CS Paper Radar

Reducing 6G Energy Consumption: TDD-Aligned Drain Voltage Modulation for Power Amplifiers

Meizhen Zhuo, Gunter Wolff, Stephan ten Brink, Silvio Mandelli

eess.SP ·submitted 2026-10-23 16:57 UTC · v2

Abstract

The Power Amplifier (PA) of a base station operates inefficiently at partial load, where back-off from the peak output power wastes supply headroom. Adapting the PA drain voltage to the instantaneous signal recovers this loss but requires frequent switching, increasing hardware cost. We propose TDD-Aligned Drain Voltage Modulation (TDD-DVM), a drain voltage modulation scheme that instead selects the drain voltage level once per Time-Division Duplex (TDD) period based on the downlink resource load and switches the voltage during the uplink window. This is enabled by the authors' previous work on POLITE link adaptation, which spreads the transmit power over resources left unused at partial load and moves the PA into a regime where a lower drain voltage suffices. In a 3GPP Urban Macro system-level simulation across traffic loads, we compare TDD-DVM against baseline approaches under conventional and POLITE link adaptation. At equal delivered throughput, TDD-DVM with POLITE keeps the packet failure ratio of the full drain voltage while consuming up to 35% less power than it under conventional link adaptation and up to 7% less than it under POLITE, capturing most of the gain of an idealized reference at moderate loads and roughly half at the highest load.

Comment
6 pages, 5 figures. This work has been submitted to the IEEE for possible publication. Copyright may be transferred without notice, after which this version may no longer be accessible

Closest papers

Nearest neighbours by meaning across the whole index.

Energy Efficiency Optimization for 5G NR PDSCH: A Cross-Layer Link Abstraction Framework

eess.SP ·2026-10-04 ·Jaebum Park, Chan-Byoung Chae, Robert W. Heath
similarity 0.59
Abstract · 6 pages, 4 figures

Energy efficiency (EE) optimization for cellular links often assumes Shannon-capacity transmission. The 3GPP New Radio (NR) physical downlink shared channel (PDSCH), however, delivers a transport block whose size is fixed by the modulation and coding scheme (MCS), the rank, and the resource allocation chosen by the scheduler. The transport block must also meet a target block error rate (BLER). In this paper, we optimize EE for the NR PDSCH with the standard transport block size as the throughput and the target BLER as the constraint. Exponential effective signal-to-noise ratio (SNR) mapping (EESM) turns the BLER constraint into a convex per-subcarrier power constraint. We derive a closed-form waterfilling-like power allocation and an EE-maximizing MCS selection rule. With a single calibration parameter per MCS, fitted offline over 3GPP tapped delay line C (TDL-C) channels, EESM predicts the BLER without per-realization link-level simulation. Numerical results show that a Shannon-capacity baseline overestimates the EE of equal-power transmission by 1.5 to 1.7 times at high SNR within the transmit power budget.

0.26

Aggressive Non-Orthogonal Transmission with DFT-s-OFDM for Direct Device-to-Satellite Communications

eess.SP ·2026-08-17 ·Chathura Jayawardena, Konstantinos Nikitopoulos
published similarity 0.58
Abstract · Accepted at IEEE CAMAD 2026

Direct Device-to-Satellite (D2S) communications promise global connectivity to unmodified user equipment (UE), extending coverage beyond terrestrial networks. Realizing this promise is fundamentally challenging: severe path loss and limited UE transmit power push uplink SNRs far below terrestrial norms, while suitable spectrum remains scarce. Together, these constraints impose a spectral-efficiency (SE) bottleneck, and under such conditions the efficiency of the UE power amplifier becomes critical, jointly governing transmit power and battery life. To improve UE-side power efficiency, 3GPP has adopted Discrete Fourier Transform-spread OFDM (DFT-s-OFDM) as an optional uplink waveform, exploiting its substantially lower Peak-to-Average Power Ratio (PAPR) relative to OFDM. To break the SE bottleneck, we show that aggressive non-orthogonal transmission, in which the number of concurrent users exceeds the number of receive antennas by more than 2x, can unlock substantial capacity gains that remain entirely unexploited. Realising these gains, however, requires receiver architectures that, to the best of our knowledge, have not yet been developed. DFT-s-OFDM intensifies the difficulty: the DFT spreading couples signal components across subcarriers, inflating the effective dimensionality of the detection problem. We address both challenges with a novel receiver design that jointly exploits the SE gains of aggressive non-orthogonal transmission and the power-efficiency benefits of DFT-s-OFDM. Simulations under realistic channel-estimation errors and high-mobility Doppler show that the proposed scheme achieves 2x the SE of baseline, surpasses recent nonlinear MIMO receivers by 40% at 15% of their complexity, and reduces PAPR by up to 6 dB relative to DFT-s-OFDM MIMO and 11 dB relative to OFDM.

0.30

Age of Information for Power-Saving Devices with DRX Mechanism

cs.NI cs.PF ·2026-11-06 ·Hung-Chun Lin, Kuang-Hsun Lin, Hung-Yu Wei
publishedtheoryhighly cited similarity 0.57
Abstract · 6 pages, 4 figures, 1 table. Published in IEEE ICC 2023

Reducing the power consumption of User Equipment (UE) has always been a crucial issue in communication systems. As a result, Discontinuous reception (DRX) is introduced in today's New Radio (NR) networks as a power-saving strategy. In addition, the variety of low latency applications in 6G makes the issue of maintaining data freshness increasingly important. This paper aims to study the relationship between freshness and power-saving. To capture the information freshness, we use Age of Information (AoI) as the performance metric. To our best knowledge, unlike previous studies focusing on power saving and delay trade-offs, this is the first study considering the impact of DRX on AoI. We solve the closed-form solution of the peak average AoI with the DRX mechanism. Moreover, we propose a parameters adjustment strategy. Based on the simulation validation, our proposed strategy can enable the UE to keep the AoI close to the theoretical lower bound AoI while achieving high power-saving efficiency.

0.64

Minimizing Energy Consumption based on Waste Factor in Multi-user Multi-relay Systems

eess.SP ·2026-10-03 ·Nurullah Sevim, Mostafa Ibrahim, Sabit Ekin, Theodore S. Rappaport
similarity 0.57
Abstract · Submitted to IEEE Transactions on Green Communications and Networking for review

The escalating energy demands of modern wireless networks make energy-efficient system design a central challenge for future 6G deployments. Relay-assisted communication has long been recognized as a powerful tool for improving coverage and throughput, tracing its roots to early repeater communication systems and the foundational relay channel models in information theory. Meanwhile, modern relay selection and routing strategies are primarily driven by rate-based or transmit-power-centric metrics, which often neglect hardware-level losses that is independent of the transmitted signal. As networks grow denser and more heterogeneous, signal-independent hardware inefficiencies and circuit power consumption increasingly dominate the total energy consumption and fundamentally alter the optimality of relay assignment decisions. To address the challenge of modeling signal-independent power consumption in relay-assisted systems, the Waste Factor (WF) framework is adopted: a hardware-aware, unifying metric that explicitly captures signal-independent power losses across cascaded transceivers and wireless channels. Using WF, the energy consumption of multi-user, multi-relay wireless systems is quantified and minimized under practical hardware and network constraints. The formulation jointly accounts for component inefficiencies, propagation losses, and relay-selection constraints. The proposed framework demonstrates that the WF formulation provides a fundamentally new way to model relay-assisted communication, enabling hardware-aware energy-per-bit minimization and a structured representation that enables computationally efficient analysis. Simulation results confirm that WF-based relay assignment reduces total energy per bit while improving the ability of users to satisfy minimum received-power requirements, outperforming conventional formulations across both metrics.

0.26

Non-Uniform Activation Aided Distributed Generalized Spatial Modulation for DMIMO Systems

cs.IT eess.SP ·2026-09-24 ·Haojin Li, Chen Sun, Rang Su, Zhaojian Liu, Wenqi Zhang +1 more
publishedtheory similarity 0.57
Abstract

This letter investigates a non-uniform activation aided distributed generalized spatial modulation (DGSM) scheme in a downlink distributed multiple-input multiple-output (DMIMO) system formed by geographically separated transmission reception points (TRPs). Unlike conventional uniform-activation DGSM, the proposed scheme assigns adaptive activation probabilities to different TRP subsets, thereby jointly exploiting the data-domain transmission capability and the index-domain information carried by cooperative subset selection. We derive a mutual-information upper bound under non-uniform activation and formulate a joint activation-probability and power allocation problem subject to a long-term average power constraint. To solve this problem, we develop a semi-closed-form joint probability and power optimization (SC-JPPO) algorithm, where the optimal activation probabilities are shown to follow a Softmax function of the effective utilities. Simulation results demonstrate that the proposed scheme improves spectral efficiency under the same activation scale and power budget compared with existing benchmarks.

0.33

Interference-Aware Downlink Power Control for High-Altitude Platform Stations with QoS and Max-Min Fairness

eess.SP ·2026-10-08 ·Rajan Shrestha, Hayder Al-Hraishawi
published similarity 0.56
Abstract · Accepted for presentation at IEEE Consumer Communications & Networking Conference (CCNC 2027)

High-altitude platform stations (HAPS) are a promising component of non-terrestrial networks (NTNs) for wide-area connectivity. However, serving multiple users over large user footprints requires efficient power-control mechanisms that account for the unique propagation characteristics and strict power constraints of HAPS. This paper develops a tractable analytical and optimization framework for downlink power allocation in HAPS systems under statistical channel state information, 3GPP NTN path loss, and Rician fading. A closed-form expression for the signal-to-interference-plus-noise ratio (SINR) with mean-channel maximal-ratio transmission (MRT) precoding is derived, capturing geometry-dependent inter-user interference coupling. Based on this, two power-control schemes are proposed: quality-of-service (QoS)-constrained power minimization and max-min SINR fairness. The QoS solution is obtained in closed form or through a low-complexity fixed-point iteration, while the max-min solution is obtained through bisection. Numerical results demonstrate up to 6 dB reduction in required transmit power at moderate-to-high target rates and improved worst-user SINR compared to the uniform power, inverse path-loss, and geometry-aware heuristic allocations. The proposed QoS-optimal scheme also achieves a QoS feasibility probability of approximately 0.95 at R_req = 2.5 bits/s/Hz and P_max = 35 dBm, while the uniform power, inverse path-loss, and geometry-aware heuristic allocations achieve less than 0.4. Moreover, the proposed schemes achieve performance comparable to the linear programming (LP)-based benchmarks at a fraction of the computational cost, reducing the average computation time by approximately 99.97% when K = 20.

0.25

HAPS-RIS or HAPS-Relay: Which Outperforms Under Impairments with NOMA in 6G NTN?

cs.NI ·2026-09-09 ·Bilal Karaman, Faicel Khennoufa, Ilhan Basturk, Metin Ozturk, Ferdi Kara +2 more
published similarity 0.55
Abstract · accepted in GLOBECOM 2026

This paper investigates the performance of high-altitude platform station (HAPS)-assisted communication systems employing either reconfigurable intelligent surfaces (RIS) or relay stations (RS) under non-orthogonal multiple access (NOMA) scheme. Practical system impairments, including hardware impairments (HWI) and imperfect channel state information (CSI), are explicitly considered. The results show that HAPS-RIS outperforms HAPS-RS in terms of both sum-rate and energy efficiency under non-ideal conditions due to its passive nature, which avoids noise amplification. Furthermore, it is demonstrated that RIS element allocation and user spatial distribution significantly impact NOMA performance, where increased user separation and proper allocation enhance channel disparity and improve system efficiency. Despite its higher sensitivity to imperfect CSI, HAPS-RIS can effectively compensate for performance degradation through large-scale RIS element deployment, maintaining a performance advantage over half-duplex RS-based systems. These insights provide useful design guidelines for impairment-aware HAPS-assisted 6G communication systems.

0.44

SINR-Aware Adaptive Offloading and Resource Allocation in Shared-Spectrum Integrated Terrestrial and Non-Terrestrial Networks

eess.SP ·2026-10-31 ·Aman Khalid, Muhammad Sohaib Aslam, Ahmed Naeem, Seyit Karatepe, Muhammet Kirik +1 more
theory similarity 0.55
Abstract

Sharing the sub-6~GHz spectrum between terrestrial networks and low Earth orbit satellites introduces cross-tier interference in both directions, as terrestrial transmissions can degrade satellite-link reception, while satellite transmissions can impair the performance of terrestrial links. Conventional reference signal received power (RSRP)-based offloading, designed for separate frequency bands, does not account for this cross-tier interference. We study offloading and resource allocation in an integrated terrestrial and non-terrestrial network through a two-timescale framework in which signal-to-interference-plus-noise ratio (SINR)-aware adaptive traffic offloading (SAATO) updates user associations from filtered SINR and load-aware expected throughput, switching a user only across a hysteresis band, while joint cross-tier fractional programming (Joint-FP) optimizes resource allocation for the resulting associations. Under an equal-share resource allocation model, the resulting decision metric approximates the change in proportional-fair utility with an error that decays with load. We prove that joint allocation under the sum-rate utility is nondeterministic polynomial-time (NP)-hard and that the utility sequence accepted by Joint-FP is non-decreasing and convergent. At full spectral overlap, RSRP-based offloading leaves 44\% of user samples below 0.5~Mbps (outage), whereas SAATO with Joint-FP, given instantaneous channel knowledge, leaves none and increases geometric-mean throughput by 8\% and 2\% under half and full spectral overlap, respectively, relative to power control without offloading. It also limits tier switching to at most 0.05 switches per user per minute.

0.20