CS Paper Radar

TRACE: A Modular Framework for RIS-Assisted Channel Estimation and Differential Channel-Aware Reconfiguration

Smriti Kumar, Mansi Ambwani, Arzad Alam Kherani, Vimal Bhatia

eess.SP eess.SY ·submitted 2026-08-12 08:41 UTC · v1

Abstract

Reconfigurable Intelligent Surface (RIS) research tightly couples channel-estimation, control and communication, yet existing implementations often rely on fixed algorithmic pipelines, making it difficult to compare alternative estimation, tracking and communication strategies under identical conditions and to study low-overhead RIS adaptation under time-varying channels. This paper addresses both challenges through two complementary contributions. First, it presents TRACE (Toolkit for RIS-assisted channel-estimation, adaptive control and communication experimentation), a modular socket-based framework that decouples the transmitter, radio environment, controller and receiver through separate control- and data-plane interfaces, enabling reproducible evaluation across substitutable modules. Second, it proposes the differential channel-aware RIS update (DCAR) algorithm, which estimates channel perturbations from reduced probe observations using a regularized differential update to reduce retraining overhead. TRACE is validated through interchangeable minimum mean square error and orthogonal matching pursuit channel-estimation, Gaussian random walk and Gauss--Markov channel evolution, BPSK, QPSK and 16-QAM modulation techniques and multiple RIS sizes, without modifying the underlying framework. Within TRACE, DCAR is observed to reduce pilot overhead and computational complexity while maintaining beamforming performance close to Kalman-filter-based tracking under time-varying channels.

Comment
14 pages, 18 figures, Submitted to IEEE TCoM for review on 18th July 2026

Closest papers

Nearest neighbours by meaning across the whole index.

RIS Configuration with Low-Overhead Measurements via Physics-Guided Neural Networks

eess.SP ·2026-10-20 ·Son Dinh-Van, Matthew D. Higgins
similarity 0.63
Abstract

This paper studies reconfigurable intelligent surface (RIS) configuration for a single-input single-output (SISO) communication link using a two-stage estimate-then-optimize procedure. Within this framework, two common approaches to the estimation stage are pilot-based channel estimation and received signal strength (RSS)-based channel estimation. Our hardware experiments reveal substantial inter-block phase evolution consistent with residual CFO, while simulations show that such phase rotations can severely degrade pilot-based channel estimation when left uncompensated. In contrast, RSS-based approaches are less affected by these phase rotations, although they often require a large number of measurements to achieve a near-optimal received signal-to-noise ratio (SNR). To address this measurement requirement, we propose parametric physics-guided neural blind beamforming (\textsc{P-PGNBB}) for RSS-based channel estimation. Simulations and hardware experiments confirm that the proposed method achieves a received SNR close to that obtained with perfect channel state information (CSI) and comparable to existing methods, while requiring substantially fewer RSS measurements.

0.20

CII: Novel CSI-RS Metric for Joint Precoder and RIS Reporting in Multi-User NextG Networks

eess.SP ·2026-08-11 ·Ali Fuat Sahin, Sefa Kayraklik, Ali Gorcin, Ibrahim Hokelek, Ertugrul Basar +1 more
published similarity 0.59
Abstract · Accepted in IEEE CSCN2026, Copyright IEEE

While reconfigurable intelligent surfaces (RISs) are among the key enablers for next-generation (NextG) wireless networks, efficient feedback reporting for joint base station (BS) precoding and passive RIS configuration remains a major challenge due to the associated signaling overhead. By extending the standard-compliant channel state information reference signal framework, this paper introduces a novel channel information indicator (CII) that jointly represents the active BS precoding matrix and passive RIS configuration within a single feedback metric for multi-user multiple-input single-output systems. Simulation results demonstrate that the proposed unified feedback framework significantly reduces uplink signaling overhead compared with conventional disjoint reporting schemes. Furthermore, despite only a modest increase in the feedback payload, the proposed CII-based scheme outperforms conventional precoding matrix indicator approaches in terms of system performance, offering a practical and standards-compatible solution for RIS integration in NextG wireless networks.

0.19

A Bussgang-based Latent Lifting Method: Discrete RIS Channel Estimation and Beamforming

eess.SP ·2026-11-07 ·Mintaek Oh, Namyoon Lee, Jinseok Choi
similarity 0.59
Abstract · 13 pages, 8 figures

This paper addresses the challenge of discrete phase-shift optimization in reconfigurable intelligent surface (RIS)-aided multiuser communication systems. Practical RIS hardware often utilizes low-resolution phase shifters, leading to challenging combinatorial optimization problems. To address this challenge, we propose a Bussgang-based latent lifting (BuLL) method that represents discrete phase shifts as quantized outputs of continuous latent variables. Our BuLL method calibrates the Bussgang gain and distortion covariance under a reference distribution and keeps these moments fixed during deterministic latent optimization. These fixed moments are then used to construct a distortion-aware continuous surrogate that incorporates reference-averaged discretization effects without penalty terms. For uplink channel estimation, we develop a matrix quadratic transform-based algorithm to optimize a mean-square-error surrogate. For downlink beamforming, we develop a generalized power iteration-based RIS phase-shift optimization algorithm for a spectral efficiency (SE) surrogate. Numerical results demonstrate improvements in channel estimation accuracy and sum SE over conventional benchmarks in the evaluated low-resolution RIS settings.

0.34

Exploiting Mutual Coupling Structure for Channel Estimation of Active RIS-Assisted Links

cs.IT eess.SP ·2026-09-17 ·Simon Tarboush, Pinjun Zheng, Hadi Sarieddeen, Tareq Y. Al-Naffouri, Giuseppe Caire
similarity 0.58
Abstract

Accurate channel modeling and estimation of active reconfigurable intelligent surface (RIS)-assisted links with densely integrated elements are essential to fully unleashing this technology's potential. This work adopts a physically consistent model incorporating mutual coupling (MC) effects, modeled via scattering parameters, in RIS-aided communication. We formulate the MC-aware channel estimation as a compressed sensing (CS) problem. The MC effect leads to an increase in the sensing matrix dimensions. This increased dimensionality substantially elevates the complexity of the formulated CS problem. To overcome this, we propose a low-complexity estimator that leverages the structure of the scattering matrix and MC mechanisms to obtain a reduced-size design sensing matrix. Numerical results demonstrate that our approach outperforms MC-unaware estimators by several dBs, achieving accuracy comparable to fully MC-aware solutions but with significantly lower complexity.

0.34

A Reduced Greedy Minimum Distance Phase Shift Design for Quantized RIS-Assisted Spatial Modulation

eess.SP ·2026-10-12 ·Alexander Kelly, Mark F. Flanagan
benchmark similarity 0.57
Abstract

Reconfigurable intelligent surfaces (RISs) have emerged as a key enabler for next-generation wireless networks, offering control over the propagation environment through nearly passive reflecting elements. When combined with spatial modulation (SM), an RIS shapes a finite set of noise-free signal points at the receiver, and the error rate performance under maximum-likelihood (ML) detection is governed by the smallest pairwise Euclidean distance among these points. In this paper, we propose a low-complexity RIS phase shift design algorithm for RIS-assisted SM under practical discrete phase shift control. The proposed method targets the minimum Euclidean distance directly through a reduced greedy search over the discrete set of RIS phase shifts, in contrast to existing approaches that align RIS phase shifts to maximize the effective channel gain and therefore do not directly address the dominant error events. The search effort is controlled by a small set of integer parameters, providing a tunable trade-off between bit error rate (BER) performance and computational cost. We evaluate the proposed method against continuous and quantized phase-alignment baselines, including a complexity-matched comparison against the most directly comparable benchmark. Numerical results show that the proposed method achieves a significant SNR gain over quantized phase alignment under the same discrete hardware model, and this advantage persists under imperfect channel state information.

0.24

Structured Channel Parameter Estimation for RIS-Assisted MIMO Systems via Kronecker and Tensor Factorizations

eess.SP ·2026-09-17 ·Melryllin G. O. Sousa, Jean C. S. Ferreira, Fazal-E Asim
publishedbenchmark similarity 0.57
Abstract

This paper proposes structured channel-parameter estimators for reconfigurable intelligent surface (RIS)-assisted multiple-input multiple-output (MIMO) systems employing uniform rectangular arrays under line-of-sight propagation. By exploiting the Kronecker and multilinear structures of the cascaded channel, we introduce the Successive Kronecker Factorization (SKF) alongside two Third-Order Tensor Parameter Estimation (TOPE) methods: TOPE-ALS and TOPE-HOSVD. These estimators recover spatial signatures from the pilot-filtered signal matrix, and then decouple the corresponding horizontal and vertical spatial frequencies. This structured formulation achieves benchmark estimation accuracy while reducing computational complexity, offering a efficient solution for RIS-aided systems.

0.25

Discrete Phase-Shift Optimization of Reconfigurable Intelligent Surfaces using Uniform Reference Directions

cs.PF cs.ITeess.SY ·2026-10-17 ·Pavithra P., Manoj Kumar Panda, Chandramani Singh
similarity 0.57
Abstract

Reconfigurable Intelligent Surfaces (RISs) enable programmable control of the wireless propagation environment through adjustable reflecting elements. A fundamental challenge in RIS-assisted communications is the optimization of discrete phase shifts to maximize the received signal power. While recently developed algorithms can obtain optimal solutions with linear complexity, their computational cost may still be excessive in applications requiring large-scale simulations, real-time adaptation, or repeated optimization over numerous channel realizations. This paper proposes a low-complexity discrete phase-shift optimization algorithm based on multiple reference directions within the feasible optimality sector. By evaluating candidate phase configurations generated from uniformly distributed reference directions, the proposed method systematically improves upon existing approximation approaches that rely on a fixed set of reference directions. The number of reference directions serves as a design parameter that enables a controllable trade-off between computational complexity and optimality. Extensive simulations demonstrate that the proposed algorithm achieves substantial computational speedups while maintaining a small optimality gap relative to the optimal solution. The results further show that increasing the number of reference directions progressively reduces the optimality gap, providing flexible operating points that can be tailored to application-specific complexity and performance requirements.

0.22

Pilot Decontamination via Data-aided Channel Tracking in Cell-free Massive MIMO

eess.SP ·2026-10-21 ·Varad Deshpande, Ribhu Chopra, Kumar Appaiah
similarity 0.56
Abstract

As cell-free massive MIMO emerges as a promising technology for future wireless networks, robust channel estimation becomes increasingly important. Channel estimation relies on pilot transmissions, and with increasing number of users, pilot reuse inevitably introduces contamination that degrades channel estimation and symbol detection. This limitation is compounded by rapidly evolving channels, which render the estimates obsolete over time. To address both the problems, viz. pilot contamination and channel aging without additional pilot overhead, we propose a Kalman filter-based data-aided channel tracking strategy. By leveraging the symbol estimates as virtual pilots, the proposed approach successively refines the channel estimates over time. Unlike the conventional Kalman filter model, here, the observation model depends on symbol estimates, introducing symbol uncertainty that gets coupled with channel uncertainty. This requires a careful calculation of the innovation covariance matrices. Additionally, we discuss a stochastic-gradient-descent based tracking approach with low computational complexity. Extensive simulations are used to demonstrate that successive refinement progressively decontaminates the channel estimate, achieving lower channel estimation error and improved spectral efficiency.

0.29