CS Paper Radar

GIST: Location-Dependent Uplink Path Structure Transfer for FDD Downlink Channel Estimation

Jinghan Zhang, Xitao Gong, Qi Wang, Mate Boban, Giuseppe Caire

eess.SP ·submitted 2026-11-02 17:23 UTC · v1
hot direction

Abstract

A key challenge of downlink (DL) channel estimation in frequency division duplex (FDD) massive multiple-input multiple-output (MIMO) systems is the pilot overhead, which grows with the numbers of antennas and subcarriers. However, a prior on path delays and directions shared by the uplink (UL) and DL channels can reduce this overhead. A model trained only on UL channels measured at a base station (BS) can predict the path structure (delays, directions and power gains) from the location of a user equipment (UE) and thereby assist DL channel estimation. In this paper, we propose Gaussian-Informed Structure Transfer (GIST), in which each Gaussian primitive models one propagation path, whose delay, directions and power gain are predicted from the UE location relative to the primitive center. The complex gains of the predicted paths are estimated from DL pilots by linear minimum mean square error estimation with this prior. Experiments on a ray-traced and a measured dataset show that GIST outperforms all baselines, reaching a lower DL estimation error with fewer pilot subcarriers. Further experiments demonstrate its robustness to UE location errors, its low storage and computational requirements.

Comment
Submitted to IEEE ICC 2027

Closest papers

Nearest neighbours by meaning across the whole index.

Mean Spatial Frequency Decoupling for Learning-Based Uplink-to-Downlink Covariance Conversion in FDD Massive MIMO

eess.SP cs.LG ·2026-09-30 ·Melih Can Zerin
benchmark similarity 0.68
Abstract

In frequency division duplexing (FDD) massive multiple-input multiple-output (MIMO) systems, the uplink (UL)-to-downlink (DL) channel covariance matrix (CCM) conversion problem is studied to relieve the heavy burden of DL training and feedback required for channel estimation. Learning- based methods perform well up to a certain array size, but for a fixed dataset size their accuracy deteriorates with the number of antennas, to the point where simple model-based methods outperform them. This paper identifies a key cause of this behavior and addresses it. The mean angle of arrival (AoA) induces a phase ramp along the lags of the CCM. Since the oscillation rate of this ramp grows with the number of antennas, a dataset of fixed size becomes increasingly sparse relative to the variation that must be captured. We propose estimating the slope of this ramp from the UL CCM separately and mapping it to the DL band in closed form, leaving the learner with a residual that is largely insensitive to the mean AoA, which substantially reduces the performance degradation with an increasing number of antennas. The proposed scheme, termed deramping, is a combination of pre- and post-processing steps that applies to learning-based conversion methods without altering their internal structure, as demonstrated on three structurally different learners. Simulation results show that deramping reduces the covariance estimation error of all three learners under uniform, Laplacian, and Gaussian angular power spectra,keeps the interpolation-based learners ahead of a model-based benchmark at large array sizes, and improves downlink channel estimation.

0.21

UL-Assisted Parametric CSI Feedback and Prediction for FDD Systems

eess.SP ·2026-10-10 ·Hao Chang, Mingcheng Nie, Shuangyang Li, Chang Liu, Branka Vucetic +2 more
similarity 0.66
Abstract · The paper is accepeted in GlobeCom 2026

In frequency-division duplex (FDD) systems, the uplink (UL) and downlink (DL) channels are not fully reciprocal. Therefore, DL channel state information (CSI) estimated by each user equipment (UE) must be fed back to the base station (BS). However, because the channel varies between CSI acquisition and utilization, the feedback CSI may become outdated before it is used at the BS. To address this challenge, this paper proposes an UL-assisted parametric CSI feedback and prediction scheme for multi-user FDD systems with time-varying channel parameters. By exploiting the partial reciprocity between the UL and DL channel parameters, the BS first estimates the UL channel parameters from the sounding reference signals (SRSs) transmitted by the UEs. The BS then broadcasts DL pilots, allowing each UE to obtain observations containing information about its current DL channel. Instead of explicitly estimating the DL channel from these observations, each UE directly encodes them into feedback symbols and transmits the symbols to the BS. The BS decoder combines the feedback symbols with the partially reciprocal UL parameters to predict the future DL channel parameters. Finally, the corresponding DL channel matrix is synthesized from the predicted parameters using an explicit physical channel model. Simulation results on Sionna ray tracing (RT) dataset show that the proposed scheme outperforms the considered baselines in terms of channel prediction performance over different signal-to-noise ratios and prediction lengths.

0.24

Environment-Aware Diffusion Model for Massive MIMO-OFDM Channel Estimation

eess.SP ·2026-09-15 ·Wanchen Hu, Jie Yang, Yi Song, Jun Xia, Shuangyang Li +2 more
similarity 0.65
Abstract

This paper proposes an environment-aware diffusion based channel estimation in massive multiple-input multiple-output orthogonal frequency division multiplexing (MIMO-OFDM) systems. The high dimensionality of massive MIMO channels combined with limited pilot resources makes accurate estimation challenging. To address this issue, we exploit the spatial variability of wireless channels by training a diffusion model to learn the location-conditioned distribution of channel state information, which provides an environment-aware prior for channel estimation. Based on this learned prior, a posterior inference algorithm is developed to incorporate pilot observations into the reverse diffusion process, enabling Bayesian channel estimation by combining the received-signal likelihood with the learned channel prior. By jointly leveraging location information and measurement data, the proposed approach improves estimation accuracy under limited pilot resources. Simulation results based on ray-tracing channel datasets demonstrate that the proposed method consistently outperforms conventional estimators and existing learning-based approaches across various signal-to-noise ratios and pilot configurations.

0.40

Geometry-Informed Neural Network for Pilot-Limited Channel Estimation via Sensing from Uplink Traffic

eess.SP ·2026-10-06 ·Wenyu Huang, Alireza Javid, Nuria González-Prelcic
code/data similarity 0.64
Abstract · This work has been submitted to the IEEE for possible publication

Reliable wireless systems depend on accurate uplink channel estimation for precoding, scheduling, and link adaptation at the base station. In the upper mid-band, wide bandwidths and large antenna arrays increase the channel dimension and make pilot-efficient estimation particularly challenging. While uplink data is available as every user transmits it, sounding resources are shared across all users in the cell, leaving only a few pilots for each user. Thus, channel estimation heavily depends on prior information. Existing approaches obtain such priors in different ways, each with limitations. Ray tracing requires a site model, channel knowledge maps rely on measurements at or near the locations they represent, and learned channel distributions do not explicitly capture propagation geometry. We therefore propose TRaffic-Aided Channel Estimation (TRACE), which builds the prior from uplink traffic without additional sounding. TRACE learns a geometry-aware channel prior from routine multi-UE uplink traffic and combines it with the available pilots for channel estimation. In a ray-traced street canyon at 15 GHz, TRACE achieves -7.48 dB NMSE with 8 pilots, outperforming three state-of-the-art priors and two geometric ablations by more than 3 dB, while remaining effective with only 2 pilots. Within a deployment, TRACE remains robust across SNRs, carrier frequencies, and reduced mapping traffic without retraining.

0.25

Physics-Guided Bayesian Optimization for High-Dimensional Mixed-Variable MIMO Base Station Design

eess.SP cs.NI ·2026-10-01 ·Koki Kanzaki, Koya Sato
similarity 0.60
Abstract · 6 pages, 4 figures. This work has been submitted to the IEEE for possible publication

This paper proposes a physics-guided Bayesian optimization for high-dimensional mixed-variable multiple-input and multiple-output (MIMO) base station (BS) design. The considered problem jointly selects a subset of candidate sites for BS deployment and optimizes the azimuth angles, downtilt angles, and transmit power spectral densities of the BSs, while each configuration is evaluated using computationally expensive site-specific ray tracing. To efficiently optimize the system configuration, the proposed method constructs a low-cost physics-based proxy from precomputed propagation information. The proxy-estimated communication coverage is used as the Gaussian process (GP) prior mean, and a residual GP with three-dimensional physical features learns the discrepancy between the proxy and full evaluations. Ray-tracing-based evaluations in two urban scenarios show that the proposed method achieves up to approximately 15 percentage points higher coverage than conventional and high-dimensional optimization baselines under the same evaluation budget.

0.28

Digital Twin-Aided Prescreening for User Scheduling in MU-MIMO Downlink Systems

eess.SP ·2026-08-11 ·Namhyun Kim, Mahmoud Saad Abouamer, Jeonghun Park, Petar Popovski, Ahmed Alkhateeb
similarity 0.60
Abstract · 13 pages, 8 figures

In dense deployments, massive multi-user multiple-input multiple-output (MU-MIMO) base stations can acquire instantaneous channel state information (CSI) for only a limited subset of users per scheduling interval, restricting multiuser diversity. We therefore propose Digital Twin User pre-Screening (DiTUS), a digital-twin (DT)-aided framework that identifies promising users before instantaneous CSI acquisition. DiTUS forms spatial covariances from DT-inferred departure angles and path powers. Optional Gaussian-process (GP) calibration mitigates path-power bias, while the dominant rank-r eigenspace of the aggregate covariance yields common reference beams. It prescreens the pool using DiTUS-P, a low-complexity projection-energy rule, or DiTUS-L, a greedy log-determinant rule that promotes spatial compatibility. A two-level protocol collects scalar beam reports from shortlisted users and requests r-dimensional effective-channel vectors only from the scheduled set. The framework also supports proportional-fair scheduling. At 15 dB under DT imperfections, simulations with 128 candidates, a 64-user effective-CSI acquisition budget, and a 64-user shortlist show that DiTUS-L achieves 35.06 +/- 0.49 bps/Hz versus 30.28 +/- 0.60 bps/Hz for semi-orthogonal user selection (SUS) with full-dimensional CSI from 64 users, demonstrating that DT-based prescreening preserves substantial multiuser-diversity gains by identifying strong, spatially compatible users before acquiring effective-channel vectors.

0.10

Prior-Aided Masked Vector Quantization CSI Feedback for FDD Massive MIMO Systems

cs.IT ·2026-09-15 ·Yi Song, Tianyu Yang, Kangda Zhi, Shuangyang Li, Giuseppe Caire
similarity 0.60
Abstract

Downlink channel state information (CSI) feedback is a key bottleneck in frequency-division duplex (FDD) massive MIMO systems, as the user equipment (UE) must convey its estimated channel to the base station (BS) over a limited uplink (UL) budget. To improve CSI reconstruction accuracy under tight feedback constraints, we propose prior-aided masked vector quantization (PM-VQ), a learning-based separate source--channel coding (SSCC) feedback scheme conditioned on the average angle--delay power map---a compact representation of the channel second-order statistics available at both the UE and the BS. In PM-VQ, a prior-aided encoder maps the CSI to latent tokens, and a spatially-adaptive masking module (SAMM) scores and selects the most informative tokens within the feedback budget. The selected tokens are vector-quantized and fed back together with their positions, while an adaptive de-masking module (ADM) completes the latent representation at the BS before prior-conditioned decoding. To support variable-rate compression, a single model is trained over a range of selected-token counts, enabling operation across multiple feedback dimensions without retraining. We evaluate PM-VQ against three representative baselines on a Sionna-generated 3GPP TR~38.901 UMa dataset, focusing on the most challenging diffuse regime where channel energy is spread across many angle--delay coefficients. Simulation results show that PM-VQ achieves the lowest NMSE across all tested SNR levels and feedback dimensions in this regime. Moreover, the angle--delay power-map prior remains beneficial even when estimated from only a few channel realizations.

0.29

Geometry-Aware Channel Aging in MIMO Systems: When Is Kronecker Separability Enough?

eess.SP ·2026-11-05 ·Steven Rivetti, Gabor Fodor, Emil Bjornson, Mikael Skoglund
similarity 0.60
Abstract · 5 pages, 3 figures. Submitted to IEEE Wireless Communication Letters

This letter investigates when Kronecker-separable spatial correlation approximates the covariance of multiple-input-multiple-output (MIMO) channels. We propose a geometry-aware channel model in which the same propagation environment determines both the Weischelberger spatial coupling matrix and the temporal correlation coefficient. The propagation environment follows a 3GPP-inspired clustered channel model. We consider a MIMO system affected by symbol-level channel aging caused by the user equipment's mobility. We schedule both uplink and downlink pilots, thereby deriving the respective spectral efficiencies (SEs) in the presence of imperfect channel state information. Numerical results show that channel aging's magnitude is strongly geometry-dependent, with diffuse propagation inducing greater temporal decorrelation and SE degradation than concentrated scattering. The results also identify regimes where Kronecker separability can be applied and regimes where geometry-aware Weischelberger coupling is needed.

0.31