by onsite visits with DJI Matrice 350 RTK drone demonstrate that the system supports rapid, repeatable, and safe roof inspections while reducing human risk, lowering operational costs, and enabling more sustainable building maintenance.

0.64

Should All Noises Be Treated Equally: Impact of Input Noise Variability on Neural Network Robustness

cs.LG eess.SPphysics.geo-ph ·2026-09-13 ·Salma Alsinan, Maksim Makarenko, Sixiu Liu, Ali Aldawood, Ibrahim Hoteit
published similarity 0.55
Abstract · Main:(pages 1-31,15 figures), Supplementary: (pages: 32-75, 37 figures)

Geophysical data collected from active field sites are often contaminated by complex and heterogeneous noise, obscuring weak seismic events, and complicating automated interpretation. Although deep learning offers promising solutions for seismic processing, its performance is highly sensitive to the nature of training noise, especially under out-of-distribution (OOD) conditions. This study investigates the influence of noise parameters, such as type, scale, and complexity on the performance, generalization and robustness of neural networks in two geophysical tasks: first break picking and denoising. We simulate seismic-while-drilling data and apply controlled input source noise augmentation using stochastic generators to vary the noise characteristics. Different neural networks are trained on fixed noise types and scales, then evaluated across both seen and unseen noise scenarios. We incrementally increase the complexity of the noise by introducing compound noise mixtures and assess the performance of the model under increasingly challenging OOD conditions. This yields a robustness matrix that captures the generalizability of each model relative to its training configuration. Results indicate that larger noise scales boost generalization, and that effective alignment between noise type, task complexity, and architecture is key for maximizing generalization gains. In addition, training with compound noises mitigate weaknesses associated with single-noise training, acting as an additional implicit regularizer to improving robustness. These findings highlight key factors influencing model resilience in noisy geophysical environments and offer guidance for developing deep learning models that generalize effectively across diverse and unpredictable noise conditions.

0.49

Lightweight Replay Attack Detection via Interpretable Physical Descriptors

cs.SD eess.AS ·2026-11-13 ·Saba Nasiri, Alireza Amirshahi, Milos Cernak
published similarity 0.54
Abstract · Accepted to the 34th European Signal Processing Conference (EUSIPCO 2026)

This paper proposes a lightweight, interpretable audio anti-spoofing method that distinguishes between bona fide human speech and replay attacks by analyzing physical acoustic signatures rather than learned spectro-temporal patterns. Unlike black-box Deep Neural Networks (DNNs), our approach exploits fundamental physical invariants, specifically source kinematics, binaural phase dynamics, and aerodynamic consistency, captured via multi-channel microphone arrays. By extracting these explicit physical descriptors and classifying them with an efficient XGBoost model, we achieve detection performance (Equal Error Rate (EER) of 17.8% on 6-channel arrays) comparable to state-of-the-art deep learning baselines, but with a fraction of the computational cost. The proposed system operates with a 1 MB memory footprint and 0.9 s latency on a standard ARM Cortex-M7 microcontroller, enabling privacy-preserving, real-time liveness detection on edge devices.

0.24

Fault detection on manifolds of nonlinear dynamical systems with dual autoencoders

eess.SY ·2026-08-18 ·Bulut Kuşkonmaz, Szymon Greś, Rafał Wiśniewski
similarity 0.53
Abstract

Autoencoders are commonly used for unsupervised data-driven fault detection in nonlinear dynamical systems. Despite their widespread success and often favorable performance compared with traditional approaches, most applications rely on heuristic reconstruction of measured data using features learned from nominal training data, without explicit insight into the underlying nonlinear dynamics. This lack of interpretability limits the extension of autoencoder-based fault detection methods to higher levels of fault diagnosis, e.g., fault localization and quantification, and confines their use largely to application-oriented studies. To address this limitation, we propose a strategy for detecting parametric faults in nonlinear stochastic mechanical systems. A mathematical representation of the output data is developed using Koopman operator theory, which motivates their embedding on a manifold and its subsequent approximation with a two-stage autoencoder. Fault detection is formulated within a hypothesis-testing framework, in which new data are tested for consistency with a neighborhood of the manifold identified from nominal observations. The proposed method is validated through Monte Carlo simulations of a toy mechanical system with two types of nonlinearity and applied to two well-known real benchmarks, where it provides favorable fault-detection performance compared with standard autoencoders.

0.24