CS Paper Radar

Floquet Fibre Geometry and Higher-Order Reduced Coordinates for Off-Manifold Transients near Nonlinear Aeroelastic Flutter

Puxue Tan

cs.CV ·submitted 2026-09-13 17:16 UTC · v2
benchmarktheoryunusual

Abstract

Assigning reduced coordinates to states near an attracting limit cycle requires the correct invariant-fibre geometry. The classical first-order phase-isostable chart obtained from adjoint Floquet modes projects along the strong-stable quotient fibre, whereas a metric-orthogonal complement of the retained slow bundle generally does not. We prove locally that a chart satisfying the linearised semiconjugacy relation leaves an O(delta^2) invariance residual, while projection along a non-invariant complement generically leaves an O(delta) term. For a nonlinear aeroelastic limit cycle, the metric-normal and strong-stable directions differ by 48.5 to 71.7 degrees, and metric-normal perturbations contain first-order retained phase and slow-amplitude components. Replacing the metric normal by the strong-stable fibre changes the measured residual scaling from delta^1.01 to delta^1.87 without fitted parameters. We then test learned higher-order corrections whose linearisation is pinned to the adjoint-Floquet chart, whose symmetry is exact, and whose reduced flow is fixed. Although they reduce the registered fixed-normalisation latent residual, post-hoc amplitude recalibration and adjoint-Floquet-targeted future consistency move or reverse the ranking. Because the learned maps already share the baseline's first-order gauge and the future target is supplied by the baseline chart, these diagnostics establish neither an independent positive nor negative higher-order result. Correct first-order Floquet geometry is therefore necessary in this benchmark, while the additional predictive value of the learned correction remains unidentified by the available representation-dependent diagnostics.

Closest papers

Nearest neighbours by meaning across the whole index.

Memory in Behavioral Models as Motion on a Slow Invariant Manifold

eess.SP math.DS ·2026-09-30 ·Nicholas B. Tufillaro
unusual similarity 0.49
Abstract · 10 pages, 2 figures, 3 tables. v2: prior work attributed (the hidden-variable formulation of Root et al.; the dynamic gain model of Verspech…

A single-tone large-signal operating point of a nonlinear two-port is a periodic orbit of a periodically forced circuit. When the device has memory, the Floquet exponents of that orbit separate into fast (electrical) and slow (thermal and trapping) modes, and long-term memory is motion on the invariant manifold attached to the slow modes. Existence and uniqueness of that manifold follow from the parameterization method of Cabré, Fontich and de la Llave, applied to the stroboscopic map at the orbit; the manifold is the spectral submanifold of Haller and Ponsioen, without a small-forcing parameter. The manifold is a bundle over the circle of drive phase, its fiber dimension the number of slow exponents, and the dynamic X-parameter kernel of Verspecht et al. identifies its reduced dynamics from the transient after a step in drive amplitude. An exact reduced model has one memory state per slow exponent, the memoryless X-parameter surface is the fixed-point family of the reduced dynamics, and the envelope-domain model is the reduced dynamics driven by the envelope. The hypotheses are verified and the manifold constructed for a GaN HEMT compact model with thermal and trap memory: the trap's time constant at the operating point, $14 μ$s, is set by the linearization, not by its $6$ ms emission time, and the trap's nonlinearity confines a polynomial representation of the manifold to a few millivolts of drive, so trap memory must be represented over the operating range, by tables or a fitted network, not by an expansion about the operating point.

0.52

Why the Swing Parameters Are Sloppy

eess.SY ·2026-10-21 ·Sunny Kumar, Madhavi Parimi, Shashank Varma, Sushama Wagh, Alexsandar Stanković +1 more
theoryunusual similarity 0.48
Abstract

When a multi-parameter model is fitted to measured data, only a few parameter combinations are often identifiable, as Fisher Information Matrix eigenvalues span several orders of magnitude. Sensitivity-based tools, including the Fisher Information Matrix and MBAM, reveal this structure analytically, while manifold learning can recover it from sampled trajectories. For an infinite-bus synchronous generator, both approaches show that inertia H and damping D are among the least identifiable parameters on a late post-disturbance window, t in [3,5] s, where six of the eleven parameters suffice to describe the response. We explain this result from the geometry of the dynamics rather than from that of the parameter-to-data map. The rotor swing is a fast fibre that has collapsed onto a two-dimensional normally attracting invariant manifold (NAIM) of the transient fluxes before the window opens. The zeroth-order NAIM is exactly independent of $H$, $D$, $T_{d0}''$ and $T_{q0}''$, four of the five MBAM limits. We prove, under stated smoothness and rank conditions, that each of the four limits is a boundary of the model manifold at a distance equal, to first order in the parameter, to its current profiled speed. The same analysis predicts how identifiability changes with the experiment: neither a larger initial speed deviation nor a load change restores H or D in the late window, whereas the early window [0, 2]s makes H the best-determined parameter. Evaluated in a physical metric fixed by synchrophasor accuracy limits, the late window identifies five parameters rather than six and the early window nine. The spiked-covariance structure of the linearised trajectory map explains why the principal components of whitened, sampled trajectories reproduce the prior-scaled Fisher spectrum, and regression on those components attains the Fisher-predicted recovery error in 113 of 114 parameter scenario pairs.

0.24

How the elastic axis folds the transonic flutter boundary: shock energy transfer and conformally calibrated active learning

cs.LG physics.flu-dyn ·2026-10-16 ·Ashray Saxena, Sharad Shrivastava
publishedunusual similarity 0.48
Abstract · 28 pages, 15 figures, 8 tables. Accepted for publication in Transport Phenomena (Special Edition: Tribute to John Charles Slattery). Code an…

Isogai's case A, a pitch-plunge aerofoil whose elastic axis lies half a chord ahead of the leading edge, has a folded transonic flutter boundary in inviscid flow, with several flutter speeds at one Mach number. We map this boundary and its elastic-axis family with coupled Euler simulations, a Gaussian-process surrogate of the damping trained by batch active learning, and distribution-free split conformal prediction, which bounds the marginal error rate of stability calls. Three failure modes of damping labels are invisible in the residuals, and the half-degree mean incidence left by an impulsive start at $1^\circ$ freestream incidence raises the flutter speed at the dip by 2.8%, more than any numerical setting. With 80 simulations the learned case A boundary labels 63 of 64 independent runs correctly, and at most 1.8% of calibrated calls on held-out runs are wrong. Over Mach number, elastic axis and flutter speed index, 193 simulations show that, for the case A structure about the axis, the inviscid fold exists only for axes more than about 0.4 chord ahead of the leading edge, on two meshes. Chordwise energy budgets, closed three ways, explain both branches. On the lower branch the falling reduced frequency, at unchanged shock phase, raises the shock input and lowers the upstream damping similarly. On the upper branch the shock is pinned at the trailing edge; moving the axis aft brings the flutter-mode pivot towards the section, so the upstream damping falls faster than the residual shock input and the fold closes.

0.41

Modal Integrators for Isogeometric Stabilization of Outliers

cs.CE math.NA ·2026-09-19 ·Sreeram Shankar
unusual similarity 0.43
Abstract · 44 pages, 28 figures

High-order isogeometric discretizations produce a small number of non-physical outlier modes at the top of the discrete spectrum. These modes can pollute the numerical solution in wave propagation and structural dynamics. Most existing remedies modify the spatial discretization through outlier-free bases, mass lumping, subspace projection, and related constructions. We introduce MIISO (Modal Integrators for Isogeometric Stabilization of Outliers), a family of exponential Rosenbrock-Krylov methods of orders two through six that suppress the outliers in the time integrator and leave the spatial discretization unchanged. We construct a non-holomorphic amplification map by blending a Padé approximation that preserves physical oscillatory modes with a Pade approximation that damps high frequencies, with the blend placed at the known spectral location of the outliers. For orders three and higher the damping approximant is repaired so that the method is unconditionally A-stable. Physical modes receive no numerical dissipation and the outliers are driven to zero. The outlier handling and the method steps are fully matrix-free, and the method extends to nonlinear problems. Numerical experiments recover the predicted orders, match spatial outlier removal without changing the discretization, show lower cost than generalized-alpha at matched accuracy and in scaling, and demonstrate the method on nonlinear and three-dimensional problems.

0.31

Transducer Placement and the Limits of a Four-State Reduced Model in Post-Flutter Piezoelectric Energy Harvesting from a Pitch-Plunge-Flap Aerofoil

cs.CE eess.SYmath-ph ·2026-09-11 ·Nikolaos D. Tantaroudas, Ilias Karachalios, Andrew J. McCracken
unusualhighly cited similarity 0.41
Abstract · 16 pages; 6 figures;

Aeroelastic ?utter is normally a failure mode to be designed against, yet the limit-cycle oscillations (LCOs) that follow it convert flow energy into sustained structural motion that a piezoelectric transducer can turn into electrical power. A transducer is embedded in a three-degree-of-freedom pitch-plunge aerofoil with a finite-mass trailing-edge flap and unsteady strip-theory aerodynamics, giving a fifteen-state electro-aeroelastic system with a cubic hardening pitch spring, and the system is reduced by biorthonormal projection of the Taylor-expanded residual onto eigenvectors of the coupled Jacobian. The testbed is deliberately low order, so that every reduced prediction can be checked against the full-order system it replaces. The degree of freedom that carries the transducer is a first-order design variable, since it sets both the sign of the shift in the flutter boundary and the magnitude of the harvested power. The error of the reduced model is dominated not by the size of the retained basis but by how the reduced operator is made to depend on low speed. Expanding the retained eigenvalues leaves the reduced operator block-diagonal, with no coupling between the retained modes at any order of the expansion, whereas re-projecting the exact Jacobian onto the same frozen basis supplies that coupling and restores the structural response without enlarging the basis. It is found that the error that remains lies in the harvested voltage, which the equilibrium eigenvectors carry in a fixed proportion to the motion, and this is not removed by adding the electrical modes to the basis, whereas the flap detection, which the same basis also misses, is recovered by retaining the flap modes. The accuracy of a harvester reduced-order model must therefore be reported on the harvested quantity itself.

0.57

Floquet-Parameterized Koopman-MPC for Tracking Periodic Orbits

cs.RO eess.SY ·2026-11-08 ·Kartik A. Pant, Vishnu Vijay, Yufei Zhu, Xintong Deng, Taewoo Nam +1 more
similarity 0.41
Abstract · 6 pages, 2 figures

Designing real-time control for nonlinear systems to track periodic orbits can be challenging, especially for complex and coupled dynamical systems (e.g., tethered kites), where the true model parameters are hard to obtain. To address this, we propose a physics-informed Koopman learning approach that incorporates periodic-orbit stability directly into the learned linear predictor. The approach combines the underlying periodic structure of the dynamics along with periodic state-input trajectory data to learn physically consistent linear predictors (in lifted/observable space). We leverage Floquet theory, which studies the stability of periodic orbits in nonlinear systems, to obtain the periodic stability information of a given orbit via a monodromy matrix (i.e., the state transition matrix over an entire period). Subsequently, we impose open-loop monodromy constraints to learn Floquet-parameterized linear predictors using a least-squares Extended Dynamic Mode Decomposition (EDMD) formulation, thereby constraining the search space and aiding in Koopman learning. We then utilize these linear predictors to design a model predictive control (MPC) law for tracking periodic references. Finally, we evaluate the designed framework on a cartpole system under periodic forcing and compare it against a purely data-driven baseline.

0.32

Singular Sampling in Nonlinear Observability: Higher-Order Minimax Laws and Timing Crossovers

eess.SY ·2026-10-11 ·Jerzy Baranowski
unusual similarity 0.41
Abstract · This work has been submitted to the IEEE for possible publication

We study deterministic bounded-noise state reconstruction for nonlinear systems when the measurement schedule drives the sampled-output map through a rank-deficient configuration. Local reconstruction is governed by the leading pairwise separation order and its corresponding higher-order modulus, which together determine the leading minimax noise-to-state law. For corank-one cubic singular schedules, including overdetermined sampled maps, we derive the exact physical $\ell_\infty$ cubic modulus through quotient geometry in $\mathbb{R}^q/\operatorname{Im}DF$ and show how the required finite jet is computed from trajectory sensitivities. We then prove a uniform signed timing crossover: a transversal timing perturbation has transition scale $\varepsilon=O(δ^{2/3})$, linking the regular, cubic-singular, and fold regimes. A damped pendulum provides closed-form crossover coefficients and exact nonlinear minimax validation, while a four-state downward cart--pole verifies the rectangular theory. The results show that measurement timing can change not only reconstruction conditioning but the exponent governing bounded-noise state uncertainty.

0.48

Nonlinear homogenization of periodic unit cells composed of mixed continuum and structural elements with variationally consistent boundary-member reduction

cs.CE ·2026-11-10 ·Jonathan Stollberg, Dominik Schillinger
code/data similarity 0.40
Abstract

Periodic architected materials may be represented by representative volume elements (RVEs) combining continuum, truss, beam, and shell constituents. Their mixed translational and rotational kinematics complicate a consistent scale transition to a macroscale Cauchy continuum. We establish a nonlinear first-order computational homogenization framework for such mixed-dimensional RVEs. An auxiliary finite-strain Cosserat continuum serves solely as a power-equivalent carrier of their virtual power and generalized boundary kinematics. Its uniform rotation is identified with the macroscopic polar rotation and its wryness vanishes, so the effective medium remains of Cauchy type. Under periodic translational and rotational constraints, the Hill-Mandel condition yields a common nodal-force virial for the effective first Piola-Kirchhoff stress, independent of element type. For lower-dimensional members on periodically identified cell boundaries, fractional ownership of internal virtual work is shown to be variationally equivalent to a topology-preserving reduction retaining one representative of each set of periodic element copies. Because this equivalence covers the complete element virtual work and consistent linearization, it applies to geometrically and materially nonlinear and path-dependent constituents without rescaling section properties, constitutive parameters, or internal variables. Numerical examples recover the analytical small-strain response and cubic symmetry of a mixed continuum-shell-beam cell, verify the reduction and discrete power balance, and demonstrate finite-rotation buckling of a hyperelastic Octet lattice and history-dependent yield-surface evolution of an elastoplastic sandwich cell. The open-source implementation abqhom couples the framework to Abaqus.

0.46