CS Paper Radar

Projection-Based Partitioned MiLAC Architecture for MU-MIMO Precoding

Israel Coelho Cunha, Francisco L. F. Martins, Giovanni G. R. Milan, Fazal Asim, André L. F. de Almeida

eess.SP ·submitted 2026-11-16 18:40 UTC · v1
published

Abstract

This work proposes a partitioned Microwave Linear Analog Computer (MiLAC) architecture for user-specific MU-MIMO precoding based on independently configured analog subnetworks. The proposed method reformulates user-level interference suppression as an invertible projection-based transformation, which is computed from the channel and synthesized into the MiLAC admittances. While the resulting offline configuration incurs higher computational complexity than conventional ZFBF and regularized ZFBF, it remains substantially below fully digital Block Diagonalization. Once configured, the Sub-MiLACs perform the precoding operation in the analog domain, yielding significantly lower online processing complexity. Under ideal conditions, the proposed method achieves performance close to fully digital BD.

Comment
5 pages, 3 figures

Closest papers

Nearest neighbours by meaning across the whole index.

MiLAC-Aided Beamforming for MIMO Over-the-Air Computation

cs.IT ·2026-08-13 ·Yaru Wang, Deyou Zhang, Qingchao Li, Jun Liu, Chuang Shi
similarity 0.67
Abstract

Over-the-air computation (AirComp) enables low-latency wireless data aggregation, but its accuracy is limited by imperfect signal alignment over fading channels and receiver noise. Fully digital beamforming improves aggregation accuracy in multiple-input multiple-output (MIMO) AirComp systems but requires one radio-frequency (RF) chain per antenna. To reduce this hardware burden, we investigate microwave linear analog computer (MiLAC)-aided beamforming for MIMO AirComp. Under a lossless and reciprocal MiLAC model, we jointly optimize the transmit digital precoding matrices and the receive-side MiLAC aggregation matrix to minimize the mean squared error (MSE). An alternating optimization algorithm is developed, in which the precoding matrices are optimally updated using the Karush--Kuhn--Tucker conditions and bisection, while the resulting convex aggregation matrix subproblem is solved globally using projected gradient descent. Numerical results verify the algorithm's convergence and demonstrate that MiLAC-aided beamforming approaches the MSE performance of fully digital beamforming with substantially fewer RF chains and outperforms phase-shifter-based hybrid beamforming under the same RF-chain budget.

0.04

Frequency-Dependent Hybrid Digital and Microwave Linear Analog Computer (MiLAC) Beamforming for Multiuser MIMO-OFDM Systems

eess.SP ·2026-10-25 ·Yiyang Peng, Zheyu Wu, Bruno Clerckx
similarity 0.66
Abstract

Microwave linear analog computing (MiLAC) has recently emerged as a promising approach for reducing the hardware and digital-processing requirements of large-scale multiple-input multiple-output (MIMO) systems. In narrowband multiuser systems, hybrid digital-MiLAC beamforming can achieve digital beamforming flexibility with only as many radio-frequency (RF) chains as data streams. However, extending this advantage to wideband systems is nontrivial because practical MiLAC circuits exhibit frequency-dependent responses. In this paper, we investigate hybrid digital-MiLAC beamforming for multiuser MISO-OFDM systems with a frequency-dependent MiLAC circuit model. We characterize the frequency dependence of MiLAC by relating the susceptance of each tunable component across subcarriers to its center-frequency value. Under this frequency coupling, we show that a single MiLAC circuit generally cannot simultaneously match the desired beamforming directions across all subcarriers, highlighting the essential role of subcarrier-dependent digital precoding. We then develop a block coordinate descent (BCD) algorithm to jointly optimize the digital and MiLAC beamformers for average sum-rate maximization. In particular, an efficient alternating direction method of multipliers (ADMM) algorithm is custom-designed to handle the frequency-coupled circuit constraints in the MiLAC beamformer subproblem. Simulation results show that the proposed hybrid digital-MiLAC design outperforms conventional hybrid digital-analog beamforming, particularly when fewer RF chains are available and the channel is more frequency-selective. With $64$ transmit antennas and $4$ data streams, it attains $96.3\%$ of the digital sum-rate using only $8$ RF chains. Furthermore, under highly frequency-selective channels and using $4$ RF chains, it provides a $48\%$ sum-rate gain over the conventional hybrid design.

0.39

Two-Layer Microwave Linear Analog Computer (MiLAC)-Aided Multi-User MIMO Networks

eess.SP ·2026-10-28 ·Xiaohua Zhou, Tianyu Fang, Matteo Nerini, Yijie Mao, Bruno Clerckx
theory similarity 0.64
Abstract

Microwave linear analog computer (MiLAC)-aided beamforming, which performs signal processing directly in the analog domain, has recently emerged as a promising alternative to fully digital and hybrid beamforming for multi-antenna systems. However, existing studies have shown that a single lossless and reciprocal MiLAC at the transmitter cannot, in general, attain the performance of fully digital beamforming in multi-user scenarios. To overcome this limitation, we propose a two-layer MiLAC-aided transmit beamforming architecture for downlink multi-user multiple-input multiple-output (MIMO) networks. Leveraging multiport microwave network theory, we first establish a general physics-compliant model of the proposed architecture, and then derive a simplified model under the assumptions of unilateral and perfectly matched amplifiers. We prove that, with lossless and reciprocal MiLACs, the two-layer MiLAC-aided transmitter can realize any fully digital transmit beamformer, while a single-layer MiLAC-aided receiver can attain the same achievable rate as a fully digital linear combiner. We then derive closed-form mappings from fully digital transmit beamformers and receive combiners to their corresponding MiLAC-aided analog implementations. Based on these equivalence results, we formulate a sum-rate maximization problem for the considered multi-user MIMO network and develop an optimization framework for jointly designing the power allocation and scattering matrices of the MiLAC-aided transceivers. Numerical results validate the theoretical analysis and show that the proposed two-layer MiLAC-aided design attains the same sum-rate performance as its fully digital counterpart.

0.21

Energy Efficiency in Microwave Linear Analog Computer (MiLAC)-Enabled Communications

eess.SP ·2026-08-31 ·Ahmed Magbool, Marco Di Renzo
similarity 0.62
Abstract · Submitted to the IEEE for possible publication

Microwave linear analog computers (MiLACs) have emerged as a promising architecture for energy-efficient wireless communications by shifting signal processing from the digital to the analog domain using tunable impedance networks. Several MiLAC architectures have recently been proposed, including the single-layer MiLAC (SLM), two-layer MiLAC (TLM), and hybrid digital-MiLAC (HDM). In this paper, we investigate the energy efficiency (EE) of these architectures. Specifically, we formulate EE maximization problems for the SLM, TLM, and HDM architectures under transmit power, user rate, and architecture-specific constraints, and develop a dimensionality reduction technique with successive convex approximation (SCA)-based algorithms to efficiently solve the resulting non-convex problems. We further derive a computationally efficient solution for EE maximization based on a search over only $(K+1)$ closed-form candidate solutions, where $K$ is the number of users, and analyze the asymptotic EE in the large-antenna regime under negligible quantization noise. Our analysis shows that the EE of the SLM, TLM, and HDM architectures scales as $\ln(N)/N^2$, whereas conventional digital beamforming (DBF) scales as $\ln(N)/N$, where $N$ denotes the number of transmit antennas. Despite these different scaling laws, the faster EE decay of MiLAC-based architectures becomes relevant only at very large antenna dimensions, typically involving thousands of antennas, while they maintain superior EE over practically relevant finite antenna regimes. Finally, we derive an approximation of the number of antennas required to achieve the maximum EE for each architecture and the corresponding EE. Simulation results show that, over practically relevant antenna regimes, MiLAC-based architectures achieve substantially higher EE than conventional fully digital and hybrid analog-digital beamforming.

0.42

Finite-Resolution Microwave Linear Analog Computer (MiLAC)-Aided Multiuser Beamforming

eess.SP cs.IT ·2026-09-28 ·Zheyu Wu, Bruno Clerckx
theory similarity 0.60
Abstract · 16 pages, 7 figures, submitted to IEEE for possible publication

Large-scale antenna arrays are essential to future wireless networks but impose significant hardware and digital-processing burdens. The microwave linear analog computer (MiLAC) offers a promising architecture for addressing these challenges. In a MiLAC, beamforming is realized entirely in the analog domain through a reconfigurable multiport microwave network comprising tunable admittance elements. However, existing studies assume that these elements are continuously tunable, whereas practical implementations can support only finitely many configurable states. This paper investigates finite-resolution MiLAC-aided multiuser beamforming under lossless and reciprocal constraints with prescribed connectivity patterns. Each tunable susceptance is selected from a symmetric uniform finite-resolution codebook. We formulate an online problem that jointly optimizes the discrete susceptances and power allocation for a prescribed codebook, and an offline problem that designs the codebook based on channel statistics. By exploiting the odd-uniform codebook structure, we express each multilevel susceptance as a weighted sum of two-level variables and develop exact continuous penalty models for both the online beamforming and offline codebook design problems. We prove that, for sufficiently large penalty parameters, these penalty models are globally equivalent to their original discrete counterparts. Building on these formulations, we develop efficient ADMM-based algorithms for solving the two problems. Numerical results demonstrate that the performance of an unquantized fully-connected MiLAC can be approached with substantially reduced connectivity and finite resolution. In particular, a 3-bit stem-connected MiLAC achieves more than 95% of the sum-rate performance of the unquantized fully-connected MiLAC while requiring only 22% of its tunable components.

0.41

Wideband Microwave Linear Analog Computer (MiLAC) for Frequency-Flat and Frequency-Selective Processing

cs.IT eess.SP ·2026-11-01 ·Juan Vidal Alegría, Matteo Nerini, Bruno Clerckx
similarity 0.58
Abstract · 15 pages, 6 figures. Copyright information may change upon publication at an IEEE journal

Microwave linear analog computer (MiLAC) has been proposed as an analog processing architecture to perform efficient computation in the microwave domain. Consisting of reconfigurable impedance networks, a MiLAC can extract many of the gains of large multi-antenna systems without costly digital processing, e.g., achieving capacity in narrowband multiple-input single-output (MISO). However, the behavior of wideband MiLAC, required to support high data-rate transmissions, is widely unknown. The impedance components of MiLACs have non-trivial frequency-dependent response, requiring specific implementations to characterize it. In this work, we consider MiLAC implementations based on LC resonators with tunable capacitance, which allow synthesizing near-arbitrary passive lossless impedance matrices at individual frequencies using inductors and varactors. We characterize the mapping between optimal MISO precoding at a reference frequency, and the vector of capacitances configuring the MiLAC. We derive the degrees of freedom (DoFs) remaining after fixing such optimum precoding at the reference frequency, and show that these DoFs can be exploited to tune the frequency response of the MiLAC. We propose two techniques to exploit these DoFs: a closed-form approach for frequency-flat MiLAC processing, and a numerical approach for multi-frequency MiLAC processing, optimizing processing at frequencies other than the reference one. The frequency-flat approach shows satisfactory performance in a simulated frequency-flat millimeter-wave scenario, approaching the performance of digital processing. The multi-frequency approach can adapt to the frequency-selectivity of a simulated sub-6GHz scenario, attaining gains over frequency-flat digital processing. This constitutes the first demonstration that realistic MiLAC implementations can be configured to perform independent computations at different frequencies.

0.27

Wave Processing Unit: Closed-Form Matrix Synthesis for Wave Computing in Multiuser MIMO Communications

eess.SP cs.IT ·2026-10-21 ·Xiaokun Teng, Yanqing Ren, Weicong Chen, Wankai Tang, Xiao Li +1 more
similarity 0.57
Abstract · Submitted to IEEE journals for possible publication

Wave computing offers a compelling route to bypass the latency and energy bottlenecks of digital baseband processing. However, existing wave-domain processors rely on task-specific, non-convex iterative optimization, which incurs substantial configuration overhead and limits real-time applications. In this paper, we propose the wave processing unit (WPU), a programmable planar Mach--Zehnder interferometer (MZI) network that accelerates matrix--vector multiplications in MIMO communications. First, we model the tunable MZI element as a parameterized $2\times2$ unitary transformation, and establish a closed-form synthesis framework for the WPU that decomposes an arbitrary unitary matrix into a cascade of MZI elements arranged in a compact rectangular topology. To handle arbitrary complex-valued operators, we further extend the method through singular value decomposition (SVD) and a hardware-efficient semi-unitary synthesis, avoiding redundant hardware and reducing the compilation complexity. We then apply the WPU to multiuser downlink precoding by an efficient WPU synthesis method, and compare the proposed architecture with hybrid and wave-domain ones. Numerical results demonstrate machine-precision synthesis with negligible residuals for up to $64\times64$ operators, with approximately $380\times$ faster configuration than iterative wave computing baselines. For 64-antenna, 8-user downlink precoding, WPU requires 87.5% fewer RF chains than the fully digital architecture while achieving the same sum rate under ideal hardware. These results highlight the potential of the WPU for precise, hardware-efficient wave-domain processing with rapid configuration.

0.23

A Universal Random Precoding Framework for MIMO Systems

eess.SP cs.IT ·2026-08-12 ·Jiazhen Dong, Lei Liu, Xiaojun Yuan, Baoming Bai
similarity 0.56
Abstract · Accepted by the 2026 IEEE International Symposium on Information Theory Workshop (ISIT 2026 Workshop)

Current wireless systems combat inter-symbol interference (ISI) by diagonalizing or sparsifying the channel matrix, yet they remain vulnerable to selective fading. To address this, we propose a universal random precoding (RP) transmission framework based on the universality class. RP leverages random transforms to statistically exploit all subchannels and construct an equivalent channel belonging to the universality class, thereby enhancing diversity gain while maintaining backward compatibility with existing waveforms. Low-complexity implementations include the randomly permuted fast transform (FT-RP) and the interleaved block-sparse fast transform (IBSFT-RP). A cross-domain OAMP/MAMP (CD-OAMP/MAMP) detector is designed for RP systems, which is replica maximum \textit{a posteriori} (MAP)-optimal according to state evolution (SE). Simulation results on MIMO systems demonstrate that RP with CD-OAMP/MAMP achieves near-RM performance with much lower complexity, with additional benefits of flexible compression ratios for spectral efficiency.

0.15