CS Paper Radar

Flatness-based Neural Network Control of DC-DC Converters

Kamakshi Tatkare, Ufuk Topcu, Brian Johnson

eess.SY ·submitted 2026-09-30 14:40 UTC · v1
published

Abstract

In this work, we present a simple method to engineer a small neural network to control power converters. Learning-based methods have emerged as a promising approach for power converter control over wide operating point variations. However, many of these approaches do not exploit the analytical structure of converter dynamics and, therefore, search over unnecessarily broad policy classes. We address this gap with a systematic framework that combines model-based trajectory generation with policy learning. First, we use differential flatness of averaged converter models to generate feasible state and constrained duty cycle trajectories where duty acts as a control effort signal. Then for policy learning, we use these model-generated trajectories to construct labeled state-to-duty data and train a multilayer perceptron to approximate the control law with a static map. We apply this framework across buck, boost, and buck-boost converters through topology-dependent flat output selection and a common learning pipeline. Simulations show close agreement between learned and model-generated duty trajectories and stable regulation under large synchronous input and load disturbances.

Comment
Accepted to 2026 65th IEEE Conference on Decision and Control (CDC)

Closest papers

Nearest neighbours by meaning across the whole index.

Learning Higher Order DC-DC Converter Control from Inversion

eess.SY ·2026-09-30 ·Kamakshi Tatkare, Ufuk Topcu, Brian Johnson
similarity 0.75
Abstract · Accepted at the IEEE 27th Workshop on Control and Modeling for Power Electronics (COMPEL 2026)

Control design for high-order converters with nonlinear dynamics is generally difficult. Nonlinear controls introduce formidable model complexity whereas linear controls suffer from poor disturbance rejection. Our objective in this paper is to develop a simple neural-network-based controller that learns the control law from supervised trajectories generated by a model-based bounded inversion framework. First, we establish strong invertibility for the converter models. Next, we prescribe the desired closed-loop behavior through a trajectory model that defines the target dynamics. We then invert the converter dynamics numerically to obtain the corresponding duty-cycle and state trajectories. We use these model-based trajectories as supervision and train a neural network to approximate the resulting state-to-duty control law. The results show that the learned controllers accurately recover the inversion-based control action and achieve effective regulation under load and input-voltage disturbances. We validate the method on fourth order Cuk, SEPIC, and zeta converters.

0.53

Enhanced Imitation Learning of Model Predictive Control through Importance Weighting

eess.SY ·2026-11-04 ·Pere Izquierdo Gómez, Miguel E. López Gajardo, Nenad Mijatovic, Tomislav Dragicevic
top venuehighly cited similarity 0.62
Abstract

The approximation of model predictive control (MPC) algorithms with neural network models has received significant attention in the power electronics research community, as a valuable tool to enable the real-time implementation of computationally expensive methods. Training machine learning models to imitate MPC algorithms typically follows a traditional supervised learning flow, with a static training data set generated through either uniform sampling or simulation. Training with uniformly distributed data allows models to maintain consistent performance throughout the entire operating space, but very small models may fail to achieve satisfactory results in the regions corresponding to expected operation. Conversely, simulation data can be used in training to obtain models that can accurately track certain trajectories but fail to achieve adequate performance in underrepresented regions. The present article proposes a method to combine the advantages of both methods, by training models on sampled data with importance weights obtained through the kernel density estimation of experimental data. This allows the training process to target specific regions of the operating space, and results in measurable performance improvements. The method is demonstrated through the imitation of a moving discretized control set MPC algorithm for a dual active bridge converter, and is validated through experimental results.

0.70

Safe Receding Horizon Mixed-Integer Differentiable Predictive Control for Degradation-Aware Battery Dispatch

eess.SY ·2026-09-23 ·Eshagh Safarzadeh Ravajiri, Jan Drgona, Benjamin F. Hobbs
publishedbenchmark similarity 0.60
Abstract · 6 pages, accepted to the 65th IEEE Conference on Decision and Control (CDC 2026)

We present a safe receding-horizon mixed-integer differentiable predictive control methodology for residential battery energy storage dispatch that combines neural-network speed with recursive feasibility guarantees. Unlike open-loop learning-to-optimize methods, it incorporates real-time state-of-charge feedback and sinusoidal time-of-day conditioning, enabling closed-loop re-planning at every timestep without re-solving a mixed-integer program. A differentiable rainflow cycle-counting layer enables self-supervised training of the mixed-integer policy on exact degradation physics. The controller is a hybrid closed-loop system pairing a neural mode-selection and continuous-action policy with a quadratic-programming safety filter that guarantees recursive feasibility independent of network weights or mode optimality. We establish mode-conditioned Lipschitz continuity and a conditional regret decomposition into training-quality, mode-mismatch, and forecast-error terms. On a 7-day net-metering evaluation, the method attains a 6.9% cost gap versus the closed-loop mixed-integer MPC benchmark with a 25x speedup (0.11 s vs 2.7 s per step), while average regret rises by under 4% across 0-30% forecast noise. The learned and benchmark modes agree at every step, so the bound reduces to its training-quality and forecast-error terms, both empirically validated.

0.19

Differentiable Hybrid-Action Neural Feedback Control for District Heating Networks

eess.SY ·2026-10-01 ·Nicolas Kirsch, Corrado Sgadari, Alessio La Bella, Giancarlo Ferrari-Trecate
similarity 0.58
Abstract

Many cyber-physical systems require control policies that combine continuous setpoints with discrete operational de- cisions, such as equipment switching, mode selection, or resource scheduling. Discrete actions are not differentiable, which ob- structs gradient-based policy training, while conventional mixed- integer formulations remain costly to solve online. This paper proposes a hybrid-action neural controller (HANC) in which a continuous branch, a categorical branch and a differentiable assembly layer jointly generate commands that satisfy complex actuator constraints by construction. Categorical decisions are handled using a straight-through Gumbel estimator, enabling the policy to be trained by backpropagation through time over full closed-loop rollouts. The proposed framework is deployed on a district heating network (DHN) featuring multiple heat generation units and stratified thermal energy storage. Its performance is evaluated on a simulation of a real DHN located at RSE SpA in Italy. The resulting policy jointly learns switching decisions and continu- ous operating setpoints. Under dynamic electricity pricing, the learned controller reduces operating cost by 30% compared to a rule-based industrial baseline. We also show that, compared with a deterministic straight-through relaxation, injecting noise during training achieves similar cost while reducing hard switching by an order of magnitude, and attribute this difference to the wider decision margins of the resulting policy.

0.24

Sequential Learning-Based Physics-Informed Neural Network Modeling for Parameter Estimation on a Power Converter

cs.LG eess.SY ·2026-10-14 ·Samuela Rokocakau, Panagiotis Kakosimos, Giulia Tresca, Pericle Zanchetta
similarity 0.57
Abstract · IEEE ECCE 2026

A staged physics-informed neural network (PINN) is proposed for identifying the inductance, capacitance and parasitic resistances of a DC buck converter from time-domain data. Gradients are released in the order of L to C to rL to rC, a sequence derived from sensitivity analysis. The five-stage schedule recovers L and C to within 5% and the series ESR to 10%, while a three-stage variant attains the same accuracy 11% faster. An 84 factorial sweep confirms that the trained PINN remains accurate for simultaneous 8% perturbations of all four components, achieving a waveform RMSE of 2.6 x 10-2 over 5 ms-an order-of-magnitude better than a simultaneous-training baseline.

0.13

Hierarchical Control via MPC-RL for Multi-Timescale Battery Systems

eess.SY ·2026-10-02 ·Rasa Pourjam, Ehecatl Antonio del Río Chanona, Paulina Quintanilla
similarity 0.57
Abstract

Multi-timescale systems present a fundamental challenge, where fast operational decisions must coexist with long-horizon sustainability targets. In this work, we propose a new hierarchical control framework via Model Predictive Control (MPC) and Reinforcement Learning (RL) to separate decision-making on two distinct timescales. The high-level MPC optimizes long-horizon setpoints at the slow dynamic and on a fast timescale, a low-level pretrained RL agent tracks these setpoints in real time to maximize short-term objectives. RL is introduced to learn nonlinear control policies, without relying on model linearizations or requiring the heavy online computation from solving repeated optimal control problems. The framework is applied to a Battery Energy Storage System (BESS) operating in frequency regulation markets to balance fast profit opportunities (seconds) and slow battery degradation (weeks to months). The design employs a degradation-aware RL agent trained offline to generate safe long-horizon setpoints, and a degradation-unaware agent fine-tuned from it for fast runtime setpoint tracking. Compared to MPC baselines, the proposed approach successfully extends battery lifetime by 84% and increases operational profit by 34%.

0.17

Certified Neural Approximation of Robust Nonlinear Model Predictive Control

eess.SY cs.LG ·2026-10-21 ·Hendrik Alsmeier, Maik Pfefferkorn, Rolf Findeisen
similarity 0.57
Abstract · 12-page article plus 4-page supplement, 3 figures

Model predictive control is a high-performance control method, but it incurs comparatively high online computational costs across many control tasks and is challenging to realize in low-level hardware settings. To address this, we present a framework for generating neural network controllers that provably inherit the safety and stability guarantees of a robust model predictive policy. In contrast to approaches based on post-verification or additional online safety filters, our method provides constructive, a priori design conditions that ensure preservation of recursive feasibility and stability before deployment. We treat the approximation error as a bounded input disturbance, which is addressed in the MPC design. This allows the neural network controller to directly inherit robustness from the underlying model predictive controller, which enables the transfer of guarantees to the approximation. The design process is an offline, constructive synthesis pipeline and can be implemented once Lipschitz bounds are specified. We further demonstrate in simulation that the learned controller reproduces the closed-loop behavior of the original controller while reducing online computation.

0.11

Graph Machine Learning: An Opportunity for Power Systems

cs.LG cs.AIcs.CEeess.SY ·2026-08-17 ·Martin Sadric, Sebastian Pütz, Christian Nauck, Veit Hagenmeyer, Frank Hellmann +2 more
surveybenchmark similarity 0.56
Abstract

Modern power systems face growing operational complexity driven by the integration of renewable energy sources, decentralization, and the need for real-time decision-making across a wide range of timescales. Addressing these challenges traditionally relies on model-based methods that, while accurate, can be too slow for operational demands. Machine learning (ML) has therefore emerged as a faster, data-driven alternative. As grid topology plays a central role in power system operation, graph machine learning (GML) methods offer a natural framework for incorporating topological dependencies as an inductive bias. We survey nearly 800 papers at the intersection of GML and power systems, covering forecasting, state estimation, optimization, control, fault diagnosis, and cybersecurity. Power systems constitute an unusually rich benchmark setting for GML, as they combine hard physical constraints, multi-scale dynamics, safety-critical requirements, and scarce labeled data within a single, well-defined domain. Conversely, power systems can benefit from utilizing GML to complement classical solvers, as GML provide scalable, topology-aware approximations with promising generalization and computational efficiency. We identify open challenges, including limited real-world deployment and the need for interpretable models in safety-critical settings. Despite the rapidly growing number of publications, standardized benchmarks and open datasets remain scarce, leaving many results difficult to reproduce and undermining the long-term scientific credibility of the field. We further derive a structured requirements catalog for ML-ready power grid benchmarks, intended to guide future dataset development and improve reproducibility across studies. We call on the community to prioritize dedicated benchmark studies and the release of open datasets and models.

0.23