CS Paper Radar

Virtual Microphone Array for Direction-of-Arrival Estimation Based on Fiber-Optic Position Sensing

Sebastian Schwarze, Jiekai Wang, Thomas Kissinger, Stephan Werner

eess.AS ·submitted 2026-11-04 10:23 UTC · v1
unusual

Abstract

This paper presents a virtual microphone array approach for estimating the direction of arrival of a sound source using a moving microphone and a stationary reference microphone. The method exploits the microphone motion to generate a time-varying array geometry, using fiber-optic position sensing to reconstruct the trajectory and determine the resulting virtual microphone configurations. For each configuration, the estimated time difference of arrival between the two microphone signals and the corresponding microphone geometry define a hyperboloid representing all possible sound source positions consistent with the time difference. By combining multiple hyperboloid constraints, the direction of arrival can be estimated in azimuth and elevation relative to the microphone coordinate system. In contrast to conventional arrays with fixed geometries and approaches based on predefined microphone trajectories, the proposed method derives the virtual array geometry directly from the measured microphone motion, enabling a spatially distributed virtual array to be formed using only two physical microphones and offering potential for size- and weight-constrained applications. The approach was experimentally evaluated under controlled low-reflection conditions for different source positions, source distances, and signal characteristics. The influence of microphone motion was further examined, and the method was tested with a moving sound source. The results demonstrate the feasibility of direction-of-arrival estimation using a virtual microphone array without requiring a predefined microphone trajectory.

Comment
11 pages, 7 figures

Closest papers

Nearest neighbours by meaning across the whole index.

Neural Array-Generic Direction-of-Arrival Estimation Exploiting Array Transfer Functions

eess.AS ·2026-08-10 ·Mikko Heikkinen, Archontis Politis, Konstantinos Drossos, Tuomas Virtanen
published similarity 0.59
Abstract · Accepted for publication in IWAENC 2026

Direction-of-arrival (DoA) estimation is a key component of multichannel audio processing, yet many deep learning approaches remain tied to the microphone arrays used during training and generalize poorly to unseen devices. This paper proposes an array-generic neural DoA estimation framework using measured or simulated complex directional array transfer functions (ATFs) matched to real-world multi-microphone devices. The method processes multichannel spectrograms and ATF metadata with separate convolutional encoders, fuses the resulting representations through cross-attention, and predicts source directions using a multi-source Cartesian vector output formulation. Experiments on simulated 2D and 3D localization tasks under reverberation and diffuse babble noise show that the proposed approach generalizes to previously unseen arrays, including mobile-phone-like configurations, without major performance degradation, while remaining competitive with conventional and learning-based baselines.

0.49

Broadband Acoustic Intensity Direction Estimation with Tight-Frame Cardioid Arrays

eess.AS ·2026-09-03 ·Akira Omoto
unusual similarity 0.57
Abstract

This study experimentally investigates source-direction estimation from acoustic intensity using paired cardioid microphones, with particular emphasis on well-balanced arrangements known as tight frames. Impulse responses were measured at 6 or 24 microphone positions, and two opposed-pair spacings were examined. The resulting arrays were evaluated for a single source, coherent interference between waves arriving from two orthogonal directions, and directional tracking in the presence of interfering waves from multiple directions. The results demonstrate broadband acoustic-intensity direction estimation from 50 Hz to 20 kHz, with the 24-microphone arrangement and the shorter spacing generally providing smaller errors.

0.25

Microphone Geometry Aware Regional Target Speaker Extraction

cs.SD cs.AIeess.AS ·2026-10-31 ·Shitong Xu, Niki Trigoni, Andrew Markham
similarity 0.55
Abstract · 7 pages, 2 tables, 2 figures

Regional target speaker extraction (RSE) aims to extract speech originating from a specified angular region, relaxing the requirement for precise target speaker location when performing location based speech extraction. However, existing RSE methods typically assume a fixed microphone array configuration and microphone number, limiting their applicability to unseen microphone geometries and varying numbers of microphones. In this work, we propose a geometry-aware RSE framework capable of extract with varying microphone array geometry and microphone numbers. Specifically, we introduce an attention-based multichannel front-end to encode inter-microphone phase information, together with a spatial audio reconstruction-based auxiliary objective to improve the front-end spatial representations quality. Experimental results demonstrate that the proposed framework improves SI-SDRi by 5.1 dB over geometry-aware baselines across microphone arrays with four-microphones, while maintaining a performance gap of less than 0.6 dB compared with a tetrahedral geometry-specific baseline when evaluated on the tetrahedral microphone array.

0.22

Spatio-Temporal Calibration of a Vehicle-Mounted Microphone Array for Autonomous Driving

cs.SD eess.AS ·2026-11-10 ·Marvin Seegert, Richard Taupitz, Korbinian Moller, Johannes Betz
similarity 0.54
Abstract · Submitted to IEEE ICRA 2027

Microphones let an autonomous vehicle sense into areas its cameras and LiDAR cannot see, by picking up the sound that other traffic participants emit. Locating those sources and fusing them with the visual perception requires the microphone array to be calibrated and registered relative to the vehicle's other sensors. Existing calibration methods assume small, unobstructed indoor rigs, whereas a vehicle body casts an acoustic shadow that straight-line propagation cannot represent, and to our knowledge no calibration of an array distributed around a vehicle has been reported. We propose a pipeline that uses a balloon burst as a single cross-modal target, which the LiDAR locates in metric coordinates, every microphone hears as a sharp onset and a camera times. Each observation is weighted by its own timing variance, which discounts shadowed arrivals instead of discarding them and needs no model of the vehicle. On a full-size vehicle with eight microphones over a 4.9 m aperture, the held-out range residual of 6.37 cm approaches the 6.07 cm floor set by the onset timing noise, and the calibrated array tracks a moving source to within a few degrees of the vehicle's own LiDAR. A dozen bursts spread around the vehicle suffice, and spreading them matters more than adding more.

0.29

Active Noise Control for Augmented Reality Glasses using Virtual Sensing with Directional Robustness

eess.AS ·2026-10-20 ·Nitay Peled, Boaz Rafaely
published similarity 0.53
Abstract · 5 pages, 6 figures, 1 table. Presented at the 34th European Signal Processing Conference (EUSIPCO 2026)

Active noise control (ANC) is an established technique for mitigating acoustic noise, successfully implemented in various commercial applications. However, the application of ANC to augmented reality (AR) glasses remains an emerging area, where a key challenge is the lack of a microphone at the user's ear. This paper first validates the necessity of virtual sensing techniques for this specific geometry and investigates the Auxiliary Filter (AF) method as a potential solution. We present a theoretical analysis of the method's directional sensitivity, enabling the prediction of the system's robustness when the noise direction deviates from the calibration angle. Simulation results confirm that while a fixed AF is effective under matched conditions, it suffers significant degradation under mismatch, consistent with the theoretical predictions. To address this limitation, we propose and evaluate a solution using a finite bank of auxiliary filters that are selected based on the noise source direction of arrival. The results demonstrate that this filter bank approach significantly recovers performance compared to a fixed filter, offering a practical alternative to continuous recalibration in dynamic acoustic environments.

0.37

Geometry-Conditioned Target Speaker Extraction based on spatial features incorporating acoustic propagation principles

eess.AS ·2026-10-21 ·Jiatong Li, Simon Doclo
similarity 0.53
Abstract

Recently, spatially selective non-linear filter (SSF) was proposed for target speaker extraction, utilizing the direction-of-arrival (DOA) of the target speaker as a spatial cue. To overcome its dependency on a fixed microphone array geometry, geometry-conditioned SSF (GCSSF) was proposed, which maps the target DOA and the microphone positions into abstract high-dimensional embeddings using positional encoding. As an alternative to these high-dimensional embeddings, in this paper we propose utilizing two spatial features incorporating acoustic propagation principles for geometry conditioning: 1) the steering vector of the target speaker, which captures inter-microphone phase differences, and 2) a spatial mask based on GCC-PHAT, which quantifies presence of the target speaker per time-frequency bin. These features are used as input to a geometry-conditioning encoder and integrated via a FiLM layer into the GCSSF system. Experimental results on circular and random arrays demonstrate that conditioning with spatial features improves target extraction performance compared to abstract high-dimensional embeddings, maintaining a clear performance advantage across a wide range of target DOA errors.

0.19

GAMF: Learned and Analytical Array Transfer Function Matching for Array-Generic Direction-of-Arrival Estimation

eess.AS ·2026-09-28 ·Zhiheng Jin, Shichao Hu, Chunyang Xu, Mengyao Zhu
similarity 0.53
Abstract

Microphone positional encoding supports cross-array direction-of-arrival (DOA) estimation, but coordinates alone cannot fully describe device shadowing or microphone directivity. We propose a Generalizable ATF Matching Framework (GAMF) for DOA estimation across array geometries and microphone counts, using array transfer functions (ATFs) as acoustic descriptors. The learned branch incorporates ATF embeddings into geometry-conditioned neural estimation to match acoustic observations with candidate directions. The analytical branch performs normalized ATF matching adapted from generalized steered response power. A hybrid configuration combines their scores through adaptive gating. Simulations across array configurations show that both learned and hybrid configurations outperform a representative positional-encoding-based neural baseline, remain competitive with analytical ATF matching in clean, low-reverberation scenes, and substantially improve upon it under stronger noise or reverberation. On eight-microphone LOCATA Task 1 recordings, the hybrid configuration outperforms the evaluated state-of-the-art baselines for three-dimensional DOA estimation, achieving mean errors of $3.76^\circ$ for three-dimensional DOA and $2.87^\circ$ for azimuth.

0.08

SPATEX: Array-Flexible Multichannel-to-Multichannel Target Speech Extraction using Direction Clue

eess.AS ·2026-11-02 ·Wen Wen, Changda Chen, Yu Xi, Haoyu Li, Qiang Zhou +5 more
code/data similarity 0.52
Abstract · Submitted to ICASSP 2027

Multichannel-to-multichannel target speech extraction (MIMO TSE) aims to recover the target speech signal at each microphone while preserving interchannel spatial information. However, existing MIMO TSE systems generally assume a fixed microphone configuration, limiting their applicability to recording devices with varying microphone configurations. In this work, we propose SPATEX, the first array-flexible MIMO TSE framework that reconstructs microphone-wise target speech signals across microphone counts and array geometries. Given microphone coordinates and a target direction-of-arrival (DOA), SPATEX combines geometry-aware channel exchange and shared temporal attention to jointly reconstruct microphone-wise target signals while maintaining permutation equivariance. Experiments show that SPATEX outperforms array-flexible single-output baselines under most test conditions and consistently improves extraction quality and spatial fidelity over fixed-array MIMO baselines. Ablation studies further validate the benefits of temporal coordination and spatial supervision, while additional evaluations demonstrate robustness to target DOA errors. Our code and dataset are available at https://github.com/Wenanzhi/SPATEX.

0.33