CS Paper Radar

CII: Novel CSI-RS Metric for Joint Precoder and RIS Reporting in Multi-User NextG Networks

Ali Fuat Sahin, Sefa Kayraklik, Ali Gorcin, Ibrahim Hokelek, Ertugrul Basar, Halim Yanikomeroglu

eess.SP ·submitted 2026-08-11 13:24 UTC · v1
published

Abstract

While reconfigurable intelligent surfaces (RISs) are among the key enablers for next-generation (NextG) wireless networks, efficient feedback reporting for joint base station (BS) precoding and passive RIS configuration remains a major challenge due to the associated signaling overhead. By extending the standard-compliant channel state information reference signal framework, this paper introduces a novel channel information indicator (CII) that jointly represents the active BS precoding matrix and passive RIS configuration within a single feedback metric for multi-user multiple-input single-output systems. Simulation results demonstrate that the proposed unified feedback framework significantly reduces uplink signaling overhead compared with conventional disjoint reporting schemes. Furthermore, despite only a modest increase in the feedback payload, the proposed CII-based scheme outperforms conventional precoding matrix indicator approaches in terms of system performance, offering a practical and standards-compatible solution for RIS integration in NextG wireless networks.

Comment
Accepted in IEEE CSCN2026, Copyright IEEE

Closest papers

Nearest neighbours by meaning across the whole index.

Codebook-Based Effective CSI Feedback for Precoding Design in MIMO Systems

eess.SP ·2026-09-23 ·Bikshapathi Gouda, Antti Arvola, Juha Karjalainen, Sami Hakola, Antti Tölli
similarity 0.70
Abstract · Submitted to IEEE TWC

Downlink multi-user multiple-input multiple-output (MIMO) precoding with limited channel state information (CSI) feedback in multi-cell systems is studied. Conventional codebook-based CSI feedback compresses the UE-specific physical channels, which leaves an inherent mismatch between the base-station (BS) precoders and the interference-aware UE combiners. To address this limitation, an effective CSI (ECSI) feedback framework is proposed in which UEs compute their linear combiners from precoded downlink pilots, construct corresponding post-combining effective channels, and report compact quantized representations using the same payload structure as in conventional schemes. The BS reconstructs the effective CSI and iteratively refines its precoders through over-the-air signaling without incurring additional downlink overhead. Analytical expressions are derived to characterize the effective-channel estimation error under both conventional CSI and ECSI feedback, explicitly capturing the impact of beam selection and rank truncation. Simulations demonstrate fast convergence within a few iterations and up to 30\% average sum-rate improvement over conventional CSI-based precoding, with gains reaching 100\% at the 10th percentile of per-stream rates in interference-limited conditions.

0.29

Tri-Hybrid Beamforming for T-RIS-Enabled Base Station

cs.IT ·2026-08-20 ·Hongtao Zhang, Chenlong Ding
similarity 0.65
Abstract

Transmissive reconfigurable intelligent surfaces (T-RISs) integrated into the transmitter provide a viable realization of tri-hybrid multiple-input multiple-output (MIMO), where spatial processing is distributed across the digital, analog radio-frequency (RF), and electromagnetic (EM) domains. However, unlike conventional RIS-assisted links, a transmitter-native T-RIS directly participates in radiation formation, making T-RIS front-end modeling and weighted sum-rate (WSR)-oriented joint precoding challenging under practical hardware constraints. This paper develops a unified modeling and precoding framework for transmitter-native T-RIS tri-hybrid multi-user (MU) downlink transmission. Specifically, starting from a continuous-field description, the received field is characterized by the interaction among the feed array, the programmable T-RIS aperture, and the user-side propagation, leading to a cascaded baseband input-output model for MU precoding. Furthermore, the same representation is instantiated in the Fresnel, Fraunhofer, and mixed-field regimes, so that near-field focusing and far-field angular steering can be handled within one front-end model. Additionally, a WSR maximization problem is formulated over the digital precoder, analog network, and T-RIS coefficients under power and quantization constraints. A two-level solver is then developed by coupling outer weighted minimum mean-square error (WMMSE) updates with WMMSE-induced aperture-field shaping and hardware projection. Simulations validate the modeling accuracy and convergence, and show that the proposed full tri-hybrid design improves WSR over baselines while suppressing mixed-field cross-regime leakage.

0.17

TRACE: A Modular Framework for RIS-Assisted Channel Estimation and Differential Channel-Aware Reconfiguration

eess.SP eess.SY ·2026-08-12 ·Smriti Kumar, Mansi Ambwani, Arzad Alam Kherani, Vimal Bhatia
similarity 0.59
Abstract · 14 pages, 18 figures, Submitted to IEEE TCoM for review on 18th July 2026

Reconfigurable Intelligent Surface (RIS) research tightly couples channel-estimation, control and communication, yet existing implementations often rely on fixed algorithmic pipelines, making it difficult to compare alternative estimation, tracking and communication strategies under identical conditions and to study low-overhead RIS adaptation under time-varying channels. This paper addresses both challenges through two complementary contributions. First, it presents TRACE (Toolkit for RIS-assisted channel-estimation, adaptive control and communication experimentation), a modular socket-based framework that decouples the transmitter, radio environment, controller and receiver through separate control- and data-plane interfaces, enabling reproducible evaluation across substitutable modules. Second, it proposes the differential channel-aware RIS update (DCAR) algorithm, which estimates channel perturbations from reduced probe observations using a regularized differential update to reduce retraining overhead. TRACE is validated through interchangeable minimum mean square error and orthogonal matching pursuit channel-estimation, Gaussian random walk and Gauss--Markov channel evolution, BPSK, QPSK and 16-QAM modulation techniques and multiple RIS sizes, without modifying the underlying framework. Within TRACE, DCAR is observed to reduce pilot overhead and computational complexity while maintaining beamforming performance close to Kalman-filter-based tracking under time-varying channels.

0.12

HAPS-RIS or HAPS-Relay: Which Outperforms Under Impairments with NOMA in 6G NTN?

cs.NI ·2026-09-09 ·Bilal Karaman, Faicel Khennoufa, Ilhan Basturk, Metin Ozturk, Ferdi Kara +2 more
published similarity 0.59
Abstract · accepted in GLOBECOM 2026

This paper investigates the performance of high-altitude platform station (HAPS)-assisted communication systems employing either reconfigurable intelligent surfaces (RIS) or relay stations (RS) under non-orthogonal multiple access (NOMA) scheme. Practical system impairments, including hardware impairments (HWI) and imperfect channel state information (CSI), are explicitly considered. The results show that HAPS-RIS outperforms HAPS-RS in terms of both sum-rate and energy efficiency under non-ideal conditions due to its passive nature, which avoids noise amplification. Furthermore, it is demonstrated that RIS element allocation and user spatial distribution significantly impact NOMA performance, where increased user separation and proper allocation enhance channel disparity and improve system efficiency. Despite its higher sensitivity to imperfect CSI, HAPS-RIS can effectively compensate for performance degradation through large-scale RIS element deployment, maintaining a performance advantage over half-duplex RS-based systems. These insights provide useful design guidelines for impairment-aware HAPS-assisted 6G communication systems.

0.44

UL-Assisted Parametric CSI Feedback and Prediction for FDD Systems

eess.SP ·2026-10-10 ·Hao Chang, Mingcheng Nie, Shuangyang Li, Chang Liu, Branka Vucetic +2 more
similarity 0.58
Abstract · The paper is accepeted in GlobeCom 2026

In frequency-division duplex (FDD) systems, the uplink (UL) and downlink (DL) channels are not fully reciprocal. Therefore, DL channel state information (CSI) estimated by each user equipment (UE) must be fed back to the base station (BS). However, because the channel varies between CSI acquisition and utilization, the feedback CSI may become outdated before it is used at the BS. To address this challenge, this paper proposes an UL-assisted parametric CSI feedback and prediction scheme for multi-user FDD systems with time-varying channel parameters. By exploiting the partial reciprocity between the UL and DL channel parameters, the BS first estimates the UL channel parameters from the sounding reference signals (SRSs) transmitted by the UEs. The BS then broadcasts DL pilots, allowing each UE to obtain observations containing information about its current DL channel. Instead of explicitly estimating the DL channel from these observations, each UE directly encodes them into feedback symbols and transmits the symbols to the BS. The BS decoder combines the feedback symbols with the partially reciprocal UL parameters to predict the future DL channel parameters. Finally, the corresponding DL channel matrix is synthesized from the predicted parameters using an explicit physical channel model. Simulation results on Sionna ray tracing (RT) dataset show that the proposed scheme outperforms the considered baselines in terms of channel prediction performance over different signal-to-noise ratios and prediction lengths.

0.24

Revolutionizing 6G Wireless Networks with RISs: Enhancements in Sensing and Communications

eess.SP ·2026-10-20 ·Jiguang He, Yuwen Cao, Charles Vanwynsberghe, Aymen Fakhreddine, Yi Fang +3 more
published similarity 0.57
Abstract · 7 pages, 6 figures, accepted by IEEE Communications Magazine

Reconfigurable intelligent surfaces (RISs) have emerged as one of the most promising technologies for the next-generation wireless networks, offering advantages such as cost efficiency, low power consumption, flexible deployment, and large effective aperture. Extensive studies have demonstrated the capabilities of RISs to enhance communication performance, including coverage extension, sum-rate improvement, interference suppression, security enhancement, etc. As 6G networks continue to evolve, wireless sensing is expected to play a pivotal role alongside communication. Undoubtedly, RISs possess great potential to enable seamless integration of sensing and communication by supporting both passive and active sensing paradigms. This paper explores how RISs can revolutionize wireless networks by enhancing both communication and sensing capabilities. Specifically, we highlight the fundamental principles, potential applications, and future trends of RIS-assisted integrated sensing and communication (ISAC), anticipating that RIS-enabled ISAC will become a key enabler in the upcoming 6G era.

0.23

Reconfigurable Intelligent Surfaces for Cognitive Radio Networks: Design, Optimization, and Emerging Trends

eess.SP ·2026-08-21 ·Diluka Galappaththige, Chintha Tellambura, Ranga Kulathunga, Gayan Amarasuriya Aruma Baduge
survey similarity 0.57
Abstract · 30 pages, 17 figures, 9 tables, tutorial

Reconfigurable intelligent surfaces (RISs) enable programmable wireless propagation environments, offering new opportunities for cognitive radio networks (CRNs) to improve spectrum utilization, enhance spectral and energy efficiency, and operate reliably under low signal-to-noise ratio conditions. By combining the complementary strengths of RISs and CRNs, RIS-assisted CRNs (RCNs) have emerged as a promising architecture for future 6G wireless systems. Despite their growing importance, a comprehensive survey of this rapidly evolving field has been lacking. This paper fills this gap by providing a systematic and comprehensive review of RCNs. The paper first introduces the fundamentals of CRNs and RISs, including dynamic spectrum access models, spectrum sensing techniques, RIS operating principles, and RIS architectures. It then examines the design of RCNs, covering their system architectures, deployment strategies, channel estimation, spectrum access mechanisms, communication protocols, and the joint optimization of RIS and CRN parameters. Next, the existing literature is organized into six major research directions: performance analysis, resource allocation and optimization, secure RCNs, active RISs, simultaneously transmitting and reflecting RISs, and machine learning-enabled RCNs. Finally, the paper discusses key research challenges and future directions, including scalability, practical deployment, integration with emerging 6G technologies, coexistence with evolving network architectures, standardization, and security and privacy. This survey provides a unified reference for researchers and practitioners and establishes a roadmap for the future development of RCNs.

0.25

Link-Level Performance Comparison of 5G Beamforming: Reciprocity-Based SVD vs. Codebook-Based Precoding

cs.NI eess.SP ·2026-11-06 ·S. M. Haider Ali Shuvo, Seda Dogan-Tusha, Monisha Ghosh
similarity 0.56
Abstract · 7 pages, 8 figures. Submitted to IEEE ICC 2027

Downlink (DL) precoding in mid-band MIMO relies on uplink (UL) sounding reference signals (SRS) with reciprocity-based singular value decomposition (SVD) or channel state information reference signals (CSI-RS) with codebook-based precoding matrix indicator (PMI) feedback. Although SVD precoding offers unquantized beamforming, it depends on a channel estimate from SRS transmitted at the limited user equipment (UE) power, whereas Type-I PMI is quantized but derived from a high-power CSI-RS based channel estimate. In this paper, we compare SRS-SVD and CSIRS-PMI for single-user MIMO through an end-to-end, 3GPP-compliant link-level simulation at 3.75 GHz with 100 MHz bandwidth, using a 192 antenna element gNB mapped into 32 ports, the 3GPP Release 19 UE antenna model, and ray-traced (RT) channels in Manhattan and Chicago. We show that neither scheme is uniformly superior: CSIRS-PMI serves weak and shadowed users better and reduces outage, whereas SRS-SVD achieves higher spectral efficiency (SE) and enables more multi-layer transmission for users with strong channels. The results on the Clustered Delay Line (CDL)-C statistical channel also confirm this crossover. We further show that by utilizing a simple logistic regression based on the received power of the standard CSI reference signal (CSI-RSRP) and the channel quality indicator (CQI), the gNB can select the optimal transmission scheme with around 90% accuracy, achieving an SE that closely approaches an ideal per-user selection.

0.27