CS Paper Radar

Fault-Geometry-Aware Control Allocation for Emergency Quadrotor Landing under Single-Motor Loss of Effectiveness

Suhas S P, Samridhi Salwan, Arshan Ali Khan, Ujwal Pai Jakarbet, Savithramma R M, Ashwini B P

cs.RO eess.SY ·submitted 2026-11-05 16:34 UTC · v1

Abstract

Partial single-motor loss of effectiveness (LoE) changes the remaining control-authority geometry of a quadrotor and can change which control allocator performs best during emergency landing[cite: 11]. We compare three allocators in Crazyflie software-in-the-loop simulation: bounded weighted least squares (reported as PINV), a finite-candidate residual allocator (QP-lite), and the same residual allocator with scoring parameters tuned offline by the Cross-Entropy Method (CEM)[cite: 11]. For this study, fault geometry is represented by the known failed-motor index[cite: 11]. At $η=0.496$ remaining effectiveness, matched development trials select CEM for M1, M3, and M4 and PINV for M2; the M3 selection is a one-trial margin (29/30 versus 28/30)[cite: 11]. After freezing this routing map, the policy achieves 117/120 safe first-contact touchdowns on fresh seeds and 115/120 in a separate randomized-order integrated-supervisor evaluation[cite: 11]. For the critical M2/PINV branch, Firth regression gives a nominal $η_{50}\approx0.4956$ with a within-model 95% bootstrap interval of approximately [0.4955, 0.4956][cite: 11]. One-factor-at-a-time $\pm10\%$ plant perturbations shift $η_{50}$ by up to 0.05495 for thrust coefficient and 0.04974 for mass; the most frequent violated first-contact criterion also changes from vertical speed in many conditions to angular rate for mass -10% and thrust-coefficient +10%[cite: 11]. At fixed $η=0.496$, PINV has a higher M2 safe count than frozen CEM in 9/11 tested plant states and ties in 2/11; the two ties are both 0/30[cite: 11]. The experiments therefore distinguish motor-conditioned allocator selection from sensitivity to plant-model mismatch[cite: 11].

Comment
6 pages, 7 figures, 1 table

Closest papers

Nearest neighbours by meaning across the whole index.

Same World, Different Knowledge: When Isolated Audits Misjudge World-Model Repairs

cs.RO ·2026-09-17 ·Rui Min, Xianyao Li, Fang Xu, Sofiane Lachab, Jing Du
similarity 0.54
Abstract · 9 pages, 3 figures, 6 tables

A repair favored under an isolated input fault can be inferior when deployed modules share the faulty information. We introduce an information-interface audit for world models, distinguishing fidelity gaps, where exact inputs become estimates, from availability gaps, where inputs are missing. Fixed-weight interventions measure prediction error, input dependence, and paired closed-loop benefit, including dependencies introduced by reconstruction. In simulated quadrotor model predictive control, coupled, opposite-sign 10% mass/thrust calibration errors reduce a physics-anchored model's success from 69% to 8%; uncertainty training restores 65%. Wind reconstruction recovers control benefit but inherits calibration dependence. For a positive calibration offset, reconstruction-only corruption favors uncertainty-trained reconstruction, whereas shared corruption favors the baseline. Acceleration diagnostics reveal compensation between reconstruction bias and nominal-model error, also observed with a disturbance observer. Repair selection therefore depends on the information paths used in deployment.

0.23

Tilt as a Certified Resource: Preserving Motor Wrench-Rate Authority on Articulated Multirotors

cs.RO eess.SYmath.OC ·2026-09-18 ·Giuseppe Silano, Martin Saska
similarity 0.53
Abstract · This work has been submitted to the IEEE for possible publication

Fully-actuated multirotor aerial vehicles must not only track nominal wrenches but retain the "readiness" to modulate them rapidly under disturbances. Classical effort-minimizing allocators ignore this dynamic limit, whereas maximizing readiness leads to topologically disconnected optimal sheets demanding physically impossible actuator rates. Enforcing a readiness safety floor on fixed-geometry symmetric platforms further encounters a zero-sum degeneracy: motor-speed redistribution cannot improve authority without conceding wrench tracking. This paper uses active morphology to break the degeneracy, treating servo tilt as a geometric resource supplying authority-recovery directions unavailable to static rotors. We construct a configuration-dependent, motor-only readiness certificate - the log-volume of the reachable wrench-rate set - that explicitly excludes servo capacity, preventing a "ghost capacity fallacy" in which the certificate would falsely credit slow mechanical kinematic limits instead of collapsing accurately at motor saturation. The certificate is enforced as a Control Barrier Function (CBF) within a Unified Physical-Command Quadratic Program acting on motor torques and servo setpoints. Closed-loop simulations of an articulated octorotor under severe gust disturbances show classical allocators diverging and uncertified articulated allocators violating the safety floor, while the proposed CBF filter bounds the system state and preserves vehicle authority.

0.34

Adaptive Safety Filtering for Frozen ACC Policies via Conformal Residual Calibration

cs.RO cs.CVeess.SY ·2026-09-28 ·Zhiruo Zhou, Rigaudiere Z. Li, Chen Xiwen, Yucheng Chen, Xiaojun Zhu +1 more
similarity 0.53
Abstract

Frozen adaptive cruise control (ACC) policies can violate constraints when deployment dynamics differ from their training conditions. We propose residual-aware conformal action filtering (RACF), which calibrates residuals of a fixed nominal predictor and converts their quantile into an operating margin for finite-model action projection. Completed transitions update margins and candidate selection without retraining the policy. In a registered comparison over 2,400 controller-trial units, Adaptive RACF achieves 94.3% episode safety, improving by 19.9 percentage points over the evaluated nominal CBF-QP baseline while reducing projection frequency from 8.11% to 6.63%. A controlled study isolates a 4.54-point improvement from residual-margin injection. In a separate matched-hardware evaluation, Adaptive reduces mean amortized rollout time by 21.2% relative to Robust CBF-QP, with 161/180 versus 170/180 safe episodes. We characterize conditions linking one-step residual coverage to constraint satisfaction and quantify the observed safety-computation trade-offs.

0.18

How Tuning, Reference Preview, Actuator Modeling, and Fallback Policies Change Quadrotor Controller Comparisons: A Reproducible Simulation Study

cs.RO ·2026-10-26 ·Xuan-Quy Dao, Le-Minh Nguyen, Ngoc-Bich Le
similarity 0.52
Abstract · 20 pages, 5 figures, 11 tables. Reproducible simulation study of quadrotor controller benchmarking

Quadrotor controller comparisons commonly report a single tracking error, although the ranking also depends on tuning effort, reference information, actuator prediction, optimizer fallback, and command timing. We quantify these effects for cascade PID, hover LQR, boundary-layer sliding-mode control (BL-SMC), linear MPC with LQR fallback (LMPC-F), a preview-enabled LMPC-F, and a geometric $SO(3)$ controller on a common nonlinear plant with rotor gyroscopic coupling, motor lag, and saturation. A primary study (556 episodes at 50~Hz) combines matched twelve-candidate tuning, 400 paired evaluation episodes, and a 48-cell MPC factorial; a confirmation study (1462 episodes) repeats the evaluation on 50 fresh realizations with tuning budgets of 12, 24, and 48 candidates. A matched twelve-candidate tuning protocol changed the mean-RMSE ordering of the fixed baseline settings, mainly by moving BL-SMC from last to first. The ordering recurred on fresh realizations and did not change with 48 candidates, although BL-SMC's lead on the fresh set depends on a wider search range for its vertical switching gain. Reference preview reduced MPC tracking error and removed fallback activity on the figure-eight task. In single abrupt-step runs, completion depended jointly on fallback policy, predictor, and actuator authority. Command timing also changed the outcome: replaying measured command-call delays terminated three of four nominal MPC configurations on a desktop and all four on a Raspberry Pi~5, whereas capping the solver at 100 iterations removed every deadline miss in these profiles. We propose a reporting checklist that adds tuning effort, failure rates, fallback activity, applied-input variation, and command timing to tracking accuracy.

0.42

Readiness Barrier Functions: Forward-Invariant Control Authority for Overactuated Multirotor Allocation

cs.RO eess.SYmath.OC ·2026-08-17 ·Giuseppe Silano
similarity 0.51
Abstract · This work has been submitted to the IEEE for possible publication

Allocation schemes that greedily maximize a readiness metric over the actuator fiber bundle of an overactuated multirotor produce commands that jump between disconnected optimal strata, demanding actuator rates no motor can deliver; effort-minimizing schemes are continuous but cannot guarantee that wrench-rate authority stays above any certified level. We reconcile the two by treating authority as a forward-invariant quantity: a control barrier function on the log-determinant of the drag-aware actuator-authority co-metric, enforced at torque level by a quadratic program in the allocation null space. A single design inequality renders the certified set compact and strictly interior to the actuator box, with the readiness cost of any rotor deactivation given in closed form as $\ln(n/(n{-}m))$ for symmetric designs. An explicit alignment ratio states when tracking can stay exact, otherwise the wrench error is bounded by $\mathcal{O}(ρ^{-1/2})$, and a robust variant handles motor-parameter uncertainty with a closed-form floor shift independent of the airframe matrix. On a hexarotor and a fully-actuated octorotor the closed-form gap matches simulation to machine precision. Over $300$ randomized missions, greedy maximization violates the certified floor in up to $51\%$ of authority-scarce missions, while the proposed filter never leaves the certified set and, in the hardest moment reversal, commits a $79\times$ smaller wrench error. The robust variant holds the floor on all $150$ perturbed plants. A high-fidelity simulation with measured propeller and motor data shows that the floor holds under unmodeled aerodynamics, electrical limits, and delay, and where it stops applying.

0.55

Pre-Solve Horizon Sampling of Frozen Acceleration Residuals for Quadrotor NMPC under External Forces

eess.SY ·2026-11-03 ·Shenghan Sun
similarity 0.51
Abstract · 25 pages, including supplementary material. Revised title and abstract; clarified the contribution, residual sampling procedure, and discuss…

We investigate how a frozen supervised acceleration-residual model should be sampled within nonlinear model predictive control (NMPC) of a quadrotor subject to external forces. Cyclewise deployment holds the current-state residual across the prediction horizon, whereas stagewise deployment evaluates the same network at shifted warm-start nodes before each optimization solve. The correction sequence is fixed during optimization and the network is not updated online. In 220 simulated pulse-load conditions, cyclewise and stagewise deployment reduce mean integral absolute position error (IAE) relative to nominal NMPC by 4.38% and 7.77%, respectively. However, both worsen all 55 hover conditions, and most of the aggregate improvement arises after pulse removal rather than during loading. In 96 prescribed random-force blocks, stagewise deployment reduces mean IAE by 11.99%; the evaluated finite-budget reinforcement-learning add-ons do not improve their matched supervised means in either force bank. A separate causal innovation compensator reduces mean IAE by 27.47% relative to stagewise deployment on 32 confirmation conditions, at the cost of a 10.19% increase in angular-rate root-mean-square error. In one synthetic computational-fluid-dynamics inflow field, stagewise deployment reduces four-task mean IAE by 2.01% against a same-graph zero-residual control. These simulation results quantify deployment-dependent tracking gains and trade-offs, without establishing general wind rejection or hard-real-time guarantees.

0.28

RAYA: Learning Where and When to Intervene for Robot Recovery

cs.RO eess.SY ·2026-09-18 ·Ishaan Mahajan, Charles Chen, Frederike Dümbgen, Brian Plancher
similarity 0.50
Abstract · 8 pages, 4 figures

A robot can predict failure and still be unable to prevent it. By the time a safety mechanism reacts, the nominal plan may already have spent the control authority that recovery requires, and fixed task priorities may block whatever response remains. Our key insight is that both aspects are decided inside the controller. Recoverability must inform actions while they are chosen rather than veto them afterward, and task objectives must be adapted as recoverability shrinks. Building on this, we present RAYA, a hybrid learned-analytic framework that places a learned finite-horizon recoverability margin inside an optimal controller with hard constraints and pairs it with a bounded learned scheduler that shifts task weights to facilitate recovery. Across 7,200 simulation episodes per controller spanning quadrotor and autonomous-vehicle benchmarks, RAYA not only improves survival rates, but also transfers the learned components zero-shot to unseen trajectories, disturbances, plant shifts, and friction layouts. We developed an embedded realization of RAYA and deployed it on-board a 35g Crazyflie quadrotor. Across 40 combined hardware flights under wind with either aerodynamic mismatch or an unmodeled 40% motor-command loss, each of three baselines fails in all trials, while RAYA completes 10/10 six-cycle missions. Project Website: https://raya-control.github.io/.

0.34

DQ-MPCC: Dual-Quaternion MPCC for Quadrotor Racing

cs.RO eess.SY ·2026-09-29 ·Bryan S. Guevara, Luis F. Recalde, Guanrui Li, Tiago Nascimento
similarity 0.50
Abstract · 8 pages, 6 figures. Submitted to IEEE Robotics and Automation Letters

Quadrotor racing demands aggressive attitude and progress control while passing through every gate, and conventional quadrotor MPCC formulations state the prediction model in inertial coordinates and the attitude error in the body frame. We present a Dual-Quaternion Model Predictive Contouring Control (DQ-MPCC) for quadrotor racing in which the pose is a unit dual quaternion and the contouring errors are projected onto the tangent space of the dual quaternion manifold, expressed in the desired body frame: the same rigid-body dynamics as the conventional model, in unified pose-twist coordinates in the body frame. We compare DQ-MPCC against a baseline MPCC through Monte Carlo software-in-the-loop simulations and real-world racing on an eight-gate circuit of 11x4.5x3.65 m. With the same gains in simulation and hardware, DQ-MPCC keeps every crossing of its completed flights within the prescribed geometric margin, whereas the baseline exceeds it, its median worst-gate offset growing by 71.5% sim-to-real against a 10.1% decrease for DQ-MPCC. Among the configurations that keep every simulated gate crossing within the geometric margin, DQ-MPCC also reduces the minimum lap time by 6.7%, and by 10.5% in the real-world flights, while running onboard at 100 Hz.

0.31