CS Paper Radar

Investigation of RIS Integration in Satellite Systems Guided by ITU-R VSAT Radiation Diagram

Symeon Vaidanis, Athanasios D. Panagopoulos

eess.SP cs.IT ·submitted 2026-10-12 12:33 UTC · v1
published

Abstract

The introduction of Reconfigurable Intelligent Surfaces (RIS) technology marks a transformative era in modern communication systems, enhancing coverage and facilitating higher data transmission rates. While recent research has delved into the integration of RIS into satellite networks, a critical and practical gap persists concerning its implementation in the satellite-Very Small Aperture Terminal (VSAT) downlink, specifically amplifying contributions from the VSAT side. This paper addresses this gap by proposing a simple and engineering methodology to optimize RIS position and orientation, incorporating considerations for the antennas' radiation patterns and the system's topology to streamline optimization variables. The primary objective of this paper is to alleviate the double fading constraint in the reflect link without the need for active elements, achieved by leveraging the Fresnel zone of the RIS. The improvement power ratio depends on the frequency and the VSAT 's diameter. The results show that for a VSAT with diameter 1m the gain is up to 9dB at 2 GHz (S band) and up to 14dB at 4 GHz (C band). Additionally, the RIS channel equation is refined, encompassing the tropospheric attenuation and accounting for electromagnetic wave polarization.

Comment
This work has been accepted for publication in ITU Journal on Future and Evolving Technologies

Closest papers

Nearest neighbours by meaning across the whole index.

Transmissive RIS-Assisted Vehicular Direct-to-Satellite Communications: Opportunities, Limitations, and Comparison with Phased Arrays

cs.IT cs.ET ·2026-08-29 ·Wali Ullah Khan, Abdullah Abdullah, Juan Andres Vazquez-Peralvo, Eva Lagunas
similarity 0.61
Abstract · 9, 2

This article studies transmissive reconfigurable intelligent surface (RIS)-assisted architectures. It compares them with electronically steered phased arrays for the deployment of vehicular direct-to-satellite (D2S) communications in future satellite networks. Rather than treating RIS as a direct replacement for phased arrays, we clarify the operating regimes in which RIS can serve as a low-power wavefront-shaping aperture and those in which phased arrays remain preferable because of their high gain and mature beam-tracking capability. Moreover, phased arrays can support multi-beam operation, which is particularly beneficial for dual connectivity and seamless handover. We distinguish analog, digital, and hybrid phased arrays, discuss the relationship between transmissive RIS and reconfigurable transmitarrays, and highlight practical profile, tracking, and link-budget constraints for mobile terminals. The comparison shows that passive RIS offers attractive power efficiency and aperture scalability, active RIS can partially improve the link budget, and phased arrays remain preferable for high-throughput.

0.13

Properties of Array Factor of Reconfigurable Intelligent Surfaces for Radio Communications

eess.SP cs.IT ·2026-10-12 ·Symeon Vaidanis, Athanasios D. Panagopoulos
published similarity 0.61
Abstract · This work has been accepted for publication in 2024 IEEE INC-USNC-URSI Radio Science Meeting (Joint with AP-S Symposium)

This paper delves into the intricate aspects of Reconfigurable Intelligent Surfaces (RIS) in the antenna design. It investigates the properties of the array factor of RIS, highlighting the significance of phase shifts in establishing of the reflect path. Additionally, the paper investigates spatial positions requiring identical phase shifts, nullification of the array factor, the count of total maxima, second maximum determination (amplitude of the second lobe), and the calculation of the 3dB bandwidth. They are very useful for RIS-assisted radio communication systems.

0.40

Tri-Hybrid Beamforming for T-RIS-Enabled Base Station

cs.IT ·2026-08-20 ·Hongtao Zhang, Chenlong Ding
similarity 0.60
Abstract

Transmissive reconfigurable intelligent surfaces (T-RISs) integrated into the transmitter provide a viable realization of tri-hybrid multiple-input multiple-output (MIMO), where spatial processing is distributed across the digital, analog radio-frequency (RF), and electromagnetic (EM) domains. However, unlike conventional RIS-assisted links, a transmitter-native T-RIS directly participates in radiation formation, making T-RIS front-end modeling and weighted sum-rate (WSR)-oriented joint precoding challenging under practical hardware constraints. This paper develops a unified modeling and precoding framework for transmitter-native T-RIS tri-hybrid multi-user (MU) downlink transmission. Specifically, starting from a continuous-field description, the received field is characterized by the interaction among the feed array, the programmable T-RIS aperture, and the user-side propagation, leading to a cascaded baseband input-output model for MU precoding. Furthermore, the same representation is instantiated in the Fresnel, Fraunhofer, and mixed-field regimes, so that near-field focusing and far-field angular steering can be handled within one front-end model. Additionally, a WSR maximization problem is formulated over the digital precoder, analog network, and T-RIS coefficients under power and quantization constraints. A two-level solver is then developed by coupling outer weighted minimum mean-square error (WMMSE) updates with WMMSE-induced aperture-field shaping and hardware projection. Simulations validate the modeling accuracy and convergence, and show that the proposed full tri-hybrid design improves WSR over baselines while suppressing mixed-field cross-regime leakage.

0.17

RIS-Assisted Downlink Pinching-Antenna Systems With NLOS Environments

eess.SP ·2026-10-25 ·Yue Geng, Kah Chan Teh, Tee Hiang Cheng
similarity 0.59
Abstract · 6 pages, 4 figures

This paper investigates a reconfigurable intelligent surface (RIS)-assisted downlink pinching-antenna system (PASS) in the presence of non-line-of-sight (NLOS) users caused by unavoidable obstacles. An RIS is deployed to extend the coverage of the physically constrained PASS by establishing virtual line-of-sight (LOS) links. To improve system performance, we propose a zero-forcing (ZF) beamforming-based alternating optimization (AO) framework that minimizes the transmit power by jointly optimizing the RIS reflection coefficients and pinching-antenna (PA) activation positions. Specifically, the RIS reflection coefficients are optimized using the Riemannian conjugate gradient (RCG) method, while a novel projected gradient-based method is developed to efficiently optimize the PA activation positions. Simulation results demonstrate that the proposed AO framework outperforms baseline schemes in terms of both transmit power and computational efficiency under different system configurations including the rate requirements and RIS sizes.

0.16

Reconfigurable Intelligent Surfaces: Architectures, Models, and Applications

eess.SY ·2026-10-05 ·Mojtaba Fallahzadeh, Mohammad Hossein Koohi Ghamsari, Alireza Mallahzadeh, Amirhossein Ghasemi, Gabriele Gradoni +1 more
similarity 0.56
Abstract

Reconfigurable Intelligent Surfaces (RIS), also known as programmable metasurfaces, have emerged as a promising technology for next-generation wireless communication systems by enabling programmable control over the propagation environment. Through dynamic manipulation of the phase, amplitude, and polarization of electromagnetic waves, RIS introduces new degrees of freedom for enhancing coverage, spectral efficiency, energy efficiency, and interference management. This article reviews recent advances in RIS-enabled wireless communications, focusing on RIS architectures, emerging design and analysis techniques, and their impact on system-level performance. Key challenges related to scalability, hardware non-idealities, channel modeling, and control overhead are discussed, along with promising solutions and future research directions toward practical RIS deployment in beyond-5G and 6G networks.

0.15

A Wideband STAR-RIS Employing Shared-Aperture Polarization Conversion and Diagonal Switching Topology for 6G Applications

eess.SP ·2026-10-13 ·Ruiqi Wang, Atif Shamim
similarity 0.56
Abstract

Simultaneously transmitting and reflecting reconfigurable intelligent surfaces (STAR-RIS) enable programmable wave control on both sides of a surface, extending wireless coverage beyond single-sided operation. However, practical STAR-RIS demonstrations in literature have narrow bandwidths, because it is challenging to achieve wideband reflection and transmission simultaneously from the same aperture. To overcome this limitation, a wideband STAR-RIS architecture is proposed based on shared-aperture polarization conversion and diagonal switching topology. Here, multiple resonances enable wideband magnitude responses and mirror-symmetric current reversal maintains $180^{\circ}$ phase difference in both reflection and transmission modes. Accordingly, a diagonal four-branch unit cell configuration is developed, where the tailored top patch directs the received wave either through a pair of blind vias connected by a buried strip to the shared top aperture for reflection, or to the bottom ring patch using a through via for transmission. Based on the proposed design, a 10 by 10 STAR-RIS prototype is fabricated and experimentally characterized. The measured 3-dB bandwidths reach 19.8% in reflection mode and 21.9% in transmission mode. Near-field measurements show average signal enhancements of 19.8 and 22.6 dB for reflection and transmission, respectively, over the wide frequency range of 6.8-8.4 GHz. Far-field measurements further demonstrate average received-power enhancements of 11.2 dB in reflection and 11.9 dB in transmission. To the best of the authors' knowledge, this work presents the first experimentally demonstrated wideband STAR-RIS covering the 7.125-8.4 GHz band within the emerging 6G FR3 spectrum.

0.20

System-Level Gains of Dual-Band RIS: From Wireless Communication to SWIPT

eess.SP ·2026-10-01 ·Aritra Basu, Zina Mohamed, Sonia Aïssa
top venue similarity 0.54
Abstract · This work has been accepted for publication in IEEE Transactions on Communications. 2026 IEEE. Personal use of this material is permitted. P…

This paper introduces the integration of dual-band reconfigurable intelligent surfaces (DBRIS) in wireless system design, and investigates the ensuing performance gains in different application scenarios. This type of metasurfaces offers a compelling technology due to their reduced material usage, compact design, and multi-functional operation across multiple frequency bands compared to single-band RISs. Two representative use cases are considered to assess the achievable performance gains with the said integration, namely, DBRIS-assisted wireless communication, and DBRIS-assisted simultaneous wireless information and power transfer (SWIPT). For the first design, where the DBRIS is deployed as a relay, we focus on the energy efficiency (EE) maximization of the communication system. An alternating manifold method is proposed for the joint optimization of the source transmit power and the DBRIS phase shifting. For the second design, we investigate a DBRIS-assisted SWIPT system using a novel power splitting approach. An EE metric is defined, and an alternating optimization algorithm is developed to maximize it. Numerical results validate the advantages of the proposed design architectures as well as the proposed optimization framework. In particular, we highlight the energy efficiency gains enabled by the DBRIS as compared to operations with conventional single-frequency surfaces, in both application scenarios.

0.40

Reconfigurable Antenna-Enhanced ISAC: A Unified Perspective on Electromagnetic Adaptation

eess.SP ·2026-11-03 ·Peilan Wang, Lei Xie, Weidong Mei, Jun Fang, Yihong Su +1 more
similarity 0.54
Abstract

Integrated sensing and communication (ISAC) enables sensing and communication (S&C) functions to share time, frequency, and hardware resources, offering an efficient paradigm for next-generation wireless systems. However, conventional fixed-configuration antenna (FCA) architectures provide limited flexibility in adapting the physical electromagnetic (EM) response of the end-to-end wireless link. This article develops a unified EM-adaptation perspective on reconfigurable antenna (RA)-enhanced ISAC systems. We distinguish transceiver-side (TSc-side) and environment-side (Env-side) RA deployments and identify five fundamental EM reconfiguration dimensions: position, orientation, radiation pattern, polarization, and frequency response. Building on this framework, we examine how these dimensions customize communication channels, actively control target information mapping for sensing, and reshape the interplay between S&C, particularly by improving compatibility between S&C requirements under shared resources. Two case studies illustrate how TSc-side and Env-side EM reconfiguration can improve spatial selectivity and the achievable S&C performance tradeoff. Finally, we discuss several promising directions for advancing RA-enhanced ISAC systems, including fundamental performance limits, low-overhead black-box optimization, and artificial intelligence (AI)-enabled semantic ISAC.

0.19