CS Paper Radar

Beyond the Pseudo-Inverse: GIM Precoding for Per-Antenna Power Minimisation in MU-MIMO

Hernan X. Cordova

eess.SP ·submitted 2026-11-06 12:42 UTC · v1
theory

Abstract

We study linear precoder design for multi-user MIMO downlink under per-antenna power constraints (PAPC), which arise naturally when each antenna port has its own power amplifier. While the Moore-Penrose pseudo-inverse is the unique optimal generalized inverse for zero-forcing precoding under a total power constraint [1], we prove this optimality does not extend to the MMSE/RZF case under PAPC. Any precoder in the Generalized Inverse Matrix (GIM) family shares the same effective channel and per-user SINRs as the pseudo-inverse baseline, while its null-space component reshapes the per-antenna power profile. This separation principle enables minimising peak per-antenna power at fixed SINR targets with zero SINR penalty. We characterise the convex peak-power problem over this family and its active-set optimality, establish MRT and ZF asymptotic limits, and provide a convergent first-order subgradient algorithm. Simulations with 8-64 antennas confirm gains of 1.9-3.7 dB over pseudo-inverse RZF, with GIM-MMSE eliminating essentially all PAPC violations up to 20% per-antenna budget imbalance. The framework applies directly to fully-digital massive MIMO. Cell-free and hybrid analog-digital arrays are promising extensions.

Closest papers

Nearest neighbours by meaning across the whole index.

Joint Optimization of Antenna Partitioning and Distortion-Aware Precoding for Massive MIMO-OFDM with Peak Cancellation and In-Band Distortion Compensation

eess.SP ·2026-11-13 ·Zhuoran Li, Osamu Muta, Haris Gačanin
similarity 0.66
Abstract · This work has been submitted to the IEEE for possible publication

In massive MIMO-OFDM systems, peak cancellation (PC) reduces the peak-to-average power ratio but introduces in-band distortion, where compensation signals transmitted from a subset of antennas can suppress this distortion at the users. However, their effectiveness depends on the antenna partition and compensation precoder, while nonlinear power amplifiers (PAs) generate additional distortion. This paper proposes a joint optimization method for antenna partitioning and distortion-aware compensation precoding. To enable this joint optimization, we derive a covariance-based analytical model of PC and PA distortion to predict the per-user, per-subcarrier signal-to-interference-plusdistortion- and-noise ratio (SIDNR). The predicted SIDNR is used to select the compensation precoder regularization, the disjoint antenna partition, and the number of compensation antennas. Numerical results demonstrate that joint optimization of the antenna partition and compensation precoder regularization improves BER and SIDNR-based spectral efficiency compared with fixed-partition designs, particularly at high signal-to-noise ratios.

0.25

Tri-Hybrid SWIPT with Reconfigurable Parasitic Antennas

eess.SP cs.IT ·2026-10-09 ·Thien Duc Hua, Mohammadali Mohammadi, Hien Quoc Ngo, Michail Matthaiou
similarity 0.64
Abstract

We propose a coupling-aware tri-hybrid precoding architecture for simultaneous wireless information and power transfer (SWIPT) using reconfigurable parasitic antennas. By integrating multiport network theory and information theory, we develop a third precoding layer that explicitly accounts for mutual coupling and reactive energy storage within the antenna domain. To efficiently optimize this architecture, we propose a low-complexity tri-hybrid solution comprising coordinate descent (CD) for parasitic reactive load optimization, a singular value decomposition (SVD)-based analog precoder, and a protective partial zero-forcing (PPZF) digital precoder. Numerical results demonstrate that the transmit array introduces impedance mismatch that reduces the real power accepted by the antenna array. Moreover, the proposed tri-hybrid architecture significantly outperforms hybrid precoding by constructively exploiting the coupling effects, yielding substantial gains in spectral efficiency (SE) and sum non-linear harvested energy (NLHE) at a fraction of the hardware cost.

0.35

Mutual-Coupling-Aware Joint Precoding and Antenna Positioning for Movable-Antenna MU-MIMO Systems

cs.IT eess.SP ·2026-11-03 ·Wei Guo, Tianyi Liao, Zixin Wang, Shenghui Song, Jun Zhang +1 more
similarity 0.62
Abstract · 13 pages, 6 figures, submitted to an IEEE Journal for possible publication

Movable antennas (MAs) improve wireless communications by adapting antenna positions to the propagation environment. However, antenna movement also changes the mutual coupling (MC) among elements of the transmit and receive arrays, which affects the performance of MA-enabled systems. In this paper, we investigate MC-aware joint precoding and antenna positioning for a downlink multiuser multiple-input multiple-output (MU-MIMO) system with MAs at both the base station and users. We establish an MC-aware system model by combining field-response propagation with a circuit-based representation of the transmit and receive arrays. Based on this model, we formulate a weighted sum-rate (WSR) maximization problem that jointly optimizes multi-stream precoders and antenna positions. The problem is challenging because the precoders and positions are coupled through the propagation channels and position-dependent MC matrices. To address this challenge, we reformulate the problem in the antenna-current domain to to efficiently handle the MC matrices and develop a current-domain weighted minimum mean square error (WMMSE) framework for alternating optimization. Furthermore, we handle the nonconvex position updates within the framework by using majorization--minimization (MM) and solve the resulting convex subproblems with a dedicated conic alternating direction method of multipliers (ADMM) algorithm. Simulation results demonstrate that the proposed design improves the WSR over both an MC-aware fixed array and a movable-array design that ignores MC during optimization.

0.28

Tri-Hybrid Cell-Free Massive MIMO Systems

eess.SP ·2026-10-08 ·Janith Dassanayake, Gayan Aruma Baduge
similarity 0.61
Abstract

This paper proposes a tri-hybrid precoder design, cascading digital, analog, and electromagnetic processing layers, for cell-free massive multiple-input multiple-output (CFmMIMO) systems. We jointly optimize the three-layer precoders and access point (AP) transmit power to maximize global energy efficiency (GEE) under per-AP power and fronthaul constraints. To solve this, we develop an alternating optimization algorithm. The first sub-routine maximizes sum spectral efficiency (SE) for precoder design using weighted minimum mean square error, Riemannian manifold optimization, and gradient ascent over Lorentzian phases. The second optimizes power allocation via Dinkelbach's fractional programming and successive convex approximation. Convergence and computational complexity are also analyzed. Simulation results show the proposed design improves GEE by 87% and 11% over fully digital and classical hybrid precoders, respectively, at 20dBm transmit power. Moreover, joint power optimization yields 22% SE and 16% GEE gains over equal-power baselines, while outperforming colocated architectures in SE. Finally, we identify GEE-optimal regimes for AP and RF chain counts, and demonstrate that increasing dynamic metasurface antenna sizes enhances GEE in low-power regimes with negligible active power overhead.

0.23

Finite-Aperture Modeling of Pattern-Reconfigurable Antennas for Multiuser Beamforming

eess.SP ·2026-10-07 ·Kangjian Chen, Han Qing Yang, Hang Wong
similarity 0.61
Abstract · 14 pages, 11 figures; submitted to IEEE for possible publication

This paper establishes a finite-aperture model for pattern-reconfigurable antennas (PRAs) and exploits its aperture-constrained Fourier representation to develop an efficient multiuser beamforming framework. First, we develop an ideal model by representing the complex radiation pattern using a Fourier series. By applying the Jacobi-Anger expansion, we relate the antenna aperture to the effective Fourier order and derive aperture-dependent power bounds for individual Fourier coefficients. Second, we employ a practical multiport network model and design three representative reconfigurable pixel antennas to verify the predicted effective Fourier orders and per-order power constraints. We then formulate weighted sum-rate maximization for multiuser downlink transmission under both models. Using bounded Fourier coefficients as auxiliary variables, we develop a coefficient-bound penalty-based weighted minimum mean-square error algorithm that separates continuous beamforming from discrete switch-state optimization. We further propose a one-bit neighborhood search that exploits the Sherman-Morrison identity to accelerate the discrete optimization. Simulation results validate the physical relevance of the ideal model and demonstrate multiuser sum-rate gains and reduced optimization runtime for densely switched antennas. The proposed model provides a physically grounded basis for PRA-enabled communication analysis and design, while the framework accommodates different beamforming objectives and PRA implementations.

0.32

Rotatable Antenna Relaying: Joint Precoding and Antenna Pointing Design

eess.SP ·2026-08-25 ·Ying Gao, Qingqing Wu, Wen Chen
similarity 0.60
Abstract · 13 pages,8 figures,submitted to an IEEE journal for possible publication

This paper investigates a rotatable antenna (RA)-enhanced half-duplex amplify-and-forward relaying system, where a multi-antenna base station (BS) serves multiple single-antenna users via a multi-antenna relay. The BS and users employ isotropic antennas, whereas the relay employs directional RAs whose pointing matrix is shared by both hops to avoid inter-hop reorientation delay and control overhead. We aim to maximize the minimum signal-to-interference-plus-noise ratio (SINR) among all users by jointly optimizing the BS precoding, relay precoding, and RA pointing matrices. To tackle this non-convex problem, we first investigate the single-user scenario and reduce the joint design to RA pointing optimization using the optimal relay precoding matrix available in closed form. A manifold-aware Frank--Wolfe (MFW) method is then employed to obtain a suboptimal pointing solution. Under a symmetric far-field line-of-sight geometry, we further characterize the globally optimal pointing structure and derive a directivity threshold separating common pointing from antenna splitting. Building on this MFW procedure, we next address the general multiuser scenario. Specifically, the quadratic transform is first applied to obtain an equivalent auxiliary-variable formulation, which is subsequently solved suboptimally via alternating optimization (AO). In particular, we employ a safeguarded extension of the MFW method based on log-sum-exp smoothing to update the RA pointing matrix in each AO iteration. Simulation results demonstrate that the proposed algorithms consistently achieve the best signal-to-noise ratio (SNR) and SINR performance among all considered schemes. It is further shown that the optimized RA pointing adapts to the two-hop geometry, the preferred directivity factor depends on user load, and relay placement with relatively balanced two-hop propagation conditions is generally preferable.

0.25

Sparse Rotatable Arrays (SRAs) for Cell-Free MIMO: Network-Wide Design of Antenna Activation and Panel Orientation

cs.IT ·2026-11-15 ·Ailing Zheng, Qingqing Wu, Xiyuan Liu, Wei Feng, Wen Chen +1 more
benchmark similarity 0.60
Abstract

This paper investigates a sparse rotatable array (SRA)-enabled cell-free multiuser multiple-input multiple-output (MIMO) system. Under a network-wide antenna activation budget, distributed access points (APs) select active antenna elements from their installed arrays and adjust panel orientations, enabling joint control of sparse array apertures and antenna directivity. To avoid frequent hardware reconfiguration in response to instantaneous channel variations, we formulate a two-timescale stochastic optimization problem to maximize the expected minimum-user rate. Long-term antenna activation and panel orientations are optimized based on user spatial distributions and statistical channel state information (CSI), while short-term precoders adapt to instantaneous CSI. Under line-of-sight (LoS) propagation, we derive the optimal single-user antenna allocation, characterize the two-user max-min signal-to-interference-plus-noise ratio (SINR) and establish conditions for discrete activation and panel rotation to attain the continuous-position benchmark, and obtain a closed-form multi-AP zero-forcing (ZF) allocation benchmark under a continuous antenna-count relaxation. For the general mixed-integer nonconvex stochastic problem, we develop an alternating algorithm based on sample-average approximation (SAA), integrating uplink-downlink (UL-DL) duality for short-term precoding, weighted minimum mean-square error (WMMSE) surrogates for panel-orientation optimization, and multi-start greedy search for antenna activation. Numerical results demonstrate that the proposed design outperforms the fixed-array benchmark, improves all-user service reliability with fewer active antennas, and adapts effectively to nonuniform user spatial distributions.

0.23

Finite-Resolution Microwave Linear Analog Computer (MiLAC)-Aided Multiuser Beamforming

eess.SP cs.IT ·2026-09-28 ·Zheyu Wu, Bruno Clerckx
theory similarity 0.59
Abstract · 16 pages, 7 figures, submitted to IEEE for possible publication

Large-scale antenna arrays are essential to future wireless networks but impose significant hardware and digital-processing burdens. The microwave linear analog computer (MiLAC) offers a promising architecture for addressing these challenges. In a MiLAC, beamforming is realized entirely in the analog domain through a reconfigurable multiport microwave network comprising tunable admittance elements. However, existing studies assume that these elements are continuously tunable, whereas practical implementations can support only finitely many configurable states. This paper investigates finite-resolution MiLAC-aided multiuser beamforming under lossless and reciprocal constraints with prescribed connectivity patterns. Each tunable susceptance is selected from a symmetric uniform finite-resolution codebook. We formulate an online problem that jointly optimizes the discrete susceptances and power allocation for a prescribed codebook, and an offline problem that designs the codebook based on channel statistics. By exploiting the odd-uniform codebook structure, we express each multilevel susceptance as a weighted sum of two-level variables and develop exact continuous penalty models for both the online beamforming and offline codebook design problems. We prove that, for sufficiently large penalty parameters, these penalty models are globally equivalent to their original discrete counterparts. Building on these formulations, we develop efficient ADMM-based algorithms for solving the two problems. Numerical results demonstrate that the performance of an unquantized fully-connected MiLAC can be approached with substantially reduced connectivity and finite resolution. In particular, a 3-bit stem-connected MiLAC achieves more than 95% of the sum-rate performance of the unquantized fully-connected MiLAC while requiring only 22% of its tunable components.

0.42