CS Paper Radar

Multimodal Sensor-Gated Mid-Air Launch and Vision-Based Recovery of a Child UAV on a Hovering Mothership Drone

Aashish Sahu, R. Prasanth Kumar

cs.RO ·submitted 2026-10-11 16:23 UTC · v1

Abstract

Launching a micro unmanned aerial vehicle (UAV) from a hovering carrier and recovering it in flight requires reliable confirmation that the child is securely seated before the carrier is allowed to descend. This is challenging because vision provides relative guidance but does not directly indicate load transfer, and a downward-facing camera can lose its fiducial near touchdown. This letter presents a mothership-child quadrotor system in which mission transitions are gated by complementary nonvisual sensing. An upward-facing single-beam LiDAR on the recovery deck provides a binary occupancy state using hysteresis and a debounce interval derived from the child's occluding footprint and crossing speed; real-time kinematic (RTK) positioning conditions the carrier hover; and carrier thrust provides a proprioceptive indication of load transfer. In ten outdoor missions using an F450-class mothership and a Q250-class child with camera-guided recovery, nine completed successfully while RTK-fixed positioning was maintained through release and capture. A complementary MuJoCo study of fully autonomous fiducial-based recovery achieved touchdown 0.077 m from the deck center, while marker detection was lost within the final approximately 0.2 m above the docked configuration. In simulation, carrier thrust changed by -17.0 N at release and +17.3 N at capture, agreeing within 6% with the child's 18.0 N hover thrust. The results support a sensing architecture in which vision guides the approach, while range and proprioceptive information corroborate the final docking decision.

Comment
4 pages, 5 figures, 2 tables

Closest papers

Nearest neighbours by meaning across the whole index.

Integrated Guidance and Control of a Mother-Child UAV-UGV System for Cooperative Missions

cs.RO ·2026-09-17 ·Aashish Sahu, R. Prasanth Kumar
highly cited similarity 0.72
Abstract · 27 pages, 10 figures

Autonomous recovery of a small multirotor onto a hovering multirotor carrier differs from recovery onto ground or shipborne platforms because the recovery surface is itself an actively controlled, thrust-limited aerial vehicle. This paper presents a field-validated autonomy framework for a heterogeneous rover-mothership-child system executing rover supervision, mothership transit, child deployment and sortie, autonomous return, aerial recovery, and synchronized descent. The recovery stack combines jerk-bounded reference generation, disturbance-observer-augmented planar tracking, feasibility-aware vertical control, a discrete-time barrier-based safety filter for relative vertical geometry, and communication-aware carrier-state prediction. The contribution is the coordinated system-level integration of these methods for recovery onto a hovering multirotor and its full-scale outdoor validation. The framework is implemented on a PX4-ROS 2 architecture using RTK-enabled GNSS, IMU, and barometric fusion, with mothership-side 1D lidar used only as an auxiliary near-contact cue. RTK-fixed positioning was maintained throughout testing. Across 20 outdoor cooperative missions, 17 successfully completed deployment, sortie, and recovery, giving an observed mission success rate of 85%. For successful recoveries, mean terminal-alignment time was 6.3 s, mean planar alignment error at acceptance was 0.18 m, maximum terminal planar deviation was 0.32 m within a 0.40 m capture radius, and minimum logged relative vertical separation during coupled descent was 0.41 m. Mothership planar station-keeping RMS error was 0.25 m. The three unsuccessful trials occurred at different mission stages and are analyzed separately. Results demonstrate practical autonomous aerial recovery within the tested outdoor operating envelope.

0.57

RTK-Vision PPO for Autonomous Micro UAV Recovery on an Airborne Carrier

cs.RO ·2026-09-17 ·Aashish Sahu, R Prasanth Kumar
similarity 0.69
Abstract · 9 pages, 6 figures

Autonomous recovery of a micro unmanned aerial vehicle (UAV) onto a moving airborne carrier enables reusable deploy-mission-recover operation, but couples long-range rendezvous, close-range perception, carrier motion, aerodynamic interaction, and a discontinuous contact event. This paper presents an RTK-vision-guided reinforcement-learning framework in which a child UAV is physically transported by a larger carrier, takes off from the carrier while airborne, executes an independent sortie, returns to the carrier's current position, redocks, and subsequently descends with the carrier. Both vehicles carry RTK-GNSS, and the carrier continuously shares its navigation state with the child. Near the recovery deck, RTK remains active while a downward-facing camera with a fiducial marker detector provides marker-relative alignment cues. A proximal policy optimization (PPO) policy governing the terminal recovery phase is trained in a physics-based MuJoCo simulation environment with explicit sensor noise models, an aerodynamic disturbance surrogate, and marker-latency randomization, then transferred to hardware. PX4 retains low-level stabilization, and a deterministic safety gate authorizes descent independently of the learned policy. The PPO checkpoint achieves 99.55% success over 2,000 held-out randomized terminal episodes, compared with 78.4% for a tuned PD baseline under identical conditions, with a median planar terminal error of 6.62 cm. Across 14 outdoor trials, the full mission succeeds in 13 trials (92.9%), spanning both near-region recovery and recovery after the carrier translates away from the release point. The results demonstrate a complete autonomous aerial deployment-and-recovery cycle rather than an isolated landing maneuver, establishing a practical basis for reusable carrier-child operation in inspection, surveillance, and mobile-logistics applications.

0.43

Towards Quadruped-Provided Localization and Active Tracking for Micro-UAVs

cs.RO ·2026-10-05 ·Alejandro Lorite Mora, Andrés Faíña
published similarity 0.64
Abstract · 12 pages, 5 figures. Submitted version (before peer review) of a paper accepted at CLAWAR 2026, Cranfield, UK, 14 to 16 September 2026. The …

Micro unmanned aerial vehicles (micro-UAVs) are small enough to reach confined spaces that larger robots cannot access, but too small to carry the sensing and computing power required for autonomous flight. We move the localization stack entirely off the aerial platform onto a quadruped robot with a 7-degree-of-freedom (DOF) arm, which supplies the micro-UAV (27 g bare, 42 g with fiducial markers) its full 6-DOF pose. A camera at the arm's end-effector detects AprilTag fiducial markers on the drone and composes that observation with the quadruped's own self-localization to place the drone in a shared map frame, so the ground robot localizes its partner, rather than only tracking it relative to the camera. The arm acts as an actively-controlled observer, repositioning to keep the drone in view as both robots move; the drone carries only an inertial measurement unit and fuses the external pose to fly commanded setpoints. In lab flights the external pose is accurate to 12-16 mm, enough to fly the drone autonomously within 2-5 cm of motion-capture-fed control. Having the quadruped actively follow the drone reduces the tracking error from 11.0 cm to 6.9 cm by holding the camera in the close range, where the markers are most accurate.

0.66

Vision-Based Control of a Tether-Suspended Aerial Radiation Sensing Payload

cs.RO ·2026-09-23 ·Ian Snider, Brian J. Quiter, Emil Rofors, Mark W. Mueller
survey similarity 0.61
Abstract · 7 pages, 7 figures, 2 tables. Submitted to IEEE ICRA 2027

Aerial radiation surveys achieve higher sensitivity when the radiation detector is held close to the ground. Detector sensitivity falls off roughly with the inverse square of the distance to the source, so a detector flown high is slower to reach a given minimum detectable activity. Flying the vehicle low puts the propellers near the ground, where downwash can disturb the surveyed area and resuspend contaminated particulates. Tether suspension decouples the detector from the vehicle altitude, but leaves the payload unactuated and only indirectly controllable. We therefore present a vision-based control approach for an aerial sensing payload suspended on a tether beneath a heavy-lift drone. Because a survey plan is decided as radiation detections arrive, we design a pilot aid for commanding the survey trajectory manually with a handheld transmitter. The controller regulates the payload, rather than the vehicle, onto that trajectory. The system uses onboard sensors with a downward-facing camera fixed to the drone body tracking a ring marker on the payload. A four-state Kalman filter estimates the tether swing angles and rates from payload bearing measurements, and a linear quadratic regulator with integral action takes the payload position as the regulated output. In outdoor flight tests under wind, the payload-aware controller reduced payload tracking error during transit by 20% when compared against a vehicle-referenced baseline, with the cost of higher peak error on arrival at a waypoint.

0.30

Vision-Guided Morphing Quadcopter for Multi-Geometry Payload Transport through Narrow Passages

cs.RO ·2026-08-22 ·Aashish Sahu, Shriram Hari, R. Prasanth Kumar
similarity 0.59
Abstract

Aerial payload transport using multirotor unmanned aerial vehicles is challenging because payload geometry, contact interaction, grasp stability, flight control, and narrow-passage traversal are strongly coupled during pickup and transport. Object-specific grippers often cannot adapt their footprint or grasp geometry when the payload shape or passage width changes. This paper presents a vision-guided morphing quadcopter for multi-geometry payload transport through narrow passages. The proposed platform uses four hybrid arm-leg structures that function as both landing supports and grasping members. A centrally placed actuator drives a tendon-based morphing mechanism, enabling all four arms to synchronously retract or expand for object grasping, footprint reduction, and post-transport release. Onboard vision estimates the payload geometry and passage width, while endpoint force feedback is used to confirm grasp contact during payload engagement. A phase-wise mission planner, PID-based flight stabilization, and morphology-adaptive grasp controller are implemented in a MuJoCo simulation environment. The framework is evaluated using box, cylindrical, and spherical payloads, representing flat-faced, rolling-curved, and fully curved contact conditions. Across the three cases, the simulated system completes the pickup-transport-release sequence with a maximum RMS position error of 0.31 m, a final drop-zone error below 0.18 m, a compact grasp footprint of 0.09-0.21 m2, and a footprint reduction of 75.0-89.7 percent. The results demonstrate that a single-actuator morphing quadcopter can adapt its grasp footprint for the transport of payloads with different geometries while reducing its overall footprint for narrow-passage traversal.

0.20

EVPeriscope: Extended Perception across Aerial and Ground Vehicles with Event-based Propeller Tracking

cs.RO ·2026-09-10 ·Dexter Ong, Vijay Kumar, Pratik Chaudhari
code/data similarity 0.59
Abstract

Reliable relative localization between aerial and ground robots is a key requirement for tightly coordinated heterogeneous teams. This can be difficult to do using conventional frame-based cameras and fiducial markers because they are sensitive to motion blur, lighting variations, and payload constraints. This paper presents EVPeriscope, an event-based perception system that enables detection, localization and control of a quadrotor using an upward-facing event camera on a ground robot by detecting the high-frequency visual signature of its propellers. This system allows the quadrotor to function as an extended perception system for the ground robot when onboard sensors exhibit degradation or occlusion. We demonstrate the capabilities of this marsupial ground-aerial system via experiments in challenging field conditions with wind speeds of up to 15 mph, in both daylight and at night. We show that the system supports localization and closed-loop navigation through dense foliage where the ground robot's sensors are occluded. Our control system for the quadrotor operates at 200 Hz entirely with onboard sensing and computation. More details and experiment videos can be found on the project page: https://ongdexter.github.io/evperiscope.

0.35

PATH: Continuous Target Sensing among Autonomous Cooperative Drones

cs.RO ·2026-09-11 ·Heegyeong Kim, Alice James, Avishkar Seth, Endrowednes Kuantama, Jane Williamson +2 more
similarity 0.58
Abstract

Continuous target sensing by uncrewed aerial vehicles (UAVs) is constrained by limited flight endurance, motivating the transfer of tracking responsibility between cooperating UAVs. Such a handoff requires the receiver to identify the same physical target currently tracked by the sender despite differences in viewpoint, scale, and target appearance. Existing approaches based on global target localization or appearance-based cross-view association are limited by positioning uncertainty or ambiguous visual features. This paper presents Perspective Alignment \& Tracking Handoff (\textbf{PATH}), a platform-agnostic, geometry-assisted sensing and verification framework for target handoff between two moving UAVs. The sender reconstructs the tracked target as a metric 3D point using RGB-D sensing, while the receiver estimates its relative pose from a fiducial observation and projects the transmitted target point into its own image as a spatial prior for target acquisition. The receiver-generated candidate is then returned to the sender and verified through a cross-view Mutual Agreement Handshake before tracking responsibility is transferred. Real-world UAV experiments show mean relative-position and target-position errors of 0.047~m and 0.030~m, respectively. Under visually ambiguous conditions, PATH achieves 96.0\% frame-level receiver-side target acquisition accuracy, with 2.0\% false-positive and 2.0\% false-negative rates. A sensor-error sensitivity analysis shows that relative-pose uncertainty is the dominant contributor to receiver-view projection error. The implementation operates at video rate with compact inter-UAV communication below 16~kB/s at 60~Hz, demonstrating the feasibility of lightweight geometry-assisted target handoff on resource-constrained UAV platforms.

0.38

Borrowed Eyes: Markerless Nano-UAV Flight with an Active Quadruped Observer

cs.RO ·2026-10-07 ·Alejandro Lorite Mora, Dimitrios Arapis, Andrés Faíña
similarity 0.58
Abstract · 8 pages, 7 figures, 2 tables. Submitted to ICRA 2027

Nano unmanned aerial vehicles (nano-UAVs) can navigate confined spaces that larger robots cannot, but their payload capacity severely limits the sensors and compute available for self-localization in global navigation satellite system (GNSS)-denied environments. We present a vision-based system that localizes a nano-UAV from a quadruped robot with an arm-mounted camera. The quadruped tracks the drone, estimates its position in its own coordinate system using segmentation masks and depth, and transmits that position over a real-time radio link. To ensure continuous tracking, we developed a perception-aware nonlinear Model Predictive Controller (NMPC) that dynamically adjusts the quadruped's body and arm to maximize the drone's visibility, treating observation reliability as a primary control objective. Relying solely on this external estimate, the nano-UAV executed predefined trajectories from takeoff to landing with a median 3D localization error of 59 mm. The system demonstrates robustness against short visual occlusions by smoothly transitioning to onboard inertial flight when line-of-sight is temporarily lost. Ultimately, this framework allows a quadruped to offload the localization burden of a nano-UAV, enabling inspection of complex spaces that neither robot could navigate alone.

0.20