CS Paper Radar

Modeling Diffuse Scattering in Mobility Scenarios: Ray Tracing Model and Measurement Validation

Milica Djordjevic, Thomas Wilding, Anja Dakić, Benjamin Rainer, Markus Hofer, Thomas Zemen

eess.SP ·submitted 2026-10-14 15:52 UTC · v2
code/data

Abstract

Open-source ray tracing (RT) frameworks are increasingly used for site-specific channel modeling due to their reproducibility and extensibility. In non-stationary mobility scenarios, repeated RT evaluations can generate different diffuse propagation paths without preserving their correspondence, limiting a consistent representation of their temporal evolution. To address this limitation, we extend diffuse scattering modeling in Sionna RT using persistent surface-associated scattering points. Their positions remain fixed, while their contributions evolve according to changes in the propagation geometry and visibility. The proposed approach is validated using empirical radio channel impulse response measurements in an urban vehicular scenario at 5.9 GHz. Compared with the standard Sionna RT baseline, the proposed model shows improved agreement with measurements in the delay and Doppler domains.

Comment
Submitted to EuCAP 2027

Closest papers

Nearest neighbours by meaning across the whole index.

An Open-Source Hybrid Ray-Tracing and 3GPP Channel Simulator for Non-Terrestrial Network

eess.SY ·2026-10-27 ·Yu-Chien Lin, Cheng-Yi Chang, Yen-Cheng Lai, Ming-Chun Lee, Ta-Sung Lee
code/data similarity 0.66
Abstract

This paper proposes a hybrid channel simulation framework that combines site-specific ray tracing (RT) with 3GPP-compliant statistical channel simulation for non-terrestrial networks (NTNs). The proposed approach uses RT to generate dominant propagation paths and augments them with statistically generated paths and subpaths to provide richer multipath realizations under practical simulation complexity. To provide a complete simulation framework, we integrate Sionna RT, 3GPP, and hybrid RT-3GPP simulators within a unified workflow. Simulation results based on key channel statistics and power delay profiles show that the proposed method preserves site-specific propagation characteristics while providing sufficiently rich multipath components, thereby addressing the complementary limitations of conventional RT-based and purely statistical NTN channel simulators. The developed simulator is also released as an open-source project to support reproducibility and further NTN research.

0.33

Beyond TR 38.811 for 6G NTN Channel Models

eess.SP ·2026-11-02 ·Kuan-Po Chiu, Aaron Jacob Buck, Sumit Roy
similarity 0.66
Abstract

As the 3rd Generation Partnership Project (3GPP) expands 6G non-terrestrial network (NTN) to S, Ku, and Ka bands for integration with existing terrestrial cellular networks, the necessary satellite channel model for link and network performance evaluation remains tied to TR 38.811, last revised in 2020. We identify issues on multiple fronts: inappropriate parameter specifications based on very limited site-specific environments considered, omission of satellite-induced Doppler spread and directional antenna effects and lack of a transparent channel model generation procedure. To address these limitations, we re-derive the channel parameters using ray tracing (RT) over urban and rural environments based on ITU-R building statistics. Our results show that TR 38.811 substantially overestimates the K-factor at low elevations and predicts a decreasing trend with elevation, which is inconsistent with RT. The Ka-band clutter loss (CL) also exceeds the RT estimates by more than 15 dB in urban cases. It also underestimates rural delay spread (DS) at low elevations and predicts an elevation trend inconsistent with RT. We further quantify the previously neglected satellite-induced Doppler spread. Finally, we demonstrate that the conventional TR 38.811 channel generator significantly underestimates the K-factor in the presence of directional antenna (beamforming), while our modified generator substantially reduces this discrepancy.

0.30

Enhancing 3GPP Urban Channel Models For Terrestrial-to-Non-Terrestrial Communication

eess.SP ·2026-08-28 ·Gerhard Schreiber, Chenrui Sun, Joerg Schaepperle, Le-Hang Nguyen, Thorsten Wild
code/data similarity 0.65
Abstract

We have developed enhanced models for large-scale channel parameters intended for terrestrial-to-non-terrestrial (NTN) communication in Urban environments for supporting devices above ground levels, such as drones. The models are formulated as functions of terminal height above ground and elevation angle, applicable to S-Band and Ka-Band frequencies. To ensure realistic models, an open-source 3D scene generator was utilized to create a diverse set of urban scenes across Europe. Sionna ray-tracing was employed to generate path-gain samples for outdoor terminals, covering a range of heights up to 300 meters and elevation angles up to 90°. Our proposed analytical functions show excellent agreement to ray-tracing data for line-of-sight (LOS) probability, shadow-fading (SF), and clutter-loss (CL). Furthermore, a comparative coupling gain analysis with existing 3GPP models reveals notable differences, particularly caused by smaller CL and higher LOS probabilities from proposed models. Designed for ease of use, these models can be seamlessly integrated into simulation tools, offering a practical solution for researchers and engineers.

0.35

A Novel BVH-accelerated Dynamic Ray-Tracing Channel Model for Vehicular Communication Systems

eess.SP ·2026-11-05 ·Songjiang Yang, Cheng-Xiang Wang, Yinghua Wang, Chen Wang, Jie Huang +1 more
published similarity 0.63
Abstract

Accurate and efficient channel modeling is critical for evaluating the sixth-generation (6G) networks, while dynamic ray-tracing (DRT) remains bottlenecked by its reliance on channel coherence time. To address this limitation, this paper proposes a novel bounding volume hierarchy-accelerated DRT (BVH-DRT), which introduces a mechanism shift from a time-driven update in DRT to a spatial-driven update. The proposed channel model clusters complex scatterers using the BVH method as pre-processing to establish a geometric coherence distance guided by transceiver kinematics, so that the ray update intervals in BVH-DRT can be autonomously adjusted to reduce the complexity. Furthermore, the non-stationary channel impulse responses are generated to evaluate delay-Doppler (DD) domain waveforms, including orthogonal time frequency space (OTFS) and orthogonal delay-Doppler division multiplexing (ODDM). Validations in vehicle-to-vehicle (V2V) scenarios demonstrate that BVH-DRT achieves spatial-temporal consistency with measurements and commercial software while significantly enhancing computational efficiency. Additionally, bit error rate (BER) evaluation highlights the severe impact of high-dynamic channels on waveform performance. The proposed framework is important for designing reliable communications and robust sensing in 6G networks.

0.41

Highly Detailed Simulation for Connected Automated Vehicle Cooperative Driving

cs.NI ·2026-09-01 ·Andrei Fizulin, Ilia Dolgov, Andrei Karpukhin
published similarity 0.61
Abstract · 6 pages, 5 figures. Published in the 2026 International Russian Smart Industry Conference (SmartIndustryCon)

End-to-end simulation of connected and automated vehicles requires consistent fidelity across mobility, environment modeling, V2X radio propagation, and decision-making/control modules. However, 2D representations of complex road infrastructure often fail to capture critical signal propagation dynamics, leading to overly optimistic connectivity assumptions. This paper presents a unified workflow within CAVISE that integrates map-based scene preparation with microscopic mobility simulation. The proposed framework incorporates a comparative analysis of trace-driven propagation in 3D versus a simplified 2D baseline, and a modular interface for integrating Autonomous Intersection Management (AIM) models. Collectively, these capabilities enable high-fidelity Cooperative Driving Automation (CDA) experiments. Leveraging ray tracing using Sionna RT at 5.9 GHz with the same radio and solver configuration for both geometry variants, we show that planar reduction in multi-level road infrastructure can remove physically present occlusions and substantially distort signal-loss dynamics. In a bridge overpass case study, the 2D baseline eliminates an occlusion interval observed in 3D, changing the outage behavior from intermittent to consistently connected and yielding an average signal-loss shift on the order of 10 dB. These propagation-induced biases highlight the inability of planar models to capture vertical occlusions, necessitating 3D-aware communication modeling to ensure the validity of cooperative driving automation and intersection control evaluations.

0.43

Directional and Quasi-Omnidirectional Indoor Channel Measurements at Upper 6 GHz

cs.ET cs.IT ·2026-10-10 ·Chengsong Fu, Hongbo Zhao, Jianer Zhou, Xiongbin Yu, Weichao Li +4 more
similarity 0.61
Abstract

This paper presents wideband indoor channel measurements and measurement-based statistical modeling of channel parameters in the upper 6 GHz (U6G) band using directional and quasi-omnidirectional antenna pairs. Measurements span 6.425-7.125 GHz at 32 matched positions per configuration in an open hall and an L-shaped corridor. System calibration and frequency-dependent peak-gain normalization retain antenna radiation-pattern weighting. Close-in and floating-intercept models are fitted to line-of-sight (LOS) and non-LOS (NLOS) path loss, respectively. Shadow-fading residuals, RMS delay spread (DS), and equivalent K factors derived from power delay profiles are characterized. LOS exponents range from 1.98 to 2.14. Despite similar attenuation slopes, directional links exhibit smaller LOS residuals and DS and higher equivalent K factors. Hall DS medians are 1.78 and 36.52 ns for directional and quasi-omnidirectional links. Corridor NLOS slopes are -1.12 and 2.54, respectively, while DS ordering varies by position. These results characterize antenna-dependent parameters for U6G indoor channels.

0.12

Vehicle and UAV Detection and Tracking with LTE Downlink Reference Signals: A Ray-Traced Evaluation on a Mapped Suburban Site with Licensed Base-Station Records

cs.NI ·2026-11-01 ·Arun K. Gurung, Satha K. Sathananthan
similarity 0.60
Abstract · 18 pages, 7 figures, 14 tables. Revised version

Passive sensing on the cellular downlink places the receiver at the user equipment and changes nothing in the network. We report simulation results for an LTE band-3 cell-specific reference signal arm on a ray-traced channel. On a synthetic street canyon the arm is compared with an uplink sounding reference signal arm on the same band, target and scorer: missed-detection probabilities of 0.667 and 0.772. On a surveyed site built from OpenStreetMap footprints and the licensed site record, nine receiver positions along the street track the vehicle at coverage between 29.9 % and 61.7 %; a 283 m lap separates target height from trajectory at 1.6 to 30 m; a 137 m lap on the built-up street tracks a vehicle and a 15 m airborne target on every cell, and 8 receivers at 135 m spacing carry one illuminator's coverage over 1140 m of the street. Potential future work includes extending the analysis to multiple illuminators and varying receiver configurations, and confirmation through over-the-air measurements.

0.34

How Temporal Dispersion of Radio Channels Depends on Signal Bandwidth

eess.SP ·2026-11-02 ·Jarosław Wojtuń, Tomasz Grasza, Cezary Ziółkowski, Jan M. Kelner, Aniruddha Chandra +5 more
publishedhighly cited similarity 0.59
Abstract · 5 pages, 6 figures, 2 tables, 6 equations

The degree of temporal dispersion of a radio channel is the basis for assessing its transmission capabilities. This paper addresses the practical issue of measuring the temporal parameters of a signal transmitted in the millimeter-wave (38 GHz) range. These parameters provide the basis for assessing the degree of dispersion of the received signal. The measurement results show that both the mean and RMS values of the delay spread depend on the distance between the transmitter and receiver as well as the bandwidth of the transmitted signals. The function description of these relationships (model) is determined based on a statistical analysis of the obtained measurement data obtained in a selected indoor corridor under line-of-sight conditions.

0.53