CS Paper Radar

How Temporal Dispersion of Radio Channels Depends on Signal Bandwidth

Jarosław Wojtuń, Tomasz Grasza, Cezary Ziółkowski, Jan M. Kelner, Aniruddha Chandra, Radek Zavorka, Josef Vychodil, Jiri Blumenstein, Tomas Mikulasek, Ales Prokes

eess.SP ·submitted 2026-11-02 12:45 UTC · v1
publishedhighly cited

Abstract

The degree of temporal dispersion of a radio channel is the basis for assessing its transmission capabilities. This paper addresses the practical issue of measuring the temporal parameters of a signal transmitted in the millimeter-wave (38 GHz) range. These parameters provide the basis for assessing the degree of dispersion of the received signal. The measurement results show that both the mean and RMS values of the delay spread depend on the distance between the transmitter and receiver as well as the bandwidth of the transmitted signals. The function description of these relationships (model) is determined based on a statistical analysis of the obtained measurement data obtained in a selected indoor corridor under line-of-sight conditions.

Comment
5 pages, 6 figures, 2 tables, 6 equations
Journal ref
2026 20th European Conference on Antennas and Propagation (EuCAP), Dublin, Ireland, 19-24 April, 2026, pp. 1-5
DOI
10.23919/EuCAP68105.2026.11612563

Closest papers

Nearest neighbours by meaning across the whole index.

Assessing Temporal Dispersion of Time-Varying Channel at 38 GHz for Different Reference Signals

eess.SP cs.IT ·2026-11-01 ·Jarosław Wojtuń, Bartosz Czaja, Tomasz Grasza, Rafał Przesmycki, Jan M. Kelner +7 more
similarity 0.77
Abstract · 5 pages, 7 figures

This paper investigates the influence of reference waveform selection on temporal dispersion estimation in a time-varying radio channel at 38 GHz. Three reference waveforms-numerically generated in MATLAB, measured through a conducted connection, and recorded in an anechoic chamber -are compared using the same wideband channel measurements conducted in a dynamic road environment. Their effects on the estimated power delay profiles (PDPs), mean delay, and root mean square (RMS) delay spread are evaluated. Despite noticeable differences in the time-domain and spectral characteristics of the reference waveforms, the resulting PDPs exhibit similar multipath structures, while the estimated temporal dispersion parameters show relatively small differences. The results indicate limited sensitivity to reference waveform selection under the investigated measurement conditions.

0.49

Sensitivity of RMS Delay Spread Estimation to Power Delay Profile Thresholding in Time-Varying Channels at 33 GHz

cs.IT eess.SP ·2026-10-27 ·Jarosław Wojtuń, Bartosz Czaja, Tomasz Grasza, Jan M. Kelner, Cezary Ziółkowski +6 more
similarity 0.71
Abstract · 5 pages, 7 figures

Root mean square (RMS) delay spread is a key parameter characterizing temporal dispersion in radio propagation channels. Its estimation from measured power delay profiles (PDPs), however, depends strongly on the adopted power threshold. This paper investigates the sensitivity of RMS delay spread estimates to relative PDP thresholding in a time-varying millimeter-wave channel at 33 GHz. The analysis uses wideband channel sounding measurements conducted in a dynamic road environment with moving vehicles. The temporal evolution and empirical cumulative distributions of RMS delay spread are evaluated for thresholds ranging from -20 to -50 dB. Reducing the threshold increases the median RMS delay spread from approximately 140 to 168 ns and the 90th percentile from 200 to 210 ns. Both statistics converge at lower thresholds, with -40 dB providing a practical convergence level. The results emphasize the importance of threshold selection for reliable channel characterization and consistent comparison of measurements.

0.63

Static Multipath Suppression in Power Delay Profile of Time-Varying Channel at 28 GHz

eess.SP ·2026-10-27 ·Jarosław Wojtuń, Bartosz Czaja, Tomasz Grasza, Jan M. Kelner, Cezary Ziółkowski +6 more
unusual similarity 0.60
Abstract · 5 pages, 7 figures, 1 table

This paper investigates static multipath suppression in a time-varying radio channel at 28 GHz using wideband measurements conducted in a dynamic road environment. Two temporal differencing filters and three Doppler-domain notch filtering configurations are compared in terms of their effects on power delay profiles (PDPs) and root mean square (RMS) delay spread. The results demonstrate that all investigated methods effectively suppress stationary multipath components, improving the visibility of vehicle-related reflections. However, differences in filter frequency responses influence the relative powers of dynamic multipath components and the resulting RMS delay spread distributions. The findings highlight the importance of static multipath suppression and filter selection in characterizing time-varying propagation channels.

0.65

Directional and Quasi-Omnidirectional Indoor Channel Measurements at Upper 6 GHz

cs.ET cs.IT ·2026-10-10 ·Chengsong Fu, Hongbo Zhao, Jianer Zhou, Xiongbin Yu, Weichao Li +4 more
similarity 0.59
Abstract

This paper presents wideband indoor channel measurements and measurement-based statistical modeling of channel parameters in the upper 6 GHz (U6G) band using directional and quasi-omnidirectional antenna pairs. Measurements span 6.425-7.125 GHz at 32 matched positions per configuration in an open hall and an L-shaped corridor. System calibration and frequency-dependent peak-gain normalization retain antenna radiation-pattern weighting. Close-in and floating-intercept models are fitted to line-of-sight (LOS) and non-LOS (NLOS) path loss, respectively. Shadow-fading residuals, RMS delay spread (DS), and equivalent K factors derived from power delay profiles are characterized. LOS exponents range from 1.98 to 2.14. Despite similar attenuation slopes, directional links exhibit smaller LOS residuals and DS and higher equivalent K factors. Hall DS medians are 1.78 and 36.52 ns for directional and quasi-omnidirectional links. Corridor NLOS slopes are -1.12 and 2.54, respectively, while DS ordering varies by position. These results characterize antenna-dependent parameters for U6G indoor channels.

0.12

Modeling Diffuse Scattering in Mobility Scenarios: Ray Tracing Model and Measurement Validation

eess.SP ·2026-10-14 ·Milica Djordjevic, Thomas Wilding, Anja Dakić, Benjamin Rainer, Markus Hofer +1 more
code/data similarity 0.59
Abstract · Submitted to EuCAP 2027

Open-source ray tracing (RT) frameworks are increasingly used for site-specific channel modeling due to their reproducibility and extensibility. In non-stationary mobility scenarios, repeated RT evaluations can generate different diffuse propagation paths without preserving their correspondence, limiting a consistent representation of their temporal evolution. To address this limitation, we extend diffuse scattering modeling in Sionna RT using persistent surface-associated scattering points. Their positions remain fixed, while their contributions evolve according to changes in the propagation geometry and visibility. The proposed approach is validated using empirical radio channel impulse response measurements in an urban vehicular scenario at 5.9 GHz. Compared with the standard Sionna RT baseline, the proposed model shows improved agreement with measurements in the delay and Doppler domains.

0.28

People effects on IoT indoor wireless channel characterization

cs.NI ·2026-09-28 ·Millena Michely de Medeiros Campos, Mateus de Oliveira e Mattos, Rafael da Silva Macedo, Alvaro Augusto Machado de Medeiros, Wellerson Viana de Oliveira +1 more
publishedunusual similarity 0.56
Abstract

Wireless communication under 1 GHz is suitable for Internet of Things (IoT) applications due to larger coverage capability with less power consumption. Bearing in mind that people and elements contained in the environment can cause variations in the channel, this paper aims to evaluate the effect of the presence of people on a 900-MHz indoor narrowband wireless channel, as we characterize the small-scale phenomena. With the increase in the number of people, a greater variation in the communication channel was noticed, which is reflected in the parameters of the probability distributions used in the characterization of the random part of the signal. In addition, second-order statistics were used to analyze the data and an adherence test was applied to confirm the behavior of the signal in relation to the distributions.

0.41

Channel Measurement and Characteristics Analysis for Indoor Flexible Pinching Antenna Systems in the mmWave Band

eess.SY ·2026-10-30 ·Haoyang Li, Weidong Liu, Songjiang Yang, Zhensheng Chen, Jing Zhu +2 more
similarity 0.54
Abstract

Pinching antenna (PA) systems offer flexible antenna configurations for future wireless communications, yet how PA geometry, orientation, and position affect channel characteristics in practical environments remains insufficiently studied. To address this gap, this paper first presents an indoor PA system channel measurement campaign at 59.5~GHz. A dedicated time-domain channel sounder is developed with frequency conversion and a circular-waveguide-to-dielectric-waveguide transition to feed the radio frequency (RF) signal into a flexible dielectric waveguide. Using this platform, office measurements quantify channel attenuation and channel characteristics by examining four PA geometries, arc PA orientation, circle PA pinching position, and transmitter--receiver height difference. The channel measurement data are analyzed in terms of path loss, shadow fading, root-mean-square (RMS) delay spread, Rician K-factor, normalized capacity, and spatial similarity. Indoor path loss models for PA systems are fitted for each PA geometry. The results reveal geometry-dependent attenuation and shadow-fading variability, with the arc PA showing greater variability than the circle PA. Arc PA rotation shifts the delay spread and conditional K-factor distributions. Moving the circle PA produces nonmonotonic changes in delay spread and normalized capacity, while spatial similarity remains relatively high at many receiver locations as the pinching position changes. These observations provide an empirical basis for PA systems channel model and system design.

0.28

Measurement-Based FR3 Urban Macrocell Channel Characterization and Coverage Analysis

eess.SP ·2026-09-20 ·Enrui Liu, Pan Tang, Haiyang Miao, Qi Zhen, Jianhua Zhang
similarity 0.52
Abstract · 6 pages, 11 figures, conference

The 6--18~GHz upper mid-band is a promising spectrum range for future sixth-generation (6G) networks due to its favorable balance between available bandwidth and propagation capability, while its same-site coverage performance remains a key deployment concern. This paper presents a wideband channel measurement campaign at 13 spatially aligned frequency points from 6 to 18~GHz in an urban macrocell (UMa) environment, and investigates the frequency evolution of channel characteristics and same-site coverage capability. The results show that path loss generally increases with frequency, while the higher-frequency channels tend to exhibit smaller root-mean-square (RMS) delay spread (DS) and larger PDP-based $K$-factors. Based on the measured path-loss characteristics, the additional link-budget requirement and service-aware same-site coverage are further evaluated. Under the baseline service configuration, the 80\% coverage distance $d_{80}$ decreases from approximately 129~m at 6~GHz to 58~m at 18~GHz. Further analysis quantifies the impacts of service rate, resource allocation, interference, and link-budget degradation on coverage, providing measurement-based insights for same-site deployment across the 6--18~GHz band.

0.20