CS Paper Radar

VesperCSI: A High-Performance and Extensible CSI Acquisition Framework for Edge Wi-Fi Sensing

Kaan Baydemir, Sajjad Baghaee, Ilkay Ulusoy

cs.NI cs.PFeess.SP ·submitted 2026-10-15 19:31 UTC · v1
code/data

Abstract

Channel State Information (CSI) captures fine-grained changes in Wi-Fi channel propagation and provides a foundation for device-free sensing applications such as activity recognition, localization, and occupancy detection. The development of such applications depends on an acquisition system that can handle high-rate CSI streams while remaining extensible to the requirements of individual experiments. VesperCSI is an open-source, GPL-3.0-licensed redesign of FeitCSI for CSI acquisition with Intel AX200 and AX210 Wi-Fi interfaces. It targets high-rate acquisition on amd64 and aarch64 Linux hosts using fixed-capacity preallocated object pools and separate capture and consumer threads. A loadable plugin interface supports experiment-specific monitoring, storage, and processing. We evaluate VesperCSI and FeitCSI on Raspberry Pi CM4 receivers in a burst-traffic software crossover. At a 600-MHz all-core frequency ceiling and a target rate of 2500 frames/s, VesperCSI achieves mean sequence retention of 99.017-99.087% in 10,000-frame bursts, compared with 43.972-46.553% for FeitCSI. This ordering persists after exchanging the userspace programs between two receivers while retaining their respective drivers. The comparison therefore characterizes the tested software-and-driver packages rather than isolating userspace effects. These results support VesperCSI as a reusable acquisition component for edge-hosted Wi-Fi sensing under the evaluated workload and platform conditions.

Comment
25 pages, 13 figures, 9 tables. Open-source implementation available at https://github.com/technicaluserx/vespercsi

Closest papers

Nearest neighbours by meaning across the whole index.

FIREQ: FPGA Instrumentation for Readout and Qubit control

eess.SY quant-ph ·2026-08-29 ·Giuseppe La Capra, Fabio Calabrese, Giorgio D'Amico, Christian Conti, Andrea De Simone +6 more
code/data similarity 0.58
Abstract · 15 pages, 9 figures

We present FIREQ (FPGA Instrumentation for Readout and Qubit control), an open-source RFSoC-based framework for the control and readout of superconducting qubits. FIREQ combines a modular AXI-compliant firmware architecture with a PYNQ-based software stack designed to support extensible hardware integration, deterministic experiment timing, and low-overhead execution of repeated calibration and characterization workflows. The firmware implements direct RF synthesis and acquisition, trigger-based sequencing, programmable pulse generation, frequency-multiplexed readout, and memory-efficient acquisition and waveform buffering. The software adopts a client-server architecture with streamed data transfer and dependency-aware configuration updates to reduce host-device and reconfiguration overhead during parameter sweeps. On an AMD Zynq UltraScale+ RFSoC ZCU216, FIREQ generates RF pulses up to 9.3 GHz with a pulse-duration resolution of 107 ps and an event-timing resolution of 1.7 ns. FPGA resource utilization is compared with representative open-source RFSoC control frameworks, showing a low BRAM footprint while retaining full-rate I/Q generation and acquisition. The RF output is characterized in terms of phase noise, noise spectral density, and inter-channel timing skew. End-to-end operation is validated on a superconducting qubit through resonator spectroscopy, Rabi, Ramsey, and relaxation measurements, yielding T1 = 6.94 us and T2* = 13.50 us. FIREQ can therefore be used both as a qubit-control platform and as an experimental environment for evaluating alternative control and readout IP architectures.

0.35

Temporal vs Spectral Resolution in CSI Reporting for Wi-Fi ISAC

eess.SP ·2026-10-16 ·Abolfazl Zakeri, Sumit Roy, Nhan Thanh Nguyen, Markku Juntti
similarity 0.57
Abstract · Under review for publication

CSI feedback is fundamental to proposed uses of Wi-Fi sensing such as human activity recognition (HAR); but it also constitutes significant overhead as resources must be allocated away from data communications. Wi-Fi CSI extraction can be explored along two dimensions in IEEE 802.11bf: reporting intensity, i.e., temporal resolution, and number of reported subcarriers, i.e., spectral resolution. We explore periodic and IEEE 802.11bf threshold-based reporting at matched rates, and uniform decimation and block-mean grouping at matched report sizes. We further propose reporting the mean CSI accumulated since the last report. Using the 802.11bf report size as the metric, we evaluate the accuracy-cost tradeoffs on three public datasets with our proposed model, a convolutional neural network combined with a gated recurrent unit and temporal pyramid pooling. The proposed periodic reporting with mean payload and block-mean grouping improves accuracy by up to 53 percentage points at equal CSI overhead cost. Temporal resolution is generally more cost-effective than spectral resolution. With only at most 7.7% of full-CSI feedback cost, the proposed scheme achieves 96-98% of full-CSI accuracy.

0.23

What's Your NIC Whispering? Network Threat Behavior Recognition via NIC Electromagnetic Side-Channel Leakage

cs.CR cs.AR ·2026-08-24 ·Hongchao Wang, Linrui Li, Yunkai Zou, Zhenduo Hou, Yilin Zhang +3 more
dataset similarity 0.56
Abstract

Conventional network threat detection primarily relies on packet-level, flow-level, or host-level telemetry. This paper investigates a different observation surface: unintended electromagnetic(EM) emissions generated by network interface card(NIC) activity, and asks whether such physical leakage contains sufficiently structured information for network threat-behavior recognition. We present NICWhisper, which externally captures NIC EM emissions, transforms raw measurements into time-frequency representations, and recognizes network behaviors without inspecting packet contents or host-side runtime states. Rather than competing with traffic-based detection, NICWhisper exploits the physical manifestation of traffic-driven NIC activity, whose timing, rate, concurrency, and burst organization naturally shape the measured EM leakage. We construct a NIC EM dataset covering active benign workloads and seven representative threat behaviors under diverse execution conditions, and systematically evaluate signal dependence, execution variation, measurement perturbation, and cross-device transfer. NICWhisper achieves 80.67\% Macro-F1 across eight behavior classes, while further experiments show that the observed behavior-related information extends beyond simple signal magnitude and remains partially transferable across execution conditions and NIC hardware. These results establish NIC EM leakage as a complementary physical observation source for network security monitoring when direct access to conventional traffic or host telemetry is limited or undesirable.

0.32

Empowering AI towards 6G: Realistic UAV Channel Data Acquisition using Open-Source Solutions

eess.SP ·2026-11-12 ·Qiuheng Zhou, Sergiy Melnyk, Hans D. Schotten, Robert Vilter, Nick Stuckert
publishedbenchmarkcode/datahot direction similarity 0.53
Abstract · 6 pages. Accepted version of a paper presented at the 2026 IEEE 103rd Vehicular Technology Conference (VTC2026-Spring), Nice, France

The "sim-to-real" gap introduced by hardware impairments motivates realistic experimental platforms for AI-native research in Non-Terrestrial Networks (NTN). This paper presents an open-source UAV-to-Ground measurement testbed built on the OpenAirInterface (OAI) stack and commodity Software Defined Radios (SDRs), enabling direct extraction of raw Sub-6 GHz Channel State Information (CSI) synchronized with flight telemetry. Through real-world flight campaigns, we observe a velocity-bandwidth decoupling effect: under unguided, measurement-only ridge extraction, dominant spectral ridges deviate strongly from the theoretical kinematic Doppler trajectory, whereas guided tracking substantially reduces this mismatch. This indicates that Doppler information is present, but not dominant, in the raw observable dynamics of commodity SDR-based measurements. We further benchmark representative deep learning predictors on this hardware-inclusive dataset and show, through a case study, that their behavior differs substantially from idealized expectations. By open-sourcing the testbed and dataset, we provide a realistic foundation for training and evaluating AI models for practical aerial network deployments.

0.76

Gateway-Free Kafka Streaming from FPGA-Based Detectors: A Bare-Metal Pipelined Producer on Zynq-7000

cs.NI cs.AR ·2026-11-17 ·Fernanda Zapata Bascuñán, Matías Hampel
published similarity 0.53
Abstract · Accepted for pucblishing at IEEE Explore proceedings of ARGENCON 2026

We present a bare-metal Apache Kafka producer implemented on a Zynq-7000 System-on-Chip (SoC) for event-driven data acquisition. Events are generated in Programmable Logic (PL), transferred to the Processing System (PS) through AXI4-Stream and AXI DMA, and published to a standard Kafka broker without an intermediate gateway computer. The PS constructs ProduceRequest messages and transmits them through the lwIP raw TCP/IP API. A configurable pipeline limits the number of outstanding Kafka requests. Pipeline depths of D = 1, 2, 4, and 8 were evaluated with two independent DMA sources. For each depth, 20 independent runs of 5,000 events were acquired, for 400,000 event records in total. Each event carries a 32-bit frame counter and a 32-bit PL timestamp. PS-side instrumentation records DMA start and completion, publication, successful local tcp_write() acceptance, and reception of the corresponding Kafka acknowledgement. Measurement records are exported to a separate Kafka topic after the timed event stream has completed. Each of the 80 runs contained 5,000 records with frame values from 0 to 4,999, with no sequence discontinuities in the exported metric records and no recorded Kafka errors. Mean operational throughput was approximately 5.3 kevents/s at D = 1, 9.4-9.6 kevents/s at D = 2, 16.2 kevents/s at D = 4, and 16.8-17.5 kevents/s at D = 8. The median publish-to-acknowledgement interval was 1.62-1.64 ms at D = 1, 0.98 ms at D = 2, 0.66 ms at D = 4, and 0.83-0.86 ms at D = 8. At D = 4, the corresponding P95 values were 0.81-0.83 ms.

0.35

XAI2CSI: Interpreting CSI with eXplainable AI for Human Activity Recognition

eess.SP ·2026-08-31 ·Idio Guarino, Alfredo Nascita, Domenico Ciuonzo, Damiano Carra, Antonio Pescapé
publishedhot direction similarity 0.53
Abstract · accepted at 22nd International Conference on Wireless and Mobile Computing, Networking and Communications (WiMob 26)

Wi-Fi Channel State Information (CSI) has emerged as a key enabler for device-free Human Activity Recognition (HAR), enabling low-cost, unobtrusive sensing using existing communication infrastructure. However, Deep Learning (DL) models trained on CSI data often struggle to generalize across users, environments, and device setups due to the context sensitivity of wireless propagation. Despite this challenge, limited attention has been devoted to understanding model decisions and generalization failures. This paper introduces XAI2CSI, a framework that leverages eXplainable Artificial Intelligence (XAI) to analyze DL-based CSI sensing systems. XAI2CSI employs SAGE, a model-agnostic explainability method, to quantify temporal, spectral, and spatial CSI contributions to HAR decisions under nominal and cross-context evaluations on IEEE 802.11ax data. Our analysis reveals that the considered DL model exhibits limited robustness to unseen conditions due to an over-reliance on context-specific CSI patterns, causing models to misinterpret the underlying signal dynamics when deployment conditions change. The proposed methodology and findings provide a reference framework to explore alternative solutions and guide the development of robust, transparent Wi-Fi sensing systems.

0.38

CSI-Agent: LLM-Assisted Few-Shot Adaptation for Cross-Domain Wi-Fi CSI Sensing

cs.AI cs.NI ·2026-09-25 ·Tianya Zhao, Chuan Liu, Xuyu Wang
similarity 0.53
Abstract · 10 pages, 6 figures, 5 tables. Submitted to INFOCOM

Wi-Fi channel state information (CSI) has enabled device-free sensing applications such as human activity recognition. However, CSI sensing models remain brittle in cross-domain deployment, where changes in users or environments can produce incorrect predictions. Existing solutions usually treat this problem as an offline model-design problem, by pretraining a stronger representation or applying one fixed adaptation method to the entire target domain. In practice, labeled target data are scarce and different classes may fail in different ways under the same domain shift. To address this, we propose CSI-Agent, an evidence-seeking LLM agent that reformulates cross-domain CSI adaptation as a deployment-time decision-making problem. Rather than processing raw CSI or making sample-level predictions, CSI-Agent summarizes target-domain behavior into sensing-grounded class-level evidence. It establishes a strong target-adaptive default from complementary CSI views and uses an LLM planner to determine whether each class should retain the default or invoke a specialized action. Deterministic verification and bounded execution further reduce unreliable interventions. We evaluate CSI-Agent on four public datasets using five cross-domain splits covering device, user, environment, and compositional shifts. Under 1-shot adaptation, CSI-Agent achieves the best target-domain performance across all splits and improves the average Macro-F1 by about 16\% compared to the strongest baseline method.

0.28

TLF: Rapid Characterization of RF Transceiver Parameters in Embedded Systems via Bus-Level Interception

cs.CR ·2026-08-13 ·Larry Hernandez, Sergey Bratus
published similarity 0.53
Abstract · Accepted for publication in the Proceedings of the 2026 IEEE Military Communications Conference (MILCOM 2026). This is the authors' accepted…

We present TLF (Transceiver Lifter Framework), a tool for recovering RF transceiver configuration and runtime behavior from bus-level traces captured between a microcontroller and its transceiver IC. A stateful protocol decoder, built against the transceiver's register and data interface, reconstructs operating RF parameters and behavior from intercepted register writes and FIFO transfers. For bus-attached transceivers whose hardware-cryptography keys are loaded through the intercepted host interface, key material is also recoverable. Where the firmware drives frequency hopping -- either through a hardware-assisted engine or a custom schedule -- the decoder extracts the channel table, hop sequence, and timing. We evaluate the approach on two targets from different Semtech families: an SX1233-based UAV C2 modem employing firmware-level FHSS with per-packet sync word rotation, and an SX1276-based Meshtastic node exercising the LoRa register overlay. From a single bus capture, processed in seconds, TLF recovers the complete register-exposed RF configuration (modulation, band plan, phase behavior) without prior knowledge of the target firmware -- sufficient to configure a matched receiver or develop targeted countermeasures. Above the chip layer, a pluggable protocol decoder interprets recovered FIFO payloads as application PDUs, demonstrated end-to-end on Meshtastic. Firmware-level cryptographic state remains, as expected, opaque. The approach requires physical access or emulation of the target hardware, and its recovery depth is bounded by the transceiver's register interface: parameters implemented entirely in firmware (custom FEC, whitening, encryption) are observable only as opaque FIFO payloads.

0.25