CS Paper Radar

Information-based Unified Design Framework for NMR Magnetic Tracking System

Seçkin Eren Yetim, Mehmet Efe Tiryaki

cs.RO eess.SY ·submitted 2026-10-13 07:32 UTC · v1

Abstract

Nuclear magnetic resonance (NMR) magnetic tracking offers a promising alternative to magnetic resonance imaging (MRI)-based localization for medical robotic guidance. However, scalar field measurements and field-aligned marker moments constrain position and orientation tracking, requiring careful configuration design. We present a unified information-based framework that uses local covariance analysis to evaluate receiver geometry, marker separation, and external source configuration in on/off-board NMR tracking. Numerical evaluation shows that planar-array precision depends jointly on receiver count and geometry, with triangular lattice arrays achieving the lowest best-case position uncertainty among the evaluated layouts for 9--20 receivers. Two spatially separated, field-aligned markers enable device-axis tracking, with predicted angular uncertainty below $2^\circ$ at the evaluated workspace center for suitable marker separations. We further establish point-dipole source--receiver duality, unifying the analysis of on/off-board NMR tracking. These

Comment
6 pages, 6 figures, journal letter submission

Closest papers

Nearest neighbours by meaning across the whole index.

Gradient-Field Frequency Encoding for 1D Localization of Magneto-Mechanical Resonators

eess.SP eess.SY ·2026-10-05 ·Fabian Mohn, Martin Möddel, Tobias Knopp
similarity 0.63
Abstract · 4 pages, 3 figures

Magneto-mechanical resonators (MMRs) have emerged as promising passive sensors for wireless localization and remote inductive sensing in industrial and medical environments. However, fundamental limits on achievable localization accuracy using the spatial sensitivity profiles of receive coils remain a key challenge. In this work, we demonstrate that an MMR - comprising two permanent magnets in an anti-parallel arrangement - exhibits a measurable shift in its mechanical resonance frequency in response to an externally applied magnetic field, a property we exploit for spatial encoding. We derive and experimentally validate a method that maps frequency shifts of 1D positions within a known magnetic gradient field, demonstrating accurate localization along a linear trajectory. This gradient-field frequency encoding approach constitutes a conceptually distinct alternative to conventional sensitivity encoding with receiver coil arrays, with the potential to simplify hardware requirements while improving localization accuracy.

0.27

MAGNETAR: Multipath-Guided Spatial Posteriors for Transmitter Pose Inference in the Upper Mid-Band

cs.RO eess.SP ·2026-09-17 ·Haozhe Lei, Ruibin Chen, Yuhan Jiang, Ali Rasteh, Aditya Dhananjay +1 more
similarity 0.58
Abstract

Robots that localize a radio transmitter need more than a point estimate: in cluttered rooms, one measurement is often consistent with several transmitter locations and, because upper-mid-band antennas are directional, several headings. We present MAGNETAR, which infers a joint posterior over planar transmitter position and heading from a single asynchronous radio-frequency (RF) multipath snapshot, represented by angle-of-arrival and signal-to-noise-ratio estimates, given the room layout and receiver pose. Among our five neural scorers, MAGNETAR adopts a shared 2D U-Net conditioned on each candidate heading, jointly normalizing scores over a discretized position-heading grid. Training uses real-to-sim-calibrated 10 GHz simulations and a small measured subset. Grid-based joint posteriors outperform parametric ones on held-out simulations, the heading-conditioned scorer transfers best to robotic measurements, and fusing joint posteriors improves on fusing position-only marginals.

0.20

Electromagnetic Micro-Guidewire Control in Large Workspaces

eess.SY ·2026-09-14 ·Jasan Zughaibi, Elia Jaggy, Valentin Gantenbein, Denis von Arx, Cristiano Sartini +7 more
similarity 0.58
Abstract

Electromagnetic navigation requires sufficient actuation at clinically relevant distances due to limited magnetic volumes and coil currents. We combine real-time pose feedback with constrained convex optimization, dynamic feedback, and repetitive control to achieve energy-efficient micro-guidewire steering inside realistic anatomical models. Experiments with a clinically oriented, three-coil electromagnetic navigation system and a 0.6 mm-diameter tip magnet demonstrate angular tracking with root-mean-square errors below 0.25 degrees at distances up to 55 cm from the coil cover. Nullspace current redistribution maintains accurate tracking under active 45 A coil-current constraints. Compared with conventional field alignment, we demonstrate that pose-dependent torque-based allocation substantially reduces current demand, with the efficiency benefit retained at a pose-feedback rate of 15 Hz. These results demonstrate how real-time state information and optimization can extend electromagnetic guidewire control toward clinically relevant working distances.

0.23

Optimal Trajectory Generation for Improved Magnetic Navigation

eess.SY math.OC ·2026-09-23 ·Justin Kang, Teddy Herrera, Liraz Mudrik, Sean Kragelund, Alfonso Sciacchitano +1 more
theory similarity 0.53
Abstract · 11 pages, 9 figures

Magnetic navigation has emerged as a promising alternative for navigation in Global Positioning System (GPS)-denied environments, leveraging geomagnetic field maps in conjunction with onboard magnetometer measurements. However, its performance is highly sensitive to trajectory-dependent observability, which limits its practical effectiveness under conventional flight paths. This paper proposes an optimal trajectory design framework for magnetic navigation that maximizes information content along the flight path. The trajectory generation problem is formulated as an optimal control problem that minimizes the posterior Cramér--Rao lower bound on the position estimation error, subject to a penalty on path length. The resulting trajectories are non-intuitive and significantly enhance the observability of the navigation system. Simulation results demonstrate that the proposed optimal trajectories yield substantial reductions in estimation error compared to conventional straight-line trajectories, highlighting the critical role of trajectory design in enabling high-accuracy magnetic navigation. These findings suggest that trajectory optimization can substantially improve the viability of magnetic navigation as a robust alternative for aerospace applications in GPS-denied environments.

0.26

A Tightly Coupled Magnetic-Inertial SLAM System for Field Robots

cs.RO eess.SP ·2026-11-02 ·Chuan Huang, Tongxing Peng
similarity 0.52
Abstract

Field robots operating in mines, tunnels, and disaster areas require reliable localization despite GNSS denial and degraded camera and LiDAR measurements caused by dust, smoke, or poor illumination. Missions involving both ground and aerial robots further motivate complementary sensing modalities that do not depend on visibility, preinstalled infrastructure, or wheel contact. This letter presents MISLAM, a tightly coupled magnetic-inertial simultaneous localization and mapping system using an IMU and a nine-magnetometer array, without relying on external odometry or platform-specific motion assumptions. The system combines the inertial navigation model with local polynomial magnetic-field models for short-term motion estimation and a global Gaussian process model for drift correction using an error-state Kalman filter. Offline evaluation on three indoor datasets collected with a handheld rig shows reductions in total endpoint closure error of 45.7% - 78.0% relative to magnetic-inertial odometry. Under poor illumination, MISLAM maintains tracking after visual-inertial odometry fails, achieving a horizontal closure error of 0.332 m, although vertical drift remains a limitation. These results support magnetic-inertial SLAM as a complementary localization modality for robotic sensor suites operating under degraded visual conditions.

0.16

Magnetic based In-situ Self 3D Pose Estimation for a Modular Soft Tendon-Driven Continuum Robot via IMU-Fusion

cs.RO eess.SPeess.SY ·2026-09-30 ·Zheng Cao, Guo Ning Sue, Xiangyun Bu, David Quinn, Junzhe Hu +1 more
similarity 0.52
Abstract

Continuum robots are well suited for gentle manipulation because of their inherent compliance and ability to adapt to complex environments. However, their continuously deformable structure makes accurate configuration estimation challenging, particularly when external vision systems are unavailable or obstructed. In this work, we present an embedded pose sensing framework that combines inertial measurement units (IMUs) and active magnetic fields to estimate the robot configuration without relying on external cameras. The angular measurements from the IMU and magnetic-field references are fused to improve local orientation estimation and reduce accumulated orientation error during operation. This pose sensing scheme achieves an update rate of 16.7~Hz, allowing real-time feedback. The proposed system is experimentally validated through closed-loop control, where the estimated robot configuration is used to maintain the end-effector at a desired position while interacting with an object. These results demonstrate the potential of distributed magnetic--inertial sensing for real-time pose estimation and closed-loop control of continuum robots.

0.11

MagServo: Uncertainty-Resilient Hierarchical Magnetic Servoing via Learned Latent Representations

cs.RO ·2026-10-05 ·Yuhan Tan, Yameng Zhang, Pei Liu, Yao Zhong, Zhongliang Jiang
similarity 0.50
Abstract

Magnetic navigation provides contact-free and line-of-sight-independent feedback for robotic systems, yet existing approaches typically rely on explicit pose estimation or direct use of raw magnetic measurements, making accurate control susceptible to modeling errors, measurement noise, and disturbances. This work presents MagServo, a hierarchical learning-based framework for robust 6-DoF magnetic servoing directly using the learned latent magnetic feature. MagServo learns uncertainty-resilient magnetic representations through masked reconstruction and captures state-dependent interaction dynamics between robot motion and latent magnetic transitions without analytical magnetic models or explicit Jacobian supervision. Based on the learned dynamics, a hierarchical controller combines nonlinear model predictive control for coarse approach with local Jacobian inversion for precise fine regulation. Extensive physical experiments demonstrate submillimeter and subdegree accuracy, achieving mean terminal errors of 0.386 mm and 0.479 degree for 6-DoF pose reaching. MagServo further outperforms a localization-based control baseline in complex trajectory tracking and maintains robust performance under unseen magnetic-source configurations without retraining. A supplementary video of the real-robot experiments is available at https://youtu.be/rZt1NUP1Mr0.

0.38

Target Localization and Self-Calibration in a Multistatic Radar System

eess.SP ·2026-08-16 ·Ahmad Musallam, Husheng Li
publishedtheory similarity 0.50
Abstract

Target localization in a multistatic radar system, where multiple receivers cooperate to improve target positioning accuracy, has many applications, including cooperative simultaneous localization and mapping (SLAM) and autonomous robot networks. A key challenge in these applications is the uncertainty in the position and orientation (pose) of the radar receivers due to platform mobility. This work investigates the achievable improvements in both target localization and receiver pose estimation by deriving the Cramer-Rao lower bound (CRLB) for a multistatic radar system performing bistatic range and bearing measurements. We propose an alternating weighted least-squares algorithm that jointly optimizes target and receiver parameters. Monte Carlo simulations demonstrate that the algorithm performance approaches the CRLB for low to moderate noise levels.

0.52