CS Paper Radar

Energy-Aware LoRaWAN Design for Long-Lived Agricultural Sensing: Insights from a Multi-Year Deployment and Controlled Platform Comparison

Carl Dickinson, Shishir Nagaraja, Chuadhry Mujeeb Ahmed

cs.NI ·submitted 2026-09-13 18:50 UTC · v1
top venue

Abstract

Agricultural IoT nodes are often far from mains power and have limited access for maintenance. Therefore, IoT deployments benefit from low-power, long-range communication such as LoRaWAN. However, communication alone does not guarantee multi-year operation. Previous work has measured communication energy, modelled system lifetime, and documented long-lived deployments. This paper connects long-term deployment evidence with controlled platform measurements. The AgriTrust deployment has operated for 2 years and 8 months using MKR WAN1310-based Squirrel Box nodes. Building on this evidence, we compared the MKR WAN1310 and STM32WL LoRaWAN platforms using time-resolved current traces during confirmed-uplink cycles. For this outdoor comparison, we tested nine combinations of payload size and data rate with three repetitions each. Both platforms achieved 3/3 ACKed packets in every condition. The STM32WL had lower cycle energy than the WAN1310 in all tested conditions. Cycle energy ranged from 0.0350 J to 0.3550 J for STM32WL and from 0.0698 J to 0.5662 J for WAN1310. These communication events are brief, while sleep and leakage currents persist between cycles. The STM32WL sleep current was recorded at 59.6 nA, while the WAN1310 sleep current was 104 microamperes, approximately 1745 times that of the STM32WL. This difference shows that sleep current is a first-order determinant of long-term viability. However, the whole-system energy budget also depends on sensing loads, duty cycle, communication energy, and harvested-energy support. The study should be treated as a controlled characterisation, not a universal comparison across all sites, firmware stacks, or LoRaWAN modes.

Comment
8 pages, 5 figures. Presented at the 4th International Workshop on Long and Short Range Wireless Technologies Applied to IoT for Networks of Tomorrow (LS-NoT 2026), co-located with DCOSS-IoT 2026, Reykjavik, Iceland, 22-24 June 2026
Journal ref
2026 22nd International Conference on Distributed Computing in Smart Systems and the Internet of Things (DCOSS-IoT), Reykjavik, Iceland, 22-24 June 2026, IEEE, 2026
DOI
10.1109/DCOSS-IoT69657.2026.00122

Closest papers

Nearest neighbours by meaning across the whole index.

Centralized RAN for Future Low-Power Wide-Area Networks: A LoRa Case Study

eess.SP ·2026-08-24 ·Joachim Tapparel, Amavi Dossa, El Mehdi Amhoud, Andreas Burg
published similarity 0.64
Abstract · Accepted for publication in IEEE Internet of Things Magazine

In recent years, low-power wide-area network (LPWAN) technologies have gained significant traction as a connectivity option for Internet of Things (IoT) applications. While these networks have been successful in providing long-range, low-power, and low-cost connectivity, they currently face scalability, reliability, and efficiency challenges that require immediate attention. In this paper, we first identify important challenges for LPWANs. We then advocate for the introduction of a centralized radio access network (C-RAN) architecture tailored for LPWANs and present a proof-of-concept implementation and deployment of the proposed C-RAN for the widely popular long range (LoRa) standard. We also provide experimental results to demonstrate and quantify the increased sensitivity that can be obtained from joint processing of the baseband signals of multiple receivers, enabled by the proposed centralized architecture in quasi-static scenarios and drone-mounted transmitters.

0.35

Performance Analysis of LoRa and LR-FHSS in 3GPP LEO Satellite and HAPS Channel Scenarios for Remote Area IoT Coverage

eess.SP ·2026-09-07 ·Jean Michel de Souza Sant'Ana, Nurul Huda Mahmood, Vinicius Pozzobon Borin
published similarity 0.60
Abstract · 5 pages, 5 figures, 2 tables, presented at Wireless Europe 2026, Rimini, Italy, June 2026

In this paper, we analyze and compare the performance of LoRa and LR-FHSS in a remote area Internet-of-Things (IoT) connectivity scenario using a low-earth orbit (LEO) satellites and high-altitude platform station (HAPS)-mounted gateway. We conducted a link budget analysis to evaluate communication stability to assess the ability of the technologies to support the different distances and behaviors using a 3GPP channel model for non-terrestrial networks. Several parameters are considered, such as altitude, minimum elevation angle as well as the impact of different types of loss, such as shadow and fast fading, ionosphere scintillation loss, for example. Our findings highlight the performance gap between LR-FHSS and LoRa in terms of both connectivity. We also highlight how lower HAPS altitudes can benefit certain LoRa settings compared to LEO satellites. We show that HAPS can enable the use of lower LoRa spreading factors, which improves scalability and energy efficiency, while LR-FHSS and a higher spreading factor LoRa remain the solution for LEO satellites.

0.36

Terra-Fi: Decoupling Sensing and Wireless Depths for Sustainable Deep Underground Monitoring

eess.SY cs.ETcs.NI ·2026-10-23 ·Kaiqiang Lin, Mohamed-Slim Alouini
similarity 0.55
Abstract · 8 pages, 4 figures, 2 tables, submitted to IEEE IoTM

Wireless underground sensor networks (WUSNs) enable in-situ monitoring of subsurface processes and buried assets to deliver substantial social and economic benefits across diverse verticals. However, meter-scale underground monitoring remains challenging since conventional WUSNs place the entire underground device at the target sensing depth, where severe soil-induced attenuation significantly degrades communication reliability and makes wireless energy transfer (WET) inefficient and even impractical. To address this limitation, we propose Terra-Fi, a novel shallow-hub and deep-sensing architecture that decouples the sensing depth from the wireless communication and energy-replenishment depth. In Terra-Fi, a shallow wireless hub is deployed at a depth favorable for communication, WET, and maintenance, while application-specific sensing probes are extended to meter-scale target layers through power-and-signal feeders. On this basis, we first examine the depth limitations of underground communication and WET and compare representative monitoring architectures. Then, we present its system architecture, operation flow, and potential benefits. Through a precision agriculture case study, our numerical results reveal that Terra-Fi establishes more robust wireless connectivity and a longer operational lifetime than conventional fully buried WUSN architectures, particularly at greater sensing depths and higher volumetric water content. Moreover, its performance gain can be enhanced through time allocation and transmission-configuration optimization. Finally, we pinpoint practical challenges and future research directions for deploying Terra-Fi into WUSN systems.

0.48

LoRIS: LoRaWAN-based IoT Platform for Sustainability Monitoring in Hotels

cs.NI ·2026-08-18 ·Yash Pandey, Angus Gray, Reza Serati, Oscar Zhu, Emil Juvan +7 more
unusual similarity 0.55
Abstract

The hospitality sector is a major source of global greenhouse gas emissions, water stress, and waste generation, yet sustainability reporting in hotels remains constrained by coarse, manually collected operational data. We present LoRIS (LoRaWAN-based IoT platform for sustainability monitoring in hotels), a LoRaWAN-based sensing system that delivers high-resolution measurements of resource consumption, environmental conditions, and guest behaviour across geographically distributed hotel properties. The architecture follows the canonical LoRaWAN reference model and is built for the operational realities of hospitality deployments: restrictive hotel IT policies, guest privacy expectations, rapid and reversible installation, and multi-year battery operation. Privacy-by-design guides modality selection and deployment zoning, and end-to-end encryption protects data from sensor to dashboard. This system has been running since February 2022 and currently spans 850 sensors of 19 types across 21 sites in Australia and Slovenia, covering both the AU915 and EU868 regulatory regions. The platform has generated over 202 million sensor records and ingests approximately 245,000 uplink messages per day on managed serverless infrastructure. Our system has been successfully used for seven field studies spanning food waste, energy consumption, and water consumption, including controlled intervention experiments that measure environmental outcomes and guest satisfaction in parallel. This system shows that LoRaWAN sensing can be deployed at scale in operational hotels without compromising guest experience or privacy.

0.29

Exploring the Initial Performance of NB-IoT NTN over GEO: Measurement and Analysis

cs.NI ·2026-09-05 ·Xiong Wang, Yumin Du, Bin Gu, Zheng Lin, Xiaoyang Li +3 more
similarity 0.55
Abstract · 15 pages, 21 figures

With the standardization of Non-Terrestrial Networks (NTN) to provide direct satellite connectivity to massive, low-power Internet of Things (IoT) devices, 3GPP IoT-NTN bridges the worlds of cellular and satellite communications. While holding great potential for global connectivity with IoT devices, there exist several concerns about the system performance of IoT-NTN over Geostationary Earth Orbit (GEO), which covers multiple dimensions such as end-to-end delay and energy consumption considering the ultra-long transmission distance from ground IoT terminals to GEO satellite. To answer these concerns, we have conducted the first comprehensive and in depth measurement for NB-IoT NTN over GEO. Based on real NB-IoT NTN testbeds including both Skylo and Tiantong, measurements covering more than six months confirm that the available implementation of NB-IoT NTN remains in the initial stage. Amplified by ultra-long Round-Trip Time (RTT) between ground IoT terminals and GEO satellite, there exists plenty of time and energy consumption during the access process. Interestingly, it also reveals that as an energy-saving mechanism, Power Saving Mode (PSM) fundamentally reshapes NB-IoT NTN traffic into a bursty and access-driven communication pattern and thus has a considerable influence on the end-to-end delay and energy consumption. Finally, we propose corresponding optimization schemes to reduce the delay and energy, which lays a good foundation for the implementation of NB-IoT NTN in the near future.

0.56

Reliability Analysis for Ground-Air Cooperative Wireless-Powered Internet-of-Things

cs.IT ·2026-11-07 ·Xingyu Huang, Zhican Zhong, Yulei Wang, Yalin Liu, Yongqiang Cui +1 more
similarity 0.54
Abstract · 7 pages, 6 figures

Battery-constrained Internet of Things (IoT) devices face significant challenges in maintaining long-term uplink data collection, especially in network-limited scenarios. This paper investigates a Ground-Air cooperative Wireless-Powered IoT network (GA-WPIoT), where ground power beacons (GPBs) provide radio-frequency energy supply and unmanned aerial vehicles (UAVs) serve as flexible aerial access points for IoT data collection. Unlike conventional UAV-enabled wireless-powered solutions, GA-WPIoT decouples energy transfer and data collection, reducing the hardware and energy burden of UAVs. To capture the device-level performance variations among IoT devices, we develop a stochastic geometry-based analytical framework, where UAVs are modeled by a Matérn hard-core point process, IoT devices by a Poisson point process, and GPBs by a finite annular binomial point process. The conditional success probabilities of the GPB-device link (for energy transfer) and the device-UAV link (for data collection) are characterized, and device-level reliability distributions are obtained through the Meta-Distribution based analysis. Numerical results under suburban and urban environments reveal the impacts of UAV altitude and annular GPB deployment on reliability distributions, providing useful guidelines for GA-WPIoT.

0.25

Ray Tracing-Based LoRaWAN Gateway Placement for Reliable Connectivity in Amazonian Regions

cs.NI ·2026-08-31 ·Cláudio Modesto, Lucas Mozart, Cleverson Nahum, Bruno Castro, Aldebaro Klautau
similarity 0.54
Abstract · 5 pages, 2 tables and 5 figures

Network planning is an important task in wireless communications, as it helps network operators avoid unnecessary costs. In the context of the internet of things, using long-range wide-area network technologies in the Amazon rainforest, a key challenge is ensuring reliable communication between end-devices and gateways (GWs). In this sense, this reliability is strongly affected by channel conditions. Thus, during the planning phase, choosing the appropriate channel model is an important decision for accurate simulations. Given this motivation, in this work, we propose an optimization model to evaluate the impact of different types of channels on coverage and packet delivery ratio in a forest scenario. We used channels from ray tracing, empirical, and stochastic approaches to assess how decisions made during the network planning phase, in terms of the channel used, affect GW placement and, specifically, the percentage of end-devices covered and the reliability of the communication system. Our results show that GW placement based on site-independent channels can overestimate the number of GWs required to meet the network requirements, whereas using site-specific channels allows us to satisfy the same requirements with fewer GWs.

0.36

Packet Loss Analysis Under Doppler Effects and Reinforcement-Learning-Based Resource Allocation for Direct-to-Satellite LoRaWAN

eess.SP ·2026-10-16 ·Alireza Maleki, Ebrahim Bedeer, Robert Barton
similarity 0.52
Abstract

Long range wide area network (LoRaWAN) has a long communication range and low power consumption, making it a potential technology for direct-to-satellite (DtS) Internet of Things (IoT) connectivity. However, packet collisions and Doppler impairments brought on by satellite motion can greatly increase the packet loss ratio (PLR) in large-scale DtS-IoT networks. In this paper, we study resource allocation in DtSIoT LoRaWAN by first developing an analytical PLR model that simultaneously takes Doppler impairments and packet collisions in the temporal and frequency domains into account. In order to maximize resource allocation, the generated PLR is then used as the reward function for two reinforcement learning (RL) schemes: deep Q-network (DQN) and proximal policy optimization (PPO). Simulation results validate the analytical PLR model against Monte Carlo simulations and demonstrate significant improvements over random resource allocation. At a target PLR of 3*10^-2, while random allocation supports only 100 end devices (EDs), PPO and DQN support approximately 650 and 690 EDs, respectively, representing nearly a seven-fold increase. Furthermore, for 800 EDs, PPO and DQN increase the total number of transmitted packets by 106.7% and 88.0%, respectively, compared with random allocation.

0.22