CS Paper Radar

TLF: Rapid Characterization of RF Transceiver Parameters in Embedded Systems via Bus-Level Interception

Larry Hernandez, Sergey Bratus

cs.CR ·submitted 2026-08-13 23:02 UTC · v1
published

Abstract

We present TLF (Transceiver Lifter Framework), a tool for recovering RF transceiver configuration and runtime behavior from bus-level traces captured between a microcontroller and its transceiver IC. A stateful protocol decoder, built against the transceiver's register and data interface, reconstructs operating RF parameters and behavior from intercepted register writes and FIFO transfers. For bus-attached transceivers whose hardware-cryptography keys are loaded through the intercepted host interface, key material is also recoverable. Where the firmware drives frequency hopping -- either through a hardware-assisted engine or a custom schedule -- the decoder extracts the channel table, hop sequence, and timing. We evaluate the approach on two targets from different Semtech families: an SX1233-based UAV C2 modem employing firmware-level FHSS with per-packet sync word rotation, and an SX1276-based Meshtastic node exercising the LoRa register overlay. From a single bus capture, processed in seconds, TLF recovers the complete register-exposed RF configuration (modulation, band plan, phase behavior) without prior knowledge of the target firmware -- sufficient to configure a matched receiver or develop targeted countermeasures. Above the chip layer, a pluggable protocol decoder interprets recovered FIFO payloads as application PDUs, demonstrated end-to-end on Meshtastic. Firmware-level cryptographic state remains, as expected, opaque. The approach requires physical access or emulation of the target hardware, and its recovery depth is bounded by the transceiver's register interface: parameters implemented entirely in firmware (custom FEC, whitening, encryption) are observable only as opaque FIFO payloads.

Comment
Accepted for publication in the Proceedings of the 2026 IEEE Military Communications Conference (MILCOM 2026). This is the authors' accepted version; the final published version will appear in IEEE Xplore. 9 pages, 4 figures, 4 tables

Closest papers

Nearest neighbours by meaning across the whole index.

LoopHIL: Looping Hardware into LLM-assisted Agents for Wireless Embedded Systems

cs.NI cs.AIcs.ARcs.SE ·2026-10-16 ·Dhairya Shah, Spanddhana Sara, Savitha Viswanadh Kandala, Ambuj Varshney
similarity 0.56
Abstract · 8 pages, 8 figures, 4 tables. Under review

LLM agents are widely used for software development and debugging, but their adoption in embedded systems, especially for wireless tasks, remains limited. This is because embedded development requires hardware-in-the-loop testing. Agents cannot directly observe the spectrum, probe pins, or measure power, so they cannot verify wireless link functionality; currently, human engineers perform this verification. We systematically evaluate whether LLM agents can establish wireless links when provided with hardware access. We introduce LoopHIL, a framework that lets agents control a multi-device RF bench, monitor it with a spectrum analyzer, logic analyzer, and energy meter, and validate links against a verification ladder, all within code-enforced safety limits. Across four increasingly complex tasks, from generating a carrier to backscatter decoding by a commercial receiver, and using six models from two vendors, hardware-in-the-loop increases task completion rates from 54% to 79% and from 17% to 83% on the most challenging task. It also halves task time and output tokens. With debugging tools, agents decrease tag power consumption by up to 96%. However, small models often report unverified claims, so independent hardware checks remain necessary.

0.56

VesperCSI: A High-Performance and Extensible CSI Acquisition Framework for Edge Wi-Fi Sensing

cs.NI cs.PFeess.SP ·2026-10-15 ·Kaan Baydemir, Sajjad Baghaee, Ilkay Ulusoy
code/data similarity 0.53
Abstract · 25 pages, 13 figures, 9 tables. Open-source implementation available at https://github.com/technicaluserx/vespercsi

Channel State Information (CSI) captures fine-grained changes in Wi-Fi channel propagation and provides a foundation for device-free sensing applications such as activity recognition, localization, and occupancy detection. The development of such applications depends on an acquisition system that can handle high-rate CSI streams while remaining extensible to the requirements of individual experiments. VesperCSI is an open-source, GPL-3.0-licensed redesign of FeitCSI for CSI acquisition with Intel AX200 and AX210 Wi-Fi interfaces. It targets high-rate acquisition on amd64 and aarch64 Linux hosts using fixed-capacity preallocated object pools and separate capture and consumer threads. A loadable plugin interface supports experiment-specific monitoring, storage, and processing. We evaluate VesperCSI and FeitCSI on Raspberry Pi CM4 receivers in a burst-traffic software crossover. At a 600-MHz all-core frequency ceiling and a target rate of 2500 frames/s, VesperCSI achieves mean sequence retention of 99.017-99.087% in 10,000-frame bursts, compared with 43.972-46.553% for FeitCSI. This ordering persists after exchanging the userspace programs between two receivers while retaining their respective drivers. The comparison therefore characterizes the tested software-and-driver packages rather than isolating userspace effects. These results support VesperCSI as a reusable acquisition component for edge-hosted Wi-Fi sensing under the evaluated workload and platform conditions.

0.50

SentryBus: A Multi-Vantage Observability Model and Validated Instrument for I2C Sensor-Interface Manipulation

cs.CR ·2026-08-17 ·Sandesh More, Elton Batista, Karla Daley, Sneha Sudhakaran
similarity 0.52
Abstract · 8 pages, 2 figures, 3 tables. Submitted to the IEEE International Conference on Physical Assurance and Inspection of Electronics (PAINE) 202…

Sensor-driven systems in medical Internet of Things devices, drones, and cyber-physical systems commonly trust a measurement once it reaches the embedded processor. An adversary on the digital interface between sensor and processor can supply a plausible value that correct firmware accepts and reports as ordinary telemetry. The hypothesis is that sensor interface manipulation leaves observable evidence on the acquisition path, that the evidence appears at different vantages depending on attacker position, and that a passive host-side monitor therefore has a measurable boundary beyond which manipulation becomes indistinguishable from legitimate acquisition. SentryBus models acquisition behavior on the I2C sensor bus using transaction timing, read and write sequences, transfer lengths, address behavior, register and FIFO state access, and raw data transitions. The adversary is modeled as an inline interposer, parallel controller, sensor replacement, or compromised host, because a commodity target-only sensor cannot initiate transfers or stretch, reorder, or delay bus transactions. A dual sided testbed captures both busses, host memory, and telemetry, and the detector consumes the host facing bus alone while the remaining vantages serve as ground truth. A physiological instantiation reports three measured results: an inline interposer bounded at 0.842 percent of acquisition service time while preserving acquisition schedule and payload content, clean acquisition stability sustained over 6304 seconds at the telemetry vantage with no clock regression, and a negative result establishing that data-transition features encode session specific signal statistics and do not transfer across capture sessions. Instrument characterization shows that a low-cost analyzer can truncate captures without kernel visible error. Controlled attack trials are still outstanding, so no detection rate is claimed.

0.35

5G CATS: 5G-Based Cryptographic Authorization Against Trafficking of Semiconductor Devices

cs.CR cs.NI ·2026-11-10 ·Sreevikram Rajaraman, Derek Ladd, Nicholas Heinrich-Barna, Srinivas Shakkottai, Jeyavijayan Rajendran
similarity 0.52
Abstract · 10 pages, 5 figures, 4 tables

Enforcing export controls on AI accelerators requires verifying where a chip operates after deployment. Round-trip time measurements can bound a chip's distance from a trusted landmark, but any jitter in honest replies forces the verifier to loosen its timeout, giving an attacker slack to relay traffic over fiber from a restricted region. Prior approaches either cross the untrusted host stack or rely on noisy power-line channels that inflate this slack. We present 5G CATS, a location certification system that pairs a co-packaged 5G radio, cryptographic engine, and hardware interlock on the GPU package with 5G Ultra-Reliable Low-Latency Communication (URLLC) base stations. Terminating the radio link inside the package removes the host software, PCIe fabric, and baseboard management controller from the verification path. We map an authenticated challenge-response protocol onto 5G's slot structure, replace permanent key erasure with short-lived execution leases, and specify a cross-check of the chip's reported serving cell against the carrier's own attachment records. In ns-3 and 5G-LENA simulations of an unloaded cell, our URLLC-based radio profile narrows the 99.9th percentile round-trip spread to 2.60 ms, more than ten times narrower than default 5G. A tracer rejects every round of a fiber relay from 300 km, against 2,000 km for default 5G. Against a 3,000 km attacker, a tracer stays safe at up to 1,410 km from the chip, against at most 619 km for PowerCATS's published model, while default 5G is never safe.

0.50

Protocol Data Unit Header Decoding and Payload Coding Recovery in the Starlink Ku-Band Downlink

eess.SP ·2026-10-21 ·Haoyan Liu, Yichuan Ma, Haotong Zhao, Chengguang Li, Min Yang
similarity 0.52
Abstract

Existing Starlink downlink studies describe synchronization, pilots, and predictable waveform elements, but these descriptions do not establish how received header bits specify payload allocations and channel coding. Using 18 frames from one continuous complex-baseband capture spanning approximately 24 ms, we identify two protocol data unit (PDU) header regions in each frame and decode their contents after receiver correction and reference-phase removal. We recover the headers' terminated rate-1/3 convolutional code with constraint length seven and an eight-bit cyclic redundancy check over the concatenated information words. The decoded bits support a conditional 20-bit layout of modulation and coding scheme (MCS) index--length pairs, linking format labels and quantities to subsequent payload regions. Predicted allocation endpoints agree with signal-based estimates in 16 of 18 frames and differ by at most two symbols in the remaining frames. We further recover modulation mappings and equivalent quasi-cyclic low-density parity-check coding relations for several payload formats, including rate-1/2 and rate-5/8 families. Fixed generators predict 78,848, 9,984, and 811,008 parity bits for formats 5, 9, and 21 without disagreement on codewords excluded from their generator fitting. Cross-modulation tests support shared encoders. Formats 28 and 37 have verified shortened cores, with 256 and 384 additional bits unexplained, while format 68 remains unresolved.

0.22

Empowering AI towards 6G: Realistic UAV Channel Data Acquisition using Open-Source Solutions

eess.SP ·2026-11-12 ·Qiuheng Zhou, Sergiy Melnyk, Hans D. Schotten, Robert Vilter, Nick Stuckert
publishedbenchmarkcode/datahot direction similarity 0.52
Abstract · 6 pages. Accepted version of a paper presented at the 2026 IEEE 103rd Vehicular Technology Conference (VTC2026-Spring), Nice, France

The "sim-to-real" gap introduced by hardware impairments motivates realistic experimental platforms for AI-native research in Non-Terrestrial Networks (NTN). This paper presents an open-source UAV-to-Ground measurement testbed built on the OpenAirInterface (OAI) stack and commodity Software Defined Radios (SDRs), enabling direct extraction of raw Sub-6 GHz Channel State Information (CSI) synchronized with flight telemetry. Through real-world flight campaigns, we observe a velocity-bandwidth decoupling effect: under unguided, measurement-only ridge extraction, dominant spectral ridges deviate strongly from the theoretical kinematic Doppler trajectory, whereas guided tracking substantially reduces this mismatch. This indicates that Doppler information is present, but not dominant, in the raw observable dynamics of commodity SDR-based measurements. We further benchmark representative deep learning predictors on this hardware-inclusive dataset and show, through a case study, that their behavior differs substantially from idealized expectations. By open-sourcing the testbed and dataset, we provide a realistic foundation for training and evaluating AI models for practical aerial network deployments.

0.76

5GDescrambler: Locating, Descrambling, and Decoding 5G Scheduling Information (long version)

cs.CR ·2026-09-07 ·Fritz Windisch, Thorsten Strufe
top venuecode/data similarity 0.52
Abstract · To be published in the Proceedings of the 2026 ACM SIGSAC Conference on Computer and Communications Security, vendors redacted

Tracking users in 5G NR has recently been successfully demonstrated by exploiting various side-channels. This allows for identification of individuals, classification of user activity in real time as well as tracking by fingerprinting, affecting billions of users with a 5G subscription and companies with private 5G deployments. However, previous work relies on weak operator configurations that leak networking parameters--either the radio network temporary identifier (RNTI) or scrambling factor ($N_{ID}$) during handshake--or to inefficiently brute-force Downlink Control Information (DCI). In this paper we present a novel technique exploiting algebraic structure to reverse DCI scrambling, fully integrated into an open-source end-to-end binary DCI sniffing pipeline. It provides enabling input for subsequent attacks like live tracking of users and supports automatic detection of control channel configurations used. We demonstrate the robustness and performance of our approach with measurement campaigns against deployments of srsRAN, OpenAirInterface5G, and two commercial vendors. It reaches block error rates of less than $1\%$ at SNRs below expected values for efficient communication, while performing significantly faster on a reference sample than a previously suggested passive technique brute-forcing the required parameters. In addition, it is entirely passive and does not rely on any side-channel leakage.

0.56

ANTMAN: An Efficient and Interpretable RTL-Level Run-Time Detection Framework for Stealthy Branch Predictor Attacks on BOOM

cs.CR ·2026-08-10 ·Muhammad Hassan, Sharjeel Imtiaz, Maria Mushtaq, Jaan Raik, Tara Ghasempouri
similarity 0.51
Abstract

Runtime detection of microarchitectural side channel attacks remains significantly underexplored in RISCV compared with x86 and ARM ISAs, posing a serious threat to critical applications. State-of-the-art branch predictor attacks bypass traditional data and instruction caches by directly exploiting the state of internal history tables, making them inherently stealthy. Recent research has explored offline detection of microarchitectural attacks on RISC-V; however, efficient runtime detection of microarchitectural attacks on RISC-V hardware remains significantly unaddressed. State-of-the-art hardware-based runtime detection solutions leverage hardware performance counters (HPCs) but suffer from a restricted set of counter registers and tradeoffs between detection accuracy, detection speed, and sampling granularity, making them impractical for stealthy attacks. Moreover, sampling HPCs after distinct intervals leaves intermediate relationships between different microarchitectural blocks unobserved. Additionally, proprietary x86 and ARM ISAs constrain researchers from modifying processor microarchitectural designs. To address these limitations, we propose the first secure-by-design, highly interpretable, non-intrusive, RTL-level runtime detection solution for stealthy branch predictor attacks on BOOM RISC-V, evaluated under both simplified Next-Line Predictor (NLP) and complex TAGE predictor configurations. The attack detection relies on association rules extracted offline and embedded in hardware as a non-intrusive rule monitor that enables runtime detection. The proposed approach achieves excellent detection speed, terminates execution before secret disclosure, and produces zero false positives while remaining flexible for detecting previously unseen variants within the same family of branch predictor attacks.

0.04