CS Paper Radar

Doppler-compensated Space-time Coding for MIMO PMCW Radar

Gabriel Daniel, Hanqing Wu, Ashish Pandharipande, Geert Leus

eess.SP ·submitted 2026-10-19 17:58 UTC · v1

Abstract

Phase modulated continuous wave (PMCW) radar is an attractive choice for automotive sensing due to its high dynamic range, interference robustness, and support for integrated communication and sensing. In multiple-input multiple-output (MIMO) PMCW radar, code division multiplexing (CDM) separates transmit signals, but non-ideal auto- and cross-correlation properties increase range sidelobes and degrade dynamic range. This paper proposes a Doppler-compensated space-time coding (STC)-based MIMO PMCW radar framework that separates transmit signals before range correlation, eliminating cross-correlation terms under perfect compensation and allowing the same binary sequence to be used across transmit antennas. The Doppler influence on STC decoding is analytically characterized, showing that chip-wise and inter-STC-slot phase distortions increase range sidelobes and generate ghost components in the direction-of-arrival (DOA) spectrum. To mitigate these effects, Doppler is estimated first, followed by joint fast-time and STC-slot compensation before decoding. Residual STC leakage under imperfect Doppler estimation is quantified, and the processing is extended to multiple moving targets through Doppler-bin-dependent compensation. Theoretical analysis and simulation results demonstrate reduced range sidelobes and suppression of DOA ghosts, while maintaining flexibility in code sequence design.

Comment
Under review for a publication in IEEE Transactions on Signal Processing

Closest papers

Nearest neighbours by meaning across the whole index.

Continuous-Phase Frequency-Hopping MIMO Signaling and Processing for ISAC

eess.SP ·2026-10-16 ·Yi Wang, Xianxiang Yu, Jing Yang, Tao Fan, Linlong Wu +2 more
similarity 0.62
Abstract · 22 pages, 13 figures, including appendices

Frequency-hopping MIMO integrated sensing and communications (FH-MIMO-ISAC) supports agile multidimensional signaling but faces challenges in phase-continuous transmission, demodulation without channel-phase information, and coherent processing of multi-frequency echoes. We propose a continuous-phase frequency-hopping (CP-FH) MIMO ISAC waveform with matched communication and radar processing. Information is conveyed jointly by frequency combinations and continuous-phase-modulation symbols. CPM phase accumulation and frequency-hopping linear-frequency-modulation phase compensation maintain phase continuity and reduce spectral leakage. We derive exact inter-element orthogonality conditions, residual cross-correlation bounds, and a bound on averaged transmit-beampattern ripple. For communication, projection-energy demodulation requires no channel-phase information and approximates least-squares detection under weak inter-branch correlation. It separates frequency-combination search from CPM-symbol decisions, reducing complexity while retaining direct joint-search decisions. For radar, structure-matched coherent processing combines space-time-frequency matched filtering, velocity-consistent Doppler focusing, and frequency-aperture focusing to form a three-dimensional coarse-range--velocity--fine-range response. It reduces Doppler-mismatch loss and extra detections from periodic range grating lobes in conventional pulse-Doppler processing. We further derive the joint range response, output signal and noise powers, and receive beampattern. The analysis characterizes target-discrimination limits under periodic ambiguity and shows that the proposed processor preserves frequency-aperture range resolution and full-aperture angular resolution, with equal output noise power under the stated conditions.

0.31

RadarCom: Unlocking Simultaneous Communication and Sensing on Commodity Automotive mmWave Radars

cs.NI ·2026-10-27 ·Yi Wei, Yue Zhang, Peijun Hou, Qiuyu Liao, Nan Cen
published similarity 0.60
Abstract · Accepted to ACM SenSys 2027. 14 pages

Vehicle-to-vehicle (V2V) communication can improve road safety and traffic efficiency, yet its deployment remains limited by the need for dedicated communication hardware and supporting infrastructure. Meanwhile, production vehicles are already widely equipped with millimeter-wave radars for sensing. To unlock their communication potential, this paper presents RadarCom, a software-defined system that enables direct radar-to-radar communication on unmodified commercial off-the-shelf (COTS) automotive mmWave radars while preserving their native sensing functionality. The key insight is that mutual inter-radar interference, traditionally viewed as harmful, can be repurposed as a communication carrier. Based on this insight, RadarCom introduces slope-mismatch-based discovery, adaptive chirp synchronization, differential coding on range-FFT, and sensing-aware interference suppression to enable simultaneous communication and sensing without hardware modification, waveform redesign, or infrastructure support. We implement RadarCom on TI AWR2243 automotive radars and evaluate it under static, dynamic, and challenging real-world conditions. Results show an average effective data rate of 5.55 kbps with symbol error rates below 1.5%, while maintaining sensing F1 scores of up to 80.5% during concurrent communication. These results demonstrate the feasibility of transforming commodity automotive radars into dual-purpose communication and sensing devices.

0.41

Delay-Doppler Sensing Performance Analysis for MIMO-OFDM ISAC Systems

eess.SP ·2026-09-01 ·Peishi Li, Rang Liu, Qian Liu, Ming Li
published similarity 0.58
Abstract · Accepted by IEEE Globecom 2026

In communication-centric integrated sensing and communication (ISAC), delay-Doppler sensing reuses data-bearing orthogonal frequency division multiplexing (OFDM) signals rather than dedicated radar probing waveforms. Consequently, the resulting range-Doppler map (RDM) is shaped not only by target parameters, but also by communication-symbol randomness and, in multi-antenna transmissions, by spatial beamforming. While existing analyses have largely focused on single-antenna OFDM-ISAC, the delay-Doppler sensing behavior of multi-antenna OFDM-ISAC remains insufficiently understood. This paper analyzes a multi-input multi-output (MIMO)-OFDM-ISAC system in which multiple data streams jointly illuminate a sensing target. We derive second-order moment expressions for the RDM under matched filtering (MF) and reciprocal filtering (RF), and use them to characterize the dynamic range (DR). The analysis reveals two key multi-stream effects. First, under MF, the random superposition of multiple beamformed streams creates an additional RDM floor beyond the modulation-dependent and receiver-noise terms; therefore, constant-modulus signaling no longer eliminates the data-induced pedestal as in single-antenna OFDM-ISAC. Second, under RF, the matched-angle data-induced floor is removed, but the noise floor is amplified according to the reciprocal-power statistics of the beamformed target illumination. These results show that the user-target angular geometry directly governs the MF/RF tradeoff: MF is more robust under weak illumination, whereas RF can achieve a higher DR when reciprocal-noise amplification is mild. Numerical results validate the analysis and demonstrate the distinct geometry-dependent behaviors of MF and RF.

0.14

Complementary Waveform Coordination for Doppler-Resilient MIMO Radar

cs.IT ·2026-09-26 ·Maksim Antonik, Wenbing Dang, Ali Pezeshki, Stephen D. Howard, William Moran
similarity 0.58
Abstract

Complementary waveform libraries yield impulse-like aggregate delay responses at zero Doppler, but pulse-dependent Doppler phases degrade their sidelobe cancellation. This paper develops a linear-algebraic formulation for coordinating a (D)-ary transmission schedule and slow-time receive weights for paraunitary MIMO waveform libraries. Using a modal decomposition of the CPI ambiguity matrix, prescribed-order Doppler-nulling conditions for the (D-1) nonzero modes are expressed as homogeneous linear constraints on the receive weights for a fixed schedule. This representation gives the SNR-optimal fixed-schedule weights by subspace projection and reduces the remaining design to a discrete schedule search. Degrees-of-freedom and modal-growth analyses relate the design to the CPI length, null order, and waveform dimension. Numerical examples compare the resulting designs with established binary constructions and demonstrate Doppler suppression across the full ambiguity matrix of a four-waveform configuration.

0.28

Full-Frame OFDM-ISAC: Joint Constellation, Pilot, and Receive-Filter Design

eess.SP ·2026-09-19 ·Dongil Yang, Kaitao Meng, Fan Liu, Christos Masouros, Kawon Han
similarity 0.58
Abstract · 13 pages, 9 figures

Orthogonal frequency-division multiplexing (OFDM) integrated sensing and communication (ISAC) reuses the entire time-frequency frame, including pilots and data payloads, for radar sensing. The random data payload, however, reduces the sensing dynamic range and degrades the target detection and parameter estimation performance. Existing studies typically optimize the modulation constellation, the pilot pattern, the power allocation, and the receive filter in isolation, overlooking their coupled effects on the sensing ambiguity structure. To address this gap, we propose a joint design of the constellation, the pilot placement and power split, and the mismatched receive filter for full-frame OFDM-ISAC systems, which minimizes the residual interference inside declared regions of interest (ROIs) under a communication rate constraint. For a given transmit signaling scheme, the receive filter admits a closed-form solution. With this filter in place, we derive closed-form expressions for the receiver-specific interference floor and noise enhancement over the 2-D range-Doppler domain, which show that the floor is governed by a single effective statistic of the full-frame signaling. This law reduces the joint design to two steps. A balanced staggered pilot placement removes the deterministic grating lobes of pilot-power boosting, and the shaped constellation and the power split are then selected jointly on the boundary of the rate constraint under the channel estimation error, which attains the joint optimum over the constructed shaping levels to first order in the declared ROI size. Under a quality-of-service (QoS) constraint of $98\%$ of the rate of a conventional 16-QAM frame, the proposed design significantly lowers the interference floor, improves the target detection probability, and achieves better ranging accuracy compared to the conventional receive filter-aware design.

0.17

Characterizing the Effects of Mixed Division Waveform Schemes in MIMO Radar

eess.SP ·2026-09-26 ·Oliver P. R. Kirkpatrick, Santiago Ozafrain, Christopher Gilliam, Beth Jelfs
similarity 0.57
Abstract · 5 pages, 4 figures, 1 table

Direction of departure estimation in Multiple-Input-Multiple-Output (MIMO) radar is based on transmitting a set of orthogonal (or at least separable) waveforms, one per transmit element. Assuming orthogonality is preserved, these waveforms can then be separated into different channels at the receiver before beamforming. In practice, however, MIMO waveforms are not perfectly orthogonal, and at different points in the processing chain, this can manifest as phase errors in the steering manifolds used in beamforming. Furthermore, due to resource constraints, either by the channel or the sensing scenario, a mixture of orthogonality techniques, mixed division strategies, are often employed, resulting in further phase errors. Naturally, such errors will interfere in the beamforming process, spoiling the beam, introducing direction finding errors, or increasing sidelobe levels, and consequently reducing SNR. In this paper, we demonstrate how mixing division strategies significantly degrades orthogonality of otherwise orthogonal waveforms resulting in degraded beamforming performance. Specifically, we show that waveforms which exhibit favourable sidelobe levels may still induce large direction of departure errors and vice versa. Additionally, through multiple exhaustive searches of potential mixed division strategies with combinations of time-, Doppler- and code-based division techniques we show that large numbers of the possible waveforms exhibit poor beamforming qualities.

0.37

Real-Time Symbol-Domain OFDM Radar in an OpenAirInterface 5G Base Station With O-RAN Sensing Services

eess.SP ·2026-08-17 ·Karim Saifullin, Sajid Ahmed, Mohamed-Slim Alouini
similarity 0.57
Abstract

This paper presents a real-time orthogonal frequency-division multiplexing (OFDM) radar embedded in the OpenAirInterface (OAI) 5G base-station process. The radar removes communication symbols by regularized element-wise division and performs range-Doppler processing and ordered-statistic constant-false-alarm-rate detection online without modifying the 5G waveform. The implemented system provides 2.57 m nominal range resolution and 0.28 m/s velocity resolution. Hardware measurements identify and mitigate several implementation-specific limitations, most notably a deterministic carrier-dependent transmit-receive phase rotation on a Universal Software Radio Peripheral (USRP) X300. Selecting a tuning-grid-aligned carrier improves mean-removal clutter suppression from -16.4 dB to 38.0 dB and reduces coherent-integration loss from 19.81 dB to 0.27 dB. The measured processing gain closely agrees with its predicted value. Instrumented worker timing confirms real-time operation, with a conservative 58.4 percent utilization bound and no dropped soundings. A custom E2 service model, E2SM-RADAR, exports detections and a compact slow-time product to a near-real-time RAN Intelligent Controller. Live end-to-end operation demonstrates reliable delivery and supports controller-side tracking, micro-Doppler analysis, and classification. With a commercial user equipment connected on the same carrier, measurements show no measurable difference in downlink throughput estimate with sensing enabled, while the radar sensing bandwidth follows the scheduler allocation. Video demonstration can be found in youtube: youtu.be/GaYAcTJ8RKI

0.31

Frame-Induced Doppler Self-Ambiguity in SiriusXM Satellite Signals for Passive Radar

eess.SP ·2026-09-08 ·Khalid El-Darymli, Christoph H. Gierull, Ryan A. English, Tony Laneve
published similarity 0.56
Abstract

Satellite Digital Audio Radio Service (SDARS) signals are attractive illuminators of opportunity for passive radar due to their continuous geostationary coverage and relatively high effective radiated power. However, the deterministic time-division multiplexed (TDM) framing employed by these waveforms introduces inherent self-ambiguity that can constrain coherent integration and detection performance. This paper analyzes the self-ambiguity function (SAF) of the XM/SiriusXM (SXM) waveform and explicitly links the observed Doppler periodicity to the repetition of the fast synchronization preamble (FSP) embedded in the TDM master frame. A frame-accurate XM TDM signal simulation is used to establish the expected ambiguity behavior, which is then validated experimentally using real direct-path data collected from the SXM-8 satellite. Results demonstrate pronounced and persistent Doppler replicas at integer multiples of the XM FSP repetition frequency, forming a deterministic Doppler ``comb'' (grating-lobe structure) that spans Doppler extents relevant to GEO-based passive radar operation with multi-second coherent processing intervals.

0.52