CS Paper Radar

Off-Grid Position Optimization under Mutual Coupling in Fluid Antenna Arrays

Jingyuan Xu, Jian Dang, Zaichen Zhang

cs.IT ·submitted 2026-08-16 08:04 UTC · v1

Abstract

Fluid antenna arrays exploit continuous antenna repositioning within a finite aperture to provide geometry diversity beyond grid-constrained port selection. Every displacement, however, changes both the radiation response and the multiport mutual-impedance network, coupling geometry optimization with the source-voltage constraint. This paper develops an electromagnetic-aware (EM-aware) beamforming framework for planar fluid antenna arrays. Phase retrieval converts an amplitude-only shaped-beam specification into an aperture-compatible complex target, and an EM-aware orthogonal matching pursuit (OMP) method selects grid-constrained initial antenna positions. Continuous refinement then alternates exact voltage-constrained current optimization with movement-constrained projected adaptive moment estimation (Adam) updates of all physical antenna positions. Across independently perturbed symmetric dual-beam targets, the proposed method consistently improves the average mainlobe signal-to-noise ratio (SNR) and reduces the peak sidelobe level (PSLL) over a uniform array and discrete port selection.

Closest papers

Nearest neighbours by meaning across the whole index.

Sparse Port Selection under Mutual Coupling in Fluid Antenna Arrays

cs.IT ·2026-08-16 ·Jingyuan Xu, Haoyu Liang, Zaichen Zhang, Jian Dang
similarity 0.79
Abstract

Fluid antenna systems obtain spatial degrees of freedom by reconfiguring antenna positions within a confined region, a principle that extends to beamforming: shaped beams can be synthesized using far fewer radio-frequency feeds than candidate antenna positions. When the candidates are densely arranged, however, electromagnetic mutual coupling changes the relationship among terminal voltages, induced currents, and radiated fields, so an uncoupled model no longer describes the hardware and may activate an unsuitable set of ports, distorting the synthesized pattern. This paper develops a mutual-coupling-aware framework that converts the desired beam amplitude into a finite-aperture-compatible complex target and models the complete antenna lattice as a coupled multiport network, selecting the active ports and their source voltages through the coupled voltage-to-field response. Inactive candidate ports remain part of the network and carry induced currents, and every compared design is evaluated through the same electromagnetic model under the same source-voltage budget. Numerical results show that the mutual-coupling-aware design improves both the average mainlobe signal-to-noise ratio (SNR) and the peak sidelobe level (PSLL) over coupling-unaware selection and a fixed array, demonstrating that mutual coupling should be exploited in the design itself rather than compensated only in the final evaluation.

0.38

Fluid Antenna Array-Enabled Near-Field ISAC: Joint Port Position Optimization and Transmit Beamforming Design

cs.IT ·2026-11-02 ·Wangqi Shi, Zhentian Zhang, Hao Jiang, Zaichen Zhang, Kin-Fai Tong
similarity 0.70
Abstract

Fluid antenna systems (FASs) have shown that activating a single port from a densely packed antenna array can yield spatial diversity comparable to that of tens of independent antennas, a property that has substantially improved communication reliability and efficiency. The fluid antenna array (FAA) extends this concept to multi-port configurations while avoiding complex multi-dimensional spatial correlation, and offers significant geometrical flexibility under a finite aperture and a limited port budget. These attributes motivate environment-adaptive array geometry for sensing in integrated sensing and communication (ISAC) systems. Although this flexibility enables adaptive array geometries that exploit near-field distance-angle information, improving multi-parameter target estimation under communication and deployment constraints remains challenging. In this paper, we propose a planar FAA-assisted near-field ISAC framework for multiuser communication and target sensing. Specifically, we derive the Fisher information matrix (FIM) and the corresponding Cramér-Rao bound (CRB) for the joint estimation of target range, zenith angle, azimuth angle, and radial velocity. Based on the derived CRB, we jointly optimize the FAA port positions and transmit beamforming to improve sensing accuracy while satisfying communication signal-to-interference-plus-noise ratio (SINR), transmit power, and physical deployment constraints. To solve the resulting non-convex problem, we develop a two-stage alternating optimization algorithm, in which transmit beamforming is optimized through semidefinite relaxation (SDR), while FAA port positions are successively optimized through discrete search and continuous refinement. Simulation results indicate that the proposed algorithm achieves favorable sensing performance while maintaining a reasonable computational cost.

0.16

Flexible Beamforming via Fluid Antenna Array: From Discrete to Continuous Array

cs.IT ·2026-10-25 ·Jingyuan Xu, Yuanhui Wu, Zhentian Zhang, Zaichen Zhang, Tuo Wu +4 more
similarity 0.67
Abstract · 12 pages, 9 figures. Submitted to IEEE Transactions on Wireless Communications

Fluid antenna arrays (FAAs) reconfigure their effective aperture by activating radiation ports from a dense set of candidate positions within a finite physical region, thereby offering geometry diversity beyond conventional fixed arrays. This paper studies arbitrary-direction far-field beam synthesis with a planar FAA. Since a fixed array adapts its beamforming weights on a predetermined spatial sampling structure, its ability to match desired beam patterns is limited when both the aperture and the number of active elements are constrained. To exploit the geometry diversity of the FAA, we propose a coarse-to-fine scheme that couples discrete port selection with continuous joint refinement. In the coarse stage, a fast Fourier transform (FFT) based phase retrieval step converts the amplitude-only beam specification into an aperture-compatible complex target, after which an FFT-tailored greedy method selects the active ports and least squares initializes their complex weights. In the fine stage, a projected adaptive moment estimation procedure jointly refines the continuous port positions and beamforming weights while enforcing the minimum interelement spacing. For the evaluated two-beam configuration, the proposed scheme increases the mainlobe energy fraction from 35.73% to 48.92% and reduces the peak sidelobe level from -2.30 dB to -3.83 dB relative to a fixed array with the same aperture and active-port count.

0.30

Impedance-Aware Zonal Port Activation for Fluid Antenna Arrays

cs.IT ·2026-08-13 ·Yuanhui Wu, Hao Jiang, Zaichen Zhang
similarity 0.63
Abstract

Fluid antenna array (FAA) activation jointly determines the effective multi-user channel for precoding and the sparse physical aperture. Channel-oriented selection can concentrate high-gain ports and erode aperture quality, whereas geometry-oriented selection does not adapt to instantaneous channel state information (CSI). This paper formulates finite-port FAA activation as a rate--aperture--feasibility problem under an exact RF-chain budget. We propose impedance-aware zonal port activation (IA-ZPA), which couples compact CSI-conditioned port scoring with a checkerboard feasibility projection and inference-time mutual-impedance-aware selection. The learned scorer ranks ports, while the deterministic rule fixes the active aperture; a separate current-domain RZF backend then evaluates source-drive feasibility. Under a common induced-EMF protocol, IA-ZPA attains the largest constrained rate among the methods satisfying the prescribed mean-PSLL target with a substantially lower decision time than greedy selection.

0.32

Fluid Antenna Channel Reconstruction with Non-Negative Least Square Detector

eess.SP cs.IT ·2026-08-24 ·Yang Chen, Jian Dang, Zaichen Zhang
similarity 0.63
Abstract

Reconstructing the full-aperture channel of a fluid antenna system (FAS) from a few activated ports requires inferring unobserved responses from limited spatial samples. This paper proposes a covariance-domain FAS channel-reconstruction method based on nonnegative least squares (NNLS). A nonuniform port arrangement constructs a difference coarray with an enlarged aperture. Vectorizing the sample covariance maps the physical array to a virtual steering dictionary, and the resulting complex covariance-fitting model is recast as a strictly equivalent real-valued NNLS problem. A projected-gradient iteration initialized at zero estimates the nonnegative angular-occurrence coefficients, and the L_s strongest well-separated peaks yield the angles of arrival (AoAs). Simulations show that the proposed FAS-NNLS estimator exploits the enlarged virtual aperture and achieves lower AoA mean squared errors than uniform linear array (ULA) multiple signal classification (ULA-MUSIC) and ULA estimation of signal parameters via rotational invariance techniques (ULA-ESPRIT). Its non-line-of-sight (NLoS) path accuracy matches FAS covariance matching pursuit, while its line-of-sight (LoS) estimation is significantly improved.

0.17

Electromagnetically Consistent Monostatic ISAC Beamforming: Mutual Coupling, Active Mismatch and Tx-Rx Leakage in Compact Dipole Arrays

eess.SP ·2026-11-05 ·Stylianos D. Asimonis, Christos Tselios, Dimitrios Tyrovolas, Ilias Politis, George K. Karagiannidis
similarity 0.62
Abstract · 6 pages, 9 figures, 2 tables. Submitted to IEEE ICC 2027

Beamforming for integrated sensing and communication (ISAC) is usually designed on ideal array manifolds with a norm constraint on the transmit signal. In a compact monostatic transceiver this hides three antenna effects: distorted embedded patterns, beam-dependent active mismatch at the power amplifiers, and transmit-to-receive leakage that raises the radar noise floor. We build a multiport scattering model of a shared-aperture dipole array directly from method-of-moments simulations and use it to formulate a Cramer-Rao bound minimizing ISAC beamformer with multiuser SINR constraints, per-port active reflection constraints and a leakage budget, solved as a semidefinite program with a one-dimensional budget search. Full-wave evaluation shows that coupling-unaware designs miss their SINR targets by up to 6.2 dB and drive amplifiers to an equivalent VSWR above 3.3 at small spacings. For spacings from 0.3 to 0.5 wavelengths, the proposed design meets all targets with an equivalent VSWR below 2 and lowers the root Cramer-Rao bound by 32 to 53 percent for 80 dB of self-interference cancellation and by a factor of 3.4 to 5.6 for 70 dB. An independent finite-difference time-domain model of the final layout in openEMS confirms that the leakage null and the ranking of the designs are preserved.

0.24

EM-Guided Graph Learning for Fluid Antenna Beamforming under Current-Domain Constraints

cs.IT ·2026-08-13 ·Yuanhui Wu, Hao Jiang, Zaichen Zhang
similarity 0.62
Abstract

Fluid antenna arrays (FAAs) reconfigure a finite set of radiating ports within a prescribed aperture. In compact apertures, however, channel-driven placement may cluster ports, strengthen mutual coupling, degrade radiation conditioning, increase source-voltage demand, and produce uneven current loading. This paper studies downlink multi-user beamforming with jointly optimized port placement and current-domain transmission. An electromagnetic-guided graph network predicts port layouts from channel observations and refines them using geometric and mutual-impedance information. The training objective jointly considers communication performance and electromagnetic feasibility, while a common evaluation procedure is applied to all methods. The results show that, under a common feasibility standard, the proposed method provides a controllable tradeoff among communication rate, current loading, and configuration latency.

0.32

Sparse Rotatable Arrays (SRA): Unifying Array Aperture and Antenna Directivity for Wireless Communications

cs.IT ·2026-08-12 ·Ailing Zheng, Qingqing Wu, Xiyuan Liu, Wen Chen
similarity 0.62
Abstract

Sparse rotatable array (SRA) is a novel reconfigurable antenna architecture that jointly exploits sparse aperture configuration and antenna directivity to enhance spatial resolution for future wireless communications. Specifically, SRA activates a subset of rotatable antennas over a large candidate aperture and adjusts their boresight directions, thereby creating a directionally selective sparse aperture with reduced hardware requirements and enhanced spatial flexibility. In this paper, we investigate an SRA-aided multi-group communication system, where users are organized into spatial groups with different service requirements. We develop a group-aware SRA design framework by jointly optimizing the sparse-aperture allocation, RA orientations, and transmit beamforming to maximize the weighted max-min signal-to-interference-plus-noise ratio (SINR). Then, we characterize the operating principles of SRA and reveal that sparse aperture improves spatial resolution by enlarging the effective array aperture, while antenna directivity suppresses inter-group coupling through directional control, thereby enabling simplified group-wise beamforming structures. Guided by these insights, we develop a structured low-complexity alternating optimization algorithm that embeds a closed-form projected group-center RA orientation rule into the sparse-aperture allocation and beamforming design. The proposed algorithm combines analysis-guided initialization, sampled multi-start antenna-allocation search, and bisection-based second-order cone programming for beamforming. Numerical results show that the proposed SRA design closely approaches fully-shared SRA benchmarks and significantly outperforms compact subarray and omni sparse-array schemes.

0.04