CS Paper Radar

Intelligent Reflecting Surface Deployment for Low-Altitude Coverage: Illumination Geometry, Directional Characteristics, and Optimization

Guoying Zhang, Qingqing Wu, Ailing Zheng, Xingxiang Peng, Wen Chen, Wei Feng

cs.IT ·submitted 2026-08-31 11:03 UTC · v1
theory

Abstract

Terrestrial base stations (BSs) are typically configured with fixed downtilt to serve ground users, resulting in weak illumination of low-altitude airspace even under line-of-sight (LoS) propagation. In this paper, we establish a channel model that incorporates BS and intelligent reflecting surface (IRS) radiation patterns for three-dimensional (3D) low-altitude coverage while preserving the existing BS configuration. We formulate a budget-constrained IRS deployment problem that jointly determines candidate-site selection, IRS orientations, and phase shifts to maximize the worst-case signal-to-noise ratio (SNR) over the 3D low-altitude airspace. The selected sites and optimized IRS parameters remain fixed after deployment, yielding a quasi-static IRS configuration. We characterize the illumination geometry between the fixed-downtilt BS and rooftop candidates by deriving the nonnegative installation-height range satisfying the BS main-lobe condition. The separation between the mapped main-lobe height boundaries grows linearly with horizontal BS-to-site distance and decreases inversely with the number of BS antennas. We further derive an analytical lower bound on the regional worst-case normalized array gain achievable through IRS phase design over served directions with different direction spans. The resulting sufficient direction span decreases inversely with the square root of the number of IRS elements when the same worst-case normalized gain guarantee is maintained. We develop a mixed-integer alternating optimization (AO) algorithm to solve the resulting problem. Simulation results validate the analytical characterizations and show that the proposed scheme achieves higher worst-case SNR than benchmarks across different deployment budgets.

Comment
Submitted to an IEEE journal for possible publication

Closest papers

Nearest neighbours by meaning across the whole index.

Uplink Enhancement for Low-Altitude UAVs via Active RISs Under Existing Cellular Infrastructure

eess.SP ·2026-11-05 ·Weicong Chen, Chao-Kai Wen, Wankai Tang, Yiping Zuo, Xiao Li +1 more
publishedtheory similarity 0.63
Abstract · Minor Revision - IEEE Transactions on Communications

The proliferation of low-altitude aerial Internet of Things applications, such as UAV-based sensing/monitoring, demands high-performance uplinks, yet terrestrial-optimized cellular networks with downtilted base station (BS) antennas form coverage holes that severely degrade aerial uplink. To address this challenge without modifying infrastructure, active reconfigurable intelligent surfaces (RISs) are introduced. Unlike existing studies with complicated active RIS optimizations, we conduct a detailed noise analysis to simplify the transmission design. By deploying one active RIS per BS sector to fully exploit multi-sector reception, we develop a joint sector maximal signal combining scheme that improves signal quality through diversity gain. Active RISs introduce amplifier noise, raising questions about their net benefit. We derive an upper bound on the power ratio between RIS-introduced noise and BS-inherent noise, revealing that the impact of RIS noise is negligible under typical operating conditions. Based on this insight, we maximize a derived lower bound of the received signal-to-noise ratio by sequentially designing the amplitude and phase of reflection coefficients with closed-form expressions. Simulation results validate the theoretical analysis on negligible RIS-introduced noise in typical systems and demonstrate that under the same array gain, a larger RIS size rather than a higher reflection gain is preferred for enhancing the low-altitude uplink transmission.

0.35

Enhancing 3GPP Urban Channel Models For Terrestrial-to-Non-Terrestrial Communication

eess.SP ·2026-08-28 ·Gerhard Schreiber, Chenrui Sun, Joerg Schaepperle, Le-Hang Nguyen, Thorsten Wild
code/data similarity 0.61
Abstract

We have developed enhanced models for large-scale channel parameters intended for terrestrial-to-non-terrestrial (NTN) communication in Urban environments for supporting devices above ground levels, such as drones. The models are formulated as functions of terminal height above ground and elevation angle, applicable to S-Band and Ka-Band frequencies. To ensure realistic models, an open-source 3D scene generator was utilized to create a diverse set of urban scenes across Europe. Sionna ray-tracing was employed to generate path-gain samples for outdoor terminals, covering a range of heights up to 300 meters and elevation angles up to 90°. Our proposed analytical functions show excellent agreement to ray-tracing data for line-of-sight (LOS) probability, shadow-fading (SF), and clutter-loss (CL). Furthermore, a comparative coupling gain analysis with existing 3GPP models reveals notable differences, particularly caused by smaller CL and higher LOS probabilities from proposed models. Designed for ease of use, these models can be seamlessly integrated into simulation tools, offering a practical solution for researchers and engineers.

0.35

User Association and Transmit Beamforming for Rotatable Antenna-Enabled LAE Networks

eess.SP ·2026-09-28 ·Bowen Yao, Chao Zhang, Ying-Chang Liang
similarity 0.60
Abstract

This paper investigates rotatable antenna (RA)-enabled low-altitude economy (LAE) networks, where multiple base stations (BSs) are deployed to serve both terrestrial and aerial users. Unlike conventional fixed orientation antennas, RAs can adjust their boresights to serve users at diverse azimuth and elevation angles, thereby providing three-dimensional (3D) coverage. To improve the performance of LAE networks, we formulate a network sum-rate maximization problem that jointly optimizes user association, transmit beamforming, and RA orientations. However, in such LAE networks, aerial users are often visible to multiple BSs through line-of-sight (LoS) links, making user association and interference management particularly challenging. Moreover, user association and RA orientations are closely coupled: user association affects the RA pointing directions, while the RA orientations in turn reshape the channel conditions for user association. To solve this problem, we propose an alternating optimization (AO) algorithm that integrates weighted minimum mean-square error (WMMSE) for transmit beamforming, projected gradient ascent updates for user association, and Frank-Wolfe updates for RA orientations. Furthermore, we develop a discrete candidate-scanning scheme that replaces continuous orientation optimization with a finite search to reduce computational complexity. We also propose an antenna block-based scheme to reduce the number of orientation variables. Simulation results show that the proposed joint design achieves a higher sum-rate than the fixed antenna orientation and nearest BS association benchmarks. Moreover, the candidate-scanning and block-based schemes achieve approximately 89.9% and 94.3% of the performance with high transmit power, respectively, while reducing the complexity of orientation updates.

0.17

Physics-Guided Bayesian Optimization for High-Dimensional Mixed-Variable MIMO Base Station Design

eess.SP cs.NI ·2026-10-01 ·Koki Kanzaki, Koya Sato
similarity 0.60
Abstract · 6 pages, 4 figures. This work has been submitted to the IEEE for possible publication

This paper proposes a physics-guided Bayesian optimization for high-dimensional mixed-variable multiple-input and multiple-output (MIMO) base station (BS) design. The considered problem jointly selects a subset of candidate sites for BS deployment and optimizes the azimuth angles, downtilt angles, and transmit power spectral densities of the BSs, while each configuration is evaluated using computationally expensive site-specific ray tracing. To efficiently optimize the system configuration, the proposed method constructs a low-cost physics-based proxy from precomputed propagation information. The proxy-estimated communication coverage is used as the Gaussian process (GP) prior mean, and a residual GP with three-dimensional physical features learns the discrepancy between the proxy and full evaluations. Ray-tracing-based evaluations in two urban scenarios show that the proposed method achieves up to approximately 15 percentage points higher coverage than conventional and high-dimensional optimization baselines under the same evaluation budget.

0.28

Broadcasting in Centimeter-Wave Gigantic MIMO Systems: Beam Shaping is All You Need

cs.IT ·2026-10-21 ·Boyu Ning, Yike Xie, Jaebum Park, Songjie Yang, Weidong Mei +2 more
top venue similarity 0.60
Abstract

Beamforming is a key enabling technology for centimeter-wave Gigantic MIMO (G-MIMO) systems, using antenna arrays to generate wide beams for cell-wide broadcasting or narrow beams for data transmission. This paper presents a novel \emph{beam shaping technology} for designing environment-aware broadcast beams (i.e., beams for common control information delivery, as in 5G SSB). As a case study, we shape a \emph{prostrate beam} in the vertical plane to approximate uniform electromagnetic power distribution across the ground, thereby enhancing broadcast coverage quality. We first propose a geometric broadcasting model that, through coordinate transformation, relates base station height, beam spread, maximum service distance, and downtilt angle. Building on this model and the signal propagation model, we formulate the beam shaping problem as a non-convex optimization problem that aims to maximize ground-level coverage. To solve it, we develop a generalized optimization framework. We reformulate the problem into a matrix representation, equivalently transforming it into a target pursuit optimization (TPO) problem. Using variable substitution, the objective is convexified into a quadratically constrained quadratic program, and the non-convex rank constraint is handled via successive convex approximation, decomposing the problem into iteratively solved subproblems. We provide complexity and convergence analyses for the proposed algorithm. Numerical simulations confirm that the optimization effectively shapes the intended beam pattern and that the proposed prostrate beam yields significant performance gains, including substantially extended coverage distance, over conventional wide-beam benchmarks.

0.59

Site-Specific Cell Shaping: An Agentic Framework

eess.SY ·2026-11-14 ·Zhuo Xu, Zhaolin Wang, Yuanwei Liu
benchmark similarity 0.60
Abstract

An agentic framework is proposed for cell shaping in future sixth-generation (6G) wireless network planning. Cell shaping controls the coverage and interferences of base stations (BSs) through antenna parameters configuration, providing an important means of improving coverage. In contrast to conventional approaches that reply on costly performance evaluations, the proposed framework achieves intelligent and efficient antenna configuration through a perception-reasoning-reflection loop. Specifically, a Configuration Agent combines scene information, evaluation history, and reflection feedback to generate antenna configuration proposals. Then, a ray tracing(RT)-based evaluator assesses these proposals and returns a structured performance summary. Next, a Reflection Agent interprets these results to diagnose site-specific performance deficiencies, recommend feasible configuration adjustments, and accumulate conditional experience. Through this iterative process, the framework accumulates site-specific experience and progressively refines antenna configurations without human-in-the-loop intervention. Simulations in real-world urban scenarios demonstrate that the proposed framework achieves lower outage probabilities than the considered benchmark methods, highlighting the effectiveness of agentic reasoning and reflection in translating site-specific performance feedback and accumulated experience into adaptive antenna configuration decisions.

0.16

Simultaneous Indoor and Outdoor Coverage with Conformal Intelligent Omni-Surface

eess.SP ·2026-08-24 ·Yiqi Chen, Xiaoming She, Jianchi Zhu, Nanxi Li, Ruizhe Long +1 more
similarity 0.58
Abstract

Seamless indoor--outdoor coverage conventionally relies on coordinated outdoor macro cells and indoor small cells, incurring high deployment and backhaul costs. Intelligent omni-surfaces (IOSs) provide a promising alternative by enabling simultaneous reflection and transmission across building boundaries. Enabled by recent advances in conformal antennas, conformal IOSs (CIOSs) mounted on building facades offer a flexible and deployment-friendly solution for integrated indoor--outdoor coverage. This paper develops a stochastic-geometry framework to evaluate the downlink performance of CIOS-assisted networks serving both indoor and outdoor users. Specifically, a building-dependent spatial model is established where randomly located buildings are modeled via a Boolean scheme with CIOSs mounted on their facades. Unlike planar IOS deployment, conformal integration introduces geometry dependent visibility constraints, which are captured through the effective numbers of participating elements defined by visible arc metrics for reflection and transmission. Incorporating these constraints, coverage probability expressions are derived under three CIOS operating protocols. Numerical results show that, compared with planar IOS, CIOS improves the successful connection probabilities of the reflected and transmitted links by up to 75% and 125%, respectively, while the overall coverage gain remains dependent on blockage conditions because curvature reduces the effective serving aperture.

0.18

Beyond TR 38.811 for 6G NTN Channel Models

eess.SP ·2026-11-02 ·Kuan-Po Chiu, Aaron Jacob Buck, Sumit Roy
similarity 0.58
Abstract

As the 3rd Generation Partnership Project (3GPP) expands 6G non-terrestrial network (NTN) to S, Ku, and Ka bands for integration with existing terrestrial cellular networks, the necessary satellite channel model for link and network performance evaluation remains tied to TR 38.811, last revised in 2020. We identify issues on multiple fronts: inappropriate parameter specifications based on very limited site-specific environments considered, omission of satellite-induced Doppler spread and directional antenna effects and lack of a transparent channel model generation procedure. To address these limitations, we re-derive the channel parameters using ray tracing (RT) over urban and rural environments based on ITU-R building statistics. Our results show that TR 38.811 substantially overestimates the K-factor at low elevations and predicts a decreasing trend with elevation, which is inconsistent with RT. The Ka-band clutter loss (CL) also exceeds the RT estimates by more than 15 dB in urban cases. It also underestimates rural delay spread (DS) at low elevations and predicts an elevation trend inconsistent with RT. We further quantify the previously neglected satellite-induced Doppler spread. Finally, we demonstrate that the conventional TR 38.811 channel generator significantly underestimates the K-factor in the presence of directional antenna (beamforming), while our modified generator substantially reduces this discrepancy.

0.30