CS Paper Radar

Multi-Band Indoor MIMO Channel Measurements Across Sub-6 GHz, Mid-Band and mmWave: Comparing 2.55 GHz, 12.75 GHz and 25.5 GHz

Faruk Pasic, Florian Kiss, Florian Asperger, Diego Dupleich, Stefan Schwarz, Markus Rupp

eess.SP ·submitted 2026-11-11 10:22 UTC · v1
published

Abstract

Future wireless systems for indoor applications are expected to extend their operating frequencies from sub-6 GHz to mid-band and millimeter wave (mmWave) frequencies to support higher data rates. To characterize the frequency-dependent propagation behavior across these bands, multi-band channel measurements are essential. In this work, we conduct double-directional multiple-input multiple-output (MIMO) channel measurements in an indoor environment to enable a consistent comparison across three frequency bands. Measurements are performed using a 16x16 MIMO configuration at center frequencies of 2.55 GHz, 12.75 GHz and 25.5 GHz, covering both line-of-sight (LOS) and obstructed line-of-sight (OLOS) conditions. The measured channels are processed using the space-alternating generalized expectation maximization (SAGE) algorithm to extract multipath parameters, which are subsequently used to characterize the angular power distributions across the three frequency bands. The results show substantial angular-domain similarity across all three bands in both LOS and OLOS conditions, while also highlighting frequency-dependent variations.

Comment
Submitted to the 21th European Conference on Antennas and Propagation (EuCAP), 2027
Journal ref
2027 21th European Conference on Antennas and Propagation (EuCAP), 2027

Closest papers

Nearest neighbours by meaning across the whole index.

Directional and Quasi-Omnidirectional Indoor Channel Measurements at Upper 6 GHz

cs.ET cs.IT ·2026-10-10 ·Chengsong Fu, Hongbo Zhao, Jianer Zhou, Xiongbin Yu, Weichao Li +4 more
similarity 0.66
Abstract

This paper presents wideband indoor channel measurements and measurement-based statistical modeling of channel parameters in the upper 6 GHz (U6G) band using directional and quasi-omnidirectional antenna pairs. Measurements span 6.425-7.125 GHz at 32 matched positions per configuration in an open hall and an L-shaped corridor. System calibration and frequency-dependent peak-gain normalization retain antenna radiation-pattern weighting. Close-in and floating-intercept models are fitted to line-of-sight (LOS) and non-LOS (NLOS) path loss, respectively. Shadow-fading residuals, RMS delay spread (DS), and equivalent K factors derived from power delay profiles are characterized. LOS exponents range from 1.98 to 2.14. Despite similar attenuation slopes, directional links exhibit smaller LOS residuals and DS and higher equivalent K factors. Hall DS medians are 1.78 and 36.52 ns for directional and quasi-omnidirectional links. Corridor NLOS slopes are -1.12 and 2.54, respectively, while DS ordering varies by position. These results characterize antenna-dependent parameters for U6G indoor channels.

0.12

Wideband Channel Measurements in the Lower FR3 Band (6-12 GHz) for Industrial Environments

eess.SP ·2026-10-30 ·Faizan Rauf, Adam Umra, Oways Alsoloh, Aydin Sezgin
code/data similarity 0.62
Abstract

The upper mid-band, also known as Frequency Range 3 (FR3), spans 7.125-24.25 GHz and is a key candidate band for sixth-generation (6G) wireless communications. However, channel measurements in industrial environments remain scarce, and the 3GPP indoor-factory (InF) channel model, developed for omnidirectional antennas, has yet to be validated across the FR3 band. This paper presents a wideband channel measurement campaign in an industrial production hall, covering 135 line-of-sight (LOS) positions at 1-18 m and 30 non-line-of-sight (NLOS) positions behind an industrial robot at 2.5-16.5 m across 6-12 GHz. In LOS, the path-loss exponent ranged from 1.87 to 2.12, and the close-in fits agreed with the 3GPP InF-LOS model to within approximately 2 dB. However, shadow fading was only 1.4-1.7 dB, compared with the model's 4.3 dB. In NLOS, the robot caused an excess loss that increased from 10.3 to 13.0 dB between 6.5 and 11.5 GHz, consistent with diffraction. Blocking the direct path raised the mean directional delay spread from approximately 5 to 25 ns, close to omnidirectional values. These results indicate that the 3GPP InF model captures mean LOS path loss well but overestimates the variability of beam-aligned FR3 links, and that blockage loss in FR3 is frequency dependent. The dataset and processing code are publicly available.

0.28

Omnidirectional UMi Path Loss Models for 3GPP Extension Above 100 GHz Using Extensive Empirical Data Sets from 6.75 to 142 GHz

eess.SP ·2026-09-08 ·Xingchen Liu, Homa Nikbakht, Mingjun Ying, Dipankar Shakya, Hitesh Poddar +3 more
similarity 0.62
Abstract

Extending standardized urban microcell (UMi) path loss (PL) models from the upper mid-band (FR3) to sub-terahertz (sub-THz) frequencies requires measurement-based comparisons spanning a wide spectral range within a unified framework. In this paper, we derive single- and multi-frequency omnidirectional PL models for UMi environments based on extensive NYU WIRELESS measurements at 6.75, 16.95, 28, 73, and 142 GHz in line-of-sight (LOS) and non-line-of-sight (NLOS) conditions. Single-frequency close-in (CI) and floating-intercept (FI) models for each band show that CI yields more stable and physically interpretable parameters, with shadow fading standard deviations within 0.98 dB of FI across all five frequencies. We then extend the multi-frequency PL analysis to the 7-24 GHz, 0.5-100 GHz, and 0.5-150 GHz frequency ranges using CI, close-in with frequency weighting (CIF), and alpha-beta-gamma (ABG) models. Across progressively wider frequency spans, CI and CIF maintain stable distance exponents that remain closely aligned with the 3rd Generation Partnership Project (3GPP) UMi interpretations, whereas ABG offers only very modest reductions in fitting error at the cost of much greater parameter sensitivity. These results support physically anchored CI/CIF formulations with a close-in free space path loss anchor point at 1 m in order to extend 3GPP-oriented UMi PL models over the entire 0.5 to 150 GHz frequency range.

0.24

Map-Free Single-Anchor Position Localization Using Multipath Uncertainty at Upper Mid-Band

eess.SP ·2026-09-08 ·Xingchen Liu, Mingjun Ying, Xinquan Wang, Dipankar Shakya, Homa Nikbakht +2 more
published similarity 0.60
Abstract · 6 pages, 5 figures. Accepted for presentation at the 2026 IEEE Global Communications Conference (GLOBECOM), Macao, China, December 2026

Future 5G-Advanced and 6G systems will exploit directional wideband channels for path-based localization, yet map-free indoor positioning remains challenging because extracted multipath components (MPCs) vary widely in localization reliability. This paper presents an uncertainty-aware map-free single-anchor localization framework using 16.95~GHz indoor directional channel measurements collected at NYU WIRELESS in Brooklyn, New York. Per-MPC angular covariance is estimated from the local consistency of neighboring pattern-de-embedded power delay profile (PDP) observations and propagated into geometric localization through weighted fusion of point-type and line-type constraints. Measurements across 20 links with TX--RX separations from 11~m to 97~m show that the proposed covariance-weighted method achieves a mean localization error of 3.86~m, a median of 2.66~m, and 70\% of links within 5~m using five retained MPCs. It outperforms the power-weighted and unweighted variants under identical point/line constraints, as well as the literature baselines. These results indicate that local directional consistency provides reliability information beyond received power alone and demonstrate a practical map-free approach for future indoor directional systems.

0.50

Cross-Band Movable-Antenna Communications under Frequency-Dependent Multipath

eess.SP ·2026-10-24 ·Guangchen Wang, Zhifeng Tang, Haiyao Yu, Nan Yang, Salman Durrani +1 more
benchmarktheory similarity 0.58
Abstract

Movable antennas (MAs) provide additional spatial degrees of freedom by adapting their physical positions to the propagation environment. However, existing studies mainly focus on single-band or contiguous wideband transmission, leaving the cross-band spatial behavior of MAs under frequency-dependent multipath propagation largely unexplored. To address this gap, we investigate a downlink multi-band MA communication system where a common physical MA configuration is shared across multiple communication bands. Such sharing induces an inherent configuration conflict, as different bands often favor substantially divergent MA configurations. We first develop a frequency-dependent multipath channel model with shared propagation geometry but band-dependent multipath component powers and phases. Using this model, we formulate a sum-rate maximization problem by jointly optimizing user-band assignment, MA positioning, and transmit precoding. We further establish a cross-band spatial scaling relationship for the normalized channel power and derive both a position-independent channel gain upper bound and a sum-rate upper bound. Based on these results, we propose a cross-band analysis-guided optimization (CAGO) algorithm and a cross-band graph transformer (CBGT) to reduce online optimization complexity. Numerical results validate the derived cross-band spatial relationship and show that CAGO consistently outperforms the narrowband, wideband, and fixed-antenna benchmarks while remaining close to the idealized independent-MA benchmark. Additionally, CBGT with online refinement achieves near-CAGO sum-rate performance with substantially lower online computational cost, providing a practical framework for exploiting the spatial reconfiguration capability of MAs in multi-band communication systems.

0.27

Energy-Efficient RF Chain Activation for Uplink mmWave Cell-Free Massive MIMO Systems: A Minimum-Cost Maximum-Flow Approach

eess.SP ·2026-10-12 ·Bo Yu, Abdol Hamid Aghvami, Mohammad Shikh-Bahaei
published similarity 0.57
Abstract · Accepted for presentation at 2026 IEEE Globecom Workshops (GC Wkshps)

With the incessant demand for green and sustainable communications, energy efficiency (EE) has become a cornerstone of sixth-generation (6G) network design, especially for cell-free millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) systems, which can achieve significant throughput gains by leveraging large-scale antenna arrays. Adaptive radio frequency (RF) chain activation (ARFA) is a key technique for reducing power consumption without severely degrading the achievable rate, thereby enhancing the total EE of 6G MIMO systems. In this paper, we propose a minimum-cost maximum-flow (MCMF)-based ARFA scheme to reduce unnecessary power consumption and maximize the total EE of uplink mmWave cell-free massive MIMO systems. Simulation results indicate that the proposed approach can significantly improve the total EE while maintaining a relatively high achievable rate and acceptable computational complexity.

0.30

The Geometry of Mode Sampling in Reconfigurable MIMO Channel Extrapolation

cs.IT eess.SP ·2026-11-18 ·Shaoyang Sun, Chongwen Huang
similarity 0.56
Abstract · 5 pages, 3 figures, and 1 table. An 18-page supplement is included as an ancillary file

Pattern-reconfigurable arrays acquire channels by distributing radiation modes across their antenna elements. Equal mode counts fix the observation budget while leaving a spatial sampling choice that directly affects reconstruction of unmeasured channels. We establish how this assignment enters the inverse problem through the receive aperture and the coupling between propagation paths. For an isolated path with calibrated positive real responses, the power-weighted variance of antenna positions completely characterizes the assignment dependence of the profiled angle information at fixed mode counts. We then construct layouts with identical weighted apertures and different path correlations, exposing a limitation of aperture-based design in multipath propagation. A paired simulation study evaluates balanced random, contiguous, interleaved, and equal-moment sampling using a common estimator with per-detection joint angle refinement. Balanced random sampling substantially reduces complete-channel error relative to ascending contiguous blocks when some modes are entirely unobserved, with improvements across nearly all tested scenes at high signal-to-noise ratio. When every mode is sampled, the mean benefit is more sensitive to rare large errors. Together, the analysis and experiments connect the spatial distribution of mode measurements to both extrapolation accuracy and reconstruction stability.

0.35

Measurement-Based FR3 Urban Macrocell Channel Characterization and Coverage Analysis

eess.SP ·2026-09-20 ·Enrui Liu, Pan Tang, Haiyang Miao, Qi Zhen, Jianhua Zhang
similarity 0.56
Abstract · 6 pages, 11 figures, conference

The 6--18~GHz upper mid-band is a promising spectrum range for future sixth-generation (6G) networks due to its favorable balance between available bandwidth and propagation capability, while its same-site coverage performance remains a key deployment concern. This paper presents a wideband channel measurement campaign at 13 spatially aligned frequency points from 6 to 18~GHz in an urban macrocell (UMa) environment, and investigates the frequency evolution of channel characteristics and same-site coverage capability. The results show that path loss generally increases with frequency, while the higher-frequency channels tend to exhibit smaller root-mean-square (RMS) delay spread (DS) and larger PDP-based $K$-factors. Based on the measured path-loss characteristics, the additional link-budget requirement and service-aware same-site coverage are further evaluated. Under the baseline service configuration, the 80\% coverage distance $d_{80}$ decreases from approximately 129~m at 6~GHz to 58~m at 18~GHz. Further analysis quantifies the impacts of service rate, resource allocation, interference, and link-budget degradation on coverage, providing measurement-based insights for same-site deployment across the 6--18~GHz band.

0.20