CS Paper Radar

Optimal Receive Design on the Observation Axis for RSMA Satellite-UAV Downlinks

Xianwei Meng

cs.IT ·submitted 2026-10-10 06:47 UTC · v1
theory

Abstract

A receiver can change its observation state while the physical signal remains the same. In rate-splitting multiple access (RSMA) downlinks, this distinction separates receive-beam design and phase-reference transport from the motion of the satellite--UAV line of sight. We formulate receive optimization within the physical--observation dual-axis (PODA) structure and obtain three complementary results. For a known line-of-sight response and positive-definite receiver-noise covariance, a noise-weighted matched combiner simultaneously maximizes every decoding SINR and the minimum user rate. Under directional uncertainty, the principal eigenvector of the conditional response covariance globally maximizes mean array gain; for a Gaussian directional model, an equal-amplitude receiver is optimized by steering towards the conditional mean. Mean rate requires a different objective. We prove that the RSMA common-rate water level is jointly concave in the users' receive gains and derive a semidefinite relaxation with a computable global upper bound. A feasible rank-one beam can therefore be compared directly with the optimum of the finite-scenario problem. We also derive a precision-weighted linear predictor that suppresses uncertain physical-velocity estimates after observation-frame transport. Paired dynamic simulations reduce direction-cosine RMSE by 51.29\% relative to unrestricted nine-point extrapolation. In a separate uncertainty experiment, direct rate optimization increases mean minimum spectral efficiency from 0.32425 to 0.41712 bit/s/Hz, an improvement of 28.64\%; the corresponding design objective is within $2.28\times10^{-4}$ bit/s/Hz of a global upper bound. The phase-transport equation fixes a coherent representative of each optimal beam without changing its gain.

Closest papers

Nearest neighbours by meaning across the whole index.

ISAC with Co-Prime Arrays: Virtual-Aperture Sensing and uplink downlink communications

cs.IT ·2026-09-02 ·Jing Zhang, Yuxiao Liu, Jiayi Sun, Junliang Ye, Derrick Wing Kwan Ng
benchmark similarity 0.62
Abstract

Integrated sensing and communication (ISAC) enables simultaneous communication and environmental sensing in unmanned aerial vehicle (UAV) networks, but its performance is constrained by the physical antenna aperture and residual self-interference (SI) in full-duplex (FD) sensing. To address these issues, we propose a shared-aperture ISAC architecture in which a sparse co-prime array (CPA) is embedded in a uniform linear array (ULA) grid for FD sensing, while the remaining antenna positions support time-division duplexing (TDD) communication. We characterize the sensing performance through an order-wise Cramer-Rao bound (CRB) analysis, showing that the CPA achieves a stronger asymptotic sensing gain than the partitioned ULA benchmark in both single-target and nondegenerate multi-target scenarios. We further reveal a space-time sampling tradeoff under the same physical aperture. Based on the proposed architecture, we formulate a non-convex joint resource allocation problem that maximizes the weighted downlink-uplink sum rate by jointly designing the sensing transmit covariance, downlink precoder, and uplink receive beamformers under sensing accuracy, BS transmit-power, communication QoS, and residual SI constraints. An alternating-optimization-based algorithm is developed. Simulations demonstrate consistent performance gains over the considered baselines and confirm the complementary benefits of the CPA virtual aperture and sensing covariance optimization.

0.08

UAV-Mounted Hybrid RIS-Assisted ISAC-RSMA: Performance Analysis with Imperfect CSI and SIC

eess.SP cs.ETcs.PFeess.SY ·2026-10-10 ·Chandan Kumar Singh, Arthur Sousa de Sena, Smriti Uniyal, Deepak Kumar, Prabhat K. Upadhyay +1 more
publishedtheory similarity 0.59
Abstract

In integrated sensing and communication (ISAC) systems, strict sensing requirements can substantially constrain the transmit power available for communication. A hybrid reconfigurable intelligent surface (HRIS) with passive reflection and active amplification capabilities mounted on an unmanned aerial vehicle (UAV) can enhance coverage and strengthen communication links in such power-limited regimes. Meanwhile, rate-splitting multiple access (RSMA) provides an effective transmission strategy for managing inter-user interference, particularly in dense multiuser wireless scenarios. Motivated by this, we analyze the performance of a UAV-mounted HRIS-assisted monostatic ISAC system employing RSMA scheme. We consider the imperfections in the channel state information and successive interference cancellation in the RSMA, which are inevitable in practical system implementations. We then derive highly accurate expressions for outage probability, ergodic rate, and throughput to evaluate communication performance over Nakagami-$m$ fading channels. These expressions reveal key insights into the diversity order and coding gain of the system in the high signal-to-noise ratio regime. To characterize the sensing performance, we derive expressions for the probability of detection, the probability of false alarm, and the Cramér-Rao lower bound. Numerical results validate the theoretical findings and highlight the performance gains of the proposed system over conventional multiple-access schemes and RIS-based systems.

0.39

RSMA-Enabled ISAC Networks with Fluid Antenna Systems: Stochastic Geometry Analysis and Low-Complexity Resource Allocation

eess.SP ·2026-08-12 ·Abdelhamid Salem, Hana Shamata, Salma Elkawafi, Khaled M. Rabie, Xingwang Li +2 more
similarity 0.57
Abstract

In this paper, we investigate the downlink performance of multi-cell RSMA-enabled ISAC networks in which base stations (BSs), communication users, and sensing targets are spatially distributed according to independent Poisson point processes (PPPs). Each BS simultaneously serves multiple users using RSMA while exploiting the common stream as a dual-functional communication and sensing waveform. The users are equipped with FAS that selects the best antenna port to maximize the received signal quality. Closed-form analytical expressions are derived for the ergodic sum-rates by combining stochastic geometry, order statistics, and Laplace-transform-based interference analysis. Furthermore, a tractable approximation for the average radar SINR is developed by characterizing the statistical properties of the common precoder. Leveraging the derived analytical expressions, a low-complexity analytical resource allocation framework is proposed to jointly optimize the RSMA power allocation, the communication-sensing beam tradeoff, and the number of scheduled users while sat- isfying the sensing quality-of-service constraint. Compared with conventional iterative optimization approaches, the proposed analytical design significantly reduces computational complexity while achieving nearly identical communication performance. Simulation results verify the accuracy of the developed analytical expressions and demonstrate substantial improvements in both RSMA sum-rate and sensing performance over conventional transmission schemes.

0.04

Array Rotation in Near-Field ISAC: Communication, Detection, and Estimation Under Low-Complexity Transmit Architectures

eess.SP cs.IT ·2026-10-22 ·Marziyeh Soltani, Mark F. Flanagan
similarity 0.57
Abstract

This paper studies near-field integrated sensing and communication (ISAC) with a rotatable base-station array under an exact spherical-wave propagation model. For a general transmit covariance, we derive a Cramér--Rao bound (CRB) decomposition that separates target-side geometry from transmit-covariance-dependent terms. We then specialize the framework to two representative low-complexity architectures: a single-stream superposition architecture, and a dual-waveform split architecture design. We characterize the communication-, detection-, and estimation-optimal rotations for each architecture using the exact finite-array model. In addition, we show how a second-order approximation yields compact approximate expressions for the optimal rotation angles. We also study uncertainty in the target state used for beamforming design through a correlated Gaussian perturbation model, and derive approximations of the optimal robust rotation angles for target sensing and detection. The analysis shows that the two architectures behave differently under rotation: the single-stream design can align communication and detection tasks, whereas the dual-waveform design exhibits a direct communication--detection tradeoff and can incur a larger communication loss when sensing is prioritized. Numerical results show clear gains over a fixed array orientation, especially for range estimation, and close agreement between the approximate and exact rotation choices. Detection is less affected by target-state errors than estimation in the considered cases.

0.11

Fluid Antenna Array-Inspired Location-Posterior-Driven Subarray Sizing and Power Control for Two-Hop AF UAV Relaying

cs.IT ·2026-08-17 ·Xuanyi Zhu, Jian Dang, Chen Zhao, Huaifeng Shi, Zaichen Zhang
similarity 0.57
Abstract · 6 pages, 5 figures

This paper develops fluid antenna array (FAA)-inspired subarray sizing and transmit-power design for a two-hop amplify-and-forward (AF) unmanned aerial vehicle (UAV) relay using progressively contracting user-location posteriors. A contiguous reconfigurable subarray is shared by first-hop reception and second-hop forwarding, such that its active size jointly determines the receive gain, forwarding gain, and beamwidth. By adaptively controlling the effective aperture, the proposed design exploits geometric reconfigurability to balance array gain against pointing robustness under location uncertainty. Projecting the position covariance onto the array direction yields a closed-form direction-limited size inversely proportional to directional uncertainty. Posterior samples are propagated through the two-hop rate model, and the subarray size and transmit power are then selected to minimize UAV power subject to a worst-user lower-tail rate requirement and hardware power limits. The planned configuration is further audited over instantaneous two-hop Rician channels at the true user positions. At t = 8 s, the proposed design saves 3.17 dB over full-array narrow-beam transmission on paired feasible geometries and achieves 60.0% service success at a 0.15-W budget, compared with 43.2% for a fixed eight-element subarray.

0.14

Joint Beamforming for Continuous Transmissive RIS-Enabled Multiuser Communications

cs.IT ·2026-10-06 ·Beining Han, Shumeng Zhang, Deyou Zhang, Qingchao Li, Jun Liu +1 more
similarity 0.56
Abstract

This paper studies continuous transmissive reconfigurable intelligent surface (CT-RIS)-enabled multiuser downlink communications, where passive beamforming is characterized by a phase function defined over the continuous aperture. We employ a distance-dependent spherical-wave model for the base station (BS)-to-CT-RIS link and introduce a finite-path model based on field-response vectors for the CT-RIS-to-user links. The resulting weighted sum rate maximization problem jointly optimizes the finite-dimensional BS precoders and the infinite-dimensional CT-RIS phase function, giving rise to a mixed finite- and infinite-dimensional non-convex optimization problem. To address this problem, we develop an alternating optimization algorithm that combines a closed-form BS precoder update with a functional phase update derived using the calculus of variations and minorization-maximization. Numerical results demonstrate that the proposed CT-RIS consistently outperforms the considered benchmarks, with the performance gains attributed to spatially continuous phase control and a larger effective receiving area.

0.24

Certified Dynamic Subspace Optimization for Bayesian ISAC Design

eess.SP ·2026-11-12 ·Zongyao Zhao, Cheng-Jie Zhao, Zhaolin Wang, Qingjiang Shi, Yuanwei Liu
similarity 0.56
Abstract · 19 pages, 10 figures, submitted to IEEE journal

Full-space covariance optimization is costly in large-array Bayesian integrated sensing and communication (ISAC). A fixed transmit subspace can reduce this cost, but the resulting optimality loss depends on the posterior distribution. In this paper, a certified dynamic subspace method is developed for angle Bayesian Cramér-Rao bound (BCRB) minimization under joint angle and complex-gain uncertainty. For uniform linear arrays, exact response preservation over a nondegenerate posterior angular interval requires the full antenna space. Subspace sufficiency is therefore assessed through full-space objective-gap bounds. A communication-feasible basis is initialized from the user-channel span and local BCRB sensitivity. Restricted semidefinite programs are then solved. Primal restoration and dual repair yield gap bounds that remain valid after lossless user-beam recovery. When an accurate restricted solve does not certify the requested tolerance, the basis is expanded using a direction identified from the covariance dual slacks. Under a strict communication-power margin, joint uniqueness of the restricted optimal dual multipliers is established. With exact restricted solves, this uniqueness guarantees strict BCRB improvement after certificate-driven expansion. Numerical results validate the bounds against full-space references for the sampled problems. Compared with a fixed Fisher ordering, the proposed method can reach the same certificate target with fewer dimensions. On large arrays, total runtime is reduced relative to the full-space and factorized baselines at matched certificate targets.

0.32

Cooperative Target Localization in RIS-Enabled ISAC Systems

eess.SP ·2026-09-30 ·Rouhollah Amiri, Abdollah Ajorloo, Mohammad Mahdi Mojahedian, Ahmad Reza Hassanshahi, Fabiola Colone
similarity 0.56
Abstract

This paper develops a cooperative integrated sensing and communication (ISAC) framework in which a multi-antenna base station (BS) simultaneously localizes a target and serves multiple communication users, a subset of which is equipped with reconfigurable intelligent surfaces (RISs). The Fisher information matrix (FIM) for target positioning is derived, explicitly characterizing its dependence on the BS beamforming coefficients, RIS phase profiles, and bistatic sensing geometry. Under the stated scaling assumptions, coherent RIS phase alignment yields a Fisher-information gain that scales quadratically with the number of RIS elements, whereas independent random phases provide a linear gain in expectation. We formulate a sensing-centric joint active and passive beamforming problem that minimizes the position error bound (PEB) subject to per-user signal-to-interference-plus-noise ratio (SINR) and transmit-power constraints. The resulting non-convex problem is addressed through an iterative successive convex approximation (SCA) procedure that solves a sequence of convex subproblems. We further develop a target localization estimator that fuses one direct time-of-arrival (ToA) measurement, one angle-of-arrival (AoA) measurement, and multiple RIS-assisted indirect ToA measurements. Under small measurement errors and asymptotically efficient first-stage ToA/AoA estimation, the estimator covariance approaches the Cramér--Rao bound (CRB) to first order. Numerical results validate the analytical scaling laws and demonstrate the localization gains enabled by cooperative RIS-equipped users.

0.13