CS Paper Radar

Joint Transceiver and Group Index Modulation Design for Wideband Integrated Sensing and Communications Under Beam Squint

Kaiwen Zheng, Shijian Gao

eess.SP ·submitted 2026-09-27 15:12 UTC · v1
benchmark

Abstract

The combination of ultra-wide bandwidth and large-scale multiple-input multiple-output arrays with frequency-independent phase shifters induces beam squint, causing frequency and distance dependent array gain variations across subcarriers and degrading integrated sensing and communications performance. Transceiver beamforming and group index modulation (GIM) can alleviate the impact of beam squint on communication and sensing performance. However, their designs are coupled in the frequency domain, as beamforming shapes the subcarrier responses on which GIM grouping and activation depend. To address this coupling, we propose a joint transceiver beamforming and GIM design that maximizes a weighted combination of normalized worst-case communication and sensing distances. An alternating optimization algorithm jointly refines the transceiver beamformers and GIM configuration. Simulation results show that the proposed joint design reduces bit error rate in the high signal-to-noise ratio region and achieves a more favorable communication-sensing trade-off, while maintaining an average sensing AUC comparable to that of the considered GIM based benchmark schemes.

Closest papers

Nearest neighbours by meaning across the whole index.

Exploiting Beam Squint for Near-Field Wideband Beamforming in Multi-User OFDMA Systems

eess.SP ·2026-10-17 ·Lanqing Zhi, Peilan Wang, Jun Fang
similarity 0.62
Abstract · 7 pages, 4 figures

The beam squint effect has traditionally been viewed as detrimental to near-field wideband beamforming due to the reduction of beamforming gain towards the desired direction. In this paper, we show that it can instead be harnessed as a benefit in a hardware-constrained orthogonal frequency division multiple access (OFDMA) system, where the system, equipped with a single radio-frequency (RF) chain, aims to serve multiple spatially distributed users by allocating different subcarriers to different users. By exploiting the beam squint effect, flexible frequency-dependent beamfocusing patterns are realized via parallel true-time-delay (TTD) units, enabling nearly full beamforming gain across users. In particular, we formulate a max-min rate optimization problem that jointly designs the time delays, subcarrier-user association, analog beamforming, and power allocation. To tackle the resulting nonconvex mixed-integer problem, a two-stage optimization framework is proposed. In Stage~I, subcarrier-user association and structured analog beamforming are jointly optimized. In Stage~II, power allocation is obtained via bisection search and inverse water-filling. Simulation results demonstrate that the proposed method can achieve a significant improvement by utilizing beam squint to serve multiple spatially distributed users in OFDMA systems.

0.24

Robust Beamforming Design for Integrated Sensing and Communications with Mutual Coupling Effect

eess.SP ·2026-08-16 ·Jieon Maeng, Kawon Han
published similarity 0.60
Abstract · 5 pages, 5 figures, submitted to IEEE Wireless Communication Letters, 2026

Integrated sensing and communications (ISAC) is a key technology for next-generation wireless networks, enabling communication and radar sensing over shared spectral and hardware resources. In practical multi-user multiple-input multiple-output (MU-MIMO) ISAC transmitters, however, mutual coupling (MC) between antenna elements distorts the array steering vector and each communication user (CU) channel, so that the sensing beampattern deviates from the desired one and the communication link to each user degrades. To address this limitation, we propose a robust MC-compensated beamforming design that guarantees both the sensing and communication performance of MU-MIMO ISAC transmitters against the residual MC error. We introduce a residual error on the MC matrix, so that a norm-bounded residual error induces both the sensing beampattern uncertainty and the communication channel uncertainty. The transmit covariance is then optimized against the worst-case of each uncertainty, minimizing the worst-case beampattern matching mean-squared error (MSE) for sensing while guaranteeing the signal-to-interference-plus-noise ratio (SINR) for each CU. Each worst-case constraint is converted into a linear matrix inequality, and the problem becomes a convex semidefinite program (SDP). Numerical results show that the proposed robust design attains both a lower sensing beampattern matching MSE and a higher communication SINR than those of the conventional designs, with an advantage that widens as the residual error grows.

0.58

Joint EM-BB Beamforming Design for ISAC Systems With Reconfigurable Antenna Arrays

eess.SP ·2026-10-06 ·Jvxiang Hu, Mengzhen Liu, Rang Liu, Qian Liu, Ming Li
benchmark similarity 0.60
Abstract · 6 pages, 4 figures, conference

This paper investigates the joint electromagnetic (EM)-domain and baseband (BB)-domain beamforming for integrated sensing and communication (ISAC) systems enabled by pattern- and polarization-reconfigurable pixel-antenna arrays. A multiport-network-based antenna model is developed to map each binary switch configuration to its radiation response using the impedance and open-circuit radiation data extracted from Computer Simulation Technology (CST) Studio Suite simulations. Based on this model, polarization-aware virtual channels are constructed for downlink communication and statistical target sensing, leading to a mixed-integer nonconvex problem that maximizes the average sensing signal-to-noise ratio (SNR) subject to user signal-to-interference-plus-noise ratio (SINR) and transmit-power constraints. To handle the coupled binary and continuous variables, we propose an alternating optimization algorithm, in which the EM-domain switch-state matrices are updated using successive exhaustive Boolean optimization (SEBO), the BB-domain precoder is optimized via a minorization-maximization (MM) and second-order cone programming (SOCP) procedure, and the sensing combiner is obtained from a Rayleigh-quotient update. Simulation results show that the proposed design achieves higher sensing SNR and stronger target-angle robustness than the fixed-patch benchmark.

0.30

Joint Communication Sensing Beamforming and Uplink Power Control for Network-Assisted Full-Duplex Cell-Free ISAC Systems

eess.SP ·2026-09-07 ·Reza Roshanghias, Seyed Mohammad Karbasi, Reza Saadat
similarity 0.58
Abstract · 19 pages, 14 figures, journal

In this paper, we investigate the problem of designing joint downlink (DL) communication beamformer and uplink (UL) power as well as sensing beamformer in a multi static integrated sensing and communication (ISAC) enabled cell free massive multiple input multiple output (CF mMIMO) system. To this goal, we first consider two priority based beamforming strategies. In the communication prioritized sensing design, we first design the communication beamformers and then the sensing beamformer is projected onto the nullspace of the effective communication channels to suppress its additional interference to both the DL UEs and UL receivers. In the sensing prioritized communication design, we select the sensing beamformer first according to the target direction, while the communication beamformers are subsequently optimized using a max min SINR formulation. In addition to these priority based designs, we formulate a sensing centric joint optimization problem to determine the optimal DL communication beamformers, sensing beamformer, and UL UE transmit powers. Our objective is to maximize the sensing SINR while guaranteeing individual DL and UL SINR requirements and satisfying the per AP and per UE transmitpower constraints. Since the resulting problem is non convex because of the coupled beamforming and UL power variables, the beamforming vectors are lifted into positive semidefinite transmit covariance matrices and semidefinite relaxation (SDR) is applied.

0.16

Sparse Rotatable Arrays (SRA): Unifying Array Aperture and Antenna Directivity for Wireless Communications

cs.IT ·2026-08-12 ·Ailing Zheng, Qingqing Wu, Xiyuan Liu, Wen Chen
similarity 0.58
Abstract

Sparse rotatable array (SRA) is a novel reconfigurable antenna architecture that jointly exploits sparse aperture configuration and antenna directivity to enhance spatial resolution for future wireless communications. Specifically, SRA activates a subset of rotatable antennas over a large candidate aperture and adjusts their boresight directions, thereby creating a directionally selective sparse aperture with reduced hardware requirements and enhanced spatial flexibility. In this paper, we investigate an SRA-aided multi-group communication system, where users are organized into spatial groups with different service requirements. We develop a group-aware SRA design framework by jointly optimizing the sparse-aperture allocation, RA orientations, and transmit beamforming to maximize the weighted max-min signal-to-interference-plus-noise ratio (SINR). Then, we characterize the operating principles of SRA and reveal that sparse aperture improves spatial resolution by enlarging the effective array aperture, while antenna directivity suppresses inter-group coupling through directional control, thereby enabling simplified group-wise beamforming structures. Guided by these insights, we develop a structured low-complexity alternating optimization algorithm that embeds a closed-form projected group-center RA orientation rule into the sparse-aperture allocation and beamforming design. The proposed algorithm combines analysis-guided initialization, sampled multi-start antenna-allocation search, and bisection-based second-order cone programming for beamforming. Numerical results show that the proposed SRA design closely approaches fully-shared SRA benchmarks and significantly outperforms compact subarray and omni sparse-array schemes.

0.04

Sensing-Assisted OFDM with Index Modulation: A Waveform for Optical Wireless Integrated Communication and Localisation

eess.SP ·2026-10-15 ·Ali Waqar Azim, Mohamed Sufyan Islim, Muhammad Ali Imran, Harald Hass, Hanaa Abumarshoud
similarity 0.58
Abstract

This paper proposes sensing-assisted OFDM with index modulation (SA-OFDM-IM) for joint communication and localisation over optical wireless systems. In SA-OFDM-IM, a multilayer frequency-domain architecture partitions each layer's admissible subcarriers into disjoint communication and distributed sensing-pilot subsets, applying group-wise index modulation (IM) within the communication subset. A constrained sensing-to-communication energy allocation jointly minimises average bit-error rate (BER) and delay-based localisation root mean square error (RMSE) under a minimum power-domain margin, enabling low-complexity, ordered-energy detection of both sensing and communication subcarriers without exhaustive maximum-likelihood search. Sensing tones are aggregated across the frame to reconstruct the channel frequency response, yielding the line-of-sight (LoS) delay tap and phase-compensated LoS gain for multilateration and, via the proposed delay-aided received signal strength (RSS) refinement. Simulation results indicate that SA-OFDM-IM can achieve up to 5 dB lower SNR requirement in BER and up to three orders of magnitude lower channel-estimation error than DC-biased optical OFDM, while the RSS estimator removes the SNR-independent error floors of delay-only and hybrid-RSS benchmarks to attain sub-delay-bin range and position accuracy, remaining robust under random known and unknown receiver orientations.

0.22

Index Modulation Aided Phase-Rotated AFDM for Efficient Integrated Sensing and Communication: Framework, Optimization and Performance Analysis

eess.SP ·2026-09-27 ·Shiqi Cui, Zeping Sui, Tianqi Mao, Yuanshuo Gang, Guangyao Liu +5 more
theory similarity 0.57
Abstract · 13 pages, 8 figures

Affine frequency division multiplexing (AFDM) has emerged as a competitive waveform for integrated sensing and communication (ISAC) in high-mobility scenarios, but its data-dependent high peak-to-average power ratio (PAPR) and ambiguity function (AF) sidelobes may degrade the power-amplifier efficiency as well as the sensing performance. To mitigate the issues, one promising candidate is the phase-rotation optimization philosophy, which necessitates auxiliary side information (SI) to guarantee successful data recovery at the receiver. However, using additional signalling overhead to deliver the SI degrades the spectral efficiency. Against the background, this paper proposes a power level index modulation (PLIM)-aided phase-rotated AFDM (PLIM-PR-AFDM) scheme, which embeds the phase-rotation SI within the transmitted block. At the transmitter, the proposed scheme jointly optimizes the waveform by coordinating the PLIM power allocation, phase rotation, and embedding of SI. Specifically, subcarriers are flexibly allocated with different transmit power levels. High-power subcarriers are phase-rotated to suppress the PAPR and fast-slow-time AF sidelobes. By decomposing the fast-slow-time AF sidelobe energy into per-block periodic autocorrelation function (PACF) terms, the sensing objective can be formulated as a PACF-weighted integrated sidelobe level (WISL) minimization problem, while selected low-power subcarriers embed the phase bits as SI through constellation labels. Furthermore, the PLIM power patterns of each transmitted block can convey additional index bits, which compensates for the spectral efficiency loss caused by SI transmission. Moreover, the error performance is analyzed by deriving an upper bound of the average bit error probability (ABEP) and identifying the condition for full diversity.

0.17

OFDM-ISAC over Data Payloads: MSE Analysis, Constellation Design, and Experimentation

eess.SP ·2026-08-16 ·Kawon Han, Kaitao Meng, Alexandra Chatzicharistou, Christos Masouros
similarity 0.57
Abstract · 13 pages, 12 figures

Orthogonal frequency division multiplexing (OFDM) is a key waveform for integrated sensing and communication (ISAC) systems due to its high spectral efficiency and inherent compatibility with modern wireless standards. However, its fundamental estimation-theoretic sensing performance under random data modulation remains largely unexplored. This paper presents a unified and explicit performance analysis of OFDM-based ISAC systems for multi-target range estimation, focusing on the distinct impacts of the modulation constellation on the sensing performance. We develop a comprehensive estimation-theoretic framework to characterize the range estimation mean-square error (MSE) for both matched filtering (MF) and reciprocal filtering (RF) sensing receiver architectures. Our theoretical analysis reveals that in multi-target and clutter-rich environments, the sensing performance of the MF receiver is fundamentally limited by the fourth-order moment (kurtosis) of the constellation, which determines the data-dependent sidelobe interference level. In contrast, the RF receiver eliminates such interference at the cost of noise enhancement, with its performance governed by the inverse second-order moment of the constellation. Building on these closed-form MSE derivations, we propose a sensing-receiver specific geometric constellation shaping (GCS) framework. By jointly optimizing the constellation geometry based on the minimum Euclidean distance (MED) and receiver-dependent sensing metrics, we enable a flexible trade-off between communication reliability and sensing precision. Our results demonstrate that the proposed constellation shaping provides significant performance gains and facilitates a tailored sensing and communication trade-off across different receiver architectures in practical over-the-air implementations.

0.46