CS Paper Radar

Directional and Quasi-Omnidirectional Indoor Channel Measurements at Upper 6 GHz

Chengsong Fu, Hongbo Zhao, Jianer Zhou, Xiongbin Yu, Weichao Li, Chen Zhuang, Meng Li, Wenquan Feng, Xiaofeng Tao

cs.ET cs.IT ·submitted 2026-10-10 13:10 UTC · v2

Abstract

This paper presents wideband indoor channel measurements and measurement-based statistical modeling of channel parameters in the upper 6 GHz (U6G) band using directional and quasi-omnidirectional antenna pairs. Measurements span 6.425-7.125 GHz at 32 matched positions per configuration in an open hall and an L-shaped corridor. System calibration and frequency-dependent peak-gain normalization retain antenna radiation-pattern weighting. Close-in and floating-intercept models are fitted to line-of-sight (LOS) and non-LOS (NLOS) path loss, respectively. Shadow-fading residuals, RMS delay spread (DS), and equivalent K factors derived from power delay profiles are characterized. LOS exponents range from 1.98 to 2.14. Despite similar attenuation slopes, directional links exhibit smaller LOS residuals and DS and higher equivalent K factors. Hall DS medians are 1.78 and 36.52 ns for directional and quasi-omnidirectional links. Corridor NLOS slopes are -1.12 and 2.54, respectively, while DS ordering varies by position. These results characterize antenna-dependent parameters for U6G indoor channels.

Closest papers

Nearest neighbours by meaning across the whole index.

Wideband Channel Measurements in the Lower FR3 Band (6-12 GHz) for Industrial Environments

eess.SP ·2026-10-30 ·Faizan Rauf, Adam Umra, Oways Alsoloh, Aydin Sezgin
code/data similarity 0.73
Abstract

The upper mid-band, also known as Frequency Range 3 (FR3), spans 7.125-24.25 GHz and is a key candidate band for sixth-generation (6G) wireless communications. However, channel measurements in industrial environments remain scarce, and the 3GPP indoor-factory (InF) channel model, developed for omnidirectional antennas, has yet to be validated across the FR3 band. This paper presents a wideband channel measurement campaign in an industrial production hall, covering 135 line-of-sight (LOS) positions at 1-18 m and 30 non-line-of-sight (NLOS) positions behind an industrial robot at 2.5-16.5 m across 6-12 GHz. In LOS, the path-loss exponent ranged from 1.87 to 2.12, and the close-in fits agreed with the 3GPP InF-LOS model to within approximately 2 dB. However, shadow fading was only 1.4-1.7 dB, compared with the model's 4.3 dB. In NLOS, the robot caused an excess loss that increased from 10.3 to 13.0 dB between 6.5 and 11.5 GHz, consistent with diffraction. Blocking the direct path raised the mean directional delay spread from approximately 5 to 25 ns, close to omnidirectional values. These results indicate that the 3GPP InF model captures mean LOS path loss well but overestimates the variability of beam-aligned FR3 links, and that blockage loss in FR3 is frequency dependent. The dataset and processing code are publicly available.

0.28

Omnidirectional UMi Path Loss Models for 3GPP Extension Above 100 GHz Using Extensive Empirical Data Sets from 6.75 to 142 GHz

eess.SP ·2026-09-08 ·Xingchen Liu, Homa Nikbakht, Mingjun Ying, Dipankar Shakya, Hitesh Poddar +3 more
similarity 0.71
Abstract

Extending standardized urban microcell (UMi) path loss (PL) models from the upper mid-band (FR3) to sub-terahertz (sub-THz) frequencies requires measurement-based comparisons spanning a wide spectral range within a unified framework. In this paper, we derive single- and multi-frequency omnidirectional PL models for UMi environments based on extensive NYU WIRELESS measurements at 6.75, 16.95, 28, 73, and 142 GHz in line-of-sight (LOS) and non-line-of-sight (NLOS) conditions. Single-frequency close-in (CI) and floating-intercept (FI) models for each band show that CI yields more stable and physically interpretable parameters, with shadow fading standard deviations within 0.98 dB of FI across all five frequencies. We then extend the multi-frequency PL analysis to the 7-24 GHz, 0.5-100 GHz, and 0.5-150 GHz frequency ranges using CI, close-in with frequency weighting (CIF), and alpha-beta-gamma (ABG) models. Across progressively wider frequency spans, CI and CIF maintain stable distance exponents that remain closely aligned with the 3rd Generation Partnership Project (3GPP) UMi interpretations, whereas ABG offers only very modest reductions in fitting error at the cost of much greater parameter sensitivity. These results support physically anchored CI/CIF formulations with a close-in free space path loss anchor point at 1 m in order to extend 3GPP-oriented UMi PL models over the entire 0.5 to 150 GHz frequency range.

0.24

Multi-Band Indoor MIMO Channel Measurements Across Sub-6 GHz, Mid-Band and mmWave: Comparing 2.55 GHz, 12.75 GHz and 25.5 GHz

eess.SP ·2026-11-11 ·Faruk Pasic, Florian Kiss, Florian Asperger, Diego Dupleich, Stefan Schwarz +1 more
published similarity 0.66
Abstract · Submitted to the 21th European Conference on Antennas and Propagation (EuCAP), 2027

Future wireless systems for indoor applications are expected to extend their operating frequencies from sub-6 GHz to mid-band and millimeter wave (mmWave) frequencies to support higher data rates. To characterize the frequency-dependent propagation behavior across these bands, multi-band channel measurements are essential. In this work, we conduct double-directional multiple-input multiple-output (MIMO) channel measurements in an indoor environment to enable a consistent comparison across three frequency bands. Measurements are performed using a 16x16 MIMO configuration at center frequencies of 2.55 GHz, 12.75 GHz and 25.5 GHz, covering both line-of-sight (LOS) and obstructed line-of-sight (OLOS) conditions. The measured channels are processed using the space-alternating generalized expectation maximization (SAGE) algorithm to extract multipath parameters, which are subsequently used to characterize the angular power distributions across the three frequency bands. The results show substantial angular-domain similarity across all three bands in both LOS and OLOS conditions, while also highlighting frequency-dependent variations.

0.40

Measurement-Based FR3 Urban Macrocell Channel Characterization and Coverage Analysis

eess.SP ·2026-09-20 ·Enrui Liu, Pan Tang, Haiyang Miao, Qi Zhen, Jianhua Zhang
similarity 0.64
Abstract · 6 pages, 11 figures, conference

The 6--18~GHz upper mid-band is a promising spectrum range for future sixth-generation (6G) networks due to its favorable balance between available bandwidth and propagation capability, while its same-site coverage performance remains a key deployment concern. This paper presents a wideband channel measurement campaign at 13 spatially aligned frequency points from 6 to 18~GHz in an urban macrocell (UMa) environment, and investigates the frequency evolution of channel characteristics and same-site coverage capability. The results show that path loss generally increases with frequency, while the higher-frequency channels tend to exhibit smaller root-mean-square (RMS) delay spread (DS) and larger PDP-based $K$-factors. Based on the measured path-loss characteristics, the additional link-budget requirement and service-aware same-site coverage are further evaluated. Under the baseline service configuration, the 80\% coverage distance $d_{80}$ decreases from approximately 129~m at 6~GHz to 58~m at 18~GHz. Further analysis quantifies the impacts of service rate, resource allocation, interference, and link-budget degradation on coverage, providing measurement-based insights for same-site deployment across the 6--18~GHz band.

0.20

Beyond TR 38.811 for 6G NTN Channel Models

eess.SP ·2026-11-02 ·Kuan-Po Chiu, Aaron Jacob Buck, Sumit Roy
similarity 0.62
Abstract

As the 3rd Generation Partnership Project (3GPP) expands 6G non-terrestrial network (NTN) to S, Ku, and Ka bands for integration with existing terrestrial cellular networks, the necessary satellite channel model for link and network performance evaluation remains tied to TR 38.811, last revised in 2020. We identify issues on multiple fronts: inappropriate parameter specifications based on very limited site-specific environments considered, omission of satellite-induced Doppler spread and directional antenna effects and lack of a transparent channel model generation procedure. To address these limitations, we re-derive the channel parameters using ray tracing (RT) over urban and rural environments based on ITU-R building statistics. Our results show that TR 38.811 substantially overestimates the K-factor at low elevations and predicts a decreasing trend with elevation, which is inconsistent with RT. The Ka-band clutter loss (CL) also exceeds the RT estimates by more than 15 dB in urban cases. It also underestimates rural delay spread (DS) at low elevations and predicts an elevation trend inconsistent with RT. We further quantify the previously neglected satellite-induced Doppler spread. Finally, we demonstrate that the conventional TR 38.811 channel generator significantly underestimates the K-factor in the presence of directional antenna (beamforming), while our modified generator substantially reduces this discrepancy.

0.30

Modeling Diffuse Scattering in Mobility Scenarios: Ray Tracing Model and Measurement Validation

eess.SP ·2026-10-14 ·Milica Djordjevic, Thomas Wilding, Anja Dakić, Benjamin Rainer, Markus Hofer +1 more
code/data similarity 0.61
Abstract · Submitted to EuCAP 2027

Open-source ray tracing (RT) frameworks are increasingly used for site-specific channel modeling due to their reproducibility and extensibility. In non-stationary mobility scenarios, repeated RT evaluations can generate different diffuse propagation paths without preserving their correspondence, limiting a consistent representation of their temporal evolution. To address this limitation, we extend diffuse scattering modeling in Sionna RT using persistent surface-associated scattering points. Their positions remain fixed, while their contributions evolve according to changes in the propagation geometry and visibility. The proposed approach is validated using empirical radio channel impulse response measurements in an urban vehicular scenario at 5.9 GHz. Compared with the standard Sionna RT baseline, the proposed model shows improved agreement with measurements in the delay and Doppler domains.

0.28

Map-Free Single-Anchor Position Localization Using Multipath Uncertainty at Upper Mid-Band

eess.SP ·2026-09-08 ·Xingchen Liu, Mingjun Ying, Xinquan Wang, Dipankar Shakya, Homa Nikbakht +2 more
published similarity 0.60
Abstract · 6 pages, 5 figures. Accepted for presentation at the 2026 IEEE Global Communications Conference (GLOBECOM), Macao, China, December 2026

Future 5G-Advanced and 6G systems will exploit directional wideband channels for path-based localization, yet map-free indoor positioning remains challenging because extracted multipath components (MPCs) vary widely in localization reliability. This paper presents an uncertainty-aware map-free single-anchor localization framework using 16.95~GHz indoor directional channel measurements collected at NYU WIRELESS in Brooklyn, New York. Per-MPC angular covariance is estimated from the local consistency of neighboring pattern-de-embedded power delay profile (PDP) observations and propagated into geometric localization through weighted fusion of point-type and line-type constraints. Measurements across 20 links with TX--RX separations from 11~m to 97~m show that the proposed covariance-weighted method achieves a mean localization error of 3.86~m, a median of 2.66~m, and 70\% of links within 5~m using five retained MPCs. It outperforms the power-weighted and unweighted variants under identical point/line constraints, as well as the literature baselines. These results indicate that local directional consistency provides reliability information beyond received power alone and demonstrate a practical map-free approach for future indoor directional systems.

0.50

Channel Measurement and Characteristics Analysis for Indoor Flexible Pinching Antenna Systems in the mmWave Band

eess.SY ·2026-10-30 ·Haoyang Li, Weidong Liu, Songjiang Yang, Zhensheng Chen, Jing Zhu +2 more
similarity 0.60
Abstract

Pinching antenna (PA) systems offer flexible antenna configurations for future wireless communications, yet how PA geometry, orientation, and position affect channel characteristics in practical environments remains insufficiently studied. To address this gap, this paper first presents an indoor PA system channel measurement campaign at 59.5~GHz. A dedicated time-domain channel sounder is developed with frequency conversion and a circular-waveguide-to-dielectric-waveguide transition to feed the radio frequency (RF) signal into a flexible dielectric waveguide. Using this platform, office measurements quantify channel attenuation and channel characteristics by examining four PA geometries, arc PA orientation, circle PA pinching position, and transmitter--receiver height difference. The channel measurement data are analyzed in terms of path loss, shadow fading, root-mean-square (RMS) delay spread, Rician K-factor, normalized capacity, and spatial similarity. Indoor path loss models for PA systems are fitted for each PA geometry. The results reveal geometry-dependent attenuation and shadow-fading variability, with the arc PA showing greater variability than the circle PA. Arc PA rotation shifts the delay spread and conditional K-factor distributions. Moving the circle PA produces nonmonotonic changes in delay spread and normalized capacity, while spatial similarity remains relatively high at many receiver locations as the pinching position changes. These observations provide an empirical basis for PA systems channel model and system design.

0.28