CS Paper Radar

MiLAC-Aided Beamforming for MIMO Over-the-Air Computation

Yaru Wang, Deyou Zhang, Qingchao Li, Jun Liu, Chuang Shi

cs.IT ·submitted 2026-08-13 15:18 UTC · v1

Abstract

Over-the-air computation (AirComp) enables low-latency wireless data aggregation, but its accuracy is limited by imperfect signal alignment over fading channels and receiver noise. Fully digital beamforming improves aggregation accuracy in multiple-input multiple-output (MIMO) AirComp systems but requires one radio-frequency (RF) chain per antenna. To reduce this hardware burden, we investigate microwave linear analog computer (MiLAC)-aided beamforming for MIMO AirComp. Under a lossless and reciprocal MiLAC model, we jointly optimize the transmit digital precoding matrices and the receive-side MiLAC aggregation matrix to minimize the mean squared error (MSE). An alternating optimization algorithm is developed, in which the precoding matrices are optimally updated using the Karush--Kuhn--Tucker conditions and bisection, while the resulting convex aggregation matrix subproblem is solved globally using projected gradient descent. Numerical results verify the algorithm's convergence and demonstrate that MiLAC-aided beamforming approaches the MSE performance of fully digital beamforming with substantially fewer RF chains and outperforms phase-shifter-based hybrid beamforming under the same RF-chain budget.

Closest papers

Nearest neighbours by meaning across the whole index.

Two-Layer Microwave Linear Analog Computer (MiLAC)-Aided Multi-User MIMO Networks

eess.SP ·2026-10-28 ·Xiaohua Zhou, Tianyu Fang, Matteo Nerini, Yijie Mao, Bruno Clerckx
theory similarity 0.73
Abstract

Microwave linear analog computer (MiLAC)-aided beamforming, which performs signal processing directly in the analog domain, has recently emerged as a promising alternative to fully digital and hybrid beamforming for multi-antenna systems. However, existing studies have shown that a single lossless and reciprocal MiLAC at the transmitter cannot, in general, attain the performance of fully digital beamforming in multi-user scenarios. To overcome this limitation, we propose a two-layer MiLAC-aided transmit beamforming architecture for downlink multi-user multiple-input multiple-output (MIMO) networks. Leveraging multiport microwave network theory, we first establish a general physics-compliant model of the proposed architecture, and then derive a simplified model under the assumptions of unilateral and perfectly matched amplifiers. We prove that, with lossless and reciprocal MiLACs, the two-layer MiLAC-aided transmitter can realize any fully digital transmit beamformer, while a single-layer MiLAC-aided receiver can attain the same achievable rate as a fully digital linear combiner. We then derive closed-form mappings from fully digital transmit beamformers and receive combiners to their corresponding MiLAC-aided analog implementations. Based on these equivalence results, we formulate a sum-rate maximization problem for the considered multi-user MIMO network and develop an optimization framework for jointly designing the power allocation and scattering matrices of the MiLAC-aided transceivers. Numerical results validate the theoretical analysis and show that the proposed two-layer MiLAC-aided design attains the same sum-rate performance as its fully digital counterpart.

0.21

Frequency-Dependent Hybrid Digital and Microwave Linear Analog Computer (MiLAC) Beamforming for Multiuser MIMO-OFDM Systems

eess.SP ·2026-10-25 ·Yiyang Peng, Zheyu Wu, Bruno Clerckx
similarity 0.71
Abstract

Microwave linear analog computing (MiLAC) has recently emerged as a promising approach for reducing the hardware and digital-processing requirements of large-scale multiple-input multiple-output (MIMO) systems. In narrowband multiuser systems, hybrid digital-MiLAC beamforming can achieve digital beamforming flexibility with only as many radio-frequency (RF) chains as data streams. However, extending this advantage to wideband systems is nontrivial because practical MiLAC circuits exhibit frequency-dependent responses. In this paper, we investigate hybrid digital-MiLAC beamforming for multiuser MISO-OFDM systems with a frequency-dependent MiLAC circuit model. We characterize the frequency dependence of MiLAC by relating the susceptance of each tunable component across subcarriers to its center-frequency value. Under this frequency coupling, we show that a single MiLAC circuit generally cannot simultaneously match the desired beamforming directions across all subcarriers, highlighting the essential role of subcarrier-dependent digital precoding. We then develop a block coordinate descent (BCD) algorithm to jointly optimize the digital and MiLAC beamformers for average sum-rate maximization. In particular, an efficient alternating direction method of multipliers (ADMM) algorithm is custom-designed to handle the frequency-coupled circuit constraints in the MiLAC beamformer subproblem. Simulation results show that the proposed hybrid digital-MiLAC design outperforms conventional hybrid digital-analog beamforming, particularly when fewer RF chains are available and the channel is more frequency-selective. With $64$ transmit antennas and $4$ data streams, it attains $96.3\%$ of the digital sum-rate using only $8$ RF chains. Furthermore, under highly frequency-selective channels and using $4$ RF chains, it provides a $48\%$ sum-rate gain over the conventional hybrid design.

0.39

Finite-Resolution Microwave Linear Analog Computer (MiLAC)-Aided Multiuser Beamforming

eess.SP cs.IT ·2026-09-28 ·Zheyu Wu, Bruno Clerckx
theory similarity 0.70
Abstract · 16 pages, 7 figures, submitted to IEEE for possible publication

Large-scale antenna arrays are essential to future wireless networks but impose significant hardware and digital-processing burdens. The microwave linear analog computer (MiLAC) offers a promising architecture for addressing these challenges. In a MiLAC, beamforming is realized entirely in the analog domain through a reconfigurable multiport microwave network comprising tunable admittance elements. However, existing studies assume that these elements are continuously tunable, whereas practical implementations can support only finitely many configurable states. This paper investigates finite-resolution MiLAC-aided multiuser beamforming under lossless and reciprocal constraints with prescribed connectivity patterns. Each tunable susceptance is selected from a symmetric uniform finite-resolution codebook. We formulate an online problem that jointly optimizes the discrete susceptances and power allocation for a prescribed codebook, and an offline problem that designs the codebook based on channel statistics. By exploiting the odd-uniform codebook structure, we express each multilevel susceptance as a weighted sum of two-level variables and develop exact continuous penalty models for both the online beamforming and offline codebook design problems. We prove that, for sufficiently large penalty parameters, these penalty models are globally equivalent to their original discrete counterparts. Building on these formulations, we develop efficient ADMM-based algorithms for solving the two problems. Numerical results demonstrate that the performance of an unquantized fully-connected MiLAC can be approached with substantially reduced connectivity and finite resolution. In particular, a 3-bit stem-connected MiLAC achieves more than 95% of the sum-rate performance of the unquantized fully-connected MiLAC while requiring only 22% of its tunable components.

0.41

ISAC Beamforming Design Based on a Matrix Nearness Formulation With Improved Efficiency

eess.SP ·2026-08-23 ·Berkan Kilic, Kenan Turbic, Slawomir Stanczak
published similarity 0.67
Abstract

We propose an integrated sensing and communication (ISAC) beamforming method that performs joint multiple-input multiple-output (MIMO) radar sensing and multi-user MIMO communication. Our approach builds on a matrix nearness formulation of the MIMO radar problem and utilizes our recently proposed efficient solver, where the computational complexity is dominated by an eigenvalue decomposition (EVD) evaluation at each iteration. We extend this formulation to an ISAC scenario by incorporating minimum signal-to-noise ratio constraints as communication design criteria, only requiring statistical channel state information knowledge at base station. Furthermore, we propose a method to avoid the burdensome EVD evaluations in certain iterations, reducing the computation time by up to six times in a massive MIMO setting.

0.53

Projection-Based Partitioned MiLAC Architecture for MU-MIMO Precoding

eess.SP ·2026-11-16 ·Israel Coelho Cunha, Francisco L. F. Martins, Giovanni G. R. Milan, Fazal Asim, André L. F. de Almeida
published similarity 0.67
Abstract · 5 pages, 3 figures

This work proposes a partitioned Microwave Linear Analog Computer (MiLAC) architecture for user-specific MU-MIMO precoding based on independently configured analog subnetworks. The proposed method reformulates user-level interference suppression as an invertible projection-based transformation, which is computed from the channel and synthesized into the MiLAC admittances. While the resulting offline configuration incurs higher computational complexity than conventional ZFBF and regularized ZFBF, it remains substantially below fully digital Block Diagonalization. Once configured, the Sub-MiLACs perform the precoding operation in the analog domain, yielding significantly lower online processing complexity. Under ideal conditions, the proposed method achieves performance close to fully digital BD.

0.36

Mutual-Coupling-Aware Joint Precoding and Antenna Positioning for Movable-Antenna MU-MIMO Systems

cs.IT eess.SP ·2026-11-03 ·Wei Guo, Tianyi Liao, Zixin Wang, Shenghui Song, Jun Zhang +1 more
similarity 0.66
Abstract · 13 pages, 6 figures, submitted to an IEEE Journal for possible publication

Movable antennas (MAs) improve wireless communications by adapting antenna positions to the propagation environment. However, antenna movement also changes the mutual coupling (MC) among elements of the transmit and receive arrays, which affects the performance of MA-enabled systems. In this paper, we investigate MC-aware joint precoding and antenna positioning for a downlink multiuser multiple-input multiple-output (MU-MIMO) system with MAs at both the base station and users. We establish an MC-aware system model by combining field-response propagation with a circuit-based representation of the transmit and receive arrays. Based on this model, we formulate a weighted sum-rate (WSR) maximization problem that jointly optimizes multi-stream precoders and antenna positions. The problem is challenging because the precoders and positions are coupled through the propagation channels and position-dependent MC matrices. To address this challenge, we reformulate the problem in the antenna-current domain to to efficiently handle the MC matrices and develop a current-domain weighted minimum mean square error (WMMSE) framework for alternating optimization. Furthermore, we handle the nonconvex position updates within the framework by using majorization--minimization (MM) and solve the resulting convex subproblems with a dedicated conic alternating direction method of multipliers (ADMM) algorithm. Simulation results demonstrate that the proposed design improves the WSR over both an MC-aware fixed array and a movable-array design that ignores MC during optimization.

0.28

Structure-Exploiting ADMM for Low-Complexity Finite-Blocklength Beamforming in Cellular IoT Networks

eess.SP ·2026-10-11 ·Asim Ihsan, Muhammad Asif, Ali Arshad Nasir, Wali Ullah Khan, Galymzhan Nauryzbayev +1 more
benchmark similarity 0.65
Abstract · 14 pages, 8 figures. Submitted to IEEE

Ultra-reliable and low-latency communication (URLLC) is essential for mission-critical cellular Internet of Things (IoT) applications requiring reliable short-packet transmission and efficient radio-resource allocation. However, finite-blocklength (FBL)-aware beamforming becomes computationally demanding as the numbers of users and antennas increase. Existing successive convex approximation (SCA) methods typically rely on general-purpose convex solvers without exploiting the structure of the resulting beamforming problem. This paper develops a structure-exploiting consensus alternating direction method of multipliers (ADMM) framework for low-complexity FBL-aware beamforming in downlink multi-user multiple-input single-output (MU-MISO) cellular IoT networks. The FBL sum rate is maximized subject to transmit-power and per-user minimum-rate constraints. Each SCA iteration yields a convex quadratically constrained quadratic program (QCQP), reformulated into an equivalent consensus problem. For an M-antenna base station serving N IoT nodes, the global update exploits Kronecker structure to replace an MN-by-MN factorization with a shared M-by-M factorization, while rank-one channel matrices enable low-complexity local projections. CVX-SCA serves as a general-purpose benchmark, whereas standard ADMM-SCA isolates the gains from structural exploitation. Numerical results demonstrate close agreement with CVX-SCA in objective value, feasibility, and convergence. Under user scaling, the proposed method achieves more than 4-fold end-to-end speedup over CVX-SCA and approximately 6-fold per-iteration speedup over standard ADMM-SCA, demonstrating its computational efficiency for cellular IoT resource allocation.

0.22

An Efficient SIM Beamforming Scheme Based on Physical-Empowered Projected Gradient

eess.SP ·2026-10-29 ·Yuzhi Yang, Hao Liu, Tianhao Guo, Jiancheng An, Lu Gan +2 more
similarity 0.64
Abstract · under review by ieee trans

Stacked Intelligent Metasurfaces (SIMs) have emerged as a promising technology for next-generation wireless systems. Especially in multi-input multi-output (MIMO) systems, it has the potential to realize complicated wave-domain transformations with low hardware costs and energy consumption. However, SIM-assisted MIMO systems face two major challenges in channel estimation and beamforming. As the SIM elements do not have the signal processing capability, channel estimation can only be conducted in an indirect manner, which makes it challenging. Moreover, the precoding optimization after channel estimation is non-convex and also difficult. Targeting these issues, we exploit the time-division duplex (TDD) channel reciprocity to calculate the gradient backpropagation in an over-the-air manner. Based on this structure, we propose a gradient-based optimization framework that optimizes beamforming without explicitly estimating the SIM--UE channel. The proposed method, namely the physical projected gradient descent (P2GD) method, optimizes the achievable sum rate while incorporating zero-forcing (ZF) constraints. Based on the method of incorporating the ZF restriction, we propose two variations of P2GD, namely user equipment (UE)-P2GD and base station (BS)-P2GD. We also provide a theoretical convergence analysis and projected gradient techniques to ensure physical feasibility. Simulation results show that the proposed approach can achieve suboptimal beamforming in the multi-user system within a small number of over-the-air iterations, using a per-direction signaling budget below the pilot cost of explicit SIM--UE channel estimation. The proposed method provides a low-overhead beamforming scheme for SIM systems without explicit SIM--UE channel estimation.

0.48