CS Paper Radar

Impedance-Aware Zonal Port Activation for Fluid Antenna Arrays

Yuanhui Wu, Hao Jiang, Zaichen Zhang

cs.IT ·submitted 2026-08-13 13:52 UTC · v1

Abstract

Fluid antenna array (FAA) activation jointly determines the effective multi-user channel for precoding and the sparse physical aperture. Channel-oriented selection can concentrate high-gain ports and erode aperture quality, whereas geometry-oriented selection does not adapt to instantaneous channel state information (CSI). This paper formulates finite-port FAA activation as a rate--aperture--feasibility problem under an exact RF-chain budget. We propose impedance-aware zonal port activation (IA-ZPA), which couples compact CSI-conditioned port scoring with a checkerboard feasibility projection and inference-time mutual-impedance-aware selection. The learned scorer ranks ports, while the deterministic rule fixes the active aperture; a separate current-domain RZF backend then evaluates source-drive feasibility. Under a common induced-EMF protocol, IA-ZPA attains the largest constrained rate among the methods satisfying the prescribed mean-PSLL target with a substantially lower decision time than greedy selection.

Closest papers

Nearest neighbours by meaning across the whole index.

Learning Representative Port Subsets for Efficient Fluid Antenna Systems

cs.IT cs.LG ·2026-10-24 ·Quan Zhou, Ming Zeng
similarity 0.65
Abstract

Fluid antenna systems (FASs) provide many candidate ports, but probing all ports for each channel realization incurs substantial online overhead. We study a complementary offline problem: compress the candidate-port space once and reuse the compressed set across future channel realizations. The method collects optimal ports from sampled training realizations, requiring only one scan of the candidate ports per realization. On a DeepMIMO 7-by-7 FAS with 49 candidate ports, 120 training realizations yield 27 representative ports on average while retaining 99.995% of the channel power gain achieved by exhaustive port selection.

0.18

EM-Guided Graph Learning for Fluid Antenna Beamforming under Current-Domain Constraints

cs.IT ·2026-08-13 ·Yuanhui Wu, Hao Jiang, Zaichen Zhang
similarity 0.65
Abstract

Fluid antenna arrays (FAAs) reconfigure a finite set of radiating ports within a prescribed aperture. In compact apertures, however, channel-driven placement may cluster ports, strengthen mutual coupling, degrade radiation conditioning, increase source-voltage demand, and produce uneven current loading. This paper studies downlink multi-user beamforming with jointly optimized port placement and current-domain transmission. An electromagnetic-guided graph network predicts port layouts from channel observations and refines them using geometric and mutual-impedance information. The training objective jointly considers communication performance and electromagnetic feasibility, while a common evaluation procedure is applied to all methods. The results show that, under a common feasibility standard, the proposed method provides a controllable tradeoff among communication rate, current loading, and configuration latency.

0.32

Sparse Port Selection under Mutual Coupling in Fluid Antenna Arrays

cs.IT ·2026-08-16 ·Jingyuan Xu, Haoyu Liang, Zaichen Zhang, Jian Dang
similarity 0.64
Abstract

Fluid antenna systems obtain spatial degrees of freedom by reconfiguring antenna positions within a confined region, a principle that extends to beamforming: shaped beams can be synthesized using far fewer radio-frequency feeds than candidate antenna positions. When the candidates are densely arranged, however, electromagnetic mutual coupling changes the relationship among terminal voltages, induced currents, and radiated fields, so an uncoupled model no longer describes the hardware and may activate an unsuitable set of ports, distorting the synthesized pattern. This paper develops a mutual-coupling-aware framework that converts the desired beam amplitude into a finite-aperture-compatible complex target and models the complete antenna lattice as a coupled multiport network, selecting the active ports and their source voltages through the coupled voltage-to-field response. Inactive candidate ports remain part of the network and carry induced currents, and every compared design is evaluated through the same electromagnetic model under the same source-voltage budget. Numerical results show that the mutual-coupling-aware design improves both the average mainlobe signal-to-noise ratio (SNR) and the peak sidelobe level (PSLL) over coupling-unaware selection and a fixed array, demonstrating that mutual coupling should be exploited in the design itself rather than compensated only in the final evaluation.

0.38

Off-Grid Position Optimization under Mutual Coupling in Fluid Antenna Arrays

cs.IT ·2026-08-16 ·Jingyuan Xu, Jian Dang, Zaichen Zhang
similarity 0.63
Abstract

Fluid antenna arrays exploit continuous antenna repositioning within a finite aperture to provide geometry diversity beyond grid-constrained port selection. Every displacement, however, changes both the radiation response and the multiport mutual-impedance network, coupling geometry optimization with the source-voltage constraint. This paper develops an electromagnetic-aware (EM-aware) beamforming framework for planar fluid antenna arrays. Phase retrieval converts an amplitude-only shaped-beam specification into an aperture-compatible complex target, and an EM-aware orthogonal matching pursuit (OMP) method selects grid-constrained initial antenna positions. Continuous refinement then alternates exact voltage-constrained current optimization with movement-constrained projected adaptive moment estimation (Adam) updates of all physical antenna positions. Across independently perturbed symmetric dual-beam targets, the proposed method consistently improves the average mainlobe signal-to-noise ratio (SNR) and reduces the peak sidelobe level (PSLL) over a uniform array and discrete port selection.

0.32

CSI Reconstruction in Fluid Antenna Systems Without Spatial Covariance Priors

cs.IT ·2026-08-10 ·Zhentian Zhang, Kaitao Meng, Tuo Wu, Kai-Kit Wong, Hao Xu +4 more
similarity 0.63
Abstract

Fluid antenna systems (FASs) exploit many candidate ports for spatial diversity, but hardware constraints allow channel observations at only a few active ports. Whether full-port CSI can be recovered without pre-acquired channel statistics remains open. Under the Clarke isotropic scattering model, we show that the channel lies in a low-dimensional spatial modal subspace determined by the scattering environment rather than the total port count. Consequently, recovery becomes feasible when the number of observed ports reaches the modal dimension (i.e., $M\geq r$), even when $M\ll N$. We further establish a sharp feasibility threshold: reliable recovery is impossible below this dimension regardless of SNR, whereas accuracy improves with additional observations above it. By decomposing the recovery error into modal truncation, estimation, and learning components, we derive explicit tradeoffs among RF chains, pilot overhead, transmit power, and training data. These results enable scalable prior-free full-port CSI recovery with few active ports.

0.04

Active Inference for Joint Port Selection and Pilot Allocation in Fluid Antenna Systems Under Partial CSI

eess.SP ·2026-09-02 ·Kian Fotovat, Kamran Fotovat, Zijun Wang
similarity 0.63
Abstract · 6 pages, 3 figures, 1 table

Fluid antenna systems (FAS) obtain spatial degrees of freedom by activating a few radiating ports from a dense grid of candidates, but deciding which ports to activate presupposes channel knowledge at ports that are never measured. Prior port-selection work assumes full or near-full channel state information (CSI) and treats the pilot overhead as a fixed cost. We instead formulate port selection and pilot allocation jointly as active inference. A spatio-temporal generative model -- sub-wavelength spatial correlation together with an order-p autoregressive temporal prior -- maintains a Gaussian belief over all N port channels, and the transmitter chooses both the ports it serves and the subset of them it pilots by minimizing an expected free energy that trades achievable rate against information gain and port-switching cost. Selection is greedy and submodular, at O(NM) per slot. On a 441-port grid with a hybrid front end at n_RF = 2K, the agent attains 91% of a full-CSI genie's sum rate while measuring only 2.3% of the candidate ports; pilots can then be withdrawn from ports that are still served, one fifth of them for 2% of the sum rate and two fifths for 8%. No training is required.

0.27

Movable Antenna Arrays with Imperfect Channel State Information in Rich Scattering Environments

eess.SP ·2026-08-29 ·Yizhen Zhao, Amna Irshad, Emil Bjornson
published similarity 0.61
Abstract

The growing demand for high spectral efficiency in 6G and beyond has driven research into adaptive antenna architectures capable of exploiting the spatial structure of multipath propagation channels. Conventional base station arrays are deployed with fixed element positions and cannot adapt to the instantaneous spatial structure of the propagation channel. In contrast, movable antenna (MA) systems enable dynamic reconfiguration of antenna positions, allowing the array geometry to track the channel characteristics of the current user set. While prior MA studies have demonstrated significant gains under perfect or statistical channel state information (CSI) assumptions, the interplay between imperfect instantaneous CSI, antenna placement optimization, and precoder design has received limited attention. This paper addresses this gap by proposing a practical end-to-end framework encompassing uplink pilot transmission, MMSE channel estimation under a clustered multipath model, and downlink ZF precoding designed from estimated CSI. Antenna positions are optimized via particle swarm optimization under two objectives: sum-rate maximization and max-min fairness. Simulation results show that MA gains are most pronounced under sparse, near-LoS propagation and diminish as channel richness increases. Furthermore, we reveal a fundamental coupling between array geometry and precoder design: a fairness-oriented antenna geometry encodes spatial fairness information that is only recoverable when evaluated with a compatible power allocation strategy. A mismatched precoder can completely mask the geometric advantage, leading to misleading conclusions about the robustness of antenna placement to the choice of optimization objective. These findings provide practically relevant guidance for the design and evaluation of movable antenna systems under realistic operating conditions.

0.26

Reconfiguring Sparse Apertures: Partial-Mobility Planar FAS for 2-D DOA Estimation

eess.SP ·2026-09-06 ·Xiaokai Song, Tuo Wu, Jie Tang, Maged Elkashlan, K. C. Ho +1 more
similarity 0.60
Abstract · 14 figures, 2 tables

Classical sparse arrays enlarge the sensing aperture under limited element and radio-frequency (RF) chain budgets, but their fixed geometries impose a persistent tradeoff between wide-sector identifiability and local angular resolution. This paper converts this static design into a two-state reconfigurable sparse aperture by allowing only part of a planar fluid antenna system (FAS) to move after an initial observation. A compact, Nyquist-spaced seed first provides an ambiguity-controlled acquisition geometry. The remaining fluid ports then move or switch to information-efficient refinement positions, and the measurements collected before and after reconfiguration are jointly processed. We formulate the receiver under fixed total numbers of ports and RF chains, a movement budget, and a common total-snapshot budget. A policy-level Fisher information matrix (FIM) identity accounts for the observation-dependent refinement geometry. For a single source, a relaxed planar D-optimal analysis gives the corner-favoring aperture law, while a finite-port certificate bounds the information retained under spacing, reachability, and partial-actuation constraints. For multiple sources, an aperture-and-conditioning surrogate generates feasible sparse layouts that are ranked and locally refined using the exact frame FIM with coarray, spacing, and movement regularization. Seed multiple signal classification (MUSIC) identifies a reliable angular basin, followed by joint concentrated-likelihood refinement over both states. Equal-budget simulations show that reconfiguring a sparse aperture converts available area and movement into lower angular error and retains much of the all-movable gain with fewer actuated ports. They also identify the operating boundary: if a full sparse aperture can remain permanently deployed, avoiding movement and snapshot splitting can be preferable.

0.13