CS Paper Radar

Physics-Guided Bayesian Optimization for High-Dimensional Mixed-Variable MIMO Base Station Design

Koki Kanzaki, Koya Sato

eess.SP cs.NI ·submitted 2026-10-01 03:04 UTC · v1

Abstract

This paper proposes a physics-guided Bayesian optimization for high-dimensional mixed-variable multiple-input and multiple-output (MIMO) base station (BS) design. The considered problem jointly selects a subset of candidate sites for BS deployment and optimizes the azimuth angles, downtilt angles, and transmit power spectral densities of the BSs, while each configuration is evaluated using computationally expensive site-specific ray tracing. To efficiently optimize the system configuration, the proposed method constructs a low-cost physics-based proxy from precomputed propagation information. The proxy-estimated communication coverage is used as the Gaussian process (GP) prior mean, and a residual GP with three-dimensional physical features learns the discrepancy between the proxy and full evaluations. Ray-tracing-based evaluations in two urban scenarios show that the proposed method achieves up to approximately 15 percentage points higher coverage than conventional and high-dimensional optimization baselines under the same evaluation budget.

Comment
6 pages, 4 figures. This work has been submitted to the IEEE for possible publication

Closest papers

Nearest neighbours by meaning across the whole index.

Broadcasting in Centimeter-Wave Gigantic MIMO Systems: Beam Shaping is All You Need

cs.IT ·2026-10-21 ·Boyu Ning, Yike Xie, Jaebum Park, Songjie Yang, Weidong Mei +2 more
top venue similarity 0.65
Abstract

Beamforming is a key enabling technology for centimeter-wave Gigantic MIMO (G-MIMO) systems, using antenna arrays to generate wide beams for cell-wide broadcasting or narrow beams for data transmission. This paper presents a novel \emph{beam shaping technology} for designing environment-aware broadcast beams (i.e., beams for common control information delivery, as in 5G SSB). As a case study, we shape a \emph{prostrate beam} in the vertical plane to approximate uniform electromagnetic power distribution across the ground, thereby enhancing broadcast coverage quality. We first propose a geometric broadcasting model that, through coordinate transformation, relates base station height, beam spread, maximum service distance, and downtilt angle. Building on this model and the signal propagation model, we formulate the beam shaping problem as a non-convex optimization problem that aims to maximize ground-level coverage. To solve it, we develop a generalized optimization framework. We reformulate the problem into a matrix representation, equivalently transforming it into a target pursuit optimization (TPO) problem. Using variable substitution, the objective is convexified into a quadratically constrained quadratic program, and the non-convex rank constraint is handled via successive convex approximation, decomposing the problem into iteratively solved subproblems. We provide complexity and convergence analyses for the proposed algorithm. Numerical simulations confirm that the optimization effectively shapes the intended beam pattern and that the proposed prostrate beam yields significant performance gains, including substantially extended coverage distance, over conventional wide-beam benchmarks.

0.36

Model Sharing Bayesian Optimization for Mechanical Wi-Fi Antenna Control in Multi-Station Environments

cs.NI ·2026-10-30 ·Akihito Taya, Yuuki Nishiyama, Kaoru Sezaki
similarity 0.64
Abstract · This work has been submitted to the IEEE for possible publication. Copyright may be transferred without notice

Some commercial Wi-Fi access points used in homes and offices have antennas whose orientations can be adjusted manually. However, selecting suitable orientations is difficult for non-expert users, particularly in indoor multipath environments where reflections and polarization effects complicate the relationship between antenna orientation and link quality. We investigate automatic mechanical antenna orientation control for uplink Wi-Fi communication when the set of active stations changes over time. Building on our previously developed antenna-control system, we propose a model-sharing Bayesian optimization (BO) framework that learns the log-capacity of each link using a separate Gaussian process regression (GPR) model. The framework reuses these models across active-station (STA) combinations and optimizes proportional fairness, equivalently maximizing the geometric mean of the active links' capacities. Exploiting the linearity of this objective in log-capacity, we also derive a upper confidence bound (UCB) acquisition function and its gradient. We evaluate the framework through simulations driven by measured channel capacities and experiments with a mechanical Wi-Fi antenna prototype. The results demonstrate that the proposed model-sharing BO achieves better optimization performance than independent state-specific optimization by reusing the models trained on previously observed links.

0.25

GIST: Location-Dependent Uplink Path Structure Transfer for FDD Downlink Channel Estimation

eess.SP ·2026-11-02 ·Jinghan Zhang, Xitao Gong, Qi Wang, Mate Boban, Giuseppe Caire
hot direction similarity 0.60
Abstract · Submitted to IEEE ICC 2027

A key challenge of downlink (DL) channel estimation in frequency division duplex (FDD) massive multiple-input multiple-output (MIMO) systems is the pilot overhead, which grows with the numbers of antennas and subcarriers. However, a prior on path delays and directions shared by the uplink (UL) and DL channels can reduce this overhead. A model trained only on UL channels measured at a base station (BS) can predict the path structure (delays, directions and power gains) from the location of a user equipment (UE) and thereby assist DL channel estimation. In this paper, we propose Gaussian-Informed Structure Transfer (GIST), in which each Gaussian primitive models one propagation path, whose delay, directions and power gain are predicted from the UE location relative to the primitive center. The complex gains of the predicted paths are estimated from DL pilots by linear minimum mean square error estimation with this prior. Experiments on a ray-traced and a measured dataset show that GIST outperforms all baselines, reaching a lower DL estimation error with fewer pilot subcarriers. Further experiments demonstrate its robustness to UE location errors, its low storage and computational requirements.

0.32

Intelligent Reflecting Surface Deployment for Low-Altitude Coverage: Illumination Geometry, Directional Characteristics, and Optimization

cs.IT ·2026-08-31 ·Guoying Zhang, Qingqing Wu, Ailing Zheng, Xingxiang Peng, Wen Chen +1 more
theory similarity 0.60
Abstract · Submitted to an IEEE journal for possible publication

Terrestrial base stations (BSs) are typically configured with fixed downtilt to serve ground users, resulting in weak illumination of low-altitude airspace even under line-of-sight (LoS) propagation. In this paper, we establish a channel model that incorporates BS and intelligent reflecting surface (IRS) radiation patterns for three-dimensional (3D) low-altitude coverage while preserving the existing BS configuration. We formulate a budget-constrained IRS deployment problem that jointly determines candidate-site selection, IRS orientations, and phase shifts to maximize the worst-case signal-to-noise ratio (SNR) over the 3D low-altitude airspace. The selected sites and optimized IRS parameters remain fixed after deployment, yielding a quasi-static IRS configuration. We characterize the illumination geometry between the fixed-downtilt BS and rooftop candidates by deriving the nonnegative installation-height range satisfying the BS main-lobe condition. The separation between the mapped main-lobe height boundaries grows linearly with horizontal BS-to-site distance and decreases inversely with the number of BS antennas. We further derive an analytical lower bound on the regional worst-case normalized array gain achievable through IRS phase design over served directions with different direction spans. The resulting sufficient direction span decreases inversely with the square root of the number of IRS elements when the same worst-case normalized gain guarantee is maintained. We develop a mixed-integer alternating optimization (AO) algorithm to solve the resulting problem. Simulation results validate the analytical characterizations and show that the proposed scheme achieves higher worst-case SNR than benchmarks across different deployment budgets.

0.19

Variational Bayesian Inference Based Progressive Multi-Target MIMO Sensing with Nuisance Parameters

cs.IT eess.SP ·2026-10-07 ·Jiayi Yao, Shuowen Zhang
similarity 0.59
Abstract · Submitted for possible publication

This paper proposes a progressive Bayesian multiple-input multiple-output (MIMO) sensing framework for multiple targets over multiple stages. We consider a practical yet challenging scenario where the targets' angles are unknown and random parameters to be estimated, while the targets' reflection coefficients are unknown nuisance parameters. With an initial prior probability density function (PDF) for the targets' angles, we progressively update the prior PDF for each sensing stage as the posterior PDF obtained from the previous stage, based on which Bayesian transmit beamforming optimization is performed to minimize the sum posterior Cramér-Rao bound (PCRB) in estimating the targets' angles and Bayesian sensing is performed with the help of new observations in this stage. To analytically characterize the intractable and high-dimensional posterior PDF with low complexity, we propose a variational Bayesian inference based approach which derives a surrogate posterior PDF in closed form with only polynomial complexity over the number of targets, in sharp contrast to existing numerical calculation approaches with exponential complexity. Numerical results validate the efficacy of our proposed framework in progressively refining sensing performance.

0.12

Joint Beamforming for Continuous Transmissive RIS-Enabled Multiuser Communications

cs.IT ·2026-10-06 ·Beining Han, Shumeng Zhang, Deyou Zhang, Qingchao Li, Jun Liu +1 more
similarity 0.59
Abstract

This paper studies continuous transmissive reconfigurable intelligent surface (CT-RIS)-enabled multiuser downlink communications, where passive beamforming is characterized by a phase function defined over the continuous aperture. We employ a distance-dependent spherical-wave model for the base station (BS)-to-CT-RIS link and introduce a finite-path model based on field-response vectors for the CT-RIS-to-user links. The resulting weighted sum rate maximization problem jointly optimizes the finite-dimensional BS precoders and the infinite-dimensional CT-RIS phase function, giving rise to a mixed finite- and infinite-dimensional non-convex optimization problem. To address this problem, we develop an alternating optimization algorithm that combines a closed-form BS precoder update with a functional phase update derived using the calculus of variations and minorization-maximization. Numerical results demonstrate that the proposed CT-RIS consistently outperforms the considered benchmarks, with the performance gains attributed to spatially continuous phase control and a larger effective receiving area.

0.24

RayAR: Autoregressive Dominant Path Generation for Low-Overhead MIMO Beam Alignment

eess.SP ·2026-10-31 ·Junxi Huang, Xiucheng Wang, Nan Cheng, Kailong Wang, Jiang Guo +1 more
similarity 0.58
Abstract

Beam alignment in multiple-input multiple-output (MIMO) systems requires selecting suitable transmit and receive beam pairs with limited measurement overhead. Although 3GPP Release 18 investigates beam prediction from partial measurements, collecting these measurements still incurs probing overhead. Geometry can focus this probing through the departure and arrival directions of dominant paths, whose identification requires accounting for coupled diffraction interactions. To address this challenge, we propose RayAR, an autoregressive method that generates dominant propagation paths from urban geometry. RayAR conditions candidate ranking on the path prefix, local diffraction geometry, and receiver reachability, updating this context after each selection until the receiver becomes visible. The completed path's departure and arrival directions rank beam pairs for probing, allowing the pair with the highest received power to be selected from a small candidate set. Under 3GPP Release 18 beam-management metrics, RayAR reduces probing by 96.88\% relative to exhaustive sweeping and achieves the highest optimal-pair hit rate among compared methods at the same budget. Real-world measurements further demonstrate the accuracy of this geometric guidance, with simulation-trained RayAR achieving the lowest departure and arrival angular errors among compared methods without fine-tuning and a mean arrival-direction error of 9.07$^\circ$.

0.36

Digital Twin-Aided Prescreening for User Scheduling in MU-MIMO Downlink Systems

eess.SP ·2026-08-11 ·Namhyun Kim, Mahmoud Saad Abouamer, Jeonghun Park, Petar Popovski, Ahmed Alkhateeb
similarity 0.57
Abstract · 13 pages, 8 figures

In dense deployments, massive multi-user multiple-input multiple-output (MU-MIMO) base stations can acquire instantaneous channel state information (CSI) for only a limited subset of users per scheduling interval, restricting multiuser diversity. We therefore propose Digital Twin User pre-Screening (DiTUS), a digital-twin (DT)-aided framework that identifies promising users before instantaneous CSI acquisition. DiTUS forms spatial covariances from DT-inferred departure angles and path powers. Optional Gaussian-process (GP) calibration mitigates path-power bias, while the dominant rank-r eigenspace of the aggregate covariance yields common reference beams. It prescreens the pool using DiTUS-P, a low-complexity projection-energy rule, or DiTUS-L, a greedy log-determinant rule that promotes spatial compatibility. A two-level protocol collects scalar beam reports from shortlisted users and requests r-dimensional effective-channel vectors only from the scheduled set. The framework also supports proportional-fair scheduling. At 15 dB under DT imperfections, simulations with 128 candidates, a 64-user effective-CSI acquisition budget, and a 64-user shortlist show that DiTUS-L achieves 35.06 +/- 0.49 bps/Hz versus 30.28 +/- 0.60 bps/Hz for semi-orthogonal user selection (SUS) with full-dimensional CSI from 64 users, demonstrating that DT-based prescreening preserves substantial multiuser-diversity gains by identifying strong, spatially compatible users before acquiring effective-channel vectors.

0.10