CS Paper Radar

Toward Lunar Legged Robots: Field Deployment Lessons at LUNA

Adrian Fuhrer, Joseph Church, Oliver Fischer, William Talbot, Nicolas Faesch, Yannic Hofmann, Hendrik Kolvenbach, Yusuke Tanaka, Marco Hutter

cs.RO ·submitted 2026-10-08 16:37 UTC · v1

Abstract

Legged robots are promising candidates for future lunar surface missions because they can traverse steep, loose, and obstacle-rich terrain that challenges conventional wheeled rovers. However, readiness for lunar deployment is limited by uncertainties in foot-regolith interaction, dust generation, illumination-driven perception degradation, and operational constraints. This paper reports lessons from the 2025 LUNA analogue campaign, where ANYmal-D and Magnecko traversed loose regolith simulant and crater-like terrain and collected long-horizon navigation and visual-inertial data under challenging lighting. We show that quadrupedal robots can traverse regolith simulant, but performance is affected by sinkage and slip, dust-generating contacts, and perception failures caused by overexposure, shadows, and low-texture regions. These results motivate tighter integration of regolith-aware locomotion policies, illumination-robust perception, repeatable analogue testing, and mission-level operational validation for future lunar legged robots.

Comment
Proceeding to the IEEE iSparo Conference 2026

Closest papers

Nearest neighbours by meaning across the whole index.

Terrain-Aware Autonomous Planetary Exploration for Exteroceptive-Proprioceptive Mapping with Quadruped Scouts

cs.RO ·2026-09-28 ·Alberto Sanchez-Delgado, João Carlos Virgolino Soares, Victor Barasuol, Claudio Semini
published similarity 0.70
Abstract · Accepted to the International Conference on Space Robotics (iSpaRo 2026)

Autonomous planetary exploration requires robots to navigate unknown, uneven terrain while assessing risk, traversability, and energetic cost. Quadruped scouts are well suited for this task because they can traverse irregular surfaces and gather mobility-relevant information during locomotion. This paper presents a terrain-aware exploration framework that combines exteroceptive and proprioceptive mapping for a quadruped robot in lunar-like environments. An onboard RGB-D camera builds robot-centered elevation maps, estimates geometric traversability, and derives navigation costs for autonomous planning. In parallel, proprioceptive measurements provide interaction-aware terrain cues that complement geometry-based assessment. Local maps are incrementally registered into a global multi-layer representation, which is used by an exploration module to select targets in unexplored regions of interest. The targets are reached by an autonomous navigation system that guides collision-aware motion using the available map and cost layers. Simulation results on NVIDIA Isaac Sim show autonomous exploration, map expansion, and spatial association between terrain geometry and robot-terrain interaction. Subsequent navigation using this information exhibits lower average Cost of Transport (CoT) than initial exploration.

0.22

MARE: An Open-Source Lunar Rover Simulator with Shadow Ground Truth for Perception and Autonomy

cs.RO ·2026-10-20 ·Raúl Castilla-Arquillo, Miguel Olivares-Mendez
code/data similarity 0.69
Abstract · 10 pages, 16 figures, 3 tables. v2: adds a dataset with segmentation and depth baselines. Code: https://github.com/raulcastar/MARE-Lunar-Sim…

Lunar surface exploration increasingly relies on autonomous rovers that must perceive and traverse unstructured terrain under extreme illumination conditions. Near the lunar poles, low sun elevations produce long, high-contrast shadows that challenge stereo vision, terrain segmentation, and localization. Developing perception and navigation algorithms for these conditions requires large amounts of sensor data with accurate ground truth, which field campaigns and analog facilities can only provide at high cost and with limited variety. This paper presents MARE (Modular Autonomy and Rendering Environment), an open-source simulation suite for lunar rover perception and autonomy built on Unreal Engine 5 and ROS 2. MARE consists of three integrated components. Terrain Studio generates cratered and rocky lunar Digital Elevation Maps (DEMs) to build simulation scenes. A dedicated Unreal Engine project hosts two physics-based rovers with plugins for stereo, lidar, event, and Single-Photon Avalanche Diode (SPAD) cameras, streaming time-stamped sensor data and pixel-accurate ground truth. Lastly, a Guidance, Navigation, and Control (GNC) stack provides web-based mission control. Validation shows a mean Intersection over Union (IoU) of 0.79 between predicted and rendered shadows at low sun elevations, and stereo depth analysis verifies decreased pixel coverage in shadowed regions relative to sunlit terrain.

0.28

End-to-End Reinforcement Learning for Quadrupedal Jumping in Lunar Gravity

cs.RO ·2026-10-21 ·Levin Müller, Oliver Fischer, Marco Trentini, Yusuke Tanaka, Marco Hutter
similarity 0.66
Abstract

Legged robots can extend planetary exploration to rugged and discontinuous terrain that is inaccessible to conventional rovers. In lunar gravity, jumping further expands this mobility by enabling robots to cross obstacles and gaps that cannot be traversed by walking alone. We present a multistage reinforcement-learning approach that produces a single end-to-end control policy for commanded point-to-point jumping under lunar gravity. The resulting policy has a simple architecture and relies exclusively on mission-compatible onboard sensing, making its deployment on a real lunar mission plausible. In simulation, the learned policy performs accurate point-to-point jumps with landing errors smaller than the robot's body size. We analyze the torque and power demands of lunar jumping and characterize performance degradation under extreme outlier events, including control-update freezes of up to \SI{1}{s} during flight. Hardware transfer demonstrates that the policy can successfully execute a vertical jump under lunar-gravity offloading. Furthermore, the measured torque and power profiles are consistent with the simulation results and remain within the robot's hardware limits.

0.12

Designing an Efficient Excavator Bucket for Lunar ISRU: A Comparative Study with Vision-Based Fill and Displacement Analysis

cs.RO ·2026-09-22 ·Abdulla Hil Kafi, Tomoki Koshi, Jorge Casir, Kenji Nagaoka
top venue similarity 0.64
Abstract · Accepted and presentaed at the 2026 IEEE International Conference on Robotics and Automation (ICRA 2026)

This paper present a spiral-cavity wheel for lunar regolith excavation and a sensor-light evaluation stack that jointly estimates fill ratio (vision), sinkage (vision), and specific energy from actuator logs. In benchtop tests (four revolutions at 5, 10, and 15~RPM) against two literature baselines, the proposed wheel achieved higher excavated mass and fill ratio, delivering 2.2-3.0 times higher excavation rate while reducing specific energy by 29 % relative to a bucket-drum baseline. Normalized sinkage (mm/kg) was also lower, indicating stable traction without bogging. Effort-time traces show a steady torque envelope with repeatable cut-carry-dump cycles across speeds. We provide a retention index $η$ that correlates with fill ratio and a DEM setup that reproduces experimental trends with low error. Results suggest spiral-cavity wheels can replace heavier multi-actuator diggers when mass, simplicity, and energy efficiency are mission drivers.

0.45

Learning Safety-Constrained Whole-Body Loco-Manipulation for Lunar Surface Operations

cs.RO ·2026-10-11 ·Alvaro Belmonte-Baeza, Miguel Cazorla, Gabriel J. García, Carlos J. Pérez-Del-Pulgar, Jorge Pomares
similarity 0.63
Abstract · 22 pages. Currently under review in a Elsevier scientific journal

Robotic systems for lunar surface operations must act autonomously and preserve their own integrity in an environment where failures are unrecoverable and continuous supervision is impossible. This paper presents a Constrained Reinforcement Learning framework for quadrupedal mobile manipulators that learns a single whole-body policy for tracking a 6D end-effector pose specified in task space, with operational limits enforced during learning through a constrained learning mechanism. We introduce a reward formulation in which the transition between locomotion and manipulation emerges from the reward geometry rather than from an explicit gating mechanism, a stability term derived from the Gravito-Inertial Inclination Margin and motivated by the reduced-gravity dynamics of the lunar surface, and a design rule for reward regularization that follows from the multiplicative structure of the termination-based objective. The framework is evaluated in a lunar-analog simulation spanning three terrain morphologies at five difficulty levels under lunar gravity, with regolith contact properties calibrated to the JSC-1a simulant and varied from loose to dense. The learned policy attains mean position and orientation errors of 3.22 cm and 6.83 deg. under nominal conditions, retains this precision across regolith densities and over the operationally representative range of terrain difficulty, and reduces soft-constraint violation time by up to an order of magnitude relative to an unconstrained baseline while incurring no hard-constraint violations.

0.51

OWLS: Open-world Language-conditioned Speed Fields for Zero-Shot Rover Navigation

cs.RO ·2026-10-23 ·Chahyon Ku, Erica Tevere, Georgios Georgakis, Rudra Mukherjee, Bernadette Bucher
code/data similarity 0.63
Abstract · 8 pages. 6 figures

Semantics can provide a proxy for physical traversability. Terrain that looks like loose sand or a rock field is likely to have similar physical properties. Open-vocabulary vision-language models (VLMs) enable this physical reasoning over terrain outside any fixed label set. We present Open-world Language-conditioned Speed Fields (OWLS), which plans directly over the dense feature map of a VLM. Prompted with a description of traversable terrain, the VLM scores every pixel of a single camera image; OWLS projects these scores onto the ground, adapts them to the platform with two morphological operations, and uses the result as the speed field of a minimum-time planner, so terrain appearance and obstacle clearance shape one trajectory. OWLS needs no task-specific training, no terrain annotation, no persistent map, and no exteroceptive sensor beyond the camera. We evaluate it on a physical rover indoors and off-road, on simulated Mars and Moon rovers over 200 procedurally generated terrains, and on real planetary imagery. Project page: https://chahyon-ku.github.io/owls/

0.31

Robot-Assisted Deployment and Maintenance of Inflatable Modules for Lunar Habitation: A Field Demonstration

cs.RO ·2026-09-28 ·Kentaro Uno, Shamistan Karimov, Ashutosh Mishra, Elian Neppel, Hazal Gozbasi +3 more
published similarity 0.63
Abstract · Author's version of a manuscript accepted at the International Conference on Space Robotics 2026 (iSpaRo 2026). (c) IEEE

Long-term human habitation and in-situ development on the Moon open a new era of space utilization. In this context, robots are a key technology for facilitating the construction of future human outposts. Toward the deployment and establishment of human habitation modules on the lunar surface, we propose a combined system consisting of inflatable modules and a modular, reconfigurable robotic system. This paper presents a report demonstrating various robot-assisted task executions using real hardware, namely the modular and reconfigurable robot MoonBot and the inflatable module HIDAS, to enhance the reliability of their deployment and maintenance. The demonstrated tasks include robotic inspection during inflation, module position alignment, final safety locking, and three-dimensional mapping for post-deployment maintenance. All demonstrations were conducted either in a laboratory environment or at a lunar analogue test site. Finally, lessons learned are discussed to provide essential insights for this robotic application to future lunar habitation.

0.34

Multi-Terrain Mastery: A Comprehensive Controller for Bipedal Locomotion

cs.RO ·2026-09-27 ·Oluwami Dosunmu-Ogunbi, Aayushi Shrivastava
similarity 0.61
Abstract

Advancing bipedal robots to navigate diverse terrains remains a significant challenge in robotics. Traditional locomotion controllers excel on specific surfaces but struggle across varied environments, limiting their practical applications. Given the unpredictable nature of real-world environments, a single controller capable of handling multiple terrains is ideal, eliminating the need for multiple specialized controllers. We propose a multi-terrain controller to enhance the versatility and robustness of bipedal locomotion. Building on previous work with a stance ankle motor for stability on inclined and rough surfaces, this paper extends capabilities to steep wet uneven grassy slopes, and compliant terrains such as sand, gravel, rocks, and constrained terrains like staircases. To address the unique demands of these terrains, we introduce a new impact map that is essential for maintaining performance and robustness against unseen terrains. We also discuss in detail the control structure for real-time deployment on the robot. We validate our controller on the 20 degree-of-freedom Cassie bipedal robot.

0.23