CS Paper Radar

Bio-inspired Thrust-Assisted Trotting on a legged-Aerial Robot via Real-Time QP-MPC

Shreyansh Pitroda, Eric Sihite, Alireza Ramezani, Morteza Gharib

cs.RO ·submitted 2026-10-19 17:50 UTC · v1
published

Abstract

This paper presents the hardware implementation of a quadratic program-based controller on Harpy: thruster-assisted bipedal robot to perform thruster-assisted trotting. This is inspired by wing-assisted locomotion observed in birds such as the chukar partridge, which employ thrust vectoring to manipulate the ground reaction force. The proposed controller formulates the thruster-assisted spring-loaded inverted pendulum dynamics as a condensed QP-based model predictive control problem, enabling simultaneous regulation of ground contact force and active thrust vectoring at 500 Hz. A decoupled control architecture is used, where the robot's sagittal dynamics are controlled using QP-MPC while the frontal dynamics is regulated using a cascade orientation stabilization controller. Two experiments were conducted with different forward reference velocities of 0 m/s and 0.1 m/s. While the instantaneous velocity oscillates, the mean velocities can track their respective reference. Additionally, joint tracking error remains within 1 deg while tracking the desired leg length given by the leg trajectory controller and desired swing trajectory given by Raibert's heuristic. The QP-MPC problem is consistently solved with 0.18ms, which is well within the 2ms computation budget while satisfying the GRF friction cone constraint.

Comment
To be published in IEEE/RSJ International Conference on Intelligent Robots and Systems (IROS 2026)

Closest papers

Nearest neighbours by meaning across the whole index.

Design and Control of a Multimodal Legged-Aerial Robot Through Separate Control Contraction Metrics

cs.RO eess.SY ·2026-10-19 ·Kaushik Venkatesh Krishnamurthy, Eric Sihite, Alireza Ramezani, Morteza Gharib
published similarity 0.74
Abstract · Presented at 2026 IEEE International Conference on Intelligent Robots and Systems, Pittsburgh PA

The integration of dynamic legged locomotion and aerial mobility offers versatility that is deterred by challenges in payload distribution, actuation, and the contrasting requirements of both domains. In this paper, we present the design and operation of a multimodal quadrupedal aerial-legged robot. The presence of legged aerial systems also allows for thruster-assisted legged locomotion, which we make possible with a unified control framework using Control Contraction Metrics (CCM). We search for separate domain-specific contraction metrics for walking and flight independently offline and unify them using an online energy-based Control Lyapunov Function Quadratic Program (CLF QP). This enables optimal, cross-domain control allocation, which we show using simulations. We also show experimental results that validate the mechanical viability of our hardware and the paradigm of thruster-assisted trotting. The stability of said experiments motivates the deployment of the control framework for multimodal operations.

0.20

DR-MPC: Fast and Feasible Dynamics-Relaxed Model-Predictive Control for Legged Locomotion

cs.RO eess.SY ·2026-09-17 ·Run Wang, Alapati Tuerxun, Shuo Liu, Wei Xiao, Ján Drgoňa +2 more
code/data similarity 0.67
Abstract · 8 pages, 5 figures, submitted to RA-L

This paper presents dynamics-relaxed model predictive control (DR-MPC), a novel MPC formulation for legged locomotion, and a tailored interior-point method (IPM) solver. The formulation combines online optimization feasibility by construction with a contact-aware input parameterization. DR-MPC moves the dynamics equality and affine input constraints into quadratic penalties and retains only nonempty box constraints. The resulting box-constrained quadratic program (QP) has a block-arrow Hessian that enables the state and affine-output directions to be eliminated through a Schur complement. The solver factors only the reduced control system after swing-force elimination and contact-aligned move blocking. For the evaluated implementations using the same DR-MPC formulation, our method achieves median end-to-end MPC speedups of $16.0\times$ over HPIPM and $4.4\times$ over OSQP, with comparable locomotion performance in simulation. DR-MPC achieves a median onboard MPC end-to-end time of $4.4$ ms and is validated on a Unitree Go1 quadruped. Open-source code will be made available after publication.

0.27

Anti-Gravity Walking by a Flying Humanoid Robot via Thrust-Rate Input Whole-Body Model Predictive Control

cs.RO ·2026-09-07 ·Kazuki Sugihara, Kei Okada
top venue similarity 0.63
Abstract

Flying humanoids are expected to perform tasks in diverse environments, while their existing locomotion is mainly limited to aerial flight and ground walking. The capability to move in complex three-dimensional space can greatly expand their application range. For such walking motion on ceilings and similar anti-gravity environments, whole-body MPC is effective. However, the discontinuous changes in dynamic structure accompanying contact switching during walking can induce thrust spikes, resulting in control instability. Therefore, in this work, we propose and implement a real-time whole-body MPC framework for anti-gravity bipedal walking. First, we formulate whole-body MPC using the time derivative of thrust, namely thrust-rate, as the control input. This formulation guarantees continuity of the thrust trajectory during contact switching while preserving the sparse structure of the optimal control problem for fast computation. Second, we address the lack of natural support forces in anti-gravity environments. We introduce lower bounds on the foot-normal component of the contact force, and smoothly transfer them during the doublesupport phase. Finally, we implement the proposed framework and demonstrate anti-gravity walking by a flying humanoid through simulation and a hardware experiment. To the best of our knowledge, this is the first demonstration of multi-contact whole-body MPC for a transformable aerial robot and walking by a flying humanoid beyond the ground.

0.39

Dynamic Modeling and LQR Control of a Single Coaxial Drone with 2DOF Thrust Vectoring Mechanism

cs.RO eess.SY ·2026-09-17 ·Ali Jokar, Amin Talaeizadeh, Aria Alasty
similarity 0.61
Abstract

Coaxial rotor drones have generated considerable interest because of energy efficiency and small size, but they are afflicted with inherent underactuation for roll and pitch control, although systems like swashplates have circumvented this limitation at the cost of greater mechanical complexity. This work presents a novel coaxial drone supplemented by a two-degreesof-freedom pendulum mechanism for active thrust vectoring that offers a less mechanically complicated alternative. We develop a comprehensive Lagrangian dynamic model that does not ignore the inertial contributions of all the components, including body, servo arms, and motor assembly. A Linear Quadratic Regulator(LQR) is designed based on the linearized dynamics around the hover equilibrium. High-fidelity simulations taking actuator dynamics and sensor noise into account validate the proposed architecture. An Extended Kalman Filter (EKF) blends GPS, barometer, and IMU estimates with high accuracy for state estimation. The findings verify the potential and reliability of this approach for power-saving, rapid coaxial UAVs.

0.13

A Bi-level Co-design Framework for Lunar Monoped with 2D Jump and Landing Control

cs.RO eess.SY ·2026-10-27 ·Sanjay Ramkumar, Suraj Kumar
similarity 0.61
Abstract · 8 pages, 13 figures

Legged robots for lunar exploration must be designed for low gravity, where reduced contact forces and long flight phases make leg morphology and controller choice interdependent. We study this for a planar monoped in lunar gravity ($1.625$ m/s$^2$) using a bi-level co-design framework: a differential evolution outer loop searches over link lengths, and each candidate is evaluated on a vertical jump by either a quadratic program based task-space controller (QP-TSC) or a direct-collocation based trajectory optimization. The two controllers yield different optimal link lengths, and trajectory optimization outperforms the QP-TSC across most of the design space, with 17% lower Cost of Transport (COT) at their respective optima. We then extend to a 2D jump, where trajectory optimization with centroidal angular momentum regulation produces stable in-place and forward jumps, and an LQR controller absorbs impact and stabilizes the robot after touchdown. This is demonstrated on a baseline morphology with both links 0.3 m long.

0.17

FAM-DQ: A Dual-Quadrotor-Based Fully Actuated Aerial Manipulator for High-Torque Interaction

cs.RO ·2026-08-13 ·Xuwei Yang, Ruoyu Ren, Ziqian Guo
similarity 0.60
Abstract · 7 pages, 7 figures

Aerial physical interaction requires aerial manipulation platforms to generate large interaction forces and torques while maintaining precise end-effector control. However, conventional underactuated aerial manipulators suffer from strong position-attitude coupling, whereas fully actuated platform designs often face structural complexity, limited payload capacity, and insufficient torque output. This paper presents FAM-DQ, a dual-quadrotor based fully actuated aerial manipulator designed for high-torque physical interaction tasks. By mounting two quadrotor propulsion modules at the ends of a central frame through passive joints, while using a gear-driven servo to regulate the pointing direction, FAM-DQ achieves decoupled $6$-DoF end-effector control with omnidirectional manipulation capability and enhanced torque output. Experiments including trajectory tracking, attitude tracking, static torque measurement, and screw driving validate the proposed design. FAM-DQ achieves a maximum torque of $1.019~\mathrm{N}\cdot\mathrm{m}$ with a total mass of $0.447~\mathrm{kg}$, corresponding to a torque-to-mass ratio of $2.28~\mathrm{N}\cdot\mathrm{m/kg}$.

0.07

Real-Time Control-Constrained DDP for Underactuated Balancing of Legged Robots

cs.RO math.OC ·2026-08-19 ·SeongWon Nam, Hyunyong Lee, Hansol Kang, Jiman Park, Yeongwoo Son +3 more
top venue similarity 0.60
Abstract · This version includes a minor correction to the notation in Eq. (2)

This paper presents a real-time control-constrained Differential Dynamic Programming (DDP) framework for underactuated legged robots. To address the limitation of classical DDP in handling control constraints, we propose an Accelerated Projected Gradient (APG)-based control-constrained DDP (ABC-DDP), which efficiently computes constrained solutions and identifies active sets without repeated Karush-Kuhn-Tucker (KKT) inversions. A virtual constraint is introduced to integrate control constraints within a feasibility-driven multiple-shooting framework, enabling stable optimization even from dynamically infeasible initializations. The proposed method supports real-time model predictive control (MPC) with short horizons under strong underactuation. Simulation results demonstrate static two-leg standing under external disturbances, along with diverse dynamic motions including slow catwalk, upright walking, and high-speed running within a unified MPC framework. To the best of our knowledge, this is the first demonstration of static two-leg standing of a quadruped robot achieved using real-time finite-horizon MPC.

0.43

Balancing a Flying Inverted Pendulum with an Unknown Length Using Model Predictive Control and a Genetic Algorithm Estimator

eess.SY ·2026-08-18 ·Esther Paul, Mitchell Torok, Mohammad Deghat
published similarity 0.58
Abstract · Accepted for presentation at the 23rd IFAC World Congress

This paper proposes an online Genetic Algorithm (GA) estimator and a Model Predictive Control (MPC) approach to solve the flying inverted pendulum problem in a practical experiment where the pendulum length is unknown. The performance of the MPC approach was demonstrated on a practical system through disturbance and trajectory tracking tests to assess controller robustness and tracking accuracy. The convergence speed and accuracy of the online GA estimator were validated on a practical system using different initial conditions.

0.27