CS Paper Radar

Vehicle-Mounted Steerable Wideband Antenna Array for NATO Band III Tactical Radio Links

Ida Pääkkölä, Mikko Heino, Taneli Riihonen

eess.SP ·submitted 2026-09-22 09:11 UTC · v1
published

Abstract

In this paper, a very compact 2 x 2 wideband beamsteering array with monocone antennas is designed and validated for NATO Band III (1350-2400 MHz) tactical communications with interference suppressing ability. The small 4 x 4 x 4 cm$^3$ size of the array enables placing it for example on vehicles with limited space. The array is manufactured and measured, and the interference suppressing capability thereof is studied with a minimum variance distortionless response beamformer and a phase-only beamformer in the presence of a single interferer. It is shown that the designed antenna array can significantly improve the signal-to-noise ratio over 10 dB for angles separated over 15$^\circ$ from the signal-of-interest, and over 20 dB for separation larger than 43$^\circ$ across the operational band.

Comment
5 pages, 10 figures, accepted for MILCOM 2026

Closest papers

Nearest neighbours by meaning across the whole index.

One ISAC Array, Two Worst Cases: Hardware Impairments in Beamforming and AoA Estimation

eess.SP ·2026-11-04 ·Xuan Chen, Luc Le Magoarou
similarity 0.54
Abstract

In integrated sensing and communication (ISAC), the same base-station array beamforms toward users and estimates their angle of arrival (AoA). In this paper, we study how element-level gain, phase, and position errors affect both functions of a beam-scanning uniform linear array. Any array produces a correlation peak at the true angle, of finite height and width, surrounded by sidelobes. Impairments shift this peak, make it lower and wider, and raise the sidelobes relative to it. A single decomposition explains these three effects: the gain-weighted least-squares fit of the per-antenna phase errors splits them into a tilt, which shifts the peak, and a residual, whose power is taken from the peak and redistributed over the sidelobes according to its spatial spectrum. A beam steered toward the strongest direction suffers from the lower peak only, whereas the AoA estimate suffers from its shift even without noise, and also from the lowering and sidelobes with noise. The worst cases for the two ISAC functions are thus nearly disjoint, and we characterize both: the worst case for beamforming leaves the AoA estimate unbiased, and the worst case for localization loses little beamforming gain. The worst case for localization is a single defect at the junction between two subarrays, and its error, relative to the main-lobe width, does not decrease with the number of antennas. We also characterize random impairments and the effect of noise. In practical terms, our analysis shows that the calibration of a dual-function array must be assessed with respect to both functions.

0.23

Electromagnetically Consistent Monostatic ISAC Beamforming: Mutual Coupling, Active Mismatch and Tx-Rx Leakage in Compact Dipole Arrays

eess.SP ·2026-11-05 ·Stylianos D. Asimonis, Christos Tselios, Dimitrios Tyrovolas, Ilias Politis, George K. Karagiannidis
similarity 0.53
Abstract · 6 pages, 9 figures, 2 tables. Submitted to IEEE ICC 2027

Beamforming for integrated sensing and communication (ISAC) is usually designed on ideal array manifolds with a norm constraint on the transmit signal. In a compact monostatic transceiver this hides three antenna effects: distorted embedded patterns, beam-dependent active mismatch at the power amplifiers, and transmit-to-receive leakage that raises the radar noise floor. We build a multiport scattering model of a shared-aperture dipole array directly from method-of-moments simulations and use it to formulate a Cramer-Rao bound minimizing ISAC beamformer with multiuser SINR constraints, per-port active reflection constraints and a leakage budget, solved as a semidefinite program with a one-dimensional budget search. Full-wave evaluation shows that coupling-unaware designs miss their SINR targets by up to 6.2 dB and drive amplifiers to an equivalent VSWR above 3.3 at small spacings. For spacings from 0.3 to 0.5 wavelengths, the proposed design meets all targets with an equivalent VSWR below 2 and lowers the root Cramer-Rao bound by 32 to 53 percent for 80 dB of self-interference cancellation and by a factor of 3.4 to 5.6 for 70 dB. An independent finite-difference time-domain model of the final layout in openEMS confirms that the leakage null and the ranking of the designs are preserved.

0.24

RF Chain Count to Mitigate Beam Split in Wideband Hybrid Arrays: From Far-Field to Near-Field

eess.SP ·2026-10-05 ·Ahmed Hussain, Asmaa Abdallah, Abdulkadir Celik, Ahmed M. Eltawil
similarity 0.53
Abstract

Deploying large antenna arrays transitions wireless communication into the radiative near-field (NF), where spherical wavefronts enable beamfocusing in the joint angle-distance domain. However, wideband beamforming with large antenna arrays suffers from beam split across both spatial dimensions. Although fully digital arrays can eliminate this impairment, their prohibitive hardware cost and power consumption motivate the adoption of hybrid array architectures equipped with a limited number of radio-frequency (RF) chains. This paper investigates the minimum number of RF chains required to mitigate the beam split. We derive closed-form expressions for the required number of RF chains in fully-connected (FC) architectures and propose an algorithm for sub-connected (SC) architectures, considering both uniform linear arrays (ULAs) and uniform circular arrays (UCAs). Our analysis reveals that beyond a focal distance of 10L, where L denotes the aperture length, the NF RF chain count converges to its far-field counterpart and becomes a function of the angle alone. Moreover, the FC hybrid architecture mitigates the beam split by using fewer RF chains than the SC architecture, albeit at the cost of increased complexity in the phase shifter network.

0.14

Effective DoF Collapse in Sparse Near-Field Beamforming: A Block-Rank-1 Mechanism

cs.IT ·2026-10-10 ·Changhao He, Xiaojuan Zhang, Francois Chin Po Shin
published similarity 0.53
Abstract · This paper(2-column version) has been accept for publish in IEEE wireless communication letter(WCL)

Sparse near-field arrays phase-cohere $M$ widely separated sub-arrays of $N$ elements and underpin distributed MIMO, satellite formations, and integrated sensing and communication. We show that their interference suppression over a protected region is set by coherence within a single sub-array rather than by the span of the formation: the effective rank of the region covariance can collapse from $MN$ to $M$. Two independent arguments establish this. For canonical line and disk regions each diagonal covariance block is exactly a classical concentration operator, which supplies sharp per-block rank thresholds and makes fewer than one spatial degree of freedom per sub-array a conservative design rule; an orthogonal decomposition with eigenvalue interlacing gives a nonasymptotic sufficient condition that assumes nothing about the coupling between platforms. The consequences are covariance-side and beamformer-independent: the unloaded Capon functional upper-bounds worst-case signal-to-interference ratio, while its regularized counterpart scales very differently for angularly separated and for in-cone targets. An eight-satellite LEO study validates the theory, including realized worst-case SIR.

0.38

Waveform Design for Simultaneous MIMO Radar Sensing and Multi-User Communication

eess.SP ·2026-08-23 ·Berkan Kilic, Kenan Turbic, Slawomir Stanczak
publishedhighly cited similarity 0.53
Abstract

This paper proposes a novel two-stage joint waveform design framework for multi-antenna Integrated Sensing and Communication (ISAC) systems that simultaneously enable Multiple-Input Multiple-Output (MIMO) radar sensing and Multi-User MIMO communication. First, a transmit waveform covariance matrix is designed by solving a convex matrix nearness problem for beampattern synthesis that simultaneously maximizes transmit power in desired directions and minimizes cross-directional correlations, while accommodating independent antenna power constraints and supporting interference suppression through radiation null steering. Second, a waveform conforming to the designed covariance is synthesized while additionally enforcing inter-user interference suppression via the zero-forcing approach and imposing practical implementation constraints, notably limiting the peak-to-average-power-ratio on the individual antenna elements. Simulation results demonstrate that the approach significantly enhances ISAC waveform design flexibility, performance, and computational efficiency compared to the alternative methods in the literature.

0.58

Transmissive RIS-Assisted Vehicular Direct-to-Satellite Communications: Opportunities, Limitations, and Comparison with Phased Arrays

cs.IT cs.ET ·2026-08-29 ·Wali Ullah Khan, Abdullah Abdullah, Juan Andres Vazquez-Peralvo, Eva Lagunas
similarity 0.52
Abstract · 9, 2

This article studies transmissive reconfigurable intelligent surface (RIS)-assisted architectures. It compares them with electronically steered phased arrays for the deployment of vehicular direct-to-satellite (D2S) communications in future satellite networks. Rather than treating RIS as a direct replacement for phased arrays, we clarify the operating regimes in which RIS can serve as a low-power wavefront-shaping aperture and those in which phased arrays remain preferable because of their high gain and mature beam-tracking capability. Moreover, phased arrays can support multi-beam operation, which is particularly beneficial for dual connectivity and seamless handover. We distinguish analog, digital, and hybrid phased arrays, discuss the relationship between transmissive RIS and reconfigurable transmitarrays, and highlight practical profile, tracking, and link-budget constraints for mobile terminals. The comparison shows that passive RIS offers attractive power efficiency and aperture scalability, active RIS can partially improve the link budget, and phased arrays remain preferable for high-throughput.

0.13

Transmit Beamformer Design for Beampattern Synthesis in Phased-Array Radar Systems

eess.SP ·2026-08-21 ·Berkan Kilic, Kenan Turbic, Slawomir Stanczak
similarity 0.52
Abstract

This paper presents a phased-array transmit beamformer design for beampattern matching and interference suppression. We propose an optimization framework jointly addressing these two objectives. The resulting non-convex problem is solved via alternating minimization, where each subproblem admits a closed-form solution, one of which recovers the classical maximum-gain and null-steering phased-array beamformers. To design an algorithm ensuring theoretical convergence guarantees, the beamformer design is then reformulated as a non-convex set feasibility problem, closely related to the original formulation. This problem is addressed using a provably convergent projected gradient descent method and further enhanced with acceleration techniques that substantially improve empirical convergence. Extensive simulations validate the excellent performance and computational efficiency of the proposed method.

0.26

Communication and Sensing Coverage of UAV Corridor under Beam Misalignment Error

cs.IT ·2026-10-01 ·Harris K. Armeniakos, Petros S. Bithas, Konstantinos Maliatsos, Christos Masouros, Athanasios G. Kanatas
published similarity 0.51
Abstract · Accepted for presentation in IEEE ISAC 2026

In this paper, a unmanned aerial vehicle (UAV) corridor-assisted network is proposed to study the joint sensing and communication (JCAS) coverage probability (CP) of a terrestrial (BS) equipped with a realistic three-dimensional (3D) 3GPP antenna pattern. By employing the 3D binomial point process (BPP) to model the spatial locations of the UAV-UEs, a fixed number of UAV-UEs are deployed in an aerial corridor modeled as a finite cylinder. The BS exploits radar sensing capabilities to track a known UAV-UE under a 3D beam misalignment error, which follows a multivariate normal distribution. Subsequently, under clutter and uplink communication interference, exact- form analytical expressions for JCAS CP are derived and used to analyze the performance at the terrestrial BS. The results highlight corridor-length saturation at high UAV heights and the beamwidth trade-off between interference suppression and misalignment sensitivity.

0.34