CS Paper Radar

NonSense: On the (In)security of FPGA Anti-tamper Sensors

Mehmet Ali Cetin, Fatemeh Khojasteh Dana, Saleh Khalaj Monfared, Nima Seyed Aghazadeh, Maryam Saadat Safa, Shahin Tajik

cs.CR ·submitted 2026-11-12 16:40 UTC · v1

Abstract

FPGAs are widely used in mission-critical systems, where a successful physical attack can have serious consequences. This makes resilience to such attacks a critical security requirement. To defend against active physical attacks, such as glitching attacks, modern FPGAs rely on on-chip sensors that detect these disturbances and trigger responses, such as key zeroization, before a device is compromised. These sensors are deployed as both hard-IP blocks and soft-IP cores, and their trustworthiness is often taken for granted. In this work, we challenge that assumption and argue that the sensors themselves are a fragile and underexplored attack surface. Drawing on recent results, we show that both the detection and response mechanisms of state-of-the-art sensors can be bypassed without invasive tampering. We further argue that sensor reliability is reduced by factors rarely captured in threat models, including the spatial and frequency-dependent behavior of the system's power delivery network, which can steer a fault to a target while sparing nearby sensors; environmental conditions such as temperature, which shift detection thresholds; and long-term aging, which drifts sensor calibration and may open silent detection gaps. Finally, we propose a set of countermeasures that harden detection and response mechanisms against these effects.

Closest papers

Nearest neighbours by meaning across the whole index.

SensorGuard-RV: Sensor-to-Register Data Protection for Resource-Constrained RISC-V Devices

cs.CR cs.AR ·2026-11-05 ·Hamid Noori, Carlton Shepherd
hot direction similarity 0.67
Abstract

Embedded systems rely on sensor measurements that traverse a complex hardware-firmware stack (e.g. peripheral interfaces, communication buses, memory, and drivers) before reaching the applications that use them. At worst, an attacker with access to this path may successfully intercept, overwrite, fabricate, or replay readings. This may cause systems that act on such data, such as flight controllers and industrial processes, to behave incorrectly or unsafely. Existing defences, such as trusted execution environments and trusted I/O paths, still depend on trusted driver software and correctly configured access control, which remain fragile in practice. In response, we present SensorGuard-RV, a hardware-first approach that delivers sensor samples into processor registers without trusting intermediate software, buses, or memory. After configuration, a write-once ownership switch hands the sensor to a fixed-function controller that performs hardware-level authenticated encryption on sensor samples under a key inaccessible to software. We develop a new RISC-V instruction then instructs the CPU to decrypt the sample and writes it to a register only after verifying its tag and rejecting replays, including across resets. We implement SensorGuard-RV on the NEORV32 core with an ADXL362 SPI accelerometer on an Artix-7 FPGA. At 100 MHz, a protected sample reaches a register in 5,191 cycles (51.9 $μ$s), of which the two Ascon authenticated encryption engines account for 30. Because fixed-function acquisition removes per-byte software polling, the protected loop sustains 19,015 transactions/s, 5.3% above a software-driven SPI baseline. The added logic (3,155 LUTs and 2,215 registers; 5.0% and 1.7% of the device) is dominated by the Ascon engine and preserves the 100 MHz clock, while estimated power rises from 118 to 368 mW.

0.29

SenTrojan: Revealing Analog Hardware Trojan Attacks on Sensors

cs.CR ·2026-11-04 ·Kun Wang, Ruochen Zhou, Wenjun Zhu, Shilin Xiao, Kai Wang +3 more
top venue similarity 0.66
Abstract · accepted by NDSS 2027

Sensors bridge the physical and digital worlds, making their integrity critical to cyber-physical system security. Existing sensor attacks largely exploit unintended and sensor-specific physical vulnerabilities, limiting their generalizability and motivating a different threat model, i.e., whether an adversary can implant hidden attack surfaces into sensors before deployment. In this paper, we present SenTrojan, an analog hardware Trojan framework for sensors. SenTrojan embeds malicious functionality into analog signal circuitry commonly shared across diverse sensor architectures, and activates the hidden behavior through crafted external physical signals. Once activated, SenTrojan can induce sensor malfunctions ranging from permanent denial-of-service to static or dynamic spoofing. To achieve these effects under different architectural constraints, we introduce two complementary designs. The Logic-Rule-Driven (LRD) Trojan adds lightweight analog monitoring logic to detect trigger features such as frequency and amplitude, enabling reliable activation across various sensor types. The Physical-Effect-Driven (PED) Trojan targets sensors with exploitable native analog effects, e.g., nonlinearity and rectification, and realizes attacks with minimal component insertion. We evaluate SenTrojan on 14 sensors spanning 6 transduction principles and demonstrate its effectiveness across diverse real-world scenarios. Overall, SenTrojan achieves an average successful trigger rate above 95%, maintains over 97% similarity to benign behavior, incurs zero false-trigger rate for LRD designs, and introduces less than 5% average deviation in drift, noise floor, and response time. To our knowledge, this work is the first systematic study of analog sensor Trojans, broadening sensor security from unintended physical vulnerabilities to intentional supply-chain compromise.

0.49

Chypothermia: Clock Freezing for Static Side-channel Attacks

cs.CR ·2026-09-10 ·Fatemeh Khojasteh Dana, Mehmet Ali Cetin, Xinrui Wang, Andrew Butler, Yuval Yarom +1 more
similarity 0.64
Abstract

Static side-channel attacks, which exploit halted-clock conditions to extract sensitive information, pose an increasing threat to chip security. To counter these attacks, various defenses have been proposed that monitor for abnormal clock behavior and trigger the clearing of sensitive data when clock anomalies are detected. In this work, we demonstrate that exposing a chip to cryogenic temperatures interferes with on-chip mixed-signal components, responsible for signal sensing and generation. Based on this observation, we develop Chypothermia, an attack that, without any electrical tampering with the system, disables the target clock sensor, the clock generation circuit, and the voltage sensors, while preserving the secret data. While effective at halting the clock, cooling is a slow process and, on its own, is often insufficient against systems equipped with temperature sensors designed to detect thermal anomalies. To bypass these protections, we combine Chypothermia with Chypnosis (Mitard et al., IEEE SP 2026) and show that, even within a moderately low-temperature operating range, this combination can halt the clock while evading detection. We implement Chypothermia on multiple FPGA/SoC platforms and demonstrate successful disabling of both soft-IP and hard-IP sensor implementations. Finally, we apply Chypothermia to the alert handler of the OpenTitan root of trust, which incorporates a state-of-the-art clock sensor, and show that the attack evades detection and prevents key zeroization. Finally, we introduce and implement an FPGA-compatible self-heating sensor as a countermeasure and demonstrate its robustness against Chypothermia.

0.26

Not Discrete Enough: On the Inherent Insecurity of dTPMs for Measured Boot

cs.CR ·2026-08-13 ·Christian Werling, Tahmid Zahin, Jean-Pierre Seifert
top venueposition similarity 0.61
Abstract · Published in: 2025 Annual Computer Security Applications Conference Workshops (ACSAC Workshops)

Measured Boot, a mechanism enabled through Trusted Platform Modules (TPMs), is commonly used for passwordless protection of data-at-rest, aiming to protect data when the device is lost or stolen. Microsoft's standpoint is neutral on which way a TPM should be implemented: Firmware-based TPMs (fTPMs) are viewed as more economical but less secure. Despite the inherent susceptibility to bus sniffing attacks, discrete TPMs (dTPMs) are still seen as the gold standard, as many deliver better on-paper tamper resistance. It is often argued that attacks against the bus can be mitigated by bus encryption and, ideally, mutual authentication between the CPU and TPM. This position paper aims to emphasize another inherent, difficult-to-mitigate attack against dTPMs that was originally shown against a TPM 1.1 over 20 years ago: We demonstrate that even brief physical access to a TPM 2.0 and the ability to boot from an attacker-controlled system enable an attacker to reset and replay arbitrary measurements, thereby allowing an attacker to unseal, for example, a disk encryption key solely protected by the TPM. While there have been attacks against fTPMs, too, we argue that their practical attack surface is fundamentally smaller. Bus protection techniques can be used to protect dTPMs, but only guard against passive attacks. After all, we argue that, from a security standpoint, firmware TPMs, or any TPM internal to the SoC, are superior to discrete (external) ones. Lastly, in order for dTPM-based setups to provide meaningful protection of sealed secrets, configurations must require a user-provided PIN or password along with the Measured Boot configuration.

0.29

Enhancing Edge AI System Security with a Stacked Hardware Security Controller for Robust and Energy-Efficient Anomaly Detectio

cs.CR cs.ET ·2026-10-31 ·Carl Benda, Eren Kurshan, Paul Franzon
similarity 0.61
Abstract · IEEE 3DIC Conference

In recent years, the growing adoption of Edge AI systems has been accompanied by a surge in security threats. Edge AI deployments face an rapidly evolving spectrum of security threats, from side-channel information leakage to ad- versarial model manipulation and physical device tampering. Conventional security mechanisms such as malware scanners and resource-intensive firewall solutions are unsuitable due to edge AIs typically limited computational resources, strict energy budgets and thermal constraints especially in battery-powered and field-deployed environments. This paper proposes a stacked, hardware-based security mechanism that enables low-overhead, continuous detection of anomalous execution patterns. Anomaly detection utilizing hard- ware performance counters and physical sensors outperforms software-based alternatives by providing key capabilities such as tamper-resistant root-of-trust isolation, negligible runtime overhead, and resilience against compromised operating systems. Experimental analysis shows that adversarial or malicious ap- plications produce observable deviations in sensor and thermal readings on Edge AI systems and hardware-based anomaly detection provides effective and low-overhead anomaly detection.

0.13

TERMon: Detecting Persistent Behavioral Threats in Edge AI via Hardware-Native Ternary Runtime Monitor

cs.CR cs.AI ·2026-09-18 ·Arish Sateesan, Edlira Dushku
published similarity 0.61
Abstract

Edge AI accelerators are increasingly deployed in safety-critical environments, where model outputs may control physical actuators, make access-control decisions, or trigger alarms. In these settings, runtime failures often remain undetected because model corruption, distribution shift, and adversarial inputs can still produce well-formed, confident predictions. This paper presents TERMon, a lightweight hardware runtime monitor that detects such anomalies by observing inference behavior rather than re-executing or formally verifying the model. TERMon represents class-conditional trusted behavior as hardware-efficient ternary patterns that are matched in parallel against a thermometer-encoded fingerprint. The ternary encoding reproduces the corresponding unquantized range decision exactly. TERMon detects harmful weight corruptions in proportion to their behavioral impact, while out-of-distribution and adversarial inputs are largely not separable using the monitored features at a strict false-positive operating point. We implemented TERMon on a PYNQ-Z2 FPGA, and the pipelined design requires no on-chip block RAM or DSPs and has a two-cycle decision latency.

0.40

Adversarially-Informed Node Criticality Identification in Power Grid Measurements

eess.SY math.OC ·2026-08-27 ·Koto Omiloli, Olugbenga Moses Anubi
similarity 0.59
Abstract

Power grid state estimation relies on sensor measurements that are increasingly vulnerable to adversarial corruption in cyberphysical environments, potentially leading to significant deviations in system observations. This motivates the need to identify critical measurement nodes whose compromise results in the most severe system-level impact. However, existing node criticality methods primarily rely on structural or steady-state analyses and do not explicitly account for adversarial effects on system behavior. To address this gap, this paper proposes an adversarially informed framework for identifying critical measurement nodes in linearized power systems. Within this framework, a structured attack generation mechanism is developed to construct stealthy and effective false data injection attacks (FDIAs) against an H-infinity resilient state estimator. Node criticality is then evaluated using coalition-based marginal contributions of compromised sensor subsets, estimated via permutation sampling over a prescribed set of admissible nodes, with the resulting importance scores mapped to the corresponding physical buses. Simulation results on the IEEE 14-bus system show that adversarially identified nodes induce larger deviations in frequency, voltage angle, and net power compared to randomly selected nodes, demonstrating the effectiveness of the proposed framework.

0.23

EVAX: Towards a Practical, Pro-active & Adaptive Architecture for High Performance & Security

cs.CR ·2026-11-08 ·Samira Mirbagher Ajorpaz, Daniel Moghimi, Jeffrey Neal Collins, Gilles Pokam, Nael Abu-Ghazaleh +1 more
top venuehighly cited similarity 0.59
Abstract · Author manuscript of 2022 55th IEEE/ACM International Symposium on Microarchitecture (MICRO), pp. 1218-1236 (2022). 19 pages

This paper provides an end-to-end solution to defend against known microarchitectural attacks such as speculative execution attacks, fault-injection attacks, covert and side channel attacks, and unknown or evasive versions of these attacks. Current defenses are attack specific and can have unacceptably high performance overhead. We propose an approach that reduces the overhead of state-of-art defenses by over 95%, by applying defenses only when attacks are detected. Many current proposed mitigations are not practical for deployment; for example, InvisiSpec has 27% overhead and Fencing has 74% overhead while protecting against only Spectre attacks. Other mitigations carry similar performance penalties. We reduce the overhead for InvisiSpec to 1.26% and for Fencing to 3.45% offering performance and security for not only spectre attacks but other known transient attacks as well, including the dangerous class of LVI and Rowhammer attacks, as well as covering a large set of future evasive and zero-day attacks. Critical to our approach is an accurate detector that is not fooled by evasive attacks and that can generalize to novel zero-day attacks. We use a novel Generative framework, Evasion Vaccination (EVAX) for training ML models and engineering new security-centric performance counters. EVAX significantly increases sensitivity to detect and classify attacks in time for mitigation to be deployed with low false positives (4 FPs in every 1M instructions in our experiments). Such performance enables efficient and timely mitigations, enabling the processor to automatically switch between performance and security as needed.

0.71