CS Paper Radar

Physical-Layer Aspects of Repeater-Assisted MIMO

Diana P. M. Osorio, Kohei Ueda, Anubhab Chowdhury, Hiroki Iimori, Yuto Hama, Koji Ishibashi, Erik G. Larsson

eess.SP ·submitted 2026-09-24 14:12 UTC · v1

Abstract

Network-controlled repeaters (NCRs) are emerg- ing as low-cost, band-selective active scatterers that can re- shape the wireless propagation environment without backhaul or tight phase synchronization. We study physical-layer design for repeater-assisted multiple-input multiple-output (RA-MIMO) networks, such as hardware impairments, gain and activation control, duplexing, channel-state information acquisition, and wideband delay effects. We then discuss integrated sensing and communication (ISAC), where repeaters can extend non- line-of-sight (NLoS) visibility, improve target observability, and enhance weak-echo detection. These gains, however, are limited by amplified noise, clutter, feedback, and calibration errors, motivating joint optimization and gain control frameworks for swarm repeater deployments within ISAC.

Comment
6 pages, 4 figures, submitted to the IEEE for possible publication

Closest papers

Nearest neighbours by meaning across the whole index.

Echo State Network (ESN) for Signal Recovery in RF-Impaired IBFD MIMO Systems

cs.AI ·2026-09-20 ·Conrad Prisby, Siyao Li, Chengtao Xu, Thomas Yang
published similarity 0.56
Abstract · 6 pages, 5 figures. This work has been accepted by IEEE Milcom 2026

In-band full-duplex (IBFD) multiple-input multiple-output (MIMO) systems enable simultaneous transmission and reception on the same frequency band, improving spectral efficiency for next-generation wireless networks. However, IBFD-MIMO systems are susceptible to self-interference (SI), which may overpower signals of interest (SOI). In this scenario, blind source separation (BSS) algorithms can be adopted to remove SI and perform joint sensing and communication (JSAC), but BSS algorithms mostly assume an idealized linear and quasi-stationary signal model, which does not hold under realistic radio frequency (RF) impairments, such as I/Q imbalance, carrier frequency offset (CFO), phase noise, and power amplifier nonlinearity. This paper proposes a two-stage echo state network (ESN)-based scheme that is superior to BSS under these realistic conditions. A frozen ESN is trained offline to characterize the static SI path, while an adaptive ESN, updated online via recursive least squares, tracks the time-varying SOI path using sparse pilot symbols. We evaluate the proposed scheme's SOI recovery performance and acquisition speed with different block sizes, comparing it against other recurrent neural networks (RNN), such as long short-term memory (LSTM) and gated recurrent unit (GRU). Simulation results show that the proposed approach outperforms BSS, LSTM, and GRU in both efficiency and SOI recovery, demonstrating the viability of ESNs for real-time, nonlinear self-interference cancellation in realistic IBFD MIMO systems.

0.41

Robust Beamforming Design for Integrated Sensing and Communications with Mutual Coupling Effect

eess.SP ·2026-08-16 ·Jieon Maeng, Kawon Han
published similarity 0.56
Abstract · 5 pages, 5 figures, submitted to IEEE Wireless Communication Letters, 2026

Integrated sensing and communications (ISAC) is a key technology for next-generation wireless networks, enabling communication and radar sensing over shared spectral and hardware resources. In practical multi-user multiple-input multiple-output (MU-MIMO) ISAC transmitters, however, mutual coupling (MC) between antenna elements distorts the array steering vector and each communication user (CU) channel, so that the sensing beampattern deviates from the desired one and the communication link to each user degrades. To address this limitation, we propose a robust MC-compensated beamforming design that guarantees both the sensing and communication performance of MU-MIMO ISAC transmitters against the residual MC error. We introduce a residual error on the MC matrix, so that a norm-bounded residual error induces both the sensing beampattern uncertainty and the communication channel uncertainty. The transmit covariance is then optimized against the worst-case of each uncertainty, minimizing the worst-case beampattern matching mean-squared error (MSE) for sensing while guaranteeing the signal-to-interference-plus-noise ratio (SINR) for each CU. Each worst-case constraint is converted into a linear matrix inequality, and the problem becomes a convex semidefinite program (SDP). Numerical results show that the proposed robust design attains both a lower sensing beampattern matching MSE and a higher communication SINR than those of the conventional designs, with an advantage that widens as the residual error grows.

0.58

Positioning with Flexible Reflectors: Solution and Performance Analysis

cs.IT ·2026-08-14 ·Jiajun He, Han Yu, Danyan Lin, Gaofeng Pan, Hing Cheung So +2 more
publishedtheory similarity 0.56
Abstract

Flexible reflectors (FRs) have emerged as a low-cost and energy-efficient solution for reshaping electromagnetic propagation environments across a wide range of applications. This paper investigates FR-swarm-assisted target localization in scenarios where line-of-sight (LoS) paths are unavailable. By leveraging the virtual LoS paths created by the FRs, a simple yet accurate estimator is proposed for localization under severe blockage conditions. To characterize the performance limits of the proposed scheme, we derive the Cramer-Rao lower bound (CRLB) and use it to optimize the positions and orientations of the FRs. Furthermore, by accounting for random FR deployment, we characterize the CRLB distribution and reveal how different network configurations affect localization accuracy. Simulation results demonstrate that the developed scheme closely approaches the CRLB performance, while the derived analytical results provide useful guidelines for FR deployment and network design.

0.17

Joint Target-Tag Estimation in Ambient Backscatter-Based ISAC

eess.SP ·2026-10-04 ·Awadhesh Gupta, Kumar Vijay Mishra, Naveen K. D. Venkategowda, Aditya K. Jagannatham
top venuetheory similarity 0.55
Abstract

Integrated sensing and communication (ISAC) has emerged as a key paradigm for unifying radar sensing and wireless communications within a shared hardware and spectral framework. In parallel, ambient backscatter communication (AmBC) has gained attention as a low-power solution for enabling passive connectivity by modulating and reflecting existing radio-frequency signals. Motivated by these developments, this paper investigates an integrated sensing and ambient backscatter communication (ISABC) framework in which a dual-functional radar-communication (DFRC) transceiver jointly performs high-resolution target sensing and low-power tag detection in cluttered environments. Within this ISAC and AmBC setting, we develop a comprehensive system model that jointly captures the estimation of target and clutter parameters, including delay, Doppler shift, and complex reflectivity, together with the recovery of embedded AmBC tag symbols. The resulting DFRC signal model reveals strong coupling among direct-path reflections, clutter echoes, and passive backscatter signals, leading to a highly entangled estimation problem. To address this challenge, we propose a robust three-stage signal processing framework that sequentially estimates target and clutter parameters before detecting the AmBC tag message. This structured approach effectively disentangles the superimposed components, improving both sensing accuracy and communication reliability in ISAC systems. Extensive simulations, benchmarked against the Cramer-Rao lower bound (CRLB), demonstrate the superior estimation performance of the proposed DFRC-based solution. The results further highlight the fundamental trade-offs between sensing accuracy and backscatter communication efficiency in ISABC systems.

0.42

Cooperative Target Localization in RIS-Enabled ISAC Systems

eess.SP ·2026-09-30 ·Rouhollah Amiri, Abdollah Ajorloo, Mohammad Mahdi Mojahedian, Ahmad Reza Hassanshahi, Fabiola Colone
similarity 0.55
Abstract

This paper develops a cooperative integrated sensing and communication (ISAC) framework in which a multi-antenna base station (BS) simultaneously localizes a target and serves multiple communication users, a subset of which is equipped with reconfigurable intelligent surfaces (RISs). The Fisher information matrix (FIM) for target positioning is derived, explicitly characterizing its dependence on the BS beamforming coefficients, RIS phase profiles, and bistatic sensing geometry. Under the stated scaling assumptions, coherent RIS phase alignment yields a Fisher-information gain that scales quadratically with the number of RIS elements, whereas independent random phases provide a linear gain in expectation. We formulate a sensing-centric joint active and passive beamforming problem that minimizes the position error bound (PEB) subject to per-user signal-to-interference-plus-noise ratio (SINR) and transmit-power constraints. The resulting non-convex problem is addressed through an iterative successive convex approximation (SCA) procedure that solves a sequence of convex subproblems. We further develop a target localization estimator that fuses one direct time-of-arrival (ToA) measurement, one angle-of-arrival (AoA) measurement, and multiple RIS-assisted indirect ToA measurements. Under small measurement errors and asymptotically efficient first-stage ToA/AoA estimation, the estimator covariance approaches the Cramér--Rao bound (CRB) to first order. Numerical results validate the analytical scaling laws and demonstrate the localization gains enabled by cooperative RIS-equipped users.

0.13

Cramér-Rao Bound Optimization for Joint Beamforming and Mode Selection in RDARS-Assisted ISAC Systems

eess.SP ·2026-10-01 ·Ahmad Reza Hassanshahi, Rouhollah Amiri, Fereidoon Behnia
benchmark similarity 0.55
Abstract

Integrated Sensing and Communication (ISAC) is a foundation of 6G networks, demanding architectures that simultaneously enhance sensing accuracy and communication reliability. This paper presents a Reconfigurable Distributed Antenna and Reflecting Surface (RDARS) aided ISAC framework, where an RDARS overcomes the limitations of conventional passive Reconfigurable Intelligent Surfaces (RIS) and Distributed Antenna Systems (DAS). By enabling each element to dynamically operate in either \textit{reflection} or \textit{connection} mode, RDARS synergistically harnesses reflection gain, distribution gain, and an additional mode-selection gain. We investigate the joint optimization of transmit beamforming at the base station and dynamic mode selection at the RDARS to minimize the sensing performance metric, namely the Cramér-Rao Bound (CRB) for target localization, while guaranteeing a minimum required Signal-to-Interference-plus-Noise Ratio (SINR) for multiple communication users. To solve the resulting non-convex and mixed-integer problem, we develop an efficient iterative algorithm based on the Alternating Optimization (AO) framework, effectively leveraging Majorization-Minimization (MM) and Penalty methods. Comprehensive simulations validate the proposed design, demonstrating that the dynamic RDARS configuration achieves a superior trade-off between the Position Error Bound (PEB) and communication SINR, significantly outperforming benchmark passive RIS and DAS systems.

0.10

Delay-Doppler Sensing Performance Analysis for MIMO-OFDM ISAC Systems

eess.SP ·2026-09-01 ·Peishi Li, Rang Liu, Qian Liu, Ming Li
published similarity 0.55
Abstract · Accepted by IEEE Globecom 2026

In communication-centric integrated sensing and communication (ISAC), delay-Doppler sensing reuses data-bearing orthogonal frequency division multiplexing (OFDM) signals rather than dedicated radar probing waveforms. Consequently, the resulting range-Doppler map (RDM) is shaped not only by target parameters, but also by communication-symbol randomness and, in multi-antenna transmissions, by spatial beamforming. While existing analyses have largely focused on single-antenna OFDM-ISAC, the delay-Doppler sensing behavior of multi-antenna OFDM-ISAC remains insufficiently understood. This paper analyzes a multi-input multi-output (MIMO)-OFDM-ISAC system in which multiple data streams jointly illuminate a sensing target. We derive second-order moment expressions for the RDM under matched filtering (MF) and reciprocal filtering (RF), and use them to characterize the dynamic range (DR). The analysis reveals two key multi-stream effects. First, under MF, the random superposition of multiple beamformed streams creates an additional RDM floor beyond the modulation-dependent and receiver-noise terms; therefore, constant-modulus signaling no longer eliminates the data-induced pedestal as in single-antenna OFDM-ISAC. Second, under RF, the matched-angle data-induced floor is removed, but the noise floor is amplified according to the reciprocal-power statistics of the beamformed target illumination. These results show that the user-target angular geometry directly governs the MF/RF tradeoff: MF is more robust under weak illumination, whereas RF can achieve a higher DR when reciprocal-noise amplification is mild. Numerical results validate the analysis and demonstrate the distinct geometry-dependent behaviors of MF and RF.

0.14

Vision--RF Cooperative ISAC for Dynamic V2I Networks: Adaptive Beam Management and Semantic Clutter Suppression

eess.SP ·2026-10-19 ·Wenqi~Fan, Ning~Wei, Xiangyu Dong, Ahmad~Bazzi, Guan Gui +3 more
similarity 0.54
Abstract

We develop a vision--radio-frequency (RF) cooperative integrated sensing and communication (ISAC) framework that jointly uses visual priors and RF observations for transmit-side beam control and receiver-side clutter suppression. Within a narrowband snapshot model, visual target priors and historical RF detections guide control in dynamic vehicle-to-infrastructure networks with roadside clutter. In this framework, posterior angular uncertainty determines beam control and the selection between communication-for-sensing and sensing-for-sensing modes. To reduce sensing overhead while accommodating unreliable visual information, we develop a reliability-adaptive beam scanning scheme that allocates a bounded scan budget according to visual target probabilities and RF history, while reserving an adaptive fraction for exploration. At the receiver, visual geometry identifies clutter support, and RF observations estimate the corresponding complex reflection coefficients. Motion-aware residual filtering is then applied before angle--Doppler detection to suppress clutter while preserving slow-moving targets. Furthermore, communication and sensing power allocation is formulated as a per-direction linear program, subject to signal-to-interference-plus-noise ratio constraints evaluated at angles sampled from the posterior distribution and a total-power budget. Simulation results show that the proposed framework improves tracking over static and vision-only beam control and reduces sensing overhead relative to full scanning. The proposed scanning scheme also provides greater robustness to visual blockage than fixed-weight scanning, while the receiver better preserves slow-moving targets than temporal cancellation when visual target information is available.

0.22