CS Paper Radar

An Open-Source Hybrid Ray-Tracing and 3GPP Channel Simulator for Non-Terrestrial Network

Yu-Chien Lin, Cheng-Yi Chang, Yen-Cheng Lai, Ming-Chun Lee, Ta-Sung Lee

eess.SY ·submitted 2026-10-27 16:54 UTC · v1
code/data

Abstract

This paper proposes a hybrid channel simulation framework that combines site-specific ray tracing (RT) with 3GPP-compliant statistical channel simulation for non-terrestrial networks (NTNs). The proposed approach uses RT to generate dominant propagation paths and augments them with statistically generated paths and subpaths to provide richer multipath realizations under practical simulation complexity. To provide a complete simulation framework, we integrate Sionna RT, 3GPP, and hybrid RT-3GPP simulators within a unified workflow. Simulation results based on key channel statistics and power delay profiles show that the proposed method preserves site-specific propagation characteristics while providing sufficiently rich multipath components, thereby addressing the complementary limitations of conventional RT-based and purely statistical NTN channel simulators. The developed simulator is also released as an open-source project to support reproducibility and further NTN research.

Closest papers

Nearest neighbours by meaning across the whole index.

Modeling Diffuse Scattering in Mobility Scenarios: Ray Tracing Model and Measurement Validation

eess.SP ·2026-10-14 ·Milica Djordjevic, Thomas Wilding, Anja Dakić, Benjamin Rainer, Markus Hofer +1 more
code/data similarity 0.66
Abstract · Submitted to EuCAP 2027

Open-source ray tracing (RT) frameworks are increasingly used for site-specific channel modeling due to their reproducibility and extensibility. In non-stationary mobility scenarios, repeated RT evaluations can generate different diffuse propagation paths without preserving their correspondence, limiting a consistent representation of their temporal evolution. To address this limitation, we extend diffuse scattering modeling in Sionna RT using persistent surface-associated scattering points. Their positions remain fixed, while their contributions evolve according to changes in the propagation geometry and visibility. The proposed approach is validated using empirical radio channel impulse response measurements in an urban vehicular scenario at 5.9 GHz. Compared with the standard Sionna RT baseline, the proposed model shows improved agreement with measurements in the delay and Doppler domains.

0.28

Joint Delay--Doppler Modeling of Multipath LEO Channels

eess.SP ·2026-11-02 ·Kuan-Po Chiu, Sumit Roy
hot direction similarity 0.65
Abstract

Multipath channel models for Low-Earth-orbit (LEO) non-terrestrial network (NTN) must contend with time variability due to rapid satellite orbital motion that in turn impacts local (near terrestrial) scattering near the ground terminal (GT) receiver. While 3GPP-defined NTN channel model pipelines TR 38.811, 38.901 incorporate elevation-dependence into statistical channel generators, these are inherited largely from 2-D terrestrial propagation and are largely insufficient. Further, they do not prescribe any integrated workflow that is broadly available for generating joint delay, Doppler/phase and component multipath power profiles as a function of satellite location over a pass. This work addresses this gap by developing a geometry-based stochastic channel model driven by prescribed slant range, elevation, and azimuth over a LEO pass. A ground scene generates wall-reflected, ground-reflected, and roof-edge-diffracted components, from which joint delay-Doppler statistics and temporal channel impulse response (CIR) evolution are obtained. The resulting locally wide-sense stationary tapped-delay-line CIR enables analysis of key statistics such as the $K$-factor of the taps, multipath delay and Doppler spreads as a function of elevation and scene parameters. Depending on the scenarios (urban and rural), our model-based results show that with omnidirectional antennas, the LoS probability, delay-spread and $K$-factor trends broadly match 3GPP NTN models in TR 38.811 as a function of elevation. Beamforming instead produces a mid-elevation $K$-factor peak, which is not predicted by TR 38.811 and 6G NTN. Doppler spreads are smaller than those from our previous model and QuaDriGa because the proposed model accounts for path existence. Stationarity durations for CIR are reported and generally decrease with elevation, but with local increases at mid-elevation due to path geometry effects.

0.56

Enhancing 3GPP Urban Channel Models For Terrestrial-to-Non-Terrestrial Communication

eess.SP ·2026-08-28 ·Gerhard Schreiber, Chenrui Sun, Joerg Schaepperle, Le-Hang Nguyen, Thorsten Wild
code/data similarity 0.63
Abstract

We have developed enhanced models for large-scale channel parameters intended for terrestrial-to-non-terrestrial (NTN) communication in Urban environments for supporting devices above ground levels, such as drones. The models are formulated as functions of terminal height above ground and elevation angle, applicable to S-Band and Ka-Band frequencies. To ensure realistic models, an open-source 3D scene generator was utilized to create a diverse set of urban scenes across Europe. Sionna ray-tracing was employed to generate path-gain samples for outdoor terminals, covering a range of heights up to 300 meters and elevation angles up to 90°. Our proposed analytical functions show excellent agreement to ray-tracing data for line-of-sight (LOS) probability, shadow-fading (SF), and clutter-loss (CL). Furthermore, a comparative coupling gain analysis with existing 3GPP models reveals notable differences, particularly caused by smaller CL and higher LOS probabilities from proposed models. Designed for ease of use, these models can be seamlessly integrated into simulation tools, offering a practical solution for researchers and engineers.

0.35

Ray Tracing-Based LoRaWAN Gateway Placement for Reliable Connectivity in Amazonian Regions

cs.NI ·2026-08-31 ·Cláudio Modesto, Lucas Mozart, Cleverson Nahum, Bruno Castro, Aldebaro Klautau
similarity 0.63
Abstract · 5 pages, 2 tables and 5 figures

Network planning is an important task in wireless communications, as it helps network operators avoid unnecessary costs. In the context of the internet of things, using long-range wide-area network technologies in the Amazon rainforest, a key challenge is ensuring reliable communication between end-devices and gateways (GWs). In this sense, this reliability is strongly affected by channel conditions. Thus, during the planning phase, choosing the appropriate channel model is an important decision for accurate simulations. Given this motivation, in this work, we propose an optimization model to evaluate the impact of different types of channels on coverage and packet delivery ratio in a forest scenario. We used channels from ray tracing, empirical, and stochastic approaches to assess how decisions made during the network planning phase, in terms of the channel used, affect GW placement and, specifically, the percentage of end-devices covered and the reliability of the communication system. Our results show that GW placement based on site-independent channels can overestimate the number of GWs required to meet the network requirements, whereas using site-specific channels allows us to satisfy the same requirements with fewer GWs.

0.36

A Novel Dynamic Ray-Tracing Channel Model for 6G LEO Satellite-to-Ground Communication Systems

eess.SP ·2026-09-26 ·Songjiang Yang, Cheng-Xiang Wang, Yinghua Wang, Jie Huang, Yuyang Zhou +2 more
top venue similarity 0.62
Abstract

The sixth generation (6G) communication systems envision a space-air-ground integrated network, making accurate satellite-to-ground (S2G) channel modeling crucial for communication systems design. Currently, the majority of S2G channel models rely on stochastic methods, which cannot provide multipath information based on realistic satellite orbits and environments. In this paper, we propose a novel low Earth orbit (LEO) S2G channel model based on dynamic ray-tracing to overcome the challenges of tracking rays for long-distance propagation by setting a virtual transmission plane (VTP). Moreover, since the line-of-sight propagation mechanism contributes the most power to satellite communications, the VTP is constructed based on the first Fresnel zone to generate parallel rays close to the ground. The realistic satellite orbit and environmental information are used in the proposed LEO S2G ray-tracing channel model to compute channel characteristics. The results show that the proposed LEO S2G ray-tracing channel model can accurately generate the channel characteristics based on the satellite orbits. The channel characteristics of LEO S2G communications computed by the proposed ray-tracing method can well match the channel measurements.

0.56

Beyond TR 38.811 for 6G NTN Channel Models

eess.SP ·2026-11-02 ·Kuan-Po Chiu, Aaron Jacob Buck, Sumit Roy
similarity 0.62
Abstract

As the 3rd Generation Partnership Project (3GPP) expands 6G non-terrestrial network (NTN) to S, Ku, and Ka bands for integration with existing terrestrial cellular networks, the necessary satellite channel model for link and network performance evaluation remains tied to TR 38.811, last revised in 2020. We identify issues on multiple fronts: inappropriate parameter specifications based on very limited site-specific environments considered, omission of satellite-induced Doppler spread and directional antenna effects and lack of a transparent channel model generation procedure. To address these limitations, we re-derive the channel parameters using ray tracing (RT) over urban and rural environments based on ITU-R building statistics. Our results show that TR 38.811 substantially overestimates the K-factor at low elevations and predicts a decreasing trend with elevation, which is inconsistent with RT. The Ka-band clutter loss (CL) also exceeds the RT estimates by more than 15 dB in urban cases. It also underestimates rural delay spread (DS) at low elevations and predicts an elevation trend inconsistent with RT. We further quantify the previously neglected satellite-induced Doppler spread. Finally, we demonstrate that the conventional TR 38.811 channel generator significantly underestimates the K-factor in the presence of directional antenna (beamforming), while our modified generator substantially reduces this discrepancy.

0.30

A Novel BVH-accelerated Dynamic Ray-Tracing Channel Model for Vehicular Communication Systems

eess.SP ·2026-11-05 ·Songjiang Yang, Cheng-Xiang Wang, Yinghua Wang, Chen Wang, Jie Huang +1 more
published similarity 0.58
Abstract

Accurate and efficient channel modeling is critical for evaluating the sixth-generation (6G) networks, while dynamic ray-tracing (DRT) remains bottlenecked by its reliance on channel coherence time. To address this limitation, this paper proposes a novel bounding volume hierarchy-accelerated DRT (BVH-DRT), which introduces a mechanism shift from a time-driven update in DRT to a spatial-driven update. The proposed channel model clusters complex scatterers using the BVH method as pre-processing to establish a geometric coherence distance guided by transceiver kinematics, so that the ray update intervals in BVH-DRT can be autonomously adjusted to reduce the complexity. Furthermore, the non-stationary channel impulse responses are generated to evaluate delay-Doppler (DD) domain waveforms, including orthogonal time frequency space (OTFS) and orthogonal delay-Doppler division multiplexing (ODDM). Validations in vehicle-to-vehicle (V2V) scenarios demonstrate that BVH-DRT achieves spatial-temporal consistency with measurements and commercial software while significantly enhancing computational efficiency. Additionally, bit error rate (BER) evaluation highlights the severe impact of high-dynamic channels on waveform performance. The proposed framework is important for designing reliable communications and robust sensing in 6G networks.

0.41

Site-specific Channel Modeling Based on Remote-Sensing Maps for 6G Space--Air--Ground Digital Twins

eess.SP ·2026-08-31 ·Peijie Liu, Pan Tang, Jianhua Zhang, Lei Tian, Bin Ao +2 more
similarity 0.58
Abstract · 17 pages, 23 figures, 4 tables

Site-specific channel models are essential for wireless digital twins of 6G space--air--ground communication systems. However, 3D maps are difficult to obtain over wide areas, which limits large-area site-specific channel modeling. To address this issue, this paper proposes a remote-sensing-based augmented ray-tracing channel modeling framework. The framework comprises a deterministic RT branch, a measurement-statistical branch, and an RT augmentation branch. To overcome the difficulty of acquiring large-area 3D maps, the deterministic RT branch reconstructs a 3D RT scene from satellite remote-sensing imagery and calibrates its electromagnetic material parameters using measured path loss. To provide the statistical parameters required for RT augmentation, the measurement-statistical branch establishes the marginal distributions and interparameter dependence models of the channel parameters. Specifically, a wideband UAV channel measurement campaign is conducted at 4.60 GHz, and a proposed multipath estimation method estimates the complex amplitudes, delays, and Doppler shifts of the measured multipath. To bridge the gap between RT predictions and measurements, the RT augmentation branch organizes the RT multipath into LoS, LoS-tail, and NLoS components, generates additional short-delay LoS-tail paths, and reallocates the component and path powers according to the measurement-derived statistics while preserving the total RT received power. The validation results show that the proposed framework reduces the path loss RMSE from 5.45 to 4.35 dB and, relative to calibrated RT, decreases the RMS delay spread and normalized Doppler spread RMSEs by 53.03 and 26.48, respectively. The proposed framework provides a site-specific channel modeling approach for 6G space--air--ground digital-twin studies.

0.26