CS Paper Radar

Omnidirectional UMi Path Loss Models for 3GPP Extension Above 100 GHz Using Extensive Empirical Data Sets from 6.75 to 142 GHz

Xingchen Liu, Homa Nikbakht, Mingjun Ying, Dipankar Shakya, Hitesh Poddar, Art Ishii, Daniel Abraham, Theodore S. Rappaport

eess.SP ·submitted 2026-09-08 17:36 UTC · v1

Abstract

Extending standardized urban microcell (UMi) path loss (PL) models from the upper mid-band (FR3) to sub-terahertz (sub-THz) frequencies requires measurement-based comparisons spanning a wide spectral range within a unified framework. In this paper, we derive single- and multi-frequency omnidirectional PL models for UMi environments based on extensive NYU WIRELESS measurements at 6.75, 16.95, 28, 73, and 142 GHz in line-of-sight (LOS) and non-line-of-sight (NLOS) conditions. Single-frequency close-in (CI) and floating-intercept (FI) models for each band show that CI yields more stable and physically interpretable parameters, with shadow fading standard deviations within 0.98 dB of FI across all five frequencies. We then extend the multi-frequency PL analysis to the 7-24 GHz, 0.5-100 GHz, and 0.5-150 GHz frequency ranges using CI, close-in with frequency weighting (CIF), and alpha-beta-gamma (ABG) models. Across progressively wider frequency spans, CI and CIF maintain stable distance exponents that remain closely aligned with the 3rd Generation Partnership Project (3GPP) UMi interpretations, whereas ABG offers only very modest reductions in fitting error at the cost of much greater parameter sensitivity. These results support physically anchored CI/CIF formulations with a close-in free space path loss anchor point at 1 m in order to extend 3GPP-oriented UMi PL models over the entire 0.5 to 150 GHz frequency range.

Closest papers

Nearest neighbours by meaning across the whole index.

Directional and Quasi-Omnidirectional Indoor Channel Measurements at Upper 6 GHz

cs.ET cs.IT ·2026-10-10 ·Chengsong Fu, Hongbo Zhao, Jianer Zhou, Xiongbin Yu, Weichao Li +4 more
similarity 0.71
Abstract

This paper presents wideband indoor channel measurements and measurement-based statistical modeling of channel parameters in the upper 6 GHz (U6G) band using directional and quasi-omnidirectional antenna pairs. Measurements span 6.425-7.125 GHz at 32 matched positions per configuration in an open hall and an L-shaped corridor. System calibration and frequency-dependent peak-gain normalization retain antenna radiation-pattern weighting. Close-in and floating-intercept models are fitted to line-of-sight (LOS) and non-LOS (NLOS) path loss, respectively. Shadow-fading residuals, RMS delay spread (DS), and equivalent K factors derived from power delay profiles are characterized. LOS exponents range from 1.98 to 2.14. Despite similar attenuation slopes, directional links exhibit smaller LOS residuals and DS and higher equivalent K factors. Hall DS medians are 1.78 and 36.52 ns for directional and quasi-omnidirectional links. Corridor NLOS slopes are -1.12 and 2.54, respectively, while DS ordering varies by position. These results characterize antenna-dependent parameters for U6G indoor channels.

0.12

Wideband Channel Measurements in the Lower FR3 Band (6-12 GHz) for Industrial Environments

eess.SP ·2026-10-30 ·Faizan Rauf, Adam Umra, Oways Alsoloh, Aydin Sezgin
code/data similarity 0.64
Abstract

The upper mid-band, also known as Frequency Range 3 (FR3), spans 7.125-24.25 GHz and is a key candidate band for sixth-generation (6G) wireless communications. However, channel measurements in industrial environments remain scarce, and the 3GPP indoor-factory (InF) channel model, developed for omnidirectional antennas, has yet to be validated across the FR3 band. This paper presents a wideband channel measurement campaign in an industrial production hall, covering 135 line-of-sight (LOS) positions at 1-18 m and 30 non-line-of-sight (NLOS) positions behind an industrial robot at 2.5-16.5 m across 6-12 GHz. In LOS, the path-loss exponent ranged from 1.87 to 2.12, and the close-in fits agreed with the 3GPP InF-LOS model to within approximately 2 dB. However, shadow fading was only 1.4-1.7 dB, compared with the model's 4.3 dB. In NLOS, the robot caused an excess loss that increased from 10.3 to 13.0 dB between 6.5 and 11.5 GHz, consistent with diffraction. Blocking the direct path raised the mean directional delay spread from approximately 5 to 25 ns, close to omnidirectional values. These results indicate that the 3GPP InF model captures mean LOS path loss well but overestimates the variability of beam-aligned FR3 links, and that blockage loss in FR3 is frequency dependent. The dataset and processing code are publicly available.

0.28

Measurement-Based FR3 Urban Macrocell Channel Characterization and Coverage Analysis

eess.SP ·2026-09-20 ·Enrui Liu, Pan Tang, Haiyang Miao, Qi Zhen, Jianhua Zhang
similarity 0.63
Abstract · 6 pages, 11 figures, conference

The 6--18~GHz upper mid-band is a promising spectrum range for future sixth-generation (6G) networks due to its favorable balance between available bandwidth and propagation capability, while its same-site coverage performance remains a key deployment concern. This paper presents a wideband channel measurement campaign at 13 spatially aligned frequency points from 6 to 18~GHz in an urban macrocell (UMa) environment, and investigates the frequency evolution of channel characteristics and same-site coverage capability. The results show that path loss generally increases with frequency, while the higher-frequency channels tend to exhibit smaller root-mean-square (RMS) delay spread (DS) and larger PDP-based $K$-factors. Based on the measured path-loss characteristics, the additional link-budget requirement and service-aware same-site coverage are further evaluated. Under the baseline service configuration, the 80\% coverage distance $d_{80}$ decreases from approximately 129~m at 6~GHz to 58~m at 18~GHz. Further analysis quantifies the impacts of service rate, resource allocation, interference, and link-budget degradation on coverage, providing measurement-based insights for same-site deployment across the 6--18~GHz band.

0.20

Multi-Band Indoor MIMO Channel Measurements Across Sub-6 GHz, Mid-Band and mmWave: Comparing 2.55 GHz, 12.75 GHz and 25.5 GHz

eess.SP ·2026-11-11 ·Faruk Pasic, Florian Kiss, Florian Asperger, Diego Dupleich, Stefan Schwarz +1 more
published similarity 0.62
Abstract · Submitted to the 21th European Conference on Antennas and Propagation (EuCAP), 2027

Future wireless systems for indoor applications are expected to extend their operating frequencies from sub-6 GHz to mid-band and millimeter wave (mmWave) frequencies to support higher data rates. To characterize the frequency-dependent propagation behavior across these bands, multi-band channel measurements are essential. In this work, we conduct double-directional multiple-input multiple-output (MIMO) channel measurements in an indoor environment to enable a consistent comparison across three frequency bands. Measurements are performed using a 16x16 MIMO configuration at center frequencies of 2.55 GHz, 12.75 GHz and 25.5 GHz, covering both line-of-sight (LOS) and obstructed line-of-sight (OLOS) conditions. The measured channels are processed using the space-alternating generalized expectation maximization (SAGE) algorithm to extract multipath parameters, which are subsequently used to characterize the angular power distributions across the three frequency bands. The results show substantial angular-domain similarity across all three bands in both LOS and OLOS conditions, while also highlighting frequency-dependent variations.

0.40

Stochastic High-Resolution Parameter-Based Channel Modeling for Sub-Terahertz Outdoor Device-to-Device Propagation at 145 GHz

eess.SP ·2026-11-06 ·Zihang Cheng, Naveed A. Abbasi, Jorge Gomez-Ponce, Jianzhong, Zhang +1 more
published similarity 0.57
Abstract · Currently under submitted and under revision in the IEEE Transactions on Wireless Communications

Since device-to-device (D2D) systems operating in the sub-THz regime are of interest for a variety of 6G applications, modeling their propagation channels is therefore essential. This paper presents high-resolution parameter estimation (HRPE) of specular multipath components (MPCs) as well as diffuse multipath components (DMCs) from an extensive measurement campaign. The extracted MPCs and DMCs are then clustered, and statistical models for both intra- and inter-cluster statistics are established. Among other insights, we find a large number (typically 10-50) of clusters; both the powers and densities of MPCs within each cluster show significant variations. DMC occurs both when associated with discrete MPCs and standalone. The paper provides a complete model that can generate double-directional impulse responses, and a MATLAB program implementing it is made available. Extensive verifications of "derived" (not directly modeled) parameters are provided as well.

0.23

Modeling Diffuse Scattering in Mobility Scenarios: Ray Tracing Model and Measurement Validation

eess.SP ·2026-10-14 ·Milica Djordjevic, Thomas Wilding, Anja Dakić, Benjamin Rainer, Markus Hofer +1 more
code/data similarity 0.56
Abstract · Submitted to EuCAP 2027

Open-source ray tracing (RT) frameworks are increasingly used for site-specific channel modeling due to their reproducibility and extensibility. In non-stationary mobility scenarios, repeated RT evaluations can generate different diffuse propagation paths without preserving their correspondence, limiting a consistent representation of their temporal evolution. To address this limitation, we extend diffuse scattering modeling in Sionna RT using persistent surface-associated scattering points. Their positions remain fixed, while their contributions evolve according to changes in the propagation geometry and visibility. The proposed approach is validated using empirical radio channel impulse response measurements in an urban vehicular scenario at 5.9 GHz. Compared with the standard Sionna RT baseline, the proposed model shows improved agreement with measurements in the delay and Doppler domains.

0.28

Beyond TR 38.811 for 6G NTN Channel Models

eess.SP ·2026-11-02 ·Kuan-Po Chiu, Aaron Jacob Buck, Sumit Roy
similarity 0.56
Abstract

As the 3rd Generation Partnership Project (3GPP) expands 6G non-terrestrial network (NTN) to S, Ku, and Ka bands for integration with existing terrestrial cellular networks, the necessary satellite channel model for link and network performance evaluation remains tied to TR 38.811, last revised in 2020. We identify issues on multiple fronts: inappropriate parameter specifications based on very limited site-specific environments considered, omission of satellite-induced Doppler spread and directional antenna effects and lack of a transparent channel model generation procedure. To address these limitations, we re-derive the channel parameters using ray tracing (RT) over urban and rural environments based on ITU-R building statistics. Our results show that TR 38.811 substantially overestimates the K-factor at low elevations and predicts a decreasing trend with elevation, which is inconsistent with RT. The Ka-band clutter loss (CL) also exceeds the RT estimates by more than 15 dB in urban cases. It also underestimates rural delay spread (DS) at low elevations and predicts an elevation trend inconsistent with RT. We further quantify the previously neglected satellite-induced Doppler spread. Finally, we demonstrate that the conventional TR 38.811 channel generator significantly underestimates the K-factor in the presence of directional antenna (beamforming), while our modified generator substantially reduces this discrepancy.

0.30

Enhancing 3GPP Urban Channel Models For Terrestrial-to-Non-Terrestrial Communication

eess.SP ·2026-08-28 ·Gerhard Schreiber, Chenrui Sun, Joerg Schaepperle, Le-Hang Nguyen, Thorsten Wild
code/data similarity 0.55
Abstract

We have developed enhanced models for large-scale channel parameters intended for terrestrial-to-non-terrestrial (NTN) communication in Urban environments for supporting devices above ground levels, such as drones. The models are formulated as functions of terminal height above ground and elevation angle, applicable to S-Band and Ka-Band frequencies. To ensure realistic models, an open-source 3D scene generator was utilized to create a diverse set of urban scenes across Europe. Sionna ray-tracing was employed to generate path-gain samples for outdoor terminals, covering a range of heights up to 300 meters and elevation angles up to 90°. Our proposed analytical functions show excellent agreement to ray-tracing data for line-of-sight (LOS) probability, shadow-fading (SF), and clutter-loss (CL). Furthermore, a comparative coupling gain analysis with existing 3GPP models reveals notable differences, particularly caused by smaller CL and higher LOS probabilities from proposed models. Designed for ease of use, these models can be seamlessly integrated into simulation tools, offering a practical solution for researchers and engineers.

0.35