CS Paper Radar

UAV Rotatable Antenna under Rotation Delay

Yinmei Xie, Chiya Zhang, Chunlong He, Weizheng Zhang, Wei Wang

cs.IT eess.SP ·submitted 2026-10-16 00:39 UTC · v1

Abstract

Rotatable antennas (RAs) can improve wireless link performance by adjusting their boresight directions. However, existing RA studies generally assume instantaneous antenna reconfiguration, whereas mechanical rotation incurs non-negligible delay in practical deployment. To address this issue, we develop a rotation-delay-aware communication model for finite communication slots, where mechanical rotation directly reduces the time available for data transmission. This model reveals a fundamental tradeoff between the communication gain achieved through RA reorientation and the associated transmission-time loss. Accordingly, we formulate a rotation-delay-aware joint design of RA orientations and transmit beamforming to maximize the minimum effective transmission rate. For the single-user system, under a sufficient condition for strict concavity, the global optimum falls into one of three regimes: no rotation, partial rotation, and full rotation. A closed-form approximation is derived using a second-order expansion. For the multi-user system, we separate rotation-budget selection from fixed-budget max-min signal-to-interference-plus-noise ratio (SINR) optimization. An analytic-gradient zero-forcing (AG-ZF) algorithm is then developed for low-complexity joint RA orientation and rotation-budget optimization. The results show that explicitly accounting for mechanical rotation delay is essential for finite-slot RA-enabled UAV communications, and that the proposed designs effectively balance reconfiguration gain and transmission-time loss while achieving favorable effective-rate performance with low computational complexity.

Comment
13 pages, 10 figures, 1 table

Closest papers

Nearest neighbours by meaning across the whole index.

Orientation-Aware Control and Trajectory Design for Aerial RIS-Assisted Wireless Communications

cs.NI cs.RO ·2026-09-19 ·Abdoul Karim A. H. Saliah, Hajar El Hammouti, Daniel Bonilla Licea, Giuseppe Silano
published similarity 0.65
Abstract · Accepted for publication in IEEE Transactions on Vehicular Technology. Copyright (c) 20xx IEEE. Personal use of this material is permitted. …

Aerial Reconfigurable Intelligent Surfaces (ARISs) can enhance wireless connectivity in obstructed environments by combining reconfigurable metasurfaces with aerial mobility. However, in practical deployments, the Reconfigurable Intelligent Surface (RIS) is rigidly mounted on a multi-rotor Unmanned Aerial Vehicle (UAV), which creates coupled position-orientation dynamics that directly affect communication quality. Since RIS performance is highly sensitive to orientation, point-mass or orientation-invariant models may lead to optimistic performance estimates. This paper proposes an orientation-aware ARIS framework that explicitly accounts for UAV dynamics, actuation limits, and orientation-dependent channels. The proposed approach combines a communications-guided reference trajectory planner with a Nonlinear Model Predictive Control for dynamically feasible trajectory tracking and favorable RIS orientation, while employing lightweight beamforming and RIS phase-shift updates. Simulations show that accounting for orientation improves user throughput by 13.77%, while the proposed joint communication updates improve network throughput by 28% over phase-shift-only optimization and by at least a factor of 2.5 over beamforming-only optimization. These results highlight the importance of orientation-aware modeling and joint communication-control design in ARIS-assisted wireless systems.

0.25

Achievable Rate Region Characterization of Rotatable Antenna-assisted Interference Channel

cs.IT ·2026-10-16 ·Junran Pei, Guangji Chen, Qingqing Wu, Qiaoyan Peng, Wei Cai
similarity 0.63
Abstract

This paper characterizes the achievable rate region of a rotatable antenna (RA)-assisted multiple-input single-output (MISO) interference channel. We exploit the additional spatial degrees of freedom (DoFs) offered by the dynamic orientation of RAs to simultaneously enhance the desired signal and suppress interference, thereby significantly enlarging the achievable rate region of the interference network. To this end, we invoke the rate-profile technique to formulate a sum-rate maximization problem for jointly optimizing the transmit beamforming and the array rotation, subject to the practical mechanical constraints of the RAs. For the special case of a two-receiver scenario, we introduce the concept of subspace correlation coefficient to derive closed-form solutions for the optimal RA rotation angles and transmit beamforming vectors. Inspired by the insights obtained in the two-receiver special case, we propose an efficient two-step optimization framework to obtain a high-quality solution for the general multi-receiver case. In particular, the array rotation angle of each transmitter is optimized to minimize the leakage interference to non-associated receivers. With the optimized array rotation angles, the optimal transmit beamforming is obtained by invoking the second order cone programming based approach. Numerical results demonstrate that the proposed solution achieves near-optimal performance and that integrating RAs effectively simplifies transceiver designs by enabling simple maximum ratio transmission (MRT) beamforming with negligible performance loss.

0.24

User Association and Transmit Beamforming for Rotatable Antenna-Enabled LAE Networks

eess.SP ·2026-09-28 ·Bowen Yao, Chao Zhang, Ying-Chang Liang
similarity 0.62
Abstract

This paper investigates rotatable antenna (RA)-enabled low-altitude economy (LAE) networks, where multiple base stations (BSs) are deployed to serve both terrestrial and aerial users. Unlike conventional fixed orientation antennas, RAs can adjust their boresights to serve users at diverse azimuth and elevation angles, thereby providing three-dimensional (3D) coverage. To improve the performance of LAE networks, we formulate a network sum-rate maximization problem that jointly optimizes user association, transmit beamforming, and RA orientations. However, in such LAE networks, aerial users are often visible to multiple BSs through line-of-sight (LoS) links, making user association and interference management particularly challenging. Moreover, user association and RA orientations are closely coupled: user association affects the RA pointing directions, while the RA orientations in turn reshape the channel conditions for user association. To solve this problem, we propose an alternating optimization (AO) algorithm that integrates weighted minimum mean-square error (WMMSE) for transmit beamforming, projected gradient ascent updates for user association, and Frank-Wolfe updates for RA orientations. Furthermore, we develop a discrete candidate-scanning scheme that replaces continuous orientation optimization with a finite search to reduce computational complexity. We also propose an antenna block-based scheme to reduce the number of orientation variables. Simulation results show that the proposed joint design achieves a higher sum-rate than the fixed antenna orientation and nearest BS association benchmarks. Moreover, the candidate-scanning and block-based schemes achieve approximately 89.9% and 94.3% of the performance with high transmit power, respectively, while reducing the complexity of orientation updates.

0.17

Sparse Rotatable Arrays (SRAs) for Cell-Free MIMO: Network-Wide Design of Antenna Activation and Panel Orientation

cs.IT ·2026-11-15 ·Ailing Zheng, Qingqing Wu, Xiyuan Liu, Wei Feng, Wen Chen +1 more
benchmark similarity 0.58
Abstract

This paper investigates a sparse rotatable array (SRA)-enabled cell-free multiuser multiple-input multiple-output (MIMO) system. Under a network-wide antenna activation budget, distributed access points (APs) select active antenna elements from their installed arrays and adjust panel orientations, enabling joint control of sparse array apertures and antenna directivity. To avoid frequent hardware reconfiguration in response to instantaneous channel variations, we formulate a two-timescale stochastic optimization problem to maximize the expected minimum-user rate. Long-term antenna activation and panel orientations are optimized based on user spatial distributions and statistical channel state information (CSI), while short-term precoders adapt to instantaneous CSI. Under line-of-sight (LoS) propagation, we derive the optimal single-user antenna allocation, characterize the two-user max-min signal-to-interference-plus-noise ratio (SINR) and establish conditions for discrete activation and panel rotation to attain the continuous-position benchmark, and obtain a closed-form multi-AP zero-forcing (ZF) allocation benchmark under a continuous antenna-count relaxation. For the general mixed-integer nonconvex stochastic problem, we develop an alternating algorithm based on sample-average approximation (SAA), integrating uplink-downlink (UL-DL) duality for short-term precoding, weighted minimum mean-square error (WMMSE) surrogates for panel-orientation optimization, and multi-start greedy search for antenna activation. Numerical results demonstrate that the proposed design outperforms the fixed-array benchmark, improves all-user service reliability with fewer active antennas, and adapts effectively to nonuniform user spatial distributions.

0.23

Rotatable Antenna Relaying: Joint Precoding and Antenna Pointing Design

eess.SP ·2026-08-25 ·Ying Gao, Qingqing Wu, Wen Chen
similarity 0.57
Abstract · 13 pages,8 figures,submitted to an IEEE journal for possible publication

This paper investigates a rotatable antenna (RA)-enhanced half-duplex amplify-and-forward relaying system, where a multi-antenna base station (BS) serves multiple single-antenna users via a multi-antenna relay. The BS and users employ isotropic antennas, whereas the relay employs directional RAs whose pointing matrix is shared by both hops to avoid inter-hop reorientation delay and control overhead. We aim to maximize the minimum signal-to-interference-plus-noise ratio (SINR) among all users by jointly optimizing the BS precoding, relay precoding, and RA pointing matrices. To tackle this non-convex problem, we first investigate the single-user scenario and reduce the joint design to RA pointing optimization using the optimal relay precoding matrix available in closed form. A manifold-aware Frank--Wolfe (MFW) method is then employed to obtain a suboptimal pointing solution. Under a symmetric far-field line-of-sight geometry, we further characterize the globally optimal pointing structure and derive a directivity threshold separating common pointing from antenna splitting. Building on this MFW procedure, we next address the general multiuser scenario. Specifically, the quadratic transform is first applied to obtain an equivalent auxiliary-variable formulation, which is subsequently solved suboptimally via alternating optimization (AO). In particular, we employ a safeguarded extension of the MFW method based on log-sum-exp smoothing to update the RA pointing matrix in each AO iteration. Simulation results demonstrate that the proposed algorithms consistently achieve the best signal-to-noise ratio (SNR) and SINR performance among all considered schemes. It is further shown that the optimized RA pointing adapts to the two-hop geometry, the preferred directivity factor depends on user load, and relay placement with relatively balanced two-hop propagation conditions is generally preferable.

0.25

Fluid Antennas Enabled UAV Communication Systems: Fundamentals, Challenges, and Future Directions

eess.SP ·2026-10-26 ·Wenchao Liu, Weijie Yuan, Jun Wu, Jinke Ren, Xuhui Zhang +1 more
similarity 0.56
Abstract

Low-altitude wireless networks (LAWNs) require uncrewed aerial vehicle (UAV) communication systems to adapt to large-scale propagation changes and fast local channel fluctuations. Fluid antennas (FAs) provide an additional degree of freedom (DoF) by reconfiguring antenna positions within a compact aperture. This article investigates FA-enabled UAV communication systems from the perspectives of fundamentals, design challenges, and future research directions. We first introduce a dual-mobility perspective, in which UAV trajectory planning provides macro-mobility for large-scale air-to-ground geometry adaptation, and FA position reconfiguration provides micro-mobility for fine-grained local channel adaptation. We then identify key design challenges arising from the high computational complexity and information uncertainty in the joint optimization of UAV trajectory, FA positions, and beamforming under mobility, energy, hardware, and security constraints. To address these challenges, we present a hybrid offline-online optimization framework, where prior information such as environment maps, user mobility patterns, and statistical channel state information (CSI) supports long-term planning, while real-time information such as instantaneous CSI and UAV state enables fast online correction. A case study on FA-enabled UAV-assisted vehicular communications demonstrates the effectiveness of the proposed framework. Finally, we discuss future directions of FA-enabled UAV communication in integrated sensing and communication (ISAC), secure communication, mobile edge computing (MEC), and aerial relaying.

0.14

Fluid Antenna Array-Inspired Location-Posterior-Driven Subarray Sizing and Power Control for Two-Hop AF UAV Relaying

cs.IT ·2026-08-17 ·Xuanyi Zhu, Jian Dang, Chen Zhao, Huaifeng Shi, Zaichen Zhang
similarity 0.56
Abstract · 6 pages, 5 figures

This paper develops fluid antenna array (FAA)-inspired subarray sizing and transmit-power design for a two-hop amplify-and-forward (AF) unmanned aerial vehicle (UAV) relay using progressively contracting user-location posteriors. A contiguous reconfigurable subarray is shared by first-hop reception and second-hop forwarding, such that its active size jointly determines the receive gain, forwarding gain, and beamwidth. By adaptively controlling the effective aperture, the proposed design exploits geometric reconfigurability to balance array gain against pointing robustness under location uncertainty. Projecting the position covariance onto the array direction yields a closed-form direction-limited size inversely proportional to directional uncertainty. Posterior samples are propagated through the two-hop rate model, and the subarray size and transmit power are then selected to minimize UAV power subject to a worst-user lower-tail rate requirement and hardware power limits. The planned configuration is further audited over instantaneous two-hop Rician channels at the true user positions. At t = 8 s, the proposed design saves 3.17 dB over full-array narrow-beam transmission on paired feasible geometries and achieves 60.0% service success at a 0.15-W budget, compared with 43.2% for a fixed eight-element subarray.

0.14

OTFS-Enabled Delayed SINR-Feedback Power Control for Reliable and Fair High-Mobility UAV Communications

eess.SP ·2026-09-15 ·Thuan Van Le, Nguyen Cong Luong, Trong-Dai Hoang, Vo Nguyen Quoc Bao, Thien Huynh-The +2 more
similarity 0.55
Abstract · This work has been submitted to the IEEE for possible publication. Copyright may be transferred without notice, after which this version may…

This paper develops a power control framework driven by delayed signal-to-interference-plus-noise ratio (SINR) feedback for orthogonal time frequency space (OTFS) unmanned aerial vehicle (UAV) communications operating under high mobility, with reliability and fairness as the primary design targets.A base station with a uniform linear array serves several UAVs on a common OTFS frame, while the path delays, Doppler shifts, and inter-UAV interference are determined by the three-dimensional propagation geometry and the base-station array response rather than by a postulated coupling model. In place of instantaneous channel state information, the proposed controller refreshes the transmit-power vector from delayed SINR measurements alone, which matches the practical limitations of fast-fading aerial links. A prediction-smoothing-projection rule mixes a reliability share, a fairness share and a spectral-efficiency share, each normalized separately, so that the utility weights control the closed loop directly. Simulations show that the effective SINR of OTFS changes 37.8% less per frame than that of orthogonal frequency division multiplexing (OFDM) at 70 m/s under the same numerology, and that the resulting controller raises the average minimum SINR by 1.21 dB over equal power allocation at 40 m/s while lifting Jain's fairness index from 0.833 to 0.970, at a sum-rate cost of 24.6% that the utility weights keep under the designer's control. The margin of OTFS over OFDM within the same controller widens from 0.18 dB at 10 m/s to 0.81 dB at 90 m/s, showing that the waveform contribution to the usefulness of stale SINR feedback increases with mobility.

0.27