CS Paper Radar

Echo State Network (ESN) for Signal Recovery in RF-Impaired IBFD MIMO Systems

Conrad Prisby, Siyao Li, Chengtao Xu, Thomas Yang

cs.AI ·submitted 2026-09-20 23:40 UTC · v1
published

Abstract

In-band full-duplex (IBFD) multiple-input multiple-output (MIMO) systems enable simultaneous transmission and reception on the same frequency band, improving spectral efficiency for next-generation wireless networks. However, IBFD-MIMO systems are susceptible to self-interference (SI), which may overpower signals of interest (SOI). In this scenario, blind source separation (BSS) algorithms can be adopted to remove SI and perform joint sensing and communication (JSAC), but BSS algorithms mostly assume an idealized linear and quasi-stationary signal model, which does not hold under realistic radio frequency (RF) impairments, such as I/Q imbalance, carrier frequency offset (CFO), phase noise, and power amplifier nonlinearity. This paper proposes a two-stage echo state network (ESN)-based scheme that is superior to BSS under these realistic conditions. A frozen ESN is trained offline to characterize the static SI path, while an adaptive ESN, updated online via recursive least squares, tracks the time-varying SOI path using sparse pilot symbols. We evaluate the proposed scheme's SOI recovery performance and acquisition speed with different block sizes, comparing it against other recurrent neural networks (RNN), such as long short-term memory (LSTM) and gated recurrent unit (GRU). Simulation results show that the proposed approach outperforms BSS, LSTM, and GRU in both efficiency and SOI recovery, demonstrating the viability of ESNs for real-time, nonlinear self-interference cancellation in realistic IBFD MIMO systems.

Comment
6 pages, 5 figures. This work has been accepted by IEEE Milcom 2026

Closest papers

Nearest neighbours by meaning across the whole index.

Physical-Layer Aspects of Repeater-Assisted MIMO

eess.SP ·2026-09-24 ·Diana P. M. Osorio, Kohei Ueda, Anubhab Chowdhury, Hiroki Iimori, Yuto Hama +2 more
similarity 0.56
Abstract · 6 pages, 4 figures, submitted to the IEEE for possible publication

Network-controlled repeaters (NCRs) are emerg- ing as low-cost, band-selective active scatterers that can re- shape the wireless propagation environment without backhaul or tight phase synchronization. We study physical-layer design for repeater-assisted multiple-input multiple-output (RA-MIMO) networks, such as hardware impairments, gain and activation control, duplexing, channel-state information acquisition, and wideband delay effects. We then discuss integrated sensing and communication (ISAC), where repeaters can extend non- line-of-sight (NLoS) visibility, improve target observability, and enhance weak-echo detection. These gains, however, are limited by amplified noise, clutter, feedback, and calibration errors, motivating joint optimization and gain control frameworks for swarm repeater deployments within ISAC.

0.26

Fundamental Limits and Joint Design for Monostatic Joint Communications and Sensing in LEO Satellites

eess.SP ·2026-10-31 ·Chandan Kumar Sheemar, Giovanni Iacovelli, Jorge Querol, Symeon Chatzinotas
benchmark similarity 0.54
Abstract

Monostatic joint communication and sensing (JCAS) from a low-Earth-orbit (LEO) satellite requires full-duplex (FD) operation, with self-interference (SI) $80$--$100$~dB stronger than the ground echo. The echo returns milliseconds after transmission, whereas the onboard coupling spans a few symbols. We develop a theory and a design that exploit this separation. Restricting the analog and digital cancellers to the short SI support is without loss of optimality and essential in practice: a least-squares canceller whose support contains the target delay absorbs the coherent echo and reduces the radar SINR by a closed-form factor, about $18$~dB for a vessel at its zero-Doppler crossing. Modeling the SI that no linear canceller can reconstruct as spatially white and accounting for ADC quantization, we derive in closed form a ceiling on the radar SINR, the minimum pre-ADC SI power under a canceller tap budget, the budget for full cancellation, and the sensing weight at which the optimal design changes over from communication to sensing. We then maximize a weighted sum of the communication and sensing SINRs, each normalized by its half-duplex benchmark, over the beamformers, sensing covariance, combiners, and cancellers for $K$ users and $Q$ targets, using an alternating algorithm with closed-form updates. Simulations confirm the closed forms. The joint design gains up to $13\%$ in the normalized objective over a sequential design that cancels the SI only at the receiver, and more than $10$~dB of downlink and radar SINR with $4$-bit ADCs and in the 10th-percentile worst-target SINR of four targets, whereas ignoring the SI overloads the ADCs.

0.26

IMNet: Intercarrier Interference Mitigation Network for Integrated Sensing and Communication in Spectrally Efficient FDM Systems

eess.SP ·2026-08-24 ·Hyeonho Noh
similarity 0.53
Abstract

Spectrally efficient frequency-division multiplexing (SEFDM) is an attractive waveform to improve communication spectral efficiency by compressing the subcarrier spacing, yet its use for integrated sensing and communication (ISAC) poses a fundamental sensing challenge. Specifically, the intentional loss of subcarrier orthogonality generates SEFDM-induced intercarrier interference (S-ICI), which combines with Doppler-induced ICI (D-ICI) from moving targets to blur range--velocity maps and severely degrade sensing accuracy. Building on multi-user multi-input-multi-output (MIMO) SEFDM systems, this paper develops a model-driven ISAC framework that supports spectrally efficient multi-user communication while mitigating both S-ICI and D-ICI in sensing. To this end, an intercarrier interference mitigation network (IMNet) is proposed, which exploits the distinct physical structures of the two interferences. A bank of Doppler correction filters first compensates the velocity-dependent D-ICI over multiple Doppler hypotheses, and an axial-attention network subsequently suppresses the residual D-ICI and the long-range S-ICI to recover reliable sensing signals. To further improve range and velocity estimation accuracy, IMNet with local refinement (IMNet-LR) is proposed, which performs maximum-likelihood refinement with nuisance projection around the IMNet detections to achieve sub-cell precision without an exhaustive global search. Simulation results show that IMNet-LR achieves near-maximum-likelihood range and velocity estimation accuracy with more than three orders of magnitude lower execution time compared to conventional detection methods.

0.26

Blind Interference Suppression for IRS-Aided Robust Wireless Communications

eess.SP ·2026-09-30 ·Tao Wang, Xiaohui Zhang, Hehe Ban, Yiwei Guo, Ming Yi
publishedbenchmark similarity 0.53
Abstract · 13 pages, 13 figures, accepted by IEEE Internet of Things Journal

The application of intelligent reflecting surfaces (IRSs) to suppress interference in wireless communication systems has recently attracted significant research attention. Most existing approaches rely on complete or partial channel state information (CSI) to configure the IRS. However, acquiring accurate CSI in IRS-assisted systems involves considerable pilot overhead and introduces non-negligible delays. This issue is further exacerbated under strong interference conditions, where interfering sources are typically non-cooperative, making CSI acquisition even more challenging. As a result, existing CSI-dependent interference suppression methods become difficult to deploy in practice. To address these limitations, we propose a novel blind interference suppression strategy that combines a proportional phase-inversion (PPI) algorithm with the conditional sample mean (CSM) method. The proposed approach determines the IRS configuration using only the received signal power, without requiring any prior CSI. We conduct a comprehensive performance evaluation by deriving the theoretical performance of the proposed scheme, which is subsequently verified through numerical simulations. Furthermore, simulation results across various parameter settings demonstrate that the proposed blind interference suppression scheme reduces the interference power to the level of noise, thereby achieving a marked signal-to-interference-plus-noise ratio (SINR) improvement and outperforms existing benchmark schemes.

0.72

Sequential Detection-Based Iterative Blind Separation for Single-Channel Co-Frequency Signals

eess.SP ·2026-09-10 ·Heng Wang, Peng Sun, Kexian Gong, Kunheng Zou, Hua Jiang
similarity 0.53
Abstract · This work has been submitted to the IEEE for possible publication. Copyright may be transferred without notice, after which this version may…

Existing single-channel co-frequency signal blind separation (SCSBS) algorithms struggle to balance separation accuracy, computational complexity, and robustness, while current channel state information (CSI) estimation methods lack precision. To address these limitations, we propose a sequential detection (SD)-based iterative separation (SDIS) algorithm. SDIS incorporates a delayed unscented Kalman filter (DUKF) into an iterative decision feedback framework, jointly enhancing signal separation and CSI estimation. Simulation results show that SDIS outperforms benchmarks in separation accuracy, CSI estimation accuracy, computational efficiency, and robustness. Notably, when the mean bit error rate (MBER) drops below $10^{-4}$, SDIS can tolerate at least $0.8$ dB more noise than the benchmarks.

0.17

SR-TTA: Spatial-Redundancy Test-Time Adaptation for Interference-Robust Respiration Sensing

cs.LG ·2026-10-08 ·Jingyuan Liu, Zheng Chang, Haoqiu Xiong, Zhuangzhuang Cui, Sofie Pollin
similarity 0.53
Abstract

Future 6G networks aim to expose sensing as a native service by reusing communication infrastructure. We study respiration sensing on a cell-free massive multiple-input multiple-output (MIMO) base station, where a 64-antenna channel must be fused into a breathing waveform. The state-of-the-art hand-crafted fusion is near-optimal in benign conditions. It collapses, however, under strong in-band motion interference, whose frequency falls inside the respiration band. We show that a learned complex-weight beamformer recovers respiration by spatial nulling, and that the remaining gap to a per-recording oracle can be closed at deployment by label-free test-time adaptation. Crucially, we identify which label-free signal makes this work. Frequency- and variance-based criteria cannot separate an in-band interferer from breathing. Our spatial-redundancy test-time adaptation (SR-TTA), which maximizes consistency across random antenna subsets under an out-of-band spectral veto, preserves benign performance in our tests. The respiration-rate error drops from 5.8 to 0.8 breaths per minute (bpm) under simulated in-band interference, and the pipeline maps onto the Open Radio Access Network (O-RAN) architecture as O-RAN distributed-unit (O-DU) range-gating, an adaptation xApp, and a calibration rApp. On real testbed recordings, a one-time cross-subject calibration plus SR-TTA reduces failures from 47% to 7%, drawing level with the hand-crafted combiner using label-free test-time adaptation.

0.25

Flexible Analog Self-Interference Cancellation for Waveform-Robust Monostatic ISAC

eess.SP ·2026-10-07 ·Anh Tuyen Le, Xiaojing Huang, J. Andrew Zhang, Peiyuan Qin, Le Chung Tran +2 more
similarity 0.53
Abstract

Monostatic integrated sensing and communication (ISAC) requires in-band full-duplex operation, where self-interference cancellation (SIC) must suppress the strong transmit leakage while preserving weak sensing echoes. In the analog domain, this task is complicated by transmitter impairments, which generate conjugate and nonlinear SI components, and by waveforms with widely different statistics. This paper develops a flexible analog self-interference cancellation (FASIC) framework for monostatic ISAC based on the widely linear normalized least-mean-square (WL-NLMS) algorithm. FASIC generates the cancellation signal in digital baseband, subtracts it in the radio-frequency domain, and enables flexible sensing-range control via a configurable cancellation span. Its normalized adaptation remains stable across waveforms with substantially different peak-to-average power ratios (PAPRs), for which fixed-step adaptation can become unstable. We further relate transmit-waveform statistics to analog SIC performance and predict the waveform-dependent cancellation floor. Simulations validate the analysis and demonstrate stable analog SIC of approximately $30$--$34$ dB, with the low-PAPR waveforms achieving a $3.3$ dB deeper floor owing to their smaller high-order amplitude moments. Near-field static reflections within the cancellation span are suppressed while delayed and Doppler-shifted echoes are preserved. These results establish FASIC as a waveform-robust analog SIC solution and identify waveform statistics as a key consideration for sixth-generation (6G) waveform selection.

0.22

Blind and Asynchronous Initial Beam Acquisition and Clock-Assisted Re-Acquisition in Standalone Mobile MIMO-OFDM Systems

eess.SP ·2026-10-09 ·Ali Abdi, Firooz B. Saghezchi, Haris Gacanin
similarity 0.52
Abstract

Building upon our preliminary study, this paper proposes a standalone beam-management framework for mobile MIMO-OFDM systems that integrates Blind Initial Beam Acquisition (BIBA) with Clock-Assisted Re-Acquisition (CARA). BIBA is a blind and asynchronous protocol that requires neither prior synchronization nor an out-of-band feedback channel, so the Base Station (BS) and User Equipment (UE) can independently identify the beam pair maximizing received signal strength. To handle subsequent link drops, the newly introduced CARA protocol exploits the clock synchronization established after BIBA to reduce the re-acquisition time by approximately 55% compared with BIBA. The operational reliability of both protocols is bounded by a probabilistic feasibility analysis under random UE mobility trajectories. Protocols are validated on a 28 GHz mmWave testbed under practical hardware constraints, including beam-switching and Time Division Duplex (TDD) latencies, and measured Software-Defined Radio (SDR) software processing delays. Finally, we formulate a unified Finite State Machine (FSM) model for both BIBA and CARA to ensure robust integration into practical wireless systems

0.24