CS Paper Radar

Centralized RAN for Future Low-Power Wide-Area Networks: A LoRa Case Study

Joachim Tapparel, Amavi Dossa, El Mehdi Amhoud, Andreas Burg

eess.SP ·submitted 2026-08-24 09:33 UTC · v1
published

Abstract

In recent years, low-power wide-area network (LPWAN) technologies have gained significant traction as a connectivity option for Internet of Things (IoT) applications. While these networks have been successful in providing long-range, low-power, and low-cost connectivity, they currently face scalability, reliability, and efficiency challenges that require immediate attention. In this paper, we first identify important challenges for LPWANs. We then advocate for the introduction of a centralized radio access network (C-RAN) architecture tailored for LPWANs and present a proof-of-concept implementation and deployment of the proposed C-RAN for the widely popular long range (LoRa) standard. We also provide experimental results to demonstrate and quantify the increased sensitivity that can be obtained from joint processing of the baseband signals of multiple receivers, enabled by the proposed centralized architecture in quasi-static scenarios and drone-mounted transmitters.

Comment
Accepted for publication in IEEE Internet of Things Magazine

Closest papers

Nearest neighbours by meaning across the whole index.

Energy-Aware LoRaWAN Design for Long-Lived Agricultural Sensing: Insights from a Multi-Year Deployment and Controlled Platform Comparison

cs.NI ·2026-09-13 ·Carl Dickinson, Shishir Nagaraja, Chuadhry Mujeeb Ahmed
top venue similarity 0.64
Abstract · 8 pages, 5 figures. Presented at the 4th International Workshop on Long and Short Range Wireless Technologies Applied to IoT for Networks of…

Agricultural IoT nodes are often far from mains power and have limited access for maintenance. Therefore, IoT deployments benefit from low-power, long-range communication such as LoRaWAN. However, communication alone does not guarantee multi-year operation. Previous work has measured communication energy, modelled system lifetime, and documented long-lived deployments. This paper connects long-term deployment evidence with controlled platform measurements. The AgriTrust deployment has operated for 2 years and 8 months using MKR WAN1310-based Squirrel Box nodes. Building on this evidence, we compared the MKR WAN1310 and STM32WL LoRaWAN platforms using time-resolved current traces during confirmed-uplink cycles. For this outdoor comparison, we tested nine combinations of payload size and data rate with three repetitions each. Both platforms achieved 3/3 ACKed packets in every condition. The STM32WL had lower cycle energy than the WAN1310 in all tested conditions. Cycle energy ranged from 0.0350 J to 0.3550 J for STM32WL and from 0.0698 J to 0.5662 J for WAN1310. These communication events are brief, while sleep and leakage currents persist between cycles. The STM32WL sleep current was recorded at 59.6 nA, while the WAN1310 sleep current was 104 microamperes, approximately 1745 times that of the STM32WL. This difference shows that sleep current is a first-order determinant of long-term viability. However, the whole-system energy budget also depends on sensing loads, duty cycle, communication energy, and harvested-energy support. The study should be treated as a controlled characterisation, not a universal comparison across all sites, firmware stacks, or LoRaWAN modes.

0.41

Performance Analysis of LoRa and LR-FHSS in 3GPP LEO Satellite and HAPS Channel Scenarios for Remote Area IoT Coverage

eess.SP ·2026-09-07 ·Jean Michel de Souza Sant'Ana, Nurul Huda Mahmood, Vinicius Pozzobon Borin
published similarity 0.61
Abstract · 5 pages, 5 figures, 2 tables, presented at Wireless Europe 2026, Rimini, Italy, June 2026

In this paper, we analyze and compare the performance of LoRa and LR-FHSS in a remote area Internet-of-Things (IoT) connectivity scenario using a low-earth orbit (LEO) satellites and high-altitude platform station (HAPS)-mounted gateway. We conducted a link budget analysis to evaluate communication stability to assess the ability of the technologies to support the different distances and behaviors using a 3GPP channel model for non-terrestrial networks. Several parameters are considered, such as altitude, minimum elevation angle as well as the impact of different types of loss, such as shadow and fast fading, ionosphere scintillation loss, for example. Our findings highlight the performance gap between LR-FHSS and LoRa in terms of both connectivity. We also highlight how lower HAPS altitudes can benefit certain LoRa settings compared to LEO satellites. We show that HAPS can enable the use of lower LoRa spreading factors, which improves scalability and energy efficiency, while LR-FHSS and a higher spreading factor LoRa remain the solution for LEO satellites.

0.36

Spreading Factor Assignment Strategy for Coverage and Capacity Flexible Tradeoff

cs.NI ·2026-09-21 ·Luiz Filho, Alvaro Medeiros, Jéssika Silva, Vicente Angelo de Sousa Junior, Níbia Bezerra
published similarity 0.55
Abstract

LoRa is a physical layer technology with the ability to connect multiple devices in a wide area of coverage, with low power consumption and with interference robustness. In this Letter, we investigate the efficiency of LoRa to send multiple uplink streams, analyzing strategies of allocating the spreading factor for coverage or capacity enhancement.

0.62

Analytical Modeling of Latency and Energy Trade-offs in FiRa-Like BLE-UWB Ranging and Localization Systems

cs.NI ·2026-10-24 ·Adelina Giurea, Jorg Wieme, Ben Van Herbruggen, Jeroen Hoebeke, Eli De Poorter
similarity 0.54
Abstract · submitted to IEEE Transactions on Mobile Computing

Accurate position and distance information provided by Ultra-Wideband (UWB) can enhance a wide range of applications. However, its receive-mode power consumption makes continuous channel monitoring impractical for energy-constrained devices. Consequently, UWB systems often rely on Bluetooth Low Energy (BLE) to discover peers and establish sessions before ranging begins. Although both technologies have been studied in isolation, an framework capturing the latency and energy consumption of the complete workflow is still lacking. To address this gap, we develop a unified analytical model for BLE-assisted UWB systems, from device-to-device ranging to infrastructure-based localization. The model includes closed-form expressions for discovery, parameter exchange, and ranging, and evaluates the resulting latency and energy consumption. Evaluation of three representative BLE configurations shows that the scanner consumes 28-57x more energy per discovery than the advertiser. In addition, the 99th-percentile discovery latency is 2-3.4x higher than the mean and reaches up to 110 s in the lowest-power configuration. The one-time BLE setup overhead is amortized after 24-562 ranging rounds, depending on the discovery configuration. Overall, the analysis demonstrates that the BLE discovery phase can dominate both the latency and the energy budget during short UWB interactions, making discovery configuration as important as the ranging scheme.

0.25

Federated learning for remote IoT over LPWAN: Preliminary insights from structural health monitoring

cs.NI ·2026-11-08 ·Lakshmiprasanna Bandaru, Anshika Singh, Tarutal Ghosh Mondal, T. Jothi Saravanan, Siddhartha S. Borkotoky
similarity 0.53
Abstract

Realizing federated learning (FL) in remote regions lacking reliable cellular infrastructure is challenging, as it requires dependable communication among participating devices. Low-power wide-area networks (LPWANs) offer an attractive communication solution for such scenarios. However, their limited data rates necessitate careful investigation of the communication-learning trade-offs and mechanisms to reduce communication overhead. This paper presents an investigation of the Long Range (LoRa) LPWAN technology for FL-based structural health monitoring (SHM), a representative remote IoT application. We consider a SCAFFOLD-based FL framework for multi-class anomaly detection and analyze the latency-accuracy trade-off. We also examine strategies for allocating the LoRa spreading factor (SF) during model-update exchange. Numerical results show that, with appropriate SF allocation, LoRa-supported FL-SHM can achieve competitive learning accuracy. In particular, jointly accounting for link distances and clients' dataset sizes when selecting the SF provides a favorable balance between convergence performance and communication latency. These preliminary findings offer useful insights into the design of FL systems over LPWANs for remote IoT deployments.

0.24

Exploring the Initial Performance of NB-IoT NTN over GEO: Measurement and Analysis

cs.NI ·2026-09-05 ·Xiong Wang, Yumin Du, Bin Gu, Zheng Lin, Xiaoyang Li +3 more
similarity 0.52
Abstract · 15 pages, 21 figures

With the standardization of Non-Terrestrial Networks (NTN) to provide direct satellite connectivity to massive, low-power Internet of Things (IoT) devices, 3GPP IoT-NTN bridges the worlds of cellular and satellite communications. While holding great potential for global connectivity with IoT devices, there exist several concerns about the system performance of IoT-NTN over Geostationary Earth Orbit (GEO), which covers multiple dimensions such as end-to-end delay and energy consumption considering the ultra-long transmission distance from ground IoT terminals to GEO satellite. To answer these concerns, we have conducted the first comprehensive and in depth measurement for NB-IoT NTN over GEO. Based on real NB-IoT NTN testbeds including both Skylo and Tiantong, measurements covering more than six months confirm that the available implementation of NB-IoT NTN remains in the initial stage. Amplified by ultra-long Round-Trip Time (RTT) between ground IoT terminals and GEO satellite, there exists plenty of time and energy consumption during the access process. Interestingly, it also reveals that as an energy-saving mechanism, Power Saving Mode (PSM) fundamentally reshapes NB-IoT NTN traffic into a bursty and access-driven communication pattern and thus has a considerable influence on the end-to-end delay and energy consumption. Finally, we propose corresponding optimization schemes to reduce the delay and energy, which lays a good foundation for the implementation of NB-IoT NTN in the near future.

0.56

A LoRa-Compatible Receiver with Programmable Noise-Power Trade-Off and Integrated Wake-Up Mode

cs.AR ·2026-10-14 ·Marco Gonzalez, Pol Maistriaux, Jérôme Louveaux, David Bol
similarity 0.52
Abstract · 13 pages, 19 figures, removed mentions to IEEE

Programmable receivers allow an optimal performance in the variable conditions of the wireless channel. An extensive analysis of their noise-power trade-off enables the development of a main receiver with embedded wake-up circuitry. This makes the seamless integration of wake-up receivers (WuRXs) in RF receivers possible, avoiding power, area, complexity, and cost overheads in the system. In this paper, we propose the first LoRa-compatible receiver with an integrated wake-up mode and a programmable noise-power trade-off. In main-receiver mode, it consumes 4.57 mW for a sensitivity of -138 dBm, but it can save up to 62.6% of power consumption at the cost of an 8.3-dB sensitivity degradation. In wake-up mode, sensitivity down to -126 dBm is achieved for a 32-ms latency and 1.5 mW of power consumption. The power consumption remains relatively high due to a sub-optimal design of the the phase-locked loop (PLL). In the end, the wake-up mode consumes 3X less than the lowest-noise configuration in main-receiver mode.

0.28

Toward Lightweight Aerial 5G gNBs: Reproducible OAI Testbed on Commodity ARM Platforms

cs.CR eess.SP ·2026-10-04 ·Marc Duboc, Ammar El Falou
similarity 0.51
Abstract

For a battery-powered UAV base station, every gram and watt devoted to RAN-compute competes with flight-duration margin. We therefore keep the 5G Core (5GC) and central unit (CU) on the ground and design the airborne unit around only the backhaul endpoint, distributed unit (DU), and radio. The key question is then a practical one: can widely available commodity ARM computers sustain a real radio OpenAirInterface (OAI) 5G DU with useful performance over heterogeneous F1? We answer it with Raspberry Pi~5 and Jetson Orin Nano as DUs, a USRP B210, a commercial handset, and Ethernet, Wi-Fi/GRE, and 5G/WireGuard backhaul. Jetson preserves 88.4% of x86 split-DU Ethernet DL throughput and 87.5-89.0% across all three bearers; 5G/WireGuard preserves 76.4-77.1% of each host's wired DL rate. The validated Jetson/B210/RM500Q-GL electronics weigh 657.4 g and draw about 28 W under sustained traffic (757.4 g with integration allowance). A controlled link adaptation intervention raises split DL from 23.4 to 99.4 Mb/s as the dominant Modulation and Coding Scheme (MCS) moves from 3 to 26. Finally, synchronized radio, F1-U, CPU, and UHD evidence narrows the remaining monolithic-split gap to split-path scheduling/timing behavior. Beyond performance, this capability serves the emergency-response use case that motivates the aerial cell: once deployed above an affected area, it can broadcast a PWS warning message. We release the OAI patch that carries the single-segment Write-Replace Warning over F1 from CU to DU, where SIB8 is scheduled to the handset. The public artifact makes the payload, performance, and emergency-broadcast baseline reproducible with laboratory-accessible hardware.

0.14