CS Paper Radar

3D Radar Imaging from the UAV Nadir

S. Hamed Javadi, Hichem Sahli, André Bourdoux

eess.SP ·submitted 2026-09-04 08:06 UTC · v1
top venue

Abstract

Radars improve the sensing robustness of UAVs by operating under poor lighting and weather conditions and seeing through occlusions such as vegetation. However, they suffer from poor angular resolution, which can be addressed using synthetic aperture radar (SAR) algorithms. State-of-the-art UAV SAR methods operate at a depression angle and are not suitable for sensor fusion applications where the data are collected from areas directly below the UAV (i.e., the UAV nadir). In this paper, we present an interferometric SAR (InSAR) framework for reconstructing 3D images from the UAV nadir using a low-cost multi-input-multi-output (MIMO) mm-wave radar. Additionally, an effective method based on the phase gradient autofocus (PGA) is presented for compensating the phase error across the virtual receive antennas. We demonstrate the effectiveness of our 3D imaging algorithm in both simulation and experimental scenarios.

Comment
Accepted for publication in IEEE Transactions on Radar Systems
DOI
10.1109/TRS.2026.3731078

Closest papers

Nearest neighbours by meaning across the whole index.

Bistatic UAV-Based 3D SAR Imaging Using Integrated Sensing and Communications Transceivers

eess.SP ·2026-11-09 ·Akanksha Sneh, Krishna Ayyagari, Vivaswan Nawani, Shobha Sundar Ram
similarity 0.67
Abstract

Integrated sensing and communication (ISAC) frameworks enable autonomous systems to jointly perform radar sensing and wireless communication using common spectral and hardware resources. Prior art on ISAC-enabled UAV for SAR focused on monostatic configurations for two-dimensional target imaging. In this work, we propose a bistatic UAV tomographic SAR framework in which the IEEE~802.11ad waveform, RF hardware, and spectral resources are jointly utilized for communication and radar sensing for three-dimensional (3D) localization of complex targets. Specifically, we demonstrate how communication packets transmitted from a master ISAC transceiver UAV to a passive receiver UAV are exploited for timing and frequency synchronization, motion compensation, and 3D localization of targets, without requiring auxiliary infrastructure on the passive receiver for these tasks. We evaluate the proposed framework for localizing automotive targets over elevated terrain, with Monte Carlo simulations modeling synchronization and platform motion errors. The results demonstrate improved localization accuracy compared with conventional InSAR-based localization. The interplay between radar and communication performances are further evaluated using diverse modulation schemes.

0.14

SPIRIT: Sparse Physics-Informed Inverse Rendering for SAR Imaging

cs.CV cs.AI ·2026-10-01 ·Yimeng Liu, Maolin Gan, Jingkai Lin, Jialuo Du, Mi Zhang +1 more
similarity 0.61
Abstract

Radio-frequency (RF) and wave-based imaging systems play a critical role in sensing under adverse conditions, but are fundamentally constrained by a trade-off between collection speed and spatial resolution. Reducing measurements to enable rapid collection of fragment geometric information across sensing dimensions, leading to highly non-injective inverse problems that destabilize conventional image-domain reconstruction and super-resolution methods. Synthetic aperture radar (SAR) exemplifies this challenge in sparse-aperture sampling. We introduce SPIRIT, a physics-informed inverse rendering framework for sparse-aperture SAR. Rather than enhancing formed images, SPIRIT reconstructs an explicit three-dimensional surface. By adopting an optimization strategy and explicitly modeling visibility, phase coherence, and wave propagation, SPIRIT aggregates distributed geometric features across sparse aperture views into a coherent reconstruction. Extensive experiments on synthetic and real-world data demonstrate that SPIRIT recovers accurate geometry and signal under extreme sparsity, reducing data collection by over 90% while achieving low geometric and signal error and consistently outperforming baselines.

0.17

mmIR: Frequency-Space Inverse Rendering for 3D Millimeter-Wave Radar ADC Synthesis

cs.CV cs.GRcs.LGeess.SP ·2026-08-28 ·Adnan Armouti, Yixuan Gao, Rajalakshmi Nandakumar
top venuecode/data similarity 0.60
Abstract · Accepted to the European Conference on Computer Vision (ECCV) 2026. Project page: https://mmwave-inverse-rendering.github.io/

High-resolution 3D radar data is scarce. Commodity mmWave sensors use small antenna arrays that limit angular resolution to several degrees, and existing datasets provide only 2D range-azimuth maps or sparse point clouds rather than raw analog-to-digital converter (ADC) signals. Hardware scaling is expensive, synthetic-aperture scanning is impractical at fleet scale, and learned synthesis methods are bottlenecked by the very data shortage they aim to address. We present mmIR, an open-source differentiable frequency-modulated continuous-wave (FMCW) radar inverse renderer that fits a physics-based forward model to real captures and re-renders from dense virtual apertures to synthesize high-resolution 3D radar data. Because radar resolution is too coarse to recover geometry directly, mmIR performs LiDAR-assisted inverse rendering: using LiDAR-derived meshes as a geometric scaffold, mmIR optimizes per-vertex International Telecommunication Union (ITU) physics materials, vertex normals, and antenna beam patterns through end-to-end automatic differentiation of a phase-coherent multiple-input multiple-output (MIMO) forward model with multi-bounce propagation, polarization, and free-space diffraction. On seven outdoor and six indoor ColoRadar scenes, mmIR achieves 0.914 mean Pearson correlation on range-azimuth maps versus 0.307 for Sionna-RT. Scenes trained on a cascaded imaging radar transfer to a co-located single-chip radar without re-training (0.554 correlation), and dense virtual arrays (100x100 elements) produce single-frame 3D occupancy validated against LiDAR. Project page: https://mmwave-inverse-rendering.github.io/

0.75

UAV SAR Imaging via Diffusion Posterior Sampling under Non-Ideal Motion in ISAC Systems

eess.SP cs.IT ·2026-10-10 ·Keying Zhu, Le Liang, Jie Yang, Fan Liu, Shi Jin
similarity 0.60
Abstract

Unmanned aerial vehicle-enabled synthetic aperture radar (SAR) offers significant potential for providing communication services to ground users while sensing the surrounding environment in low-altitude integrated sensing and communication (ISAC) systems. However, its practical deployment is challenged by known non-ULM trajectories and unknown position errors, which violate conventional SAR assumptions and cause severe image defocusing. We address these non-ideal impacts by formulating the ISAC SAR imaging as an exact linear inverse problem to accurately model arbitrary trajectories with multiple-input multiple-output orthogonal frequency division multiplexing waveforms. Based on this formulation, we develop a diffusion posterior sampling (DPS)-based super-resolution SAR framework, where a pre-trained diffusion model provides a data-driven image prior and the exact physical model enforces measurement consistency during posterior inference. The inference process is further accelerated for practical implementation. For unknown position errors, we develop a joint iterative DPS and motion compensation (MoCo) optimization algorithm with discrete cosine transform reparameterization and coarse-to-fine spectral scheduling. Simulations demonstrate that our framework achieves high-accuracy reconstruction across diverse trajectories and remarkable super-resolution, maintaining greater than 21.3 dB peak signal-to-noise ratio (PSNR) even under half physical resolution truncation. Under unknown motion errors, the joint DPS and MoCo algorithm achieves 23.65 dB PSNR with a residual position-error estimation error of 0.19 cm.

0.25

From very fine Vertical Resolution to Range Super-Resolution on BIOMASS P-BAND SAR Data

eess.SP ·2026-11-16 ·Yanghai Yu, Stefano Tebaldini, Yang Lei, Fabio Rocca
similarity 0.59
Abstract · 5 pages, 7 figures. This work has been submitted to the IEEE for possible publication. Copyright may be transferred without notice, after wh…

This paper demonstrates range super-resolution over arid regions using SAR tomography data with very fine vertical resolution from the European Space Agency's BIOMASS mission. As the first civilian spaceborne P-band SAR mission, BIOMASS is operating with a bandwidth limited to 6~MHz by International Telecommunication Union regulations, yielding a native slant-range resolution of approximately 25 m. The large spatial baseline data acquired during the commissioning phase in July and August 2025 provide a valuable opportunity to enhance range resolution based on the InSAR wavenumber shift principle. According to this principle, a wider effective bandwidth can be synthesized by combining complementary sub-bands of the ground reflectivity spectrum sampled across acquisitions at different look angles. Unlike existing literature, this paper offers a novel interpretation of this problem from the perspective of SAR tomography. Furthermore, the proposed method also accounts for residual topography errors. The range resolution enhancement performance is validated using all 20 available acquisitions from the July-August 2025 commissioning phase over Lop Nur, China, and Wadi al-Hayat, Libya, achieving spatial detail comparable to optical satellite imagery in a grid finer than 2 m. Furthermore, the reconstructed range spectrum of the central Libyan oasis exhibits an effective bandwidth exceeding 70 MHz. The point spread function (PSF) of a point like target in the scene demonstrates a slant-range resolution finer than 2.1 m, representing more than a twelvefold improvement over the native resolution.

0.28

FiLM-GPNet: Geometry-Aware Pseudo-Supervised Phase Restoration with Zero-Shot Generalization for Large Temporal InSAR Stacks

cs.CV cs.LG ·2026-08-29 ·Getnet Demil, Muhammad Farhan Humayun, Tomi Westerlund, Jukka Heikkonen, Mourad Oussalah
published similarity 0.58
Abstract · Its IEEE Geoscience And Remote Sensing Symposium (IGARSS) 2026 Data Fusion Contest Winner Paper. reference https://www.grss-ieee.org/communi…

The growing availability of dense commercial Synthetic Aperture Radar (SAR) time series enables temporal Interferometric SAR (InSAR) analysis, but fixed classical filters fail under heterogeneous acquisition geometries, degrading phase quality and temporal consistency. We propose FiLM-GPNet, a geometry-conditioned network for wrapped-phase restoration that explicitly adapts to acquisition differences using Feature-wise Linear Modulation (FiLM) and a 7D per-pair geometry descriptor. The model is trained with pseudo-supervision from Goldstein-filtered interferograms and regularized by interferometric physics via triplet-closure consistency, while also estimating per-pixel aleatoric uncertainty. Experiments on three Capella Spotlight stacks from the IEEE GRSS 2026 Data Fusion Contest show that FiLM-GPNet reduces temporal residual by 68% (Hawaii) and 66% (Western Australia) relative to the Goldstein baseline, alongside closure error reductions of 10% and 13%, respectively. In Western Australia, it further improves unwrapping success rate by 7.7 percentage points and Digital Elevation Model (DEM) Normalized Median Absolute Deviation (NMAD) by 31%. The model also shows strong zero-shot generalization to a geographically and geometrically distinct third stack (Los Angeles) without retraining, supporting geometry-conditioned restoration as an effective alternative to fixed classical filtering across heterogeneous stacks.

0.29

Spatial phase coherence and its applications to masking and adaptive neighborhood sizing in multitemporal InSAR

eess.SP ·2026-11-15 ·Magnus Heimpel, Irena Hajnsek, Othmar Frey
similarity 0.58
Abstract · 44 pages, 12 figures

We examine spatial phase coherence (SPC), a measure of the correlation between the wrapped phase time series of two pixels in a stack of single-look synthetic aperture radar acquisitions. A pixel and its adjacent neighbors share speckle through the point spread function, so that decorrelation alone does not lower their SPC below a floor. We find that masking pixels whose mean SPC to their eight neighbors is well below that floor, as in parts of layover and shadow areas, is an inexpensive complement to geometry-derived layover and shadow masks. For distributed scatterer pixels, averaging SPC over a fixed set of neighbors that share no speckle yields a proxy for the local coherence, the phase coherence indicator (PCI), that is available before the selection of statistically homogeneous pixels (SHPs). In phase estimation, averaging more pixels reduces noise but may also increase the bias in heterogeneous areas. To relax this trade-off, we propose to enhance SHP selection algorithms by scaling the search window size according to the PCI and truncating the set of selected pixels where a smaller nested set agrees clearly better with the phases at the center. In simulations of a TerraSAR-X and a Sentinel-1 stack with 44 and 79 acquisitions, we apply this adaptive neighborhood sizing (ANS) to established amplitude- and covariance-based SHP selection algorithms with thresholds that adapt to the PCI. Without ANS, the largest tested search window size has 13 to 29 % more phase linking error than the best of the tested sizes. With ANS, the largest window has the lowest error of the tested sizes, 11 % lower than that of the same selection at its best tested size without ANS. On a real TerraSAR-X stack, the mask based on SPC flags pixels in building shadows that a terrain model misses. On real Sentinel-1 stacks, ANS preserves dense fringes on a slowly deforming slope and in part on a fast landslide.

0.34

Benchmarking Regularization Methods For 3D Radio Tomographic Imaging

eess.IV eess.SP ·2026-09-08 ·Wanqin Ma, Yijun Chen, Alikhan Umirbayev, Jichen Zhang, Ross Murch
similarity 0.57
Abstract · 5 pages, 2 figures, in the process of ICASSP 2027

Integrated Sensing and Communication (ISAC) is an important technology for 6G, enabling wireless systems to perceive their physical environment. Radio Tomographic Imaging (RTI) is a potential technique for device-free sensing in ISAC, reconstructing object locations and shapes from Received Signal Strength (RSS) measurements. It can complement other techniques, such as radar and LiDAR, by providing a narrowband modality with wavelength resolution. Recently, an extended version of RTI, known as the extended phaseless Rytov approximation (x3DPRA), has been developed to enhance RTI reconstruction quality, estimate material parameters, and extend RTI from two to three dimensions (3D). However, the 3D formulation is even more ill-posed than the 2D form, as the number of measurements is far fewer than the number of unknown voxels. In this work, we systematically evaluate and compare three distinct regularization approaches (Ridge, Total Variation, and Tensor Nuclear) within the x3DPRA framework. We provide a detailed performance analysis by evaluating both reconstruction quality and computational runtime across the three methods. Our findings show that Total Variation regularization provides the best reconstruction quality but not the fastest runtime, providing guidance for developing high-resolution 3D RTI systems for future ISAC applications.

0.35