CS Paper Radar

Codebook-Based Effective CSI Feedback for Precoding Design in MIMO Systems

Bikshapathi Gouda, Antti Arvola, Juha Karjalainen, Sami Hakola, Antti Tölli

eess.SP ·submitted 2026-09-23 08:04 UTC · v1

Abstract

Downlink multi-user multiple-input multiple-output (MIMO) precoding with limited channel state information (CSI) feedback in multi-cell systems is studied. Conventional codebook-based CSI feedback compresses the UE-specific physical channels, which leaves an inherent mismatch between the base-station (BS) precoders and the interference-aware UE combiners. To address this limitation, an effective CSI (ECSI) feedback framework is proposed in which UEs compute their linear combiners from precoded downlink pilots, construct corresponding post-combining effective channels, and report compact quantized representations using the same payload structure as in conventional schemes. The BS reconstructs the effective CSI and iteratively refines its precoders through over-the-air signaling without incurring additional downlink overhead. Analytical expressions are derived to characterize the effective-channel estimation error under both conventional CSI and ECSI feedback, explicitly capturing the impact of beam selection and rank truncation. Simulations demonstrate fast convergence within a few iterations and up to 30\% average sum-rate improvement over conventional CSI-based precoding, with gains reaching 100\% at the 10th percentile of per-stream rates in interference-limited conditions.

Comment
Submitted to IEEE TWC

Closest papers

Nearest neighbours by meaning across the whole index.

CII: Novel CSI-RS Metric for Joint Precoder and RIS Reporting in Multi-User NextG Networks

eess.SP ·2026-08-11 ·Ali Fuat Sahin, Sefa Kayraklik, Ali Gorcin, Ibrahim Hokelek, Ertugrul Basar +1 more
published similarity 0.70
Abstract · Accepted in IEEE CSCN2026, Copyright IEEE

While reconfigurable intelligent surfaces (RISs) are among the key enablers for next-generation (NextG) wireless networks, efficient feedback reporting for joint base station (BS) precoding and passive RIS configuration remains a major challenge due to the associated signaling overhead. By extending the standard-compliant channel state information reference signal framework, this paper introduces a novel channel information indicator (CII) that jointly represents the active BS precoding matrix and passive RIS configuration within a single feedback metric for multi-user multiple-input single-output systems. Simulation results demonstrate that the proposed unified feedback framework significantly reduces uplink signaling overhead compared with conventional disjoint reporting schemes. Furthermore, despite only a modest increase in the feedback payload, the proposed CII-based scheme outperforms conventional precoding matrix indicator approaches in terms of system performance, offering a practical and standards-compatible solution for RIS integration in NextG wireless networks.

0.19

Prior-Aided Masked Vector Quantization CSI Feedback for FDD Massive MIMO Systems

cs.IT ·2026-09-15 ·Yi Song, Tianyu Yang, Kangda Zhi, Shuangyang Li, Giuseppe Caire
similarity 0.70
Abstract

Downlink channel state information (CSI) feedback is a key bottleneck in frequency-division duplex (FDD) massive MIMO systems, as the user equipment (UE) must convey its estimated channel to the base station (BS) over a limited uplink (UL) budget. To improve CSI reconstruction accuracy under tight feedback constraints, we propose prior-aided masked vector quantization (PM-VQ), a learning-based separate source--channel coding (SSCC) feedback scheme conditioned on the average angle--delay power map---a compact representation of the channel second-order statistics available at both the UE and the BS. In PM-VQ, a prior-aided encoder maps the CSI to latent tokens, and a spatially-adaptive masking module (SAMM) scores and selects the most informative tokens within the feedback budget. The selected tokens are vector-quantized and fed back together with their positions, while an adaptive de-masking module (ADM) completes the latent representation at the BS before prior-conditioned decoding. To support variable-rate compression, a single model is trained over a range of selected-token counts, enabling operation across multiple feedback dimensions without retraining. We evaluate PM-VQ against three representative baselines on a Sionna-generated 3GPP TR~38.901 UMa dataset, focusing on the most challenging diffuse regime where channel energy is spread across many angle--delay coefficients. Simulation results show that PM-VQ achieves the lowest NMSE across all tested SNR levels and feedback dimensions in this regime. Moreover, the angle--delay power-map prior remains beneficial even when estimated from only a few channel realizations.

0.29

Link-Level Performance Comparison of 5G Beamforming: Reciprocity-Based SVD vs. Codebook-Based Precoding

cs.NI eess.SP ·2026-11-06 ·S. M. Haider Ali Shuvo, Seda Dogan-Tusha, Monisha Ghosh
similarity 0.65
Abstract · 7 pages, 8 figures. Submitted to IEEE ICC 2027

Downlink (DL) precoding in mid-band MIMO relies on uplink (UL) sounding reference signals (SRS) with reciprocity-based singular value decomposition (SVD) or channel state information reference signals (CSI-RS) with codebook-based precoding matrix indicator (PMI) feedback. Although SVD precoding offers unquantized beamforming, it depends on a channel estimate from SRS transmitted at the limited user equipment (UE) power, whereas Type-I PMI is quantized but derived from a high-power CSI-RS based channel estimate. In this paper, we compare SRS-SVD and CSIRS-PMI for single-user MIMO through an end-to-end, 3GPP-compliant link-level simulation at 3.75 GHz with 100 MHz bandwidth, using a 192 antenna element gNB mapped into 32 ports, the 3GPP Release 19 UE antenna model, and ray-traced (RT) channels in Manhattan and Chicago. We show that neither scheme is uniformly superior: CSIRS-PMI serves weak and shadowed users better and reduces outage, whereas SRS-SVD achieves higher spectral efficiency (SE) and enables more multi-layer transmission for users with strong channels. The results on the Clustered Delay Line (CDL)-C statistical channel also confirm this crossover. We further show that by utilizing a simple logistic regression based on the received power of the standard CSI reference signal (CSI-RSRP) and the channel quality indicator (CQI), the gNB can select the optimal transmission scheme with around 90% accuracy, achieving an SE that closely approaches an ideal per-user selection.

0.27

Beyond RSRP: An Exploration of Alternative Metrics for Beam Management in an Urban Micro 5G NR Scenario

eess.SP ·2026-11-17 ·Saakshi Gupta, Tarun S. Cousik, Pratheek Upadhyaya, Nishith Tripathi, Jeffery Reed +1 more
similarity 0.65
Abstract

Reference Signal Received Power (RSRP) is widely used for beam selection in 5G NR as it is an easy indicator of path loss, but is not interference-aware, limiting its effectiveness in dense deployments. In this paper, we explore RSRP, Reference Signal Received Quality (RSRQ), and Signal to Interference-plus-Noise Ratio (SINR) as beam selection metrics alongside three UE-gNB association strategies in a 3GPP-compliant Urban Micro multi-cell simulation, benchmarked against Regularized Zero-Forcing (RZF) full-Channel State Information (CSI) upper bounds. Using a 3GPP-compliant Urban Micro multi-cell simulation benchmarked against RZF full-CSI upper bounds, we demonstrate two findings: directional RSRQ, despite its inter-cell interference awareness, is the worst-performing strategy in symmetric interference, and sequential association outperforms power-optimal Hungarian assignment. We also establish that the residual performance gap to full-CSI precoding stems from codebook quantization rather than metric imperfection, identifying adaptive codebook design as a mechanism to enhance performance.

0.26

Mobility- and Feedback-Aware Multi-Level Conflict-Triggered Hybrid Beamforming for Multi-User mmWave UAV Systems

eess.SP ·2026-09-14 ·Thuan Van Le, Nguyen Cong Luong, Xingwang Li, Vo Nguyen Quoc Bao, Ngo Hoang Tu
similarity 0.64
Abstract · This work has been submitted to the IEEE for possible publication. Copyright may be transferred without notice, after which this version may…

This paper investigates hybrid beamforming for multi-user large multiple-input multiple-output millimeter-wave unmanned aerial vehicle (UAV) downlink systems under mobility-induced channel aging and delayed beam-training feedback. Analog beam selection from compact delayed reports is a partial-observation decision, while additional candidate evaluations consume processing time and reduce the useful payload interval. We propose a mobility- and feedback-aware multi-level refinement strategy, termed MLR-TG, to improve robustness without always-on candidate search. Candidate subsets are ranked by a predicted net utility constructed from quantized complex coefficients of the reported codewords and the UAV mobility state, while the transmission regularized zero-forcing precoder is computed once from pilot-estimated effective channel state information (CSI) after analog selection. The refinement level is adaptively selected according to conflict severity and aging sensitivity. The selection rule is a two-statistic approximation of predicted-utility maximization, employs a system-size-invariant conflict score, and is calibrated offline on training data disjoint from evaluation. Simulations on a three-dimensional air-to-ground model with UAV attitude dynamics and common channel trajectories show that MLR-TG reduces system outage probability by 26.7% and improves the 5th-percentile user rate by 53.9% relative to greedy sector beamforming, while net spectral efficiency remains within 0.96%. Compared with always-on global top-3 refinement, MLR-TG improves net spectral efficiency by 5.5% while evaluating 77.9% fewer candidates, and remains within 3.4% of a noncausal-CSI level oracle in net spectral efficiency while requiring 86.9% fewer feedback bits than full-CSI reporting.

0.20

Mutual-Coupling-Aware Joint Precoding and Antenna Positioning for Movable-Antenna MU-MIMO Systems

cs.IT eess.SP ·2026-11-03 ·Wei Guo, Tianyi Liao, Zixin Wang, Shenghui Song, Jun Zhang +1 more
similarity 0.63
Abstract · 13 pages, 6 figures, submitted to an IEEE Journal for possible publication

Movable antennas (MAs) improve wireless communications by adapting antenna positions to the propagation environment. However, antenna movement also changes the mutual coupling (MC) among elements of the transmit and receive arrays, which affects the performance of MA-enabled systems. In this paper, we investigate MC-aware joint precoding and antenna positioning for a downlink multiuser multiple-input multiple-output (MU-MIMO) system with MAs at both the base station and users. We establish an MC-aware system model by combining field-response propagation with a circuit-based representation of the transmit and receive arrays. Based on this model, we formulate a weighted sum-rate (WSR) maximization problem that jointly optimizes multi-stream precoders and antenna positions. The problem is challenging because the precoders and positions are coupled through the propagation channels and position-dependent MC matrices. To address this challenge, we reformulate the problem in the antenna-current domain to to efficiently handle the MC matrices and develop a current-domain weighted minimum mean square error (WMMSE) framework for alternating optimization. Furthermore, we handle the nonconvex position updates within the framework by using majorization--minimization (MM) and solve the resulting convex subproblems with a dedicated conic alternating direction method of multipliers (ADMM) algorithm. Simulation results demonstrate that the proposed design improves the WSR over both an MC-aware fixed array and a movable-array design that ignores MC during optimization.

0.28

When Every Bit Counts in Quantized Beamforming: From CSI Feedback to Low-Resolution Hardware

eess.SP ·2026-10-20 ·Yasaman Khorsandmanesh, Parisa Ramezani, Emil Bjornson
similarity 0.63
Abstract

Multiple-input multiple-output (MIMO) is a key technology in modern wireless networks, but its performance is often analyzed under ideal hardware assumptions. In practical implementations, however, quantization appears throughout the signal-processing chain, including channel state information (CSI) feedback, fronthaul signaling, beamforming coefficients, data converters, and finite-resolution phase shifters. These impairments do not act independently: they alter the channel information available for beamforming, constrain the feasible transmit signals, and can ultimately limit beamforming gain and interference suppression. This article provides a perspective on quantized beamforming by connecting its main sources, performance implications, and mitigation strategies. We discuss codebook-based CSI feedback, quantization-aware beamforming, low-resolution converter modeling, and finite-resolution hybrid beamforming, and use representative numerical examples to illustrate when quantization becomes a dominant performance bottleneck. We further highlight emerging directions in joint beamforming and quantization design, adaptive-resolution architectures, and new antenna technologies with discrete hardware constraints. The key message is that finite-resolution effects should be modeled explicitly and incorporated into the beamforming design rather than treated as an afterthought.

0.20

MiLAC-Aided Beamforming for MIMO Over-the-Air Computation

cs.IT ·2026-08-13 ·Yaru Wang, Deyou Zhang, Qingchao Li, Jun Liu, Chuang Shi
similarity 0.63
Abstract

Over-the-air computation (AirComp) enables low-latency wireless data aggregation, but its accuracy is limited by imperfect signal alignment over fading channels and receiver noise. Fully digital beamforming improves aggregation accuracy in multiple-input multiple-output (MIMO) AirComp systems but requires one radio-frequency (RF) chain per antenna. To reduce this hardware burden, we investigate microwave linear analog computer (MiLAC)-aided beamforming for MIMO AirComp. Under a lossless and reciprocal MiLAC model, we jointly optimize the transmit digital precoding matrices and the receive-side MiLAC aggregation matrix to minimize the mean squared error (MSE). An alternating optimization algorithm is developed, in which the precoding matrices are optimally updated using the Karush--Kuhn--Tucker conditions and bisection, while the resulting convex aggregation matrix subproblem is solved globally using projected gradient descent. Numerical results verify the algorithm's convergence and demonstrate that MiLAC-aided beamforming approaches the MSE performance of fully digital beamforming with substantially fewer RF chains and outperforms phase-shifter-based hybrid beamforming under the same RF-chain budget.

0.04