CS Paper Radar

Wideband Channel Measurements in the Lower FR3 Band (6-12 GHz) for Industrial Environments

Faizan Rauf, Adam Umra, Oways Alsoloh, Aydin Sezgin

eess.SP ·submitted 2026-10-30 22:18 UTC · v2
code/data

Abstract

The upper mid-band, also known as Frequency Range 3 (FR3), spans 7.125-24.25 GHz and is a key candidate band for sixth-generation (6G) wireless communications. However, channel measurements in industrial environments remain scarce, and the 3GPP indoor-factory (InF) channel model, developed for omnidirectional antennas, has yet to be validated across the FR3 band. This paper presents a wideband channel measurement campaign in an industrial production hall, covering 135 line-of-sight (LOS) positions at 1-18 m and 30 non-line-of-sight (NLOS) positions behind an industrial robot at 2.5-16.5 m across 6-12 GHz. In LOS, the path-loss exponent ranged from 1.87 to 2.12, and the close-in fits agreed with the 3GPP InF-LOS model to within approximately 2 dB. However, shadow fading was only 1.4-1.7 dB, compared with the model's 4.3 dB. In NLOS, the robot caused an excess loss that increased from 10.3 to 13.0 dB between 6.5 and 11.5 GHz, consistent with diffraction. Blocking the direct path raised the mean directional delay spread from approximately 5 to 25 ns, close to omnidirectional values. These results indicate that the 3GPP InF model captures mean LOS path loss well but overestimates the variability of beam-aligned FR3 links, and that blockage loss in FR3 is frequency dependent. The dataset and processing code are publicly available.

Closest papers

Nearest neighbours by meaning across the whole index.

Directional and Quasi-Omnidirectional Indoor Channel Measurements at Upper 6 GHz

cs.ET cs.IT ·2026-10-10 ·Chengsong Fu, Hongbo Zhao, Jianer Zhou, Xiongbin Yu, Weichao Li +4 more
similarity 0.73
Abstract

This paper presents wideband indoor channel measurements and measurement-based statistical modeling of channel parameters in the upper 6 GHz (U6G) band using directional and quasi-omnidirectional antenna pairs. Measurements span 6.425-7.125 GHz at 32 matched positions per configuration in an open hall and an L-shaped corridor. System calibration and frequency-dependent peak-gain normalization retain antenna radiation-pattern weighting. Close-in and floating-intercept models are fitted to line-of-sight (LOS) and non-LOS (NLOS) path loss, respectively. Shadow-fading residuals, RMS delay spread (DS), and equivalent K factors derived from power delay profiles are characterized. LOS exponents range from 1.98 to 2.14. Despite similar attenuation slopes, directional links exhibit smaller LOS residuals and DS and higher equivalent K factors. Hall DS medians are 1.78 and 36.52 ns for directional and quasi-omnidirectional links. Corridor NLOS slopes are -1.12 and 2.54, respectively, while DS ordering varies by position. These results characterize antenna-dependent parameters for U6G indoor channels.

0.12

Omnidirectional UMi Path Loss Models for 3GPP Extension Above 100 GHz Using Extensive Empirical Data Sets from 6.75 to 142 GHz

eess.SP ·2026-09-08 ·Xingchen Liu, Homa Nikbakht, Mingjun Ying, Dipankar Shakya, Hitesh Poddar +3 more
similarity 0.64
Abstract

Extending standardized urban microcell (UMi) path loss (PL) models from the upper mid-band (FR3) to sub-terahertz (sub-THz) frequencies requires measurement-based comparisons spanning a wide spectral range within a unified framework. In this paper, we derive single- and multi-frequency omnidirectional PL models for UMi environments based on extensive NYU WIRELESS measurements at 6.75, 16.95, 28, 73, and 142 GHz in line-of-sight (LOS) and non-line-of-sight (NLOS) conditions. Single-frequency close-in (CI) and floating-intercept (FI) models for each band show that CI yields more stable and physically interpretable parameters, with shadow fading standard deviations within 0.98 dB of FI across all five frequencies. We then extend the multi-frequency PL analysis to the 7-24 GHz, 0.5-100 GHz, and 0.5-150 GHz frequency ranges using CI, close-in with frequency weighting (CIF), and alpha-beta-gamma (ABG) models. Across progressively wider frequency spans, CI and CIF maintain stable distance exponents that remain closely aligned with the 3rd Generation Partnership Project (3GPP) UMi interpretations, whereas ABG offers only very modest reductions in fitting error at the cost of much greater parameter sensitivity. These results support physically anchored CI/CIF formulations with a close-in free space path loss anchor point at 1 m in order to extend 3GPP-oriented UMi PL models over the entire 0.5 to 150 GHz frequency range.

0.24

Multi-Band Indoor MIMO Channel Measurements Across Sub-6 GHz, Mid-Band and mmWave: Comparing 2.55 GHz, 12.75 GHz and 25.5 GHz

eess.SP ·2026-11-11 ·Faruk Pasic, Florian Kiss, Florian Asperger, Diego Dupleich, Stefan Schwarz +1 more
published similarity 0.62
Abstract · Submitted to the 21th European Conference on Antennas and Propagation (EuCAP), 2027

Future wireless systems for indoor applications are expected to extend their operating frequencies from sub-6 GHz to mid-band and millimeter wave (mmWave) frequencies to support higher data rates. To characterize the frequency-dependent propagation behavior across these bands, multi-band channel measurements are essential. In this work, we conduct double-directional multiple-input multiple-output (MIMO) channel measurements in an indoor environment to enable a consistent comparison across three frequency bands. Measurements are performed using a 16x16 MIMO configuration at center frequencies of 2.55 GHz, 12.75 GHz and 25.5 GHz, covering both line-of-sight (LOS) and obstructed line-of-sight (OLOS) conditions. The measured channels are processed using the space-alternating generalized expectation maximization (SAGE) algorithm to extract multipath parameters, which are subsequently used to characterize the angular power distributions across the three frequency bands. The results show substantial angular-domain similarity across all three bands in both LOS and OLOS conditions, while also highlighting frequency-dependent variations.

0.31

Measurement-Based FR3 Urban Macrocell Channel Characterization and Coverage Analysis

eess.SP ·2026-09-20 ·Enrui Liu, Pan Tang, Haiyang Miao, Qi Zhen, Jianhua Zhang
similarity 0.59
Abstract · 6 pages, 11 figures, conference

The 6--18~GHz upper mid-band is a promising spectrum range for future sixth-generation (6G) networks due to its favorable balance between available bandwidth and propagation capability, while its same-site coverage performance remains a key deployment concern. This paper presents a wideband channel measurement campaign at 13 spatially aligned frequency points from 6 to 18~GHz in an urban macrocell (UMa) environment, and investigates the frequency evolution of channel characteristics and same-site coverage capability. The results show that path loss generally increases with frequency, while the higher-frequency channels tend to exhibit smaller root-mean-square (RMS) delay spread (DS) and larger PDP-based $K$-factors. Based on the measured path-loss characteristics, the additional link-budget requirement and service-aware same-site coverage are further evaluated. Under the baseline service configuration, the 80\% coverage distance $d_{80}$ decreases from approximately 129~m at 6~GHz to 58~m at 18~GHz. Further analysis quantifies the impacts of service rate, resource allocation, interference, and link-budget degradation on coverage, providing measurement-based insights for same-site deployment across the 6--18~GHz band.

0.20

Positioning with Flexible Reflectors: Solution and Performance Analysis

cs.IT ·2026-08-14 ·Jiajun He, Han Yu, Danyan Lin, Gaofeng Pan, Hing Cheung So +2 more
publishedtheory similarity 0.51
Abstract

Flexible reflectors (FRs) have emerged as a low-cost and energy-efficient solution for reshaping electromagnetic propagation environments across a wide range of applications. This paper investigates FR-swarm-assisted target localization in scenarios where line-of-sight (LoS) paths are unavailable. By leveraging the virtual LoS paths created by the FRs, a simple yet accurate estimator is proposed for localization under severe blockage conditions. To characterize the performance limits of the proposed scheme, we derive the Cramer-Rao lower bound (CRLB) and use it to optimize the positions and orientations of the FRs. Furthermore, by accounting for random FR deployment, we characterize the CRLB distribution and reveal how different network configurations affect localization accuracy. Simulation results demonstrate that the developed scheme closely approaches the CRLB performance, while the derived analytical results provide useful guidelines for FR deployment and network design.

0.17

Map-Free Single-Anchor Position Localization Using Multipath Uncertainty at Upper Mid-Band

eess.SP ·2026-09-08 ·Xingchen Liu, Mingjun Ying, Xinquan Wang, Dipankar Shakya, Homa Nikbakht +2 more
published similarity 0.51
Abstract · 6 pages, 5 figures. Accepted for presentation at the 2026 IEEE Global Communications Conference (GLOBECOM), Macao, China, December 2026

Future 5G-Advanced and 6G systems will exploit directional wideband channels for path-based localization, yet map-free indoor positioning remains challenging because extracted multipath components (MPCs) vary widely in localization reliability. This paper presents an uncertainty-aware map-free single-anchor localization framework using 16.95~GHz indoor directional channel measurements collected at NYU WIRELESS in Brooklyn, New York. Per-MPC angular covariance is estimated from the local consistency of neighboring pattern-de-embedded power delay profile (PDP) observations and propagated into geometric localization through weighted fusion of point-type and line-type constraints. Measurements across 20 links with TX--RX separations from 11~m to 97~m show that the proposed covariance-weighted method achieves a mean localization error of 3.86~m, a median of 2.66~m, and 70\% of links within 5~m using five retained MPCs. It outperforms the power-weighted and unweighted variants under identical point/line constraints, as well as the literature baselines. These results indicate that local directional consistency provides reliability information beyond received power alone and demonstrate a practical map-free approach for future indoor directional systems.

0.50

Enhancing 3GPP Urban Channel Models For Terrestrial-to-Non-Terrestrial Communication

eess.SP ·2026-08-28 ·Gerhard Schreiber, Chenrui Sun, Joerg Schaepperle, Le-Hang Nguyen, Thorsten Wild
code/data similarity 0.50
Abstract

We have developed enhanced models for large-scale channel parameters intended for terrestrial-to-non-terrestrial (NTN) communication in Urban environments for supporting devices above ground levels, such as drones. The models are formulated as functions of terminal height above ground and elevation angle, applicable to S-Band and Ka-Band frequencies. To ensure realistic models, an open-source 3D scene generator was utilized to create a diverse set of urban scenes across Europe. Sionna ray-tracing was employed to generate path-gain samples for outdoor terminals, covering a range of heights up to 300 meters and elevation angles up to 90°. Our proposed analytical functions show excellent agreement to ray-tracing data for line-of-sight (LOS) probability, shadow-fading (SF), and clutter-loss (CL). Furthermore, a comparative coupling gain analysis with existing 3GPP models reveals notable differences, particularly caused by smaller CL and higher LOS probabilities from proposed models. Designed for ease of use, these models can be seamlessly integrated into simulation tools, offering a practical solution for researchers and engineers.

0.35

Near-Field MIMO LoS Channel Recovery Under User Antenna Asymmetry

eess.SP ·2026-09-23 ·Shima Eslami, Jarkko Kaleva, Antti Tölli
similarity 0.49
Abstract

Near-field (N-F) line-of-sight (LoS) MIMO channels admit a compact representation through a small number of geometric parameters describing the relative transceiver geometry, enabling low-overhead channel acquisition without estimating the full channel matrix. This paper considers downlink (DL) channel acquisition under practical asymmetric user-equipment (UE) antenna capabilities with multiple DL receive antennas, but only a single active uplink (UL) transmit chain. In this setting, UL observations across the large BS aperture enable accurate estimation of the relative location of the UL-active UE antenna but are insufficient to determine the orientation of the entire UE array. We propose a two-stage geometry-based N-F LoS MIMO channel acquisition framework that distributes the estimation of the channel-defining geometric parameters between the BS and UE. First, a single UL pilot sequence enables the BS to estimate two BS-side reference angles that parameterize the relative location of the UL-active UE antenna. The BS conveys these estimates to the UE and transmits two DL pilot sequences, from which the UE estimates the remaining array-orientation parameter. We derive Cramer-Rao lower bounds (CRLBs) for the first-stage parameters and a first-order error-covariance approximation for the UE orientation that explicitly captures the propagation of first-stage estimation uncertainty. Numerical results characterize the resulting error propagation and demonstrate accurate estimation of the geometric parameters and reconstruction of the LoS MIMO channel using one UL and two DL pilot sequences.

0.18