CS Paper Radar

Physics-Informed Unsupervised Learning for Reliable Beamforming in Cluttered MIMO-ISAC

Yosefine Triwidyastuti, Nghia Thinh Nguyen, Tri Nhu Do

eess.SP ·submitted 2026-10-10 20:45 UTC · v1

Abstract

In this paper, we consider joint beamforming and power allocation for a mobile multiuser MIMO integrated sensing and communication (ISAC) network with clutter, residual self-interference, and outdated channel state information, under per-user rate and sensing signal-to-interference-plus-noise ratio (SINR) constraints that must hold on every realization. The design must be recomputed every block, and distant or weak targets can make the sensing constraint unmeetable. We propose a physics-informed unsupervised learning (PI-UnSL) network that corrects the analytical design, meets the power and norm constraints exactly by construction, and is conditioned on closed-form interference statistics, spanning the whole tradeoff in one pass. We derive a closed-form sensing SINR at the interference-aware combiner, yielding a necessary range-radar-cross-section-power condition and a priority-independent analytic violation floor, so the problem is intermittently infeasible. We then show that a dual targeting below the attainable floor has no fixed point, and calibrate the label-free objective against the measured floor. Numerical results confirm the floor and the bounded calibrated dual, and show that PI-UnSL substantially raises per-realization joint quality of service over the closed-form baseline, delivers more rate than time-division ISAC at matched detection over most of the tradeoff, and exceeds the reliability of an uncalibrated alternating-optimization solver at a fraction of its latency. More broadly, the physical knowledge given to the network, not its architecture, makes such problems learnable without labels: five architectures fail alike from scratch and perform alike when started from the closed-form design and conditioned on its interference statistics.

Closest papers

Nearest neighbours by meaning across the whole index.

ISAC Beamforming Design Based on a Matrix Nearness Formulation With Improved Efficiency

eess.SP ·2026-08-23 ·Berkan Kilic, Kenan Turbic, Slawomir Stanczak
published similarity 0.64
Abstract

We propose an integrated sensing and communication (ISAC) beamforming method that performs joint multiple-input multiple-output (MIMO) radar sensing and multi-user MIMO communication. Our approach builds on a matrix nearness formulation of the MIMO radar problem and utilizes our recently proposed efficient solver, where the computational complexity is dominated by an eigenvalue decomposition (EVD) evaluation at each iteration. We extend this formulation to an ISAC scenario by incorporating minimum signal-to-noise ratio constraints as communication design criteria, only requiring statistical channel state information knowledge at base station. Furthermore, we propose a method to avoid the burdensome EVD evaluations in certain iterations, reducing the computation time by up to six times in a massive MIMO setting.

0.53

Physics-Aware Transformer-Based Beamforming Optimization for Near-Field E-MIMO ISAC Systems

eess.SP ·2026-11-12 ·Mohsin Ali, Abdulahi Abiodun Badrudeen, Azharul Islam, Sunwoo Kim
similarity 0.64
Abstract

This paper proposes a physics-aware Transformer-based beamforming optimization (PATBO) framework for near-field extreme massive multiple-input multiple-output integrated sensing and communication (E-MIMO-ISAC) systems. PATBO combines regularized zero-forcing (RZF) communication directions and spherical-wave near-field sensing directions with learned stream-power allocation. A token-preserving Transformer maintains the correspondence between individual users/targets and their allocated powers, while a Cramér--Rao bound (CRB)-sensitivity-aware objective emphasizes power-allocation errors with greater localization impact. Physical feasibility is explicitly verified after inference, with infeasible predictions handled through physics-constrained power repair and optimizer fallback. For a $32\times32$ E-MIMO array with $1024$ antennas, the proposed structured representation reduces the learned output from $12{,}288$ real-valued coefficients of an unstructured complex beamformer to six stream-power variables. Direct PATBO achieves $100.98\%$ reference-rate retention and $19.54\%$ joint feasibility, which increases to $87.79\%$ after repair. The complete hybrid framework achieves $99.89\%$ reference-rate retention and $100\%$ constraint satisfaction on the retained test set, while requiring optimizer fallback for only $12.21\%$ of the scenarios. Direct PATBO inference requires $1.11$~ms per sample, corresponding to approximately $858\times$ and $779\times$ lower runtime than the evaluated cold-start and PATBO-warm-start sequential quadratic programming (SQP) implementations, respectively.

0.19

Robust Resource Allocation for STAR-RIS-Assisted ISAC Networks Using Deep Learning

cs.PF ·2026-10-19 ·Yuwen Cao, Jiajun Wu, Howard H. Yang, Tomoaki Ohtsuki, Tony Q. S. Quek
theory similarity 0.63
Abstract

In this paper, we focus on investigating the resource allocation in an integrated sensing and communication (ISAC) system assisted by a simultaneously transmitting and reflecting reconfigurable intelligent surface (STAR-RIS). Due to the coupled non-convex nature of the optimization problem, solving the above joint resource optimization problem while guaranteeing superior sensing performance is challenging, especially in dynamic environment. To conquer such challenge, prior iterative optimization algorithms have been presented. However, practical implementations of these prior algorithms face notable computational challenges, e.g., the reliance on accurate global channel information and the assumption of ideal phase shifts. In this context, we propose a model-driven deep learning framework for jointly optimizing the transmit beamforming and waveform in ISAC networks with low-overhead. In addition, we adopt the Cramer-Rao lower bound (CRLB) as the sensing performance metric, and the multi-user interference (MUI) energy as the communication performance metric for performance evaluation. Besides, our framework jointly optimizes the transmit beamforming, waveform and the STAR-RIS reflection/transmission coefficient matrices by minimizing the weighted sum of MUI energy and CRLB. Our study also considers the impact of imperfect channel information, making the research scenario more aligned with real-world applications. Simulation results validate that the proposed framework not only achieves higher sum-rate performance comparable to traditional iterative algorithms but also significantly reduces computational complexity in terms of algorithm execution time, as well as exhibits inherent robustness.

0.11

Cooperative Target Localization in RIS-Enabled ISAC Systems

eess.SP ·2026-09-30 ·Rouhollah Amiri, Abdollah Ajorloo, Mohammad Mahdi Mojahedian, Ahmad Reza Hassanshahi, Fabiola Colone
similarity 0.61
Abstract

This paper develops a cooperative integrated sensing and communication (ISAC) framework in which a multi-antenna base station (BS) simultaneously localizes a target and serves multiple communication users, a subset of which is equipped with reconfigurable intelligent surfaces (RISs). The Fisher information matrix (FIM) for target positioning is derived, explicitly characterizing its dependence on the BS beamforming coefficients, RIS phase profiles, and bistatic sensing geometry. Under the stated scaling assumptions, coherent RIS phase alignment yields a Fisher-information gain that scales quadratically with the number of RIS elements, whereas independent random phases provide a linear gain in expectation. We formulate a sensing-centric joint active and passive beamforming problem that minimizes the position error bound (PEB) subject to per-user signal-to-interference-plus-noise ratio (SINR) and transmit-power constraints. The resulting non-convex problem is addressed through an iterative successive convex approximation (SCA) procedure that solves a sequence of convex subproblems. We further develop a target localization estimator that fuses one direct time-of-arrival (ToA) measurement, one angle-of-arrival (AoA) measurement, and multiple RIS-assisted indirect ToA measurements. Under small measurement errors and asymptotically efficient first-stage ToA/AoA estimation, the estimator covariance approaches the Cramér--Rao bound (CRB) to first order. Numerical results validate the analytical scaling laws and demonstrate the localization gains enabled by cooperative RIS-equipped users.

0.13

Massive MIMO ISAC Under Target-Angle Uncertainty: CRLB Outage Analysis and Robust Resource Allocation

eess.SP ·2026-09-16 ·Smriti Uniyal, Tianyu Fang, Van-Dinh Nguyen, Hien Quoc Ngo, Markku Juntti +1 more
similarity 0.61
Abstract

In integrated sensing and communications (ISAC), the same spectral and hardware resources are shared for two functionalities. Most ISAC designs assume perfect target-angle information neglecting angle estimation errors, which introduce steering-vector mismatches, degrade sensing accuracy, and may invalidate deterministic sensing guarantees. This paper investigates monostatic massive multiple-input-multiple-output (MIMO) ISAC systems under imperfect target-angle estimates. We derive closed-form expressions for the Cramér-Rao lower bounds (CRLBs) of target azimuth and elevation estimates in the presence of angle uncertainty. We characterize the cumulative distribution functions and outage probabilities of the CRLBs under Gaussian, generalized uniform, and von Mises angle-error models. Our analysis reveals that, in the small-error regime, the CRLBs increase quadratically with the angle errors due to transmit steering-vector mismatch. To ensure reliable sensing, we propose a robust power allocation framework that jointly optimizes pilot training and communications/sensing transmission powers to maximize the communications sum rate while satisfying CRLB outage constraints. The resulting nonconvex problem is solved using an alternating-optimization algorithm based on successive convex approximation. Numerical results validate the developed analysis and show that the proposed robust design reduces azimuth and elevation CRLB outage probabilities by up to $60\%$ compared with conventional non-robust schemes. It attains up to $45\%$ higher sum rates than the non-robust design under strict CRLB thresholds.

0.20

Robust Beamforming Design for Integrated Sensing and Communications with Mutual Coupling Effect

eess.SP ·2026-08-16 ·Jieon Maeng, Kawon Han
published similarity 0.61
Abstract · 5 pages, 5 figures, submitted to IEEE Wireless Communication Letters, 2026

Integrated sensing and communications (ISAC) is a key technology for next-generation wireless networks, enabling communication and radar sensing over shared spectral and hardware resources. In practical multi-user multiple-input multiple-output (MU-MIMO) ISAC transmitters, however, mutual coupling (MC) between antenna elements distorts the array steering vector and each communication user (CU) channel, so that the sensing beampattern deviates from the desired one and the communication link to each user degrades. To address this limitation, we propose a robust MC-compensated beamforming design that guarantees both the sensing and communication performance of MU-MIMO ISAC transmitters against the residual MC error. We introduce a residual error on the MC matrix, so that a norm-bounded residual error induces both the sensing beampattern uncertainty and the communication channel uncertainty. The transmit covariance is then optimized against the worst-case of each uncertainty, minimizing the worst-case beampattern matching mean-squared error (MSE) for sensing while guaranteeing the signal-to-interference-plus-noise ratio (SINR) for each CU. Each worst-case constraint is converted into a linear matrix inequality, and the problem becomes a convex semidefinite program (SDP). Numerical results show that the proposed robust design attains both a lower sensing beampattern matching MSE and a higher communication SINR than those of the conventional designs, with an advantage that widens as the residual error grows.

0.58

Learning-Based Beam Adaptation for Active/Passive-Aware Monopulse ISAC with Leakage Suppression

eess.SP ·2026-10-02 ·Jafar Norolahi, Alireza Vahid
published similarity 0.60
Abstract · To appear in IEEE CCNC 2027

This paper proposes a learning-based beam adaptation framework for active/passive-aware monopulse integrated sensing and communication (ISAC) with spatial leakage suppression. A single gNB uses a shared array and orthogonal frequency division multiplexing dual-functional radar-communication signaling to jointly support downlink transmission and monopulse sensing. Radar detections and uplink spatial evidence are fused to distinguish cooperative active directions from passive directions, while a protected angular zone limits unintended illumination. Soft Actor-Critic deep reinforcement learning adapts the transmit beam using communication, sensing, leakage, and previous-action feedback. Numerical results show accurate active/passive spatial classification and robust leakage control as the number of passive targets increases from one to twelve. The proposed SAC controller maintains aggregate passive leakage below the prescribed budget across the full sweep and, from two passive targets onward, achieves the highest leakage-compliant sum rate among the considered baselines.

0.39

Electromagnetically Consistent Monostatic ISAC Beamforming: Mutual Coupling, Active Mismatch and Tx-Rx Leakage in Compact Dipole Arrays

eess.SP ·2026-11-05 ·Stylianos D. Asimonis, Christos Tselios, Dimitrios Tyrovolas, Ilias Politis, George K. Karagiannidis
similarity 0.60
Abstract · 6 pages, 9 figures, 2 tables. Submitted to IEEE ICC 2027

Beamforming for integrated sensing and communication (ISAC) is usually designed on ideal array manifolds with a norm constraint on the transmit signal. In a compact monostatic transceiver this hides three antenna effects: distorted embedded patterns, beam-dependent active mismatch at the power amplifiers, and transmit-to-receive leakage that raises the radar noise floor. We build a multiport scattering model of a shared-aperture dipole array directly from method-of-moments simulations and use it to formulate a Cramer-Rao bound minimizing ISAC beamformer with multiuser SINR constraints, per-port active reflection constraints and a leakage budget, solved as a semidefinite program with a one-dimensional budget search. Full-wave evaluation shows that coupling-unaware designs miss their SINR targets by up to 6.2 dB and drive amplifiers to an equivalent VSWR above 3.3 at small spacings. For spacings from 0.3 to 0.5 wavelengths, the proposed design meets all targets with an equivalent VSWR below 2 and lowers the root Cramer-Rao bound by 32 to 53 percent for 80 dB of self-interference cancellation and by a factor of 3.4 to 5.6 for 70 dB. An independent finite-difference time-domain model of the final layout in openEMS confirms that the leakage null and the ranking of the designs are preserved.

0.24