CS Paper Radar

Cross-Band Movable-Antenna Communications under Frequency-Dependent Multipath

Guangchen Wang, Zhifeng Tang, Haiyao Yu, Nan Yang, Salman Durrani, Xiangyun Zhou

eess.SP ·submitted 2026-10-24 08:23 UTC · v1
benchmarktheory

Abstract

Movable antennas (MAs) provide additional spatial degrees of freedom by adapting their physical positions to the propagation environment. However, existing studies mainly focus on single-band or contiguous wideband transmission, leaving the cross-band spatial behavior of MAs under frequency-dependent multipath propagation largely unexplored. To address this gap, we investigate a downlink multi-band MA communication system where a common physical MA configuration is shared across multiple communication bands. Such sharing induces an inherent configuration conflict, as different bands often favor substantially divergent MA configurations. We first develop a frequency-dependent multipath channel model with shared propagation geometry but band-dependent multipath component powers and phases. Using this model, we formulate a sum-rate maximization problem by jointly optimizing user-band assignment, MA positioning, and transmit precoding. We further establish a cross-band spatial scaling relationship for the normalized channel power and derive both a position-independent channel gain upper bound and a sum-rate upper bound. Based on these results, we propose a cross-band analysis-guided optimization (CAGO) algorithm and a cross-band graph transformer (CBGT) to reduce online optimization complexity. Numerical results validate the derived cross-band spatial relationship and show that CAGO consistently outperforms the narrowband, wideband, and fixed-antenna benchmarks while remaining close to the idealized independent-MA benchmark. Additionally, CBGT with online refinement achieves near-CAGO sum-rate performance with substantially lower online computational cost, providing a practical framework for exploiting the spatial reconfiguration capability of MAs in multi-band communication systems.

Closest papers

Nearest neighbours by meaning across the whole index.

Mutual-Coupling-Aware Joint Precoding and Antenna Positioning for Movable-Antenna MU-MIMO Systems

cs.IT eess.SP ·2026-11-03 ·Wei Guo, Tianyi Liao, Zixin Wang, Shenghui Song, Jun Zhang +1 more
similarity 0.70
Abstract · 13 pages, 6 figures, submitted to an IEEE Journal for possible publication

Movable antennas (MAs) improve wireless communications by adapting antenna positions to the propagation environment. However, antenna movement also changes the mutual coupling (MC) among elements of the transmit and receive arrays, which affects the performance of MA-enabled systems. In this paper, we investigate MC-aware joint precoding and antenna positioning for a downlink multiuser multiple-input multiple-output (MU-MIMO) system with MAs at both the base station and users. We establish an MC-aware system model by combining field-response propagation with a circuit-based representation of the transmit and receive arrays. Based on this model, we formulate a weighted sum-rate (WSR) maximization problem that jointly optimizes multi-stream precoders and antenna positions. The problem is challenging because the precoders and positions are coupled through the propagation channels and position-dependent MC matrices. To address this challenge, we reformulate the problem in the antenna-current domain to to efficiently handle the MC matrices and develop a current-domain weighted minimum mean square error (WMMSE) framework for alternating optimization. Furthermore, we handle the nonconvex position updates within the framework by using majorization--minimization (MM) and solve the resulting convex subproblems with a dedicated conic alternating direction method of multipliers (ADMM) algorithm. Simulation results demonstrate that the proposed design improves the WSR over both an MC-aware fixed array and a movable-array design that ignores MC during optimization.

0.28

Movable Antenna Arrays with Imperfect Channel State Information in Rich Scattering Environments

eess.SP ·2026-08-29 ·Yizhen Zhao, Amna Irshad, Emil Bjornson
published similarity 0.68
Abstract

The growing demand for high spectral efficiency in 6G and beyond has driven research into adaptive antenna architectures capable of exploiting the spatial structure of multipath propagation channels. Conventional base station arrays are deployed with fixed element positions and cannot adapt to the instantaneous spatial structure of the propagation channel. In contrast, movable antenna (MA) systems enable dynamic reconfiguration of antenna positions, allowing the array geometry to track the channel characteristics of the current user set. While prior MA studies have demonstrated significant gains under perfect or statistical channel state information (CSI) assumptions, the interplay between imperfect instantaneous CSI, antenna placement optimization, and precoder design has received limited attention. This paper addresses this gap by proposing a practical end-to-end framework encompassing uplink pilot transmission, MMSE channel estimation under a clustered multipath model, and downlink ZF precoding designed from estimated CSI. Antenna positions are optimized via particle swarm optimization under two objectives: sum-rate maximization and max-min fairness. Simulation results show that MA gains are most pronounced under sparse, near-LoS propagation and diminish as channel richness increases. Furthermore, we reveal a fundamental coupling between array geometry and precoder design: a fairness-oriented antenna geometry encodes spatial fairness information that is only recoverable when evaluated with a compatible power allocation strategy. A mismatched precoder can completely mask the geometric advantage, leading to misleading conclusions about the robustness of antenna placement to the choice of optimization objective. These findings provide practically relevant guidance for the design and evaluation of movable antenna systems under realistic operating conditions.

0.26

Full-Duplex Communication for Pinching Antenna Systems

eess.SP ·2026-11-11 ·Shaokang Hu, Ruotong Zhao, Derrick Wing Kwan Ng, Jinhong Yuan
similarity 0.62
Abstract

This paper investigates multiuser full-duplex (FD) communication assisted by a multiwaveguide pinching-antenna system (PASS) where each dielectric waveguide can be dynamically configured to operate in either downlink transmission or uplink reception mode. We develop a channel model that accounts for in-waveguide power attenuation and cumulative pinching antenna (PA)-induced phase shift. Building on this model, we jointly optimize the waveguide modes, PA locations, PA radiation/collection coefficients, downlink beamformers, uplink receive combiners, and uplink transmit powers to maximize the downlink weighted sum-rate (WSR) subject to uplink quality-of-service (QoS) requirements and power constraints. To tackle the resulting mixed-integer nonconvex resource allocation problem, we propose a low-complexity hierarchical block coordinate descent algorithm that capitalizes on weighted minimum mean-square error, fractional programming, majorization-minimization, and the alternating direction method of multipliers (ADMM) to obtain a high-quality suboptimal solution. Simulations demonstrate that the proposed FD-PASS outperforms an FD base station equipped with fixed antennas and exhibits greater robustness against residual self-interference. Moreover, ignoring cumulative PA-induced phase shifts can produce QoS-infeasible designs.

0.06

Dynamic Metasurface-Enabled Generalized Pinching-Antenna Systems

eess.SP ·2026-10-25 ·Shan Shan, Chongjun Ouyang, Yufei Zhao, Zhiguo Ding, Yong Liang Guan
theoryhot direction similarity 0.62
Abstract

This article investigates dynamic metasurfaces as an electronic realization of generalized pinching antennas (GPA). By jointly optimizing the locations and radiation coefficients of activated elements, the dynamic metasurface-enabled GPA (DM-GPA) architecture exploits additional design flexibility to enhance spatial reconfigurability beyond that attainable through antenna placement in the conventional pinching-antenna system (PASS). Based on this architecture, we study weighted sum rate (WSR) maximization for multiuser downlink transmission. 1) For two-user transmission, the sum-rate improvement of DM-GPA over conventional PASS is quantified through a lower bound that reveals when the benefit of channel orthogonalization achieved by adjusting the radiation coefficients outweighs the channel power loss caused by the Lorentzian constraint. Furthermore, when conventional PASS yields a rank-deficient channel, DM-GPA is shown to achieve spatial multiplexing and transmit diversity, with a strict sum-rate advantage at sufficiently high signal-to-noise ratios. 2) For general multiuser transmission, a weighted minimum mean-square error (WMMSE)-based alternating optimization algorithm is developed for joint pinching beamforming and digital precoder design. A sequential element-wise search is developed to optimize the locations of the activated elements, with a closed-form solution for the radiation coefficient at each candidate location. Numerical results are provided to demonstrate that: (i) DM-GPA achieves higher WSR than other PASS architectures and fixed-array benchmarks, (ii) increasing the number of activated elements further improves the WSR of DM-GPA, and (iii) radiation coefficient adjustment is particularly beneficial when candidate activation locations are limited.

0.27

Finite-Aperture Modeling of Pattern-Reconfigurable Antennas for Multiuser Beamforming

eess.SP ·2026-10-07 ·Kangjian Chen, Han Qing Yang, Hang Wong
similarity 0.60
Abstract · 14 pages, 11 figures; submitted to IEEE for possible publication

This paper establishes a finite-aperture model for pattern-reconfigurable antennas (PRAs) and exploits its aperture-constrained Fourier representation to develop an efficient multiuser beamforming framework. First, we develop an ideal model by representing the complex radiation pattern using a Fourier series. By applying the Jacobi-Anger expansion, we relate the antenna aperture to the effective Fourier order and derive aperture-dependent power bounds for individual Fourier coefficients. Second, we employ a practical multiport network model and design three representative reconfigurable pixel antennas to verify the predicted effective Fourier orders and per-order power constraints. We then formulate weighted sum-rate maximization for multiuser downlink transmission under both models. Using bounded Fourier coefficients as auxiliary variables, we develop a coefficient-bound penalty-based weighted minimum mean-square error algorithm that separates continuous beamforming from discrete switch-state optimization. We further propose a one-bit neighborhood search that exploits the Sherman-Morrison identity to accelerate the discrete optimization. Simulation results validate the physical relevance of the ideal model and demonstrate multiuser sum-rate gains and reduced optimization runtime for densely switched antennas. The proposed model provides a physically grounded basis for PRA-enabled communication analysis and design, while the framework accommodates different beamforming objectives and PRA implementations.

0.32

Channel Estimation for Movable Antenna Systems: Challenges, Solutions, and Opportunities

eess.SP ·2026-09-12 ·Linchu Chen, Zhendong Li, Zile Zou, Zhou Su, Lin Chen +3 more
similarity 0.59
Abstract

Movable antenna (MA) has emerged as a promising technology for future wireless networks by exploiting channel variation over local antenna movement regions. However, accurate and efficient channel acquisition in MA systems remains challenging due to the trade-off between estimation accuracy and computational complexity. In this article, the MA channel model and the associated estimation framework are first reviewed, where channel information over the movement region is reconstructed from finite measurements by exploiting shared path parameters. The structured dependence of MA observations across space, time, and frequency naturally motivates the adoption of tensor-based modeling for channel estimation. Subsequently, we discuss the tensor-based signal model and corresponding parameter estimation methods from multidimensional observations. These methods are further compared with conventional channel estimation methods in terms of estimation accuracy, computational complexity, and general applicability. Furthermore, a representative case study is provided to illustrate the performance and characteristics of different algorithms under MA channel estimation settings. Finally, some future research directions for tensor decomposition-based channel estimation in MA systems are outlined.

0.17

Pinching Antenna-Assisted Full-Duplex Communication Systems

cs.IT ·2026-09-24 ·Xuan Li, Xianfu Lei, Mingjiang Wu, Sotiris A. Tegos, Panagiotis D. Diamantoulakis +1 more
similarity 0.59
Abstract

Full-duplex (FD) communication theoretically doubles spectral efficiency. Despite this potential, its practical performance is primarily constrained by severe self-interference (SI) and co-channel interference. Moreover, conventional fixed antenna arrays suffer from limited spatial flexibility, resulting in insufficient spatial isolation for SI suppression. To address this issue, this letter proposes an FD architecture assisted by pinching antenna systems (PASS). By dynamically adjusting transmit and receive antenna positions, the system enables large-scale channel reconfiguration, thereby synergizing with the base station (BS) beamforming to suppress SI and enhance the desired signal reception. To demonstrate the potential of PASS for FD communication, we formulate a weighted sum-rate maximization problem that jointly optimizes antenna positions, BS beamforming, and power allocation. To tackle this non-convex problem, we reformulate it using the weighted minimum mean square error (WMMSE) framework and develop an efficient alternating optimization (AO) algorithm to iteratively update the optimization variables. Simulation results reveal that the proposed PASS-assisted FD architecture significantly outperforms conventional fixed antenna arrays, achieving substantial sum-rate gains while effectively mitigating SI to enable FD operation.

0.14

Multi-Band Indoor MIMO Channel Measurements Across Sub-6 GHz, Mid-Band and mmWave: Comparing 2.55 GHz, 12.75 GHz and 25.5 GHz

eess.SP ·2026-11-11 ·Faruk Pasic, Florian Kiss, Florian Asperger, Diego Dupleich, Stefan Schwarz +1 more
published similarity 0.58
Abstract · Submitted to the 21th European Conference on Antennas and Propagation (EuCAP), 2027

Future wireless systems for indoor applications are expected to extend their operating frequencies from sub-6 GHz to mid-band and millimeter wave (mmWave) frequencies to support higher data rates. To characterize the frequency-dependent propagation behavior across these bands, multi-band channel measurements are essential. In this work, we conduct double-directional multiple-input multiple-output (MIMO) channel measurements in an indoor environment to enable a consistent comparison across three frequency bands. Measurements are performed using a 16x16 MIMO configuration at center frequencies of 2.55 GHz, 12.75 GHz and 25.5 GHz, covering both line-of-sight (LOS) and obstructed line-of-sight (OLOS) conditions. The measured channels are processed using the space-alternating generalized expectation maximization (SAGE) algorithm to extract multipath parameters, which are subsequently used to characterize the angular power distributions across the three frequency bands. The results show substantial angular-domain similarity across all three bands in both LOS and OLOS conditions, while also highlighting frequency-dependent variations.

0.40