CS Paper Radar

When Less is More: Emerging Network-Wide Use Cases for Hollow-Core Fibers in Optical Networks [Invited]

Mëmëdhe Ibrahimi, Giovanni Simone Sticca, Angelo Ferrara, Francesco Musumeci, Massimo Tornatore

cs.ET cs.NI ·submitted 2026-11-05 18:05 UTC · v1

Abstract

Hollow-Core Fiber (HCF) is emerging as a disruptive technology for next-generation optical networks, offering 30\% lower propagation latency than standard Single-Mode Fiber (SMF), record-low attenuation (0.05-0.1 dB/km), and nonlinearities reduced by three to four orders of magnitude. While the physical-layer benefits of HCF have been extensively demonstrated, recent industrial commitments by hyperscalers (e.g., Microsoft, Amazon) and the rapid maturation of nested antiresonant nodeless fibers (NANF) call for a systematic assessment of the impact of HCF at the network level. Building on a series of prior contributions, we overview four emerging network-wide use cases for the selective deployment of HCF in hybrid SMF/HCF networks: (i) latency-constrained Edge Data Center (edgeDC) consolidation; (ii) energy-efficient high-power amplification; (iii) capacity scaling via single-fiber bidirectional (BiDi) transmission; and (iv) coexistence of classical and quantum (QKD) channels. Consolidated results across realistic metro, national, and continental topologies convey a unifying message: in each use case, a selective HCF upgrade captures a significant share of the achievable benefit compared to a network overhaul. The required HCF budget is use-case-specific, i.e., 6-24\% of the total network fiber length for edgeDC consolidation (up to 50\% fewer edgeDCs), 40\% of the network links for QKD/classical coexistence (up to 38\% fewer quantum modules), and 40-60\% of the network links for energy-efficient capacity scaling via BiDi-HCF (up to 28\% lower network power per Tbps and 70\% more served traffic, at half the HCF strand count of a unidirectional HCF upgrade), whereas for energy-efficient high-power amplification the gain keeps growing with the HCF budget (up to 60\% lower network power per Tbps at the national scale) and what saturates is the benefit of increasing the EDFA output power.

Closest papers

Nearest neighbours by meaning across the whole index.

Energy-Efficient Hollow-Core Fibre Transmission

eess.SP ·2026-09-17 ·Ronit Sohanpal, Eric Sillekens, Mindaugas Jarmolovičius, Robert I. Killey, Polina Bayvel
similarity 0.59
Abstract

Hollow-core fibres (HCFs) are a promising means of increasing the throughput of coherent transmission systems. In addition to their advantages in terms of low latency, nonlinearity and attenuation, HCFs can potentially improve the energy efficiency of coherent transmission systems by reducing the number of repeaters and enabling more efficient modulation formats than SMF links. However, the relationship between the link parameters (e.g. launch power, amplifier efficiency and transceiver noise) and the energy efficiency has not been explored. In this work, we investigate energy-efficient operating regimes in HCF transmission systems. We show that the optimum energy per bit in SMF systems is ultimately throughput-limited - maximising throughput will minimise energy per bit. In contrast, the transceiver-limited throughput of HCF leads to two separate launch power optima - minimum-energy-per-bit and maximum-throughput. We derive a closed-form equation for the minimum-energy-per-bit launch power for HCF links in terms of the link parameters, including the amplifier efficiency, transceiver power consumption and link gain. We use our model to explore the impact of span length and fibre attenuation in both operating regimes, showing how energy per bit considerations significantly impact the optimum span length. Optimising for energy efficiency can lead to 50% reduction in link energy per bit for only a 3% throughput penalty at 3000 km, whilst also reducing the required amplifier launch power from >33 dBm to <23 dBm. This work highlights the importance of including physical layer energy considerations in HCF link design.

0.23

Quasi-Single-Mode Transmission over Ultra-Low Loss Few-Mode Fibre for Data Centre Interconnects

eess.SP ·2026-08-14 ·Fabio A. Barbosa, Rostislav R. Khrapko, Ming-Jun Li, Filipe M. Ferreira
published similarity 0.52
Abstract · This article has been accepted for publication in IEEE Photonics Technology Letters. This is the author's version which has not been fully e…

A novel ultra-low-loss few-mode fibre is experimentally investigated for quasi-single-mode transmission over data centre interconnect distances. Multipath interference is characterised across the C-band matching a modified Gaussian noise model to experimental results obtained with conventional training-sequence-based digital signal processing, enabling inservice assessment without traffic disruption. This model shows strong agreement with power-fluctuation measurements performed on a dedicated unmodulated-laser setup. The impact of equaliser length and digital backpropagation on system performance is also analysed. Compared with standard ultralow-loss single-mode fibres, transmission experiments reveal only minor signal-to-noise ratio degradation for up to 42-Gbaud DP-256-QAM over a 24-km span. These findings highlight the potential of ultra-low-loss few-mode fibre for scalable, highcapacity data centre interconnect applications while offering potential for future space-division multiplexing upgrades.

0.20

Towards a Connected Heterogeneous All-Medium Integrated Network (CHAIN) for Converged Connectivity Across Land, Sea, Air, and Space

cs.NI eess.SP ·2026-09-12 ·Paul Anthony Haigh, Sujan Rajbhandari, Kyle Bottrill, Abderrahmen Trichili, Scott Watson +10 more
survey similarity 0.43
Abstract

Next-generation connectivity depends on data traversing multiple physical media within a single end-to-end path, yet research in optical fibre, free-space optical and radio wireless, non-terrestrial networks, and underwater communications has advanced largely in isolation. This fragmentation has a wider adverse impact on communication performance, deployment and adaption as the most demanding open problems in next-generation connectivity, cross-medium channel characterisation, transport-layer protocol design across heterogeneous latency regimes, and cross-domain orchestration, sit at the boundaries between domains and can only be addressed by bringing these challenges together in cross-domain systems. Space-air-ground integrated network research has begun to treat three domains analytically, and its recent extension to the sea surface represents the most ambitious multi-domain framework proposed to date, yet neither has produced experimental results, a deployed system, or a standards engagement. The subsurface and maritime domain remains absent from both. This paper proposes the connected heterogeneous all-medium integrated network (CHAIN), a framework that treats the undersea, maritime, terrestrial, aerial and space domains as a single design space. We identify an all-photonic network backbone as the unifying physical infrastructure, Artificial intelligence (AI)-driven orchestration as the cross-domain control layer, and the joints between domains as a unification challenge. We survey the state of the art across all domains and the existing cross-domain literature, develop the CHAIN framework and its technical pillars, characterise the five core open problems the field must resolve, and set out a research roadmap from near-term measurement campaigns and testbed validation through cross-medium field trials to global-scale deployment.

0.24

Practical wavelength selection for quantum-augmented networks over shared optical fiber

cs.CR quant-phcs.NI ·2026-10-14 ·Nitin Jha, Prateek Paudel, Abhishek Parakh
theory similarity 0.43
Abstract

In a quantum augmented network, sharing optical fiber with classical traffic requires quantum wavelength selection to balance logical fidelity, block acceptance, and classical data reception. Here we develop a wavelength-selection framework for an error-corrected three-stage quantum communication protocol. Under a thermal-background model with independent errors, an ideal one-photon receiver, and ideal recovery, we derive an accepted qubit channel and a key-independent lower bound on logical entanglement fidelity. Combining this bound with block acceptance gives an entanglement-fidelity yield bound, which we maximize over evaluated wavelengths subject to fidelity and classical link-budget requirements. For the Steane [[7,1,3]] code at 5 km per traversal and -10 dBm per classical channel, the largest fidelity certificate occurs near 1537 nm, whereas the largest yield bound occurs near 1551 nm. Along the 1.25 Gb/s classical link budget with 0.2% base error, the optimized yield bound falls below 10^-6 near 10 km per traversal, while fidelity remains certified at 0.99 or higher at longer spans. These results distinguish fidelity and yield constraints and identify certified operating regions for quantum-augmented networks sharing optical fiber.

0.18

A Wavelength Borrowing Architecture for Optical Data Center Networks - Extended Version

cs.NI ·2026-09-04 ·Andrea Detti, Chiara Lodovisi, Silvello Betti
similarity 0.42
Abstract

The growth of east-west traffic, along with the cost and power consumption of electronic switching, is motivating the integration of a low-power, high-rate, all-optical layer within the data center network. This paper presents a spine-leaf all-optical architecture in which the default wavelength configuration, one wavelength per source--destination leaf pair, can be reconfigured to accommodate unbalanced traffic demand: wavelengths that are unused or lightly loaded at one leaf are borrowed by another leaf with higher demand. This topology-engineering capability is combined with a traffic-engineering scheme, based on two-hop detouring, enabling the control of wavelength load while limiting the amount of detoured traffic. A key feature of the architecture is that its degree of wavelength reconfigurability is set by a single tunable parameter, the borrowing degree $B$, ranging from none to full; performance evaluation shows that performance nearly equal to that of a fully reconfigurable architecture is achieved well below the maximum $B$, saving the complexity of a fully reconfigurable solutions. The optical fabric relies on mature, data-center-grade components, namely AWGs, AWGRs, colorless OXCs, and combiners. The reconfiguration speed and the adopted dynamic control policy make the architecture suitable for network tiers where the traffic varies on timescales of tens of minutes or more, e.g., among groups of racks (pods).

0.27

Connectivity of HAPS-Based Solutions for Large-Scale Wireless Networks: A Percolation Theory Analysis

cs.NI ·2026-09-02 ·Hao Lin, Mustafa A Kishk, Mohamed-Slim Alouini
publishedtheoryhighly cited similarity 0.42
Abstract · 16 Pages, 17 figures. Published in IEEE Internet of Things Journal

In the era of sixth-generation (6G) wireless communication, numerous applications are expected to be realized, including environmental monitoring, smart agriculture, remote education, security protection, and intelligent transportation systems. These scenarios require large-scale, continuous Internet services in forests, rivers, oceans, and road networks, to name a few, where optical cables are difficult to deploy. High-altitude platform stations (HAPSs) emerge as a promising solution, offering low-latency, high-capacity services while facilitating the establishment of vertical heterogeneous networks (vHetNets) in fiber-less areas. This article investigates three HAPS-based solutions, where HAPSs can serve wireless devices directly or via gateway (GW) networks: the HAPS-to-device (H2D) scheme, the HAPS-to-GW-to-device (H2G2D) scheme, and the hybrid scheme. Leveraging percolation theory, we study the feasibility of large-scale continuous Internet coverage, where the key performance indicator (KPI) is the percolation probability. We discuss the subcritical and supercritical cases in different coverage schemes, and prove that the phase transition from zero to nonzero percolation probability appears when increasing the HAPS density or GW density. Numerical results verify that the curve of the critical condition of the phase transition exists between the derived lower bound and upper bound, which can help reduce the upfront cost of HAPS-based vHetNet solutions.

0.66

ASCEND: Automated Shockproof Cost-Efficient Network Design

cs.NI ·2026-11-16 ·Taha ValizadehAslani, Vaibhav Phatarpekar, Cameron Brackmann, Bala Ramachandran
similarity 0.42
Abstract · Submitted to IEEE Transactions on Network and Service Management

Designing resilient and cost-effective IP network topologies over an existing physical infrastructure is a challenging combinatorial optimization problem, particularly at large scale and under extensive failure modeling assumptions. Traditional deterministic approaches struggle to jointly address resiliency against shock (large customer-impact outages) and implementation cost objectives when the number of candidate circuits grows quadratically with the number of sites to be interconnected. In this paper, we propose Automated Shockproof Cost-Efficient Network Design (ASCEND), a systematic design pipeline for IP core network optimization based on a two-level optimization framework. At the outer level, ASCEND uses Multi-Objective Particle Swarm Optimization (MOPSO) to select core sites and core circuits. Given a core design, the inner-level integral Multi-Commodity Flow (MCF) formulation selects edge circuits and maps both core and edge circuits onto optical (fiber/transport) paths while prioritizing resource disjointness and latency. Network designs are evaluated using two competing objectives: a performance cost capturing resiliency under probabilistic failure scenarios and an implementation cost. The performance cost incorporates an exponentially weighted vulnerability metric that explicitly penalizes infeasible configurations. Experimental results on multiple real-world networks demonstrate that ASCEND consistently identifies designs that outperform a manually engineered baseline in both resiliency and implementation cost.

0.30

Hierarchical Edge Computing in SAGSIN: Multi-Layer Network Architecture and Multi-Level Information Processing

eess.SY ·2026-09-24 ·Jiajie Xu, Zhengying Lou, Mohamed-Slim Alouini
published similarity 0.41
Abstract

Maritime Internet of Things (IoT) deployments increasingly rely on the space-air-ground-sea integrated network (SAGSIN) to connect underwater sensors with terrestrial and space backbones. However, the heterogeneous links along this path, ranging from bandwidth-limited and energy-hungry underwater acoustic channels to high-capacity optical links above the sea, make the transport of massive raw sensing data costly in both latency and energy, and difficult to sustain for unattended, battery-powered nodes. This article presents an edge-computing paradigm for SAGSIN built on two coupled ideas: a Multi-Layer Network Architecture (MLNA) that organizes the underwater, surface, aerial, and ground/space tiers, and Multi-Level Information Processing (MLIP) that progressively refines data from raw measurements toward compact, event-level representations as they ascend the network. We characterize the computation, transmission, and storage energy at each tier and show how distributing refinement across layers trades local processing cost against transmission and storage savings. We then discuss how MLNA-MLIP reduces latency, strengthens data privacy, improves service reliability, and manages energy to prolong network lifetime. A case study on offshore monitoring quantifies the resulting lifetime gains and identifies the optimal processing depth. Open challenges and future directions are outlined.

0.27