CS Paper Radar

Balancing a Flying Inverted Pendulum with an Unknown Length Using Model Predictive Control and a Genetic Algorithm Estimator

Esther Paul, Mitchell Torok, Mohammad Deghat

eess.SY ·submitted 2026-08-18 01:26 UTC · v1
published

Abstract

This paper proposes an online Genetic Algorithm (GA) estimator and a Model Predictive Control (MPC) approach to solve the flying inverted pendulum problem in a practical experiment where the pendulum length is unknown. The performance of the MPC approach was demonstrated on a practical system through disturbance and trajectory tracking tests to assess controller robustness and tracking accuracy. The convergence speed and accuracy of the online GA estimator were validated on a practical system using different initial conditions.

Comment
Accepted for presentation at the 23rd IFAC World Congress

Closest papers

Nearest neighbours by meaning across the whole index.

Real-Time Nonlinear MPC via Sequential Quadratic Programming with Structure-Exploiting ADMM and Interior-Point Methods for Underactuated Double-Pendulum Swing-Up

eess.SY cs.RO ·2026-08-10 ·Nick Karydakis, Konstantinos Chatzilygeroudis
similarity 0.60
Abstract · 6 pages, 4 figures, 1 table, finalist in the 4th AI Olympics with RealAIGym (https://ai-olympics.dfki-bremen.de)

The 4th "AI Olympics with RealAIGym" competition, to be held at IJCAI-ECAI 2026 in Bremen, challenges participants to develop a global control policy for swinging up and stabilizing an underactuated two-link system in its upright position. In contrast to previous editions, participants develop and evaluate their control strategies directly on remotely accessible CloudPendulum hardware, with limited interaction time and without prior knowledge of the system's model parameters. This paper presents an optimal-control-based approach employing real-time nonlinear model predictive control implemented using sequential quadratic programming. The results demonstrate that the proposed SQP-based MPC controller achieves reliable swing-up and stabilization performance, while maintaining robustness against disturbances.

0.20

Bio-inspired Thrust-Assisted Trotting on a legged-Aerial Robot via Real-Time QP-MPC

cs.RO ·2026-10-19 ·Shreyansh Pitroda, Eric Sihite, Alireza Ramezani, Morteza Gharib
published similarity 0.58
Abstract · To be published in IEEE/RSJ International Conference on Intelligent Robots and Systems (IROS 2026)

This paper presents the hardware implementation of a quadratic program-based controller on Harpy: thruster-assisted bipedal robot to perform thruster-assisted trotting. This is inspired by wing-assisted locomotion observed in birds such as the chukar partridge, which employ thrust vectoring to manipulate the ground reaction force. The proposed controller formulates the thruster-assisted spring-loaded inverted pendulum dynamics as a condensed QP-based model predictive control problem, enabling simultaneous regulation of ground contact force and active thrust vectoring at 500 Hz. A decoupled control architecture is used, where the robot's sagittal dynamics are controlled using QP-MPC while the frontal dynamics is regulated using a cascade orientation stabilization controller. Two experiments were conducted with different forward reference velocities of 0 m/s and 0.1 m/s. While the instantaneous velocity oscillates, the mean velocities can track their respective reference. Additionally, joint tracking error remains within 1 deg while tracking the desired leg length given by the leg trajectory controller and desired swing trajectory given by Raibert's heuristic. The QP-MPC problem is consistently solved with 0.18ms, which is well within the 2ms computation budget while satisfying the GRF friction cone constraint.

0.40

Physics-based Online Adaptive Koopman Model Predictive Attitude Control for Combined Spacecraft with Dynamic Uncertainties

eess.SY ·2026-09-02 ·Yicheng Sun, Yueyong Lyu, Yuhan Liu, Yanning Guo, Wei Pan
top venue similarity 0.57
Abstract · 16 pages, 13 figures, 3 tables

This paper proposes a physics-based adaptive Koopman Model Predictive Control (MPC) strategy for combined spacecraft attitude stabilization under inertia uncertainties and active target maneuverability. A novel, quaternion-based Koopman model is constructed from a set of analytical lifting functions derived from the quaternion kinematics, which provides a more compact and physically interpretable linear representation of the nonlinear dynamics compared with the conventional black-box EDMD and higher-dimensional DCM-based model. Leveraging the linear structure of this nominal model, a gradient descent-based update law is employed to efficiently identify time-varying inertial uncertainties from real-time input/output data. By integrating this adaptive linear model into the MPC framework, the optimal control problem reduces to a computationally efficient Quadratic Program (QP), thereby significantly lowering the online computational burden compared to nonlinear adaptive MPC. Recursive feasibility and regional input-to-state stability are formally established through the design of terminal ingredients for the MPC. The effectiveness and superiority of the proposed strategy are validated through comparative simulations of an attitude stabilization task for combined spacecraft in a high-fidelity 3D simulator.

0.48

Taylor-Informed Predictive Cost Adaptive Control for Quadrotors with Online Gravity-Trim Adaptation

eess.SY ·2026-09-03 ·Tam W. Nguyen
similarity 0.55
Abstract · 6 pages, 4 figures

This paper develops Taylor-informed predictive cost adaptive control (PCAC) for quadrotors with online gravity-trim adaptation. First-, second-, and third-order expansions of the nonlinear dynamics about nominal hover define sparse sampled-data dictionaries for row-wise recursive least-squares identification with variable-rate forgetting. At each step, the identified predictor is linearized at the current state, and its Jacobian is fixed over the prediction horizon. The identified vertical dynamics also estimate the vehicle mass and gravity-trim input, eliminating fixed nominal gravity compensation. Simulations with an abrupt payload change and aggressive helix tracking show that the higher-order predictors improve prediction and tracking while preserving the standard PCAC formulation.

0.29

DR-MPC: Fast and Feasible Dynamics-Relaxed Model-Predictive Control for Legged Locomotion

cs.RO eess.SY ·2026-09-17 ·Run Wang, Alapati Tuerxun, Shuo Liu, Wei Xiao, Ján Drgoňa +2 more
code/data similarity 0.54
Abstract · 8 pages, 5 figures, submitted to RA-L

This paper presents dynamics-relaxed model predictive control (DR-MPC), a novel MPC formulation for legged locomotion, and a tailored interior-point method (IPM) solver. The formulation combines online optimization feasibility by construction with a contact-aware input parameterization. DR-MPC moves the dynamics equality and affine input constraints into quadratic penalties and retains only nonempty box constraints. The resulting box-constrained quadratic program (QP) has a block-arrow Hessian that enables the state and affine-output directions to be eliminated through a Schur complement. The solver factors only the reduced control system after swing-force elimination and contact-aligned move blocking. For the evaluated implementations using the same DR-MPC formulation, our method achieves median end-to-end MPC speedups of $16.0\times$ over HPIPM and $4.4\times$ over OSQP, with comparable locomotion performance in simulation. DR-MPC achieves a median onboard MPC end-to-end time of $4.4$ ms and is validated on a Unitree Go1 quadruped. Open-source code will be made available after publication.

0.27

Moving Horizon Estimation and Constrained Model Predictive Control for Balancing a Wheel-Legged Robot Under Unknown Disturbances

eess.SY ·2026-11-03 ·Haitham El-Hussieny
similarity 0.54
Abstract

Wheel-legged robots balance on two wheels while using articulated legs to change height, absorb impacts, and cross uneven terrain. On hardware, the balance controller must rely on noisy inertial and encoder measurements, and it must reject disturbances that are not known in advance, such as payloads and wind, without exceeding motor torque limits. This paper presents a moving horizon estimator (MHE) combined with an offset-free, constrained model predictive controller (MPC) for the sagittal balance of a 9.95 kg wheel-legged robot. The estimator uses a virtual-leg model augmented with a horizontal hip force, a body pitch torque, and a gyroscope bias. Its accelerometer model removes the predicted hip acceleration, and its process noise is increased when an impact is detected. We evaluate the approach in MuJoCo with simulated sensor noise, bias, quantization, and delay, and compare it with LQR baselines that use ground-truth state, a complementary filter, or the same MHE. In a driving, squatting, reversing, and bowing sequence, MPC with MHE reduced the RMS speed error to 0.11 m/s, compared with 0.24 m/s for LQR with ground-truth state. Under an unknown 2 kg payload and a 10 N headwind, the mean position error in wind was 6 cm, compared with 81 cm for LQR with ground-truth state. Across a 3 $\times$ 4 grid of payloads and headwinds, LQR with the same estimator fell in 3 of 12 combinations, compared with 1 of 12 for MPC. These results are limited to simulation on flat ground, and experimental validation on hardware remains future work.

0.14

Payload Swing Estimation and Damping Without Payload Parameters for Multirotor UAVs

eess.SY cs.RO ·2026-08-19 ·K. Taki, K. Umemoto
similarity 0.53
Abstract

Cable-suspended payload transport by multirotor UAVs is flexible but generates periodic swing disturbance that degrades tracking and risks instability. Existing anti-swing methods require additional sensors or precise identification of cable length and payload mass, limiting field deployment. We propose a swing-estimation and damping method using only the onboard IMU and throttle command, requiring no payload parameters. An extended Kalman filter extracts the periodic disturbance with the unknown pendulum frequency as an estimated state, and an active damping controller adds a correction angle to the attitude loop to dissipate pendulum energy. Flight experiments confirm robust damping across a tested range of cable-length and mass variations.

0.21

Aerodynamic Prior-Free Coordinated Trajectory Generation and Tracking Control for a Tail-Sitter UAV

cs.RO ·2026-09-10 ·Erchao Rong, Zihao Liu, Junning Liang, Jianguo Wang, Xiao Jie +3 more
top venuecode/data similarity 0.52
Abstract

This paper presents a coordinated trajectory generation and tracking control framework for a tail-sitter unmanned aerial vehicle (UAV), which does not require aerodynamic priors identified for a specific airframe while addressing the challenge of flight control under highly nonlinear aerodynamics across the full flight envelope. The core innovation lies in employing phase-specific aerodynamic modeling strategies for planning and tracking, tailored to their distinct functional characteristics, without requiring airframe-specific aerodynamic priors. Specifically, the phi-theory model under coordinated flight is employed to derive an analytic differential flatness mapping, and a simplified but locally accurate model is established for predictive control to enable real-time aerodynamic parameter estimation. The proposed framework is evaluated extensively through both simulation and challenging real-world flight tests under mild wind conditions, showing high-precision tracking and adaptability across the tested aerodynamic conditions. To the best of our knowledge, this is the first real-world demonstration of accurate trajectory tracking over tested flight regimes spanning the full envelope of a tail-sitter UAV without relying on aerodynamic identification campaigns. The source code of our framework is available at: https://github.com/SYSU-HILAB/AP-PnC.

0.34