CS Paper Radar

DQ-MPCC: Dual-Quaternion MPCC for Quadrotor Racing

Bryan S. Guevara, Luis F. Recalde, Guanrui Li, Tiago Nascimento

cs.RO eess.SY ·submitted 2026-09-29 01:42 UTC · v1
top venue

Abstract

Quadrotor racing demands aggressive attitude and progress control while passing through every gate, and conventional quadrotor MPCC formulations state the prediction model in inertial coordinates and the attitude error in the body frame. We present a Dual-Quaternion Model Predictive Contouring Control (DQ-MPCC) for quadrotor racing in which the pose is a unit dual quaternion and the contouring errors are projected onto the tangent space of the dual quaternion manifold, expressed in the desired body frame: the same rigid-body dynamics as the conventional model, in unified pose-twist coordinates in the body frame. We compare DQ-MPCC against a baseline MPCC through Monte Carlo software-in-the-loop simulations and real-world racing on an eight-gate circuit of 11x4.5x3.65 m. With the same gains in simulation and hardware, DQ-MPCC keeps every crossing of its completed flights within the prescribed geometric margin, whereas the baseline exceeds it, its median worst-gate offset growing by 71.5% sim-to-real against a 10.1% decrease for DQ-MPCC. Among the configurations that keep every simulated gate crossing within the geometric margin, DQ-MPCC also reduces the minimum lap time by 6.7%, and by 10.5% in the real-world flights, while running onboard at 100 Hz.

Comment
8 pages, 6 figures. Submitted to IEEE Robotics and Automation Letters

Closest papers

Nearest neighbours by meaning across the whole index.

CALOS: Control-Affine Lyapunov On-manifold Safety Layer for Safe Deep Reinforcement Learning for Quadrotors

cs.RO cs.AI ·2026-09-15 ·Fabrizio Cesareo, Sebastiano Mengozzi, Nicola Mimmo, Andrea Acquaviva
similarity 0.61
Abstract

Deep Reinforcement Learning has demonstrated remarkable capability in quadrotor control, yet learned policies offer no guarantee of respecting safety constraints during training or deployment. We present CALOS (Control-Affine Lyapunov On-manifold Safety), a runtime safety layer that enforces attitude constraints on a quadrotor without modifying the underlying learning algorithm. CALOS formulates four tilt-angle inequalities and a Lyapunov descent condition as a single quadratic program whose solution is the minimum-norm correction to the nominal torque output of the policy. The quadratic program is solved exactly via active-set enumeration over the three-dimensional torque space, with a computational cost low enough to enforce constraints in real time across thousands of parallel simulation environments, as required by modern massively parallel Deep Reinforcement Learning training. Evaluated on trajectory-tracking tasks in NVIDIA Isaac Lab, CALOS reduces lateral tracking error by 55-60% relative to an unconstrained Proximal Policy Optimization baseline while achieving zero attitude-constraint violations on the training trajectory. By restricting exploration to safe regions of the state space, the safety layer also accelerates training convergence and improves data efficiency without producing suboptimal policies.

0.19

LLA-MPC on Embedded Hardware: Rapid Adaptive Control with Thousands of Parallel Models

cs.RO eess.SY ·2026-10-02 ·Henry Z. Liao, Maitham F. AL-Sunni, John M. Dolan
publishedcode/data similarity 0.58
Abstract · This work has been accepted in the Sim2Real and Classical Control: From Rigorous Theory to Data-Driven Robotics Workshop at the 2026 IEEE/RS…

We present a generalized implementation of Look-Back and Look-Ahead Adaptive Model Predictive Control (LLA-MPC), a learning-free framework for real-time, rapid adaptive system identification and control. The original formulation was demonstrated only in simulation, for autonomous racing with a fixed model structure. Our implementation has modular dynamics and integrators, and we validate it on the F1TENTH platform under constrained computation and noisy state estimation. The system identifies tire parameters online by evaluating thousands of candidate models in real time on an embedded computer. Experiments with low-friction tires across changing surfaces show that LLA-MPC completes high-speed tracking tasks where a fixed nominal model fails. Code, videos, and our related work are available at: https://lla-control.github.io.

0.56

Safe whole-body backstepping control for quadcopter path-following

eess.SY ·2026-08-18 ·Arthur H. D. Nunes, Arthur Da C. Vangasse, Guilherme V. Raffo, Vinicius M. Gonçalves, Luciano C. A. Pimenta
similarity 0.58
Abstract

This paper presents a novel whole-body Backstepping control strategy for safe quadcopter path-following. The proposed approach introduces an integrated control scheme that combines a translational guidance controller with a rigid-body attitude controller. To guarantee asymptotic path convergence, the method utilizes a nominal Integrated Guidance and Control (IGC) based on Artificial Vector Fields (AVF). To ensure reactive safety and collision avoidance, the control law is modified using a smooth distance function within the High-Order Control Barrier Function (HOCBF) framework. The quadcopter dynamics are modeled using quaternion algebra to represent position, velocity, and attitude. By combining the Backstepping approach with HOCBF, the controller guarantees that the vehicle avoids obstacle sets while successfully converging to the target path when unobstructed. The proposed methodology is validated through software-in-the-loop simulations and real-world experimental results using the Crazyflie platform.

0.20

RACER: Residual-Adaptive Closed-Loop Estimation for Sampling-Based Planning in Wheeled-Quadruped Racing

cs.RO ·2026-10-05 ·Yuxiang Liu, Marla Eisman, Lizhi Yang, Aaron Ames, Francesco Borrelli
similarity 0.57
Abstract

We present RACER, a hierarchical control framework for wheel-based quadruped racing that combines an MPPI planner with a learned residual dynamics model and a low-level RL velocity tracker. The planner augments a nominal unicycle kinematic model with a neural residual term to capture the closed-loop tracking behavior of the RL policy. To train this residual model under limited real-world data, we propose Low-Rank Residual Adaptation (LoRRA), a two-stage approach that pre-trains on large-scale simulation data for broad coverage and then fine-tunes on a small real-world dataset with a low-rank constraint. In simulation, we empirically validate our engineering choices by showing (A) Residual dynamics improve the overall performance of our pipeline by capturing the tracking error of RL velocity tracker at high-speed cornering. (B) Residual dynamics trained with both source-domain and target-domain data gives racing performance significantly better than the residual dynamics trained with only target-domain data. (C) Low-rank constraint at target-domain adaptation gives higher success rates and higher performance than full-tune and from-scratch when domain gap in ground coefficient or joint gain increases.

0.23

FAME-QP: A GPU-Accelerated Quadratic-Programming Solver for Real-Time Model Predictive Control

cs.RO cs.GReess.SY ·2026-11-10 ·Santosh Mohan Rajkumar, Debdipta Goswami, Stephanie Stockar
similarity 0.57
Abstract

We present FAME-QP, a GPU-accelerated solver for dense quadratic programs arising in linear model predictive control. FAME-QP combines constraint-dependent operator representations with fused single- and two-kernel iterations replayed through CUDA graphs, automatically selecting the execution configuration through device calibration and problem-specific timing. It probes a cached operator bank to select the initial penalty and updates operators lazily when problem matrices change. Numerical benchmarks and simulated humanoid and quadrotor control experiments demonstrate reduced latency relative to competing GPU solvers while maintaining solution accuracy and control performance.

0.31

Sideslip-Conditioned Drift Trajectory Planning with Flow Matching and Control Barrier Functions

cs.RO ·2026-11-17 ·Seokjun Lee, Seung-Hyun Kong
similarity 0.57
Abstract · 8 pages, 4 figures, 3 tables. Under review. Demonstration video: https://youtu.be/nskukDD1MFg

Drifting, the deliberate control of a vehicle at large sideslip angles, is relevant to both motorsport and recovery from unexpected oversteer. Existing autonomous drifting methods typically determine drift intensity through predefined reference trajectories, optimization objectives, or learned policy rewards, rather than accepting a desired sideslip angle as an explicit input. We propose, to the best of our knowledge, the first generative drift trajectory planner explicitly conditioned on a requested peak sideslip angle. A conditional flow matching model is trained on demonstrated drift laps with hindsight-derived sideslip labels and refined through reinforcement fine-tuning. A control barrier function (CBF) correction is then applied to satisfy model-based road, tire friction, and actuator constraints at the planning waypoints. In closed-loop experiments in the racing simulator Assetto Corsa, a nonlinear model predictive controller tracks the generated plans for six requested sideslip angles from 20 deg to 45 deg, with 30 laps (approximately 75 km) per request. The median peak sideslip angle measured across drift-corner passes follows the requested angle, with a mean absolute error of 1.2 deg across the six conditions. Ablation experiments show that reinforcement fine-tuning improves conditioning accuracy, while CBF correction substantially reduces off-road and spin events.

0.43

Learning Visuomotor Quadrotor Flight Through Dynamic Narrow Gaps via Differentiable Simulation

cs.RO ·2026-10-27 ·Riccardo Bianco, Yunfan Ren, Jiaxu Xing, Davide Scaramuzza
published similarity 0.57
Abstract

Threading a quadrotor through a moving narrow gap is a demanding test of agile flight, requiring centimeter-level spatial alignment and precise temporal execution. We address this challenge using a control policy that operates directly on onboard visual and inertial measurements to output collective thrust and body-rate commands. The task is difficult because success lies on a thin feasible manifold: small errors in timing, position, attitude, or visual observability cause collision. Prior planning and learning methods rely on privileged state, teachers, planners, or distillation; learning dynamic narrow-gap traversal directly, from scratch, remains open. We introduce a differentiable moving-gap formulation that gates centering, alignment, and smooth collision terms by signed distance to a time-varying gap plane, turning a sparse traversal event into a dense pathwise objective. We integrate this formulation into a visual-feature-to-command policy trained in one stage from random initialization, without a teacher, planner, or distillation. We validate our approach in both synthetic and real-world experiments. In controlled benchmarks, we demonstrate that pathwise gradients significantly outperform score-function gradients for precision-critical tasks, yielding a 99.3% success rate in simulation after only a few minutes of training on a single GPU. Furthermore, the policy transfers directly to a real quadrotor, successfully crossing a dynamic narrow gap from varied initial conditions using onboard sensing and inertial measurements, achieving an 80% success rate over 10 physical trials.

0.26

Extended Model-Based Learned Inertial Odometry

cs.RO ·2026-11-06 ·Sasanka Kuruppu Arachchige, Joni-Kristian Kämäräinen
publishedcode/data similarity 0.57
Abstract · 8 pages, Published at ICUAS 2026

Inertial odometry is a compelling approach to state estimation for agile quadrotor flight due to its affordability, low weight, and robustness to perceptual degradation. However, relying only on integrated inertial measurements is impractical, as sensor errors and time-varying biases lead to significant pose drift. Although recent advances have enabled inertial odometry for drone racing, existing approaches show limited generalization to trajectories not seen during training. This work improves generalization by adopting a body-frame representation and incorporating body-frame torque dynamics into the learning pipeline. The learned model predicts short-horizon relative displacements, which are fused with IMU measurements in an Extended Kalman Filter. Experimental results show that the proposed method outperforms the previous state-of-the-art learned inertial odometry approach for quadrotor pose estimation on unseen trajectories. An additional evaluation on four public quadrotor datasets, with whole trajectory shapes held out of training, confirms a lower velocity error on every held-out set and shows that the torque input is most informative when it is derived from the rotor signals. Code, data pipeline and trained models are publicly available.

0.48